Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) 2 hours — Method: the time for a journey is the distance divided by the speed, so round the distance first and then divide by the speed. Working: 95 km rounds to 100 km, and 100 ÷ 50 = 2; the speed is in kilometres per hour, so the answer is a number of hours. Answer: 2 hours. The distractors: 1 hour comes from rounding the distance down to 50 km to match the speed, so that the journey looks like a single hour of driving; 30 minutes comes from dividing the speed by the distance, 50 ÷ 100, instead of the distance by the speed; 1 hour 54 minutes is the exact time, 95 ÷ 50 = 1.9 hours, worked out in full when the question asks for an estimate.
- (a) 23 — Division undoes multiplication, so the missing number is 391 ÷ 17 = 23. Writing down 17 repeats the number already given instead of solving for the missing one. Subtracting instead of dividing gives 391 − 17 = 374. Multiplying instead of dividing gives 391 × 17 = 6647.
- (c) 6 — The units digit must be even, so it can be 2 or 8, giving 2 choices. The tens digit can then be any of the remaining 3 digits, since one digit has been used for the units. Multiply: 2 × 3 = 6. 12 comes from working out how many two-digit numbers can be made in total, 4 × 3 = 12, ignoring the requirement that the number is even. 8 comes from choosing the units digit from 2 options and then wrongly allowing any of the 4 digits again for the tens digit, 2 × 4 = 8, which lets a digit repeat. 2 comes from counting only the choices for the units digit and forgetting the tens digit.
- (b) 9/25 — Method: write the decimal over the matching power of ten, then divide the numerator and the denominator by their highest common factor. Working: 0.36 has two digits after the point, so 0.36 = 36/100; the highest common factor of 36 and 100 is 4, and 36 ÷ 4 = 9 with 100 ÷ 4 = 25; since 9 and 25 share no factor greater than 1, the fraction is fully cancelled. Answer: 9/25. The distractors: 3/10 comes from reading only the first digit after the point and converting 0.3; 9/50 comes from dividing the numerator by 4 but the denominator by only 2; 36/10 comes from counting one decimal place instead of two and writing the digits over 10.
- (d) £4.80 — Method: find the error interval, then check which value falls outside it. Working: half of 20p is 10p, so the actual cost, c, satisfies £4.50 ≤ c < £4.70. £4.80 is above £4.70, so it could not be the actual cost. Answer: £4.80. (£4.50 is a genuine possible cost — it sits at the included lower boundary. £4.65 is a genuine possible cost, below the £4.70 upper boundary. £4.55 is a genuine possible cost, well inside the interval.)
- (a) 8.35 ≤ L < 8.45 — Method: a length rounded to 1 decimal place lies within half of 0.1 cm, that is 0.05 cm, of the value written down. The lower limit is included because it rounds up to that value, and the upper limit is excluded because it rounds up to the next value instead. Working: 8.4 − 0.05 = 8.35 and 8.4 + 0.05 = 8.45, so a length of 8.35 cm still rounds to 8.4 cm while a length of 8.45 cm rounds to 8.5 cm. Answer: 8.35 ≤ L < 8.45. The distractors: 8.3 ≤ L < 8.5 goes a whole 0.1 cm either side instead of half of it; 8.35 < L ≤ 8.45 has the two limits the wrong way round, excluding the length that does round to 8.4 cm and including the one that does not; 8.4 ≤ L < 8.5 is the interval for a length truncated to 1 decimal place, not one rounded to it.
- (d) 0.3 — Converting the fractions to decimals, 1/4 = 0.25 and 2/5 = 0.4, so any decimal between 0.25 and 0.4 is a valid answer, and 0.3 fits. Confusing 1/4 with 1/5 and converting it as 0.2 instead of 0.25 gives a value below the true lower bound. Confusing 2/5 with 1/2 and converting it as 0.5 instead of 0.4 gives a value above the true upper bound. Converting the fractions correctly but choosing a decimal above the true upper bound of 0.4 instead of between the two values gives 0.45.
- (c) 25 cm — Method: for a cube, the edge length is the cube root of the volume. Working: 25 × 25 × 25 = 15,625, so the edge length is 25 cm. 5 cm comes from cube-rooting 125 instead of 15,625, misreading the number of digits. 50 cm comes from working out 25 × 2 = 50, doubling the correct edge length. 125 cm comes from taking the square root of the volume instead of the cube root, since 125 × 125 = 15,625 — that would be the side of a SQUARE of area 15,625, not the edge of a cube of that volume. Answer: 25 cm.
