Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) 7/20 — Method: write the decimal over the power of ten that matches the number of digits after the point, then divide the numerator and the denominator by their highest common factor. Working: 0.35 has two digits after the point, so it is 35 hundredths and can be written as 35/100; the highest common factor of 35 and 100 is 5, and 35 ÷ 5 = 7 with 100 ÷ 5 = 20. Answer: 7/20. The distractors: 3/10 comes from reading only the first digit after the point and converting 0.3; 7/25 comes from dividing the numerator by 5 but the denominator by 4, using a different factor on the top and on the bottom; 35/10 comes from counting one decimal place instead of two and writing the digits over 10.
- (b) £45 — Since 2/3 of the amount is £30, one third is £30 ÷ 2 = £15, and the whole amount is three thirds: £15 × 3 = £45. Applying the fraction forwards to £30 instead of reversing it, £30 × 2/3 = £20, treats the given amount as the whole rather than as two thirds of it. Finding one third correctly as £15 but forgetting to multiply by 3 to get the whole amount leaves £15 as the final answer. Reading £30 as one third of the amount rather than as two thirds, and so multiplying straight by 3, gives £30 × 3 = £90.
- (c) 90 — Multiply the number of choices for each course: 5 × 6 × 3 = 90. 14 comes from adding the three numbers instead of multiplying them. 30 comes from multiplying only the starters and mains, 5 × 6, and forgetting the dessert. 18 comes from multiplying only the mains and desserts, 6 × 3, and forgetting the starter.
- (a) 12 — Compare the powers of each prime that appears in both factorisations. In 2² × 3² and 2² × 3 × 7, the prime 2 appears with power 2 in both, and the prime 3 appears with power 2 in one and only power 1 in the other — take the lower power, 3¹. Multiplying the shared primes at their lower powers, 2² × 3, gives 12. Using power 1 for both primes instead of comparing the powers properly, 2 × 3, gives 6, which misses that 2 is common at power 2, not power 1. Multiplying the primes at their higher powers and including 7, which only appears in 84, gives 2² × 3² × 7, which comes to 252 — this is the lowest common multiple, not the highest common factor. Only spotting that 3 is a common prime and overlooking that 2 is common as well gives 3. So the highest common factor of 36 and 84 is 12.
- (a) 8.15 ≤ y < 8.25 — Rounding to 1 decimal place means the error interval spans half of 0.1, so 0.05, either side of 8.2: 8.2 − 0.05 = 8.15 and 8.2 + 0.05 = 8.25. The lower bound uses ≤ because 8.15 itself rounds to 8.2, but the upper bound uses < because 8.25 would round up to 8.3. So the error interval is 8.15 ≤ y < 8.25. A candidate who used the wrong rounding band gave 8.1 ≤ y < 8.2. A candidate who used a strict inequality at both ends wrote 8.15 < y < 8.25, wrongly excluding 8.15 itself. A candidate who added the full 0.1 instead of half of it wrote 8.2 ≤ y < 8.3.
- (b) 3/5 — Method: add all three parts for the total, add together the parts that are not green, then write this over the total. Working: total parts = 4 + 5 + 6 = 15. Not green = 4 + 5 = 9. Fraction = 9/15 = 3/5. Answer: 3/5. 2/5 comes from finding the fraction that IS green (6/15 = 2/5) instead of not green. 4/15 comes from only counting the red baubles as 'not green' and forgetting the gold ones. 9/10 comes from adding only two of the three ratio parts to find the total (4+6=10), missing out the gold part, while still using 9 for the numerator.
- (a) 25 — Reverse the operations in reverse order: undo the subtraction by adding 6, then undo the division by multiplying by 5. −1 + 6 = 5, so the number divided by 5 equals 5, and 5 × 5 = 25 — checking, 25 ÷ 5 − 6 = 5 − 6 = −1. A candidate who subtracted 6 again instead of adding worked out −1 − 6 = −7, then −7 × 5 = −35. A candidate who multiplied by 5 before undoing the subtraction, doing the inverse operations in the wrong order, worked out −1 × 5 = −5, then −5 + 6 = 1. A candidate who multiplied by 5 but forgot to undo the subtraction at all worked out −1 × 5 = −5 and stopped there.
- (c) 4.6 — Since 100 lies between 64 and 125, ∛100 lies between 4 and 5. Narrow it down: 4.6³ = 97.336, which is less than 100, so ∛100 is greater than 4.6. To decide how it rounds to 1 decimal place, test the midpoint: 4.65³ = 100.544, which is more than 100, so ∛100 is less than 4.65 and therefore rounds down to 4.6. Simply taking the midpoint of 4 and 5 without testing any cube gives 4.5. Going up to the next tenth because 4.6³ fell short of 100, without checking that 4.65³ already overshoots, gives 4.7. Comparing 100 with the two given cubes, 64 and 125, noticing that 100 is nearer to 125, and rounding straight to the nearest whole number gives 5.0 — but that comparison is between the cubes, not between the cube roots, and cubing stretches the gaps unevenly, so it says nothing about which value the cube root rounds to.
