Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 1/2, 3/5, 2/3, 5/6 — Convert all four fractions to a common denominator of 30: 2/3 is 20/30, 3/5 is 18/30, 5/6 is 25/30, and 1/2 is 15/30. Ordering by these numerators, smallest to largest, gives 15/30, 18/30, 20/30, 25/30, which is 1/2, 3/5, 2/3, 5/6. Ordering by the size of the numerator in the original fractions, 1, 2, 3, 5, rather than converting to a common denominator, gives the wrong order 1/2, 2/3, 3/5, 5/6, because it ignores that the denominators are different. Ordering largest to smallest instead of smallest to largest, as the question asks, gives 5/6, 2/3, 3/5, 1/2. Using the rule "the bigger the denominator, the smaller the fraction" to place the last two, so that 5/6 is put below 2/3 because 6 is bigger than 3, gives 1/2, 3/5, 5/6, 2/3 — that rule only holds when the numerators are the same, and here 20/30 really is smaller than 25/30. So the correct order, smallest to largest, is 1/2, 3/5, 2/3, 5/6.
- (a) y¹² — Method: when a power is raised to another power, multiply the two indices. Working: (y³)⁴ means y³ × y³ × y³ × y³, which is four lots of three y's multiplied together, so the index is 3 × 4 = 12 and (y³)⁴ = y¹². y⁷ comes from adding the indices, 3 + 4 = 7, which is the rule for multiplying two separate powers, not for raising a power to a power. y⁸¹ comes from working out 3⁴ = 81 and using that as the index, raising the inner index to the outer power instead of multiplying the two indices. 12y comes from multiplying the indices to make 12 but then treating y as a coefficient instead of a power. Answer: y¹².
- (c) > — Method: write both fractions with a common denominator so they can be compared directly. Working: −2/3 = −4/6. Comparing −4/6 and −5/6, −4 is greater than −5, so −4/6 is greater than −5/6. Answer: −2/3 > −5/6, so the symbol is >. < comes from treating the fraction with the larger numerator and denominator, 5/6, as the greater number, ignoring that both fractions are negative. = comes from assuming the fractions must be equal because they look similar in size. ≤ combines < (false) with = (false).
- (d) 6,000,000 — Method: round each number to 1 significant figure, then subtract. Working: 8,340,000 rounds to 8,000,000 (1 s.f.); 1,950,000 rounds to 2,000,000 (1 s.f.); 8,000,000 − 2,000,000 = 6,000,000. Answer: 6,000,000. 6,390,000 is the exact difference, found without rounding the numbers first. 8,000,000 comes from rounding the population correctly but forgetting to subtract the capital's population at all. 6,300,000 comes from rounding 8,340,000 to the nearest hundred thousand, 8,300,000, instead of to 1 significant figure, then subtracting the correctly rounded 2,000,000.
- (c) 1/4 — A negative index means the reciprocal of the positive power, so 2⁻² = 1 ÷ 2² = 1/4. Treating the negative sign as making the answer negative instead gives −(2²) = −4. Ignoring the negative sign altogether gives just 2² = 4. Finding the reciprocal correctly but then also applying a negative sign gives −1/4.
- (d) 3/10 — Total parts = 7 + 3 = 10. Gold beads are 3 of those 10 parts, so the fraction is 3/10. 7/10 comes from finding the fraction of red beads instead of gold beads. 7/3 comes from writing the ratio itself as a fraction, without adding the parts to find the total. 3/7 comes from comparing gold beads with red beads instead of with the total number of beads.
- (a) 12 — Method: build the number one place at a time, listing systematically: fix the tens digit, then run through every units digit that is still available. Working: any of the 4 digits can go in the tens place, and once it has been used only 3 digits are left for the units place, so there are 4 × 3 = 12 numbers; listing the numbers that begin with 1 gives 12, 13 and 14, and each of the other three starting digits gives 3 numbers in the same way. Answer: 12. The distractors: 16 comes from working out 4 × 4, which allows a digit to be used twice; 8 comes from multiplying the 4 digits by the 2 places in the number instead of multiplying the choices available at each place; 6 comes from treating a number and its reverse as the same, counting only the unordered pairs of digits.
- (c) 9/5 — Method: the area of a rectangle is its length multiplied by its width; the decimal product is then written over a power of ten and cancelled. Working: 24 × 75 = 1800, and 2.4 and 0.75 have three decimal places between them, so 2.4 × 0.75 = 1.8; the area of the panel is 1.8 square metres, which is eighteen tenths, so it can be written as 18/10, and dividing the numerator and the denominator by 2 gives 9 over 5. Answer: 9/5. The distractors: 4/5 comes from converting only the digits after the decimal point and losing the whole one, turning 1.8 into eight tenths; 63/20 comes from adding the two sides instead of multiplying them, giving 3.15; 9/50 comes from misplacing the decimal point in the product and writing 0.18, which cancels to 9 over 50.
