Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) 12.3 ≤ t < 12.4 — Method: truncating cuts the later digits off instead of rounding them, so nothing is ever pushed upwards. The displayed value is therefore the smallest the time can be, and the time can run up to, but not reach, the next value the display can show. Working: the display reads 12.3, so the actual time is at least 12.3 seconds; as soon as the time reaches 12.3 + 0.1 = 12.4 seconds the display would read 12.4, so 12.4 is not included. Answer: 12.3 ≤ t < 12.4. The distractors: 12.25 ≤ t < 12.35 is the interval for a time rounded to 1 decimal place, and this display does not round; 12.3 < t ≤ 12.4 excludes the one value the display certainly allows and includes the one it rules out; 12.3 ≤ t ≤ 12.4 treats 12.4 seconds as possible, but at 12.4 seconds the display would no longer read 12.3.
- (a) 300 — Method: round each number to 1 significant figure, then divide the rounded values. Working: 8,900 rounds to 9,000 and 29 rounds to 30; cancelling a zero from each gives 900 ÷ 3. Answer: 300. The distractors: 450 comes from rounding 29 down to 20 instead of to the nearest ten, giving 9,000 ÷ 20; 3,000 comes from rounding 29 to 3 rather than to 30, a place-value slip that divides by a number ten times too small; 307 is the exact quotient rounded to the nearest whole number, worked out in full when the question asks for an estimate.
- (b) 3 — Method: list all valid two-digit numbers that can be made without starting with 0, then keep only the ones that are multiples of 5. Working: the two-digit numbers possible are 30, 35, 50 and 53. A number is a multiple of 5 only if it ends in 0 or 5: 30 ends in 0, 35 ends in 5, 50 ends in 0, but 53 ends in 3. So there are 3 multiples of 5. Answer: 3. 4 comes from including 53 as a multiple of 5 without checking that its last digit is not 0 or 5. 2 comes from leaving out 50, wrongly assuming 0 cannot be used as the second digit either. 6 comes from listing every two-digit arrangement of the three digits, including ones that start with 0, without applying either restriction.
- (d) 64 — Method: each time the power increases by 1, the value doubles, since one more 2 is multiplied in. Working: 2⁶ = 2⁵ × 2 = 32 × 2 = 64. Answer: 64. (37 comes from adding the power to the value, 32 + 5, instead of multiplying by the base. 192 comes from multiplying 32 by the new power, 6, instead of by the base, 2. 34 comes from adding the base to the value, 32 + 2, instead of multiplying.)
- (a) The tape can only give the length to the nearest centimetre — Method: a measurement should never be written to a finer degree of accuracy than the instrument used can read. Working: the tape is marked in centimetres, so the smallest division Leah can read is 1 cm, which is 0.01 m and two decimal places in metres; writing 7.3157 m claims the length to the nearest tenth of a millimetre, four decimal places, which the markings cannot support. A record of 7.32 m, to the nearest centimetre, is what this tape justifies. Answer: The tape can only give the length to the nearest centimetre. The distractors: the nearest millimetre contradicts the markings described in the question, which are centimetres, and would still claim more accuracy than the tape offers; the rule that a length in metres must be written to 2 decimal places borrows the habit of writing money to the penny, when the accuracy of a length depends on the instrument; rounding to the nearest metre would throw away accuracy the tape genuinely provides.
- (b) 3/10 — Since each bag's ratio has 5 parts and both bags contain the same total number of nuts, imagine each bag has 5 nuts: Bag A has 2 peanuts and Bag B has 1 peanut, so together there are 2 + 1 = 3 peanuts out of a combined 5 + 5 = 10 nuts, giving 3/10. 1/5 comes from using only Bag A's peanuts, 2 out of 10, without adding Bag B's peanuts. 1/10 comes from using only Bag B's peanut, without adding Bag A's peanuts. 3/5 comes from writing the combined peanuts over the number of parts in one bag instead of the combined total number of nuts.
- (d) 9 — List all the factors of 36 in pairs that multiply to give 36: 1 × 36, 2 × 18, 3 × 12, 4 × 9, and 6 × 6. This gives the factors 1, 2, 3, 4, 6, 9, 12, 18 and 36 — nine factors in total, with 6 counted only once even though it appears in a pair with itself. Forgetting that 36 is itself a factor of 36 and leaving it off the list gives 8. Counting the number of factor pairs, five of them, rather than the number of individual factors gives 5. Treating the repeated pair 6 × 6 as two separate factors, 6 and 6 again, gives 10 instead of 9. So 36 has 9 factors.