- (b) 3 — Method: list all valid two-digit numbers that can be made without starting with 0, then keep only the ones that are multiples of 5. Working: the two-digit numbers possible are 30, 35, 50 and 53. A number is a multiple of 5 only if it ends in 0 or 5: 30 ends in 0, 35 ends in 5, 50 ends in 0, but 53 ends in 3. So there are 3 multiples of 5. Answer: 3. 4 comes from including 53 as a multiple of 5 without checking that its last digit is not 0 or 5. 2 comes from leaving out 50, wrongly assuming 0 cannot be used as the second digit either. 6 comes from listing every two-digit arrangement of the three digits, including ones that start with 0, without applying either restriction.
- (a) They cannot both be describing the same path — Jon's measurement means the true length, l, satisfies 11.5 m ≤ l < 12.5 m. Mia's measurement means the true length satisfies 12.55 m ≤ l < 12.65 m. These two ranges do not overlap, so the two measurements cannot both be describing the same path. 'They must both be describing the same path' ignores that the two ranges do not overlap at all. 'Jon's measurement must be wrong' wrongly assumes Jon is the one at fault, when the mismatch does not show which measurement, if either, is wrong. 'Mia's measurement must be wrong' makes the same unjustified assumption in the other direction.
- (d) 2 hours — Method: the time for a journey is the distance divided by the speed, so round the distance first and then divide by the speed. Working: 95 km rounds to 100 km, and 100 ÷ 50 = 2; the speed is in kilometres per hour, so the answer is a number of hours. Answer: 2 hours. The distractors: 1 hour comes from rounding the distance down to 50 km to match the speed, so that the journey looks like a single hour of driving; 30 minutes comes from dividing the speed by the distance, 50 ÷ 100, instead of the distance by the speed; 1 hour 54 minutes is the exact time, 95 ÷ 50 = 1.9 hours, worked out in full when the question asks for an estimate.
- (b) 3/10 — Since each bag's ratio has 5 parts and both bags contain the same total number of nuts, imagine each bag has 5 nuts: Bag A has 2 peanuts and Bag B has 1 peanut, so together there are 2 + 1 = 3 peanuts out of a combined 5 + 5 = 10 nuts, giving 3/10. 1/5 comes from using only Bag A's peanuts, 2 out of 10, without adding Bag B's peanuts. 1/10 comes from using only Bag B's peanut, without adding Bag A's peanuts. 3/5 comes from writing the combined peanuts over the number of parts in one bag instead of the combined total number of nuts.
- (a) 24 — Method: rearrange the relationship so that the lowest common multiple stands alone; it is the product of the two numbers divided by their highest common factor. Working: 48 = 2 × the lowest common multiple, so the lowest common multiple is 48 ÷ 2 = 24. Checking, 24 is in the 6 times table and in the 8 times table. Answer: 24. The distractors: 48 comes from giving the product of the two numbers and never dividing by the highest common factor; 96 comes from multiplying by the highest common factor instead of dividing by it; 12 comes from dividing by the highest common factor twice, once for each of the two numbers.
- (b) 30 — 70 is close to the perfect square 64, so √70 ≈ 8. 65 is close to the perfect cube 64, so ∛65 ≈ 4. Multiplying these estimates: 8 × 4 = 32, which rounds to 30 to 1 significant figure. Estimating ∛65 as 5 instead of 4, perhaps by confusing it with the nearby cube 125 = 5³ rather than the much closer 64 = 4³, and then multiplying by 8, gives 8 × 5 = 40. Adding the two estimates instead of multiplying them, 8 + 4 = 12, rounds to 10 to 1 significant figure. Rounding both estimates up to the next whole number using the wrong nearby power for each, taking √70 as 9 and ∛65 as 5, gives 9 × 5 = 45, which rounds to 50 to 1 significant figure.
- (a) 42.5 ≤ t < 47.5 — Rounding to the nearest 5 minutes means the actual time can be up to half of 5 minutes, 2.5 minutes, below or above 45 before it would round to a different multiple of 5. The lower bound is 45 − 2.5 = 42.5 and the upper bound is 45 + 2.5 = 47.5. A time of exactly 47.5 minutes would round up to 50, not 45, so 47.5 is excluded while 42.5 does still round to 45. Writing 42.5 ≤ t ≤ 47.5 wrongly includes 47.5. Writing 40 ≤ t < 50 uses a whole rounding unit, 5, either side instead of half of it. Writing 44.5 ≤ t < 45.5 treats the rounding unit as 1 minute instead of 5 minutes.
Build your own mix at the worksheet builder.