- (b) 63 — 5 + 2 = 7, then 3² = 9, then 7 × 9 = 63. Ignoring the brackets and applying BIDMAS as if the expression were unbracketed gives 3² = 9, then 2 × 9 = 18, then 5 + 18 = 23. Squaring the bracket instead of the 3 gives 7² = 49, then 49 × 3 = 147 — the power belongs to the 3 alone. Multiplying by 3 before squaring the whole product gives 7 × 3 = 21, then 21² = 441.
- (b) 0.58333... — Divide 7 by 12 using long division. 70 ÷ 12 = 5 remainder 10, so the first decimal digit is 5. Bring down a 0 to make 100: 100 ÷ 12 = 8 remainder 4, so the second digit is 8. Bring down a 0 to make 40: 40 ÷ 12 = 3 remainder 4, so the third digit is 3. Bring down a 0 to make 40 again — the remainder 4 has reappeared, so the digit 3 repeats forever from here. This gives 7/12 = 0.58333... . Stopping the division after two digits and writing 0.58 treats it as if it terminated, when the remainder is not yet zero. Misreading the pattern as a two-digit repeating block, '58', gives 0.585858..., which wrongly makes the 5 recur as well as the 3. A slip in the long division that carries the wrong remainder forward can make the second digit itself appear to repeat instead of the third, giving 0.588888... .
- (a) 0.55, 58%, 3/5 — Converting all three to decimals: 3/5 = 0.6, 0.55 stays as 0.55, and 58% = 0.58. In order from smallest to largest, this is 0.55, then 58%, then 3/5. Writing the numbers in the reverse order, largest to smallest, gives 3/5, 58%, 0.55. Misconverting 3/5 as 0.5 instead of 0.6 makes it appear smaller than both other values, giving the order 3/5, 0.55, 58%. Misconverting 58% as 0.058 instead of 0.58, by moving the decimal point two extra places, makes it appear smallest of the three, giving the order 58%, 0.55, 3/5.
- (a) 12 — Method: for any two numbers, their highest common factor multiplied by their lowest common multiple equals the product of the two numbers. This holds because the HCF collects every prime factor the two numbers share, and the LCM collects every prime factor that appears in either number, so between them they use each prime factor of the two numbers exactly once — the same primes as the product. Working: 4 × 60 = 240, and 240 ÷ 20 = 12. 15 comes from working out 60 ÷ 4 = 15, dividing the wrong pair of numbers. 16 comes from working out 20 − 4 = 16, subtracting the highest common factor instead of using the product rule. 240 is 4 × 60, the product of the highest common factor and the lowest common multiple, left un-divided by 20. Answer: 12.
- (c) 2 — First write 1 1/2 as an improper fraction, 3/2. To divide by 3/4, multiply by its reciprocal, 4/3: 3/2 × 4/3 = 12/6 = 2. Dropping the whole number and dividing only the fractional part, 1/2 ÷ 3/4 = 1/2 × 4/3, gives 2/3. Multiplying by 3/4 directly instead of using its reciprocal, 3/2 × 3/4, gives 9/8. Using the reciprocal of the first fraction instead of the second, 2/3 × 3/4, gives 1/2.
- (c) 9 — Method: factors come in pairs that multiply to give the number, so work through the pairs in order; a factor paired with itself is counted only once. Working: the pairs are 1 × 100, 2 × 50, 4 × 25, 5 × 20 and 10 × 10. The first four pairs give eight different factors, and the last pair adds only one more, so the factors are 1, 2, 4, 5, 10, 20, 25, 50 and 100. Answer: 9. The distractors: 10 comes from counting the pair 10 × 10 as two separate factors; 8 comes from leaving 1 out of the list, on the view that 1 is not a proper factor; 4 comes from writing 100 = 2² × 5² and multiplying the two indices together instead of adding 1 to each index first.
- (c) 5/8 — Method: write the decimal over 1000 using its three decimal places, then simplify. Working: 0.625 = 625/1000 = 5/8 (dividing both numerator and denominator by 125). Answer: 5/8. 25/4 comes from writing the decimal over 100 instead of 1000, as if there were only two decimal places. 31/50 comes from rounding 0.625 to 0.62 before converting. 8/5 comes from simplifying correctly to 5/8 and then writing the fraction upside down.
Build your own mix at the worksheet builder.