- (a) 2.5 × 10⁷ — Method: place the decimal point so that the coefficient is at least 1 and less than 10, then count the places it has moved. Working: the digits give a coefficient of 2.5, and the decimal point travels from the end of 25,000,000 until it sits between the 2 and the 5, a move of 7 places. Answer: 2.5 × 10⁷. The distractors: 25 × 10⁶ is the same area but not in standard form, because the coefficient must be less than 10; 2.5 × 10⁸ comes from counting the eight digits of 25,000,000 instead of the seven places the decimal point moves; 2.5 × 10⁻⁷ comes from making the index negative because the decimal point was carried to the left.
- (c) 31 — Method: work out each power separately, remembering that any non-zero base raised to the power 0 is 1 and a base raised to the power 1 is itself, then add the three values. Working: 5⁰ = 1, 5¹ = 5 and 5² = 25, so the total is 1 + 5 + 25 = 31. Answer: 31. The distractors: 30 comes from taking 5⁰ as 0 instead of 1; 35 comes from taking 5⁰ as 5, treating a zero index as leaving the base unchanged; 125 comes from adding the indices first, as though the three terms were being multiplied, and working out 5³.
- (a) 2/5 — Method: find the number of vegetable plots in each allotment, add them, then divide by the total number of plots in both allotments. Working: Allotment A: 3/5 × 20 = 12 vegetable plots. Allotment B: 1/5 × 20 = 4 vegetable plots. Total vegetable plots = 12 + 4 = 16. Total plots = 20 + 20 = 40. Fraction = 16/40 = 2/5. Answer: 2/5. 3/10 comes from using only Allotment A's 12 vegetable plots over the combined total of 40 plots, forgetting to add Allotment B's vegetable plots. 1/5 comes from using only Allotment B's ratio (1:4) as the fraction of vegetables, ignoring Allotment A altogether. 3/5 comes from working out the fraction of the combined plots that grow flowers instead of vegetables.
- (c) 9 — Method: factors come in pairs that multiply to give the number, so work through the pairs in order; a factor paired with itself is counted only once. Working: the pairs are 1 × 100, 2 × 50, 4 × 25, 5 × 20 and 10 × 10. The first four pairs give eight different factors, and the last pair adds only one more, so the factors are 1, 2, 4, 5, 10, 20, 25, 50 and 100. Answer: 9. The distractors: 10 comes from counting the pair 10 × 10 as two separate factors; 8 comes from leaving 1 out of the list, on the view that 1 is not a proper factor; 4 comes from writing 100 = 2² × 5² and multiplying the two indices together instead of adding 1 to each index first.
- (a) 7.5 × 10⁴ — Standard form is A × 10ⁿ, where A is between 1 and 10 (1 ≤ A < 10) and n is an integer — 7.5 × 10⁴ satisfies all of this. 12 × 10³ fails because 12 is not below 10. 0.5 × 10⁴ fails because 0.5 is not at least 1. 6.2 × 4⁵ fails because standard form always uses a power of 10, not a power of 4.
- (a) 6 × 10² metres — Method: distance = speed × time, so multiply the coefficients and add the indices. Working: 3 × 2 = 6 for the coefficients, and 8 + (−6) = 2 for the indices; 6 lies between 1 and 10, so the coefficient needs no adjustment. Answer: 6 × 10² metres, which is 600 metres. The distractors: 5 × 10² metres comes from adding the coefficients, 3 + 2, instead of multiplying them; 6 × 10¹⁴ metres comes from subtracting the indices, 8 − (−6), which is the rule for dividing rather than for multiplying; 6 × 10⁻⁴⁸ metres comes from multiplying the indices, 8 × (−6), instead of adding them.
- (c) 693 — Method: multiplying a bracket by a number multiplies every term inside it, so 7 × (100 − 1) = 7 × 100 − 7 × 1. Working: 7 × 100 = 700 and 7 × 1 = 7, so the calculation becomes 700 − 7 = 693. Answer: 693. The distractors: 699 comes from subtracting the 1 itself rather than 7 lots of it, giving 700 − 1 = 699; 707 comes from adding the second product instead of subtracting it, giving 700 + 7 = 707; 700 comes from rounding 99 up to 100 and then offering the estimate 7 × 100 as an exact value.
- (a) 71 — 2.9⁴ = (2.9²)². First, 2.9² = 8.41. Then square that: 8.41² = 70.7281, since 841² = 707281 and the decimal point moves four places. To 2 significant figures this rounds to 71, because the figure after the first two significant figures (7 and 0) is a 7, which rounds the 0 up to 1. Rounding the working down instead of up — taking 70.7281 to 70 — ignores that the next figure is 5 or more. Rounding 2.9 up to 3 before doing any working at all, then computing 3⁴ = 81, uses a much cruder approximation and overshoots the true value. Rounding 8.41 all the way down to 8 before squaring, 8² = 64, rounds far too aggressively and loses the accuracy needed for 2 significant figures.
Build your own mix at the worksheet builder.