Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) They cannot both be describing the same path — Jon's measurement means the true length, l, satisfies 11.5 m ≤ l < 12.5 m. Mia's measurement means the true length satisfies 12.55 m ≤ l < 12.65 m. These two ranges do not overlap, so the two measurements cannot both be describing the same path. 'They must both be describing the same path' ignores that the two ranges do not overlap at all. 'Jon's measurement must be wrong' wrongly assumes Jon is the one at fault, when the mismatch does not show which measurement, if either, is wrong. 'Mia's measurement must be wrong' makes the same unjustified assumption in the other direction.
- (c) 5/11 — Let x = 0.45 recurring, so x = 0.454545... . Since two digits repeat, multiply by 100: 100x = 45.454545... . Subtracting the original x removes the recurring part exactly, because it lines up digit for digit: 100x − x = 45.454545... − 0.454545... = 45, so 99x = 45, giving x = 45/99 = 5/11. Treating the decimal as if it terminated at two places gives 45/100 = 9/20, which is only 0.45 and drops the repeating part entirely. Subtracting 10x instead of x — using 100x − 10x = 90x = 45 — is the wrong power of ten for a two-digit repeating block, and gives x = 45/90 = 1/2. Making an arithmetic slip in the numerator, 45 − 1 = 44 instead of 45, gives 44/99 = 4/9.
- (a) x¹¹ — Method: when multiplying powers of the same base, add the indices. Working: 7 + 4 = 11, so x⁷ × x⁴ = x¹¹. x²⁸ comes from multiplying the indices, 7 × 4 = 28, instead of adding them. x³ comes from working out 7 − 4 = 3, which is the rule for dividing powers, not multiplying them. 11x comes from adding the indices to make 11 but then treating x as a coefficient instead of a power. Answer: x¹¹.
- (d) 11 mm — Method: for a square, the side length is the square root of the area. Working: 11 × 11 = 121, so the side length is 11 mm. 60.5 mm comes from working out 121 ÷ 2 = 60.5, halving the area instead of finding its square root. 242 mm comes from working out 121 × 2 = 242, doubling the area instead of finding its square root. 22 mm comes from working out 11 × 2 = 22, doubling the correct side length. Answer: 11 mm.
- (d) £4.80 — Method: find the error interval, then check which value falls outside it. Working: half of 20p is 10p, so the actual cost, c, satisfies £4.50 ≤ c < £4.70. £4.80 is above £4.70, so it could not be the actual cost. Answer: £4.80. (£4.50 is a genuine possible cost — it sits at the included lower boundary. £4.65 is a genuine possible cost, below the £4.70 upper boundary. £4.55 is a genuine possible cost, well inside the interval.)
- (b) 5/27 — Method: multiply the numerators together and the denominators together, then simplify. Working: (5 × 2)/(6 × 9) = 10/54 = 5/27. Answer: 5/27. 7/15 comes from adding the fractions instead of multiplying: (5+2)/(6+9) = 7/15. 15/4 comes from flipping the second fraction, as if dividing: (5 × 9)/(6 × 2) = 45/12 = 15/4. 5/3 comes from cancelling the two denominators against each other, dividing both 6 and 9 by 3 to leave 5/2 × 2/3 = 10/6 = 5/3; cancelling is only valid between a numerator and a denominator, never between two denominators.
- (c) 150 m — Method: a fraction acts as an operator, so finding 3/7 of a length means dividing by the denominator and multiplying by the numerator. Working: 350 ÷ 7 = 50, so one seventh of the route is 50 m, and three sevenths is 50 × 3 = 150 m. Answer: 150 m. The distractors: 50 m comes from finding one seventh and stopping there instead of multiplying by 3; 1050 m comes from multiplying by the numerator without dividing by the denominator, giving 350 × 3 = 1050; 200 m comes from working out the stretch of the route the footpath does not run alongside, which is 4/7 of 350 m, instead of the stretch it does.
- (a) 12 — Compare the powers of each prime that appears in both factorisations. In 2² × 3² and 2² × 3 × 7, the prime 2 appears with power 2 in both, and the prime 3 appears with power 2 in one and only power 1 in the other — take the lower power, 3¹. Multiplying the shared primes at their lower powers, 2² × 3, gives 12. Using power 1 for both primes instead of comparing the powers properly, 2 × 3, gives 6, which misses that 2 is common at power 2, not power 1. Multiplying the primes at their higher powers and including 7, which only appears in 84, gives 2² × 3² × 7, which comes to 252 — this is the lowest common multiple, not the highest common factor. Only spotting that 3 is a common prime and overlooking that 2 is common as well gives 3. So the highest common factor of 36 and 84 is 12.