- (b) 364 — Divide in stages using multiples of 12. 12 × 300 = 3600, leaving a remainder of 4368 − 3600 = 768. Then 12 × 64 = 768, so 4368 ÷ 12 = 300 + 64 = 364. Placing the decimal point as though dividing 436.8 by 12 gives 36.4. Transposing the last two digits of 364 gives 346. Working out 768 ÷ 12 as 4 instead of 64, losing the tens digit, and adding 300 + 4 gives 304. So 4368 ÷ 12 = 364.
- (a) 2, 3, 4, 5 — Method: work out which whole numbers satisfy both parts of the inequality. Working: n ≥ 2 means n can be 2 or more; n < 6 means n must be less than 6, so 6 itself is not included. The whole numbers that fit both conditions are 2, 3, 4 and 5. Answer: 2, 3, 4, 5. 2, 3, 4, 5, 6 treats < 6 as ≤ 6 and wrongly includes 6. 3, 4, 5 treats ≥ 2 as > 2 and wrongly leaves out 2. 1, 2, 3, 4, 5 wrongly includes 1, which does not satisfy n ≥ 2.
- (c) 20p — Turn each price into the same rate before comparing. The small bag is 400 g = 0.4 kg, so it costs £1.12 ÷ 0.4 = £2.80 per kg. The large bag costs £3.90 ÷ 1.5 = £2.60 per kg. The saving is £2.80 − £2.60 = £0.20, which is 20p per kg. 2p compares the prices per 100 g rather than per kilogram, £2.78 subtracts one bag price from the other without turning either into a rate, and £2.60 is the large bag's price per kilogram rather than the saving.
- (a) 0.0069 — Leading zeros are not significant, so the significant figures in 0.006852 start at 6: 6, 8, 5, 2. Rounding to 2 significant figures means keeping 6 and 8, and looking at the next digit, 5, to decide whether to round up. Since 5 rounds up, the second significant figure increases from 8 to 9: 0.006852 rounds to 0.0069. A candidate who rounded to 1 significant figure instead of 2 wrote 0.007. A candidate who rounded to 3 significant figures instead of 2 wrote 0.00685. A candidate who did not round up despite the next digit being 5 wrote 0.0068.
- (b) 8π cm² — A diameter of 8 cm gives a radius of 4 cm. The area of a full circle would be π × r² = π × 4² = 16π cm², and a semicircle is exactly half of this, giving 16π ÷ 2 = 8π cm². Forgetting to halve the area for the semicircle gives 16π cm², the area of the whole circle. Halving the diameter twice, using a radius of 2 instead of 4, gives π × 2² = 4π cm². Using the diameter itself as the radius, so π × 8² = 64π, and then halving that for the semicircle gives 32π cm².
- (b) 11 — Method: roots and the multiplication are worked out before the addition and subtraction, and what is left is then worked through from left to right. Working: √144 = 12, √25 = 5 and 2 × 3 = 6, so the calculation becomes 12 − 6 + 5, which gives 6 + 5 = 11. Answer: 11. The distractors: 1 comes from carrying out the addition before the subtraction, giving 12 − (6 + 5) = 12 − 11 = 1; 35 comes from working from left to right with no priority, giving 12 − 2 = 10, then 10 × 3 = 30 and 30 + 5 = 35; 7 comes from combining the two roots as √(144 + 25) = √169 = 13 and then subtracting the product, giving 13 − 6 = 7.
- (a) to the nearest centimetre — Method: the error interval of a rounded measurement runs from half a unit below the stated value to half a unit above it, so the width of the interval is one whole unit of the accuracy used. Working: the interval runs from 24.5 to 25.5, a width of 25.5 − 24.5 = 1, so the unit of accuracy is 1 cm; the stated value is the midpoint, 25 cm, and 25 correct to the nearest centimetre is exactly what gives 24.5 ≤ L < 25.5. Answer: to the nearest centimetre. To the nearest 0.5 cm comes from reading the half-unit, 0.5, as the accuracy itself instead of doubling it back to the full unit. To 1 decimal place comes from seeing the bounds written with one decimal place and taking that as the accuracy, but the bounds of a value given to 1 decimal place would be only 0.05 either side. To the nearest 10 cm comes from confusing the size of the value, about 25, with the unit it was rounded to; rounding to the nearest 10 cm would give an interval 5 cm either side of the stated value.
Build your own mix at the worksheet builder.