- (d) 17 — Without the restriction there would be 5 × 4 = 20 combinations. The dragon piece can only be paired with the gold token, so of the 4 tokens, 3 are not allowed with the dragon piece, giving 20 − 3 = 17 valid combinations. 20 comes from ignoring the restriction completely. 19 comes from subtracting only 1 of the 3 invalid dragon combinations instead of all 3, 20 − 1 = 19. 16 comes from multiplying only the 4 non-dragon pieces by the 4 tokens, 4 × 4 = 16, and forgetting to add back the one valid combination of the dragon piece with the gold token.
- (a) 10 — √49 = 7 and ∛27 = 3, so √49 + ∛27 = 7 + 3 = 10. Treating the cube root as dividing by 3 instead of finding the cube root gives 27 ÷ 3 = 9, then 7 + 9 = 16. Multiplying the two roots instead of adding them gives 7 × 3 = 21. Ignoring the cube root symbol and using 27 as it stands gives 7 + 27 = 34.
- (a) 300 N/m² — Pressure is force ÷ area, and the unit N/m² says so: newtons divided by square metres. The calculation is 240 ÷ 0.8. Multiplying both numbers by 10 clears the decimal: 2400 ÷ 8 = 300 N/m². 192 N/m² multiplies the force by the area instead of dividing, 30 N/m² divides by 8 and so loses the decimal point, and 3000 N/m² multiplies only the force by 10 when clearing the decimal.
- (a) 2, 3, 4, 5 — Method: work out which whole numbers satisfy both parts of the inequality. Working: n ≥ 2 means n can be 2 or more; n < 6 means n must be less than 6, so 6 itself is not included. The whole numbers that fit both conditions are 2, 3, 4 and 5. Answer: 2, 3, 4, 5. 2, 3, 4, 5, 6 treats < 6 as ≤ 6 and wrongly includes 6. 3, 4, 5 treats ≥ 2 as > 2 and wrongly leaves out 2. 1, 2, 3, 4, 5 wrongly includes 1, which does not satisfy n ≥ 2.
- (d) 26 and 27 — Find the two consecutive perfect squares either side of 700: 26² = 676 and 27² = 729. Since 676 < 700 < 729, √700 lies between 26 and 27. Answering 7 and 8 comes from stripping the two zeros off 700 and using the 7 itself as the size of the root, instead of comparing 700 with the perfect squares around it — dividing the number under the root by 100 divides the root by 10, so the digits do not simply carry across. Answering 25 and 26 comes from checking 25² = 625, seeing that it is less than 700, and stopping there without also checking the square directly above it. Answering 35 and 36 comes from halving 700 to 350 and then treating that halved value as if it were ten times the true root, drifting into the thirties instead of the twenties.
- (b) 0.3, 32%, 7/20 — Method: convert every number to a decimal so they can be compared on the same scale. Working: 7/20 = 0.35, 0.3 stays as 0.3, and 32% = 0.32. Comparing 0.3, 0.32 and 0.35 in size gives the order 0.3, then 0.32, then 0.35. Answer: 0.3, 32%, 7/20. 7/20, 32%, 0.3 lists the numbers from largest to smallest instead of smallest to largest. 0.3, 7/20, 32% swaps 32% and 7/20, treating the fraction 7/20 as smaller even though 7/20 = 0.35 is bigger than 32% = 0.32. 32%, 0.3, 7/20 comes from moving the digits one place too far when converting the percentage, giving 0.032 instead of 0.32, which makes 32% look far smaller than it really is.
- (a) 6 — Use √a × √b = √(ab): √3 × √12 = √(3 × 12) = √36 = 6. Adding the numbers under the roots instead of multiplying them, 3 + 12 = 15, gives √15 — that comes from applying the rule for adding surds to a multiplication question. Multiplying the two numbers under the roots but then forgetting to take the square root at the end leaves 36. Simplifying only √12 to 2√3 and then dropping the other √3 factor entirely gives 2√3.
Build your own mix at the worksheet builder.