Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) £4.80 — Method: find the error interval, then check which value falls outside it. Working: half of 20p is 10p, so the actual cost, c, satisfies £4.50 ≤ c < £4.70. £4.80 is above £4.70, so it could not be the actual cost. Answer: £4.80. (£4.50 is a genuine possible cost — it sits at the included lower boundary. £4.65 is a genuine possible cost, below the £4.70 upper boundary. £4.55 is a genuine possible cost, well inside the interval.)
- (c) Exactly 1: the subtraction has no rounding at any step. — 10x − x removes the recurring part completely, because the digits after the decimal point in 10x and in x are identical from the tenths place onward, so they cancel exactly: 9.999... − 0.999... = 9.000... = 9. Nothing was rounded to reach 9x = 9, so x = 1 is an exact equality, not an approximation, and the statement that the value is exactly 1, with no rounding at any step, is the correct one. Calling it only approximately 1, on the ground that a recurring decimal can never reach a whole number, misunderstands what the subtraction has just shown: the recurring tail cancels completely, leaving no gap to approximate away. Claiming the method only works because the recurring digit is 9 is also wrong — the same subtraction cancels the recurring part for any repeating digit, not just 9; it is the choice of multiplier (10, matching the one-digit repeat) that makes the cancellation exact, not the digit itself. Saying 10x minus x gives 8.999... rather than 9 misreads the subtraction: 9.999... − 0.999... has no digit to borrow from, since every decimal digit in the two numbers matches, so the result is exactly 9, not 8.999... .
- (a) to the nearest centimetre — Method: the error interval of a rounded measurement runs from half a unit below the stated value to half a unit above it, so the width of the interval is one whole unit of the accuracy used. Working: the interval runs from 24.5 to 25.5, a width of 25.5 − 24.5 = 1, so the unit of accuracy is 1 cm; the stated value is the midpoint, 25 cm, and 25 correct to the nearest centimetre is exactly what gives 24.5 ≤ L < 25.5. Answer: to the nearest centimetre. To the nearest 0.5 cm comes from reading the half-unit, 0.5, as the accuracy itself instead of doubling it back to the full unit. To 1 decimal place comes from seeing the bounds written with one decimal place and taking that as the accuracy, but the bounds of a value given to 1 decimal place would be only 0.05 either side. To the nearest 10 cm comes from confusing the size of the value, about 25, with the unit it was rounded to; rounding to the nearest 10 cm would give an interval 5 cm either side of the stated value.
- (c) 27 — Each of the 3 digits can be chosen independently for each of the 3 positions, so multiply: 3 × 3 × 3 = 27. 9 comes from multiplying only two of the three positions, 3 × 3, and forgetting the third. 6 comes from working out 3 × 2 × 1 = 6, which counts codes where digits do not repeat, but the question allows repeated digits. 3 comes from considering only one digit position.
- (a) 8.35 ≤ L < 8.45 — Method: a length rounded to 1 decimal place lies within half of 0.1 cm, that is 0.05 cm, of the value written down. The lower limit is included because it rounds up to that value, and the upper limit is excluded because it rounds up to the next value instead. Working: 8.4 − 0.05 = 8.35 and 8.4 + 0.05 = 8.45, so a length of 8.35 cm still rounds to 8.4 cm while a length of 8.45 cm rounds to 8.5 cm. Answer: 8.35 ≤ L < 8.45. The distractors: 8.3 ≤ L < 8.5 goes a whole 0.1 cm either side instead of half of it; 8.35 < L ≤ 8.45 has the two limits the wrong way round, excluding the length that does round to 8.4 cm and including the one that does not; 8.4 ≤ L < 8.5 is the interval for a length truncated to 1 decimal place, not one rounded to it.
- (a) £4.80 — The total cost of the melons is 8 × £1.35 = £10.80. Profit is the selling total minus the cost, so £15.60 − £10.80 = £4.80. Subtracting the price of just one melon from the selling total instead of the total cost of all eight, £15.60 − £1.35, gives £14.25. Miscalculating the cost of the melons as 8 × £1.30 = £10.40, dropping the 5p from each price, gives a profit of £15.60 − £10.40 = £5.20. Adding the selling total and the cost together instead of subtracting them, £15.60 + £10.80, gives £26.40.
- (d) 9 — List all the factors of 36 in pairs that multiply to give 36: 1 × 36, 2 × 18, 3 × 12, 4 × 9, and 6 × 6. This gives the factors 1, 2, 3, 4, 6, 9, 12, 18 and 36 — nine factors in total, with 6 counted only once even though it appears in a pair with itself. Forgetting that 36 is itself a factor of 36 and leaving it off the list gives 8. Counting the number of factor pairs, five of them, rather than the number of individual factors gives 5. Treating the repeated pair 6 × 6 as two separate factors, 6 and 6 again, gives 10 instead of 9. So 36 has 9 factors.
- (d) 1 × 10⁻³ — Method: for a number smaller than 1 the index is negative, and it counts the places the decimal point moves to the right to leave a coefficient between 1 and 10. Working: the only significant digit is 1, so the coefficient is 1; the decimal point in 0.001 moves three places to the right to reach that 1, so the index is −3. Answer: 1 × 10⁻³. The distractors: 1 × 10³ comes from taking the index as positive, which describes one thousand grams rather than one thousandth of a gram; 0.1 × 10⁻² is the same mass written with a coefficient of 0.1, which is smaller than 1 and so is not standard form; 1 × 10⁻⁴ comes from counting the zero in front of the decimal point as well as the places after it.
- (b) 90 km/h — To convert metres per second to kilometres per hour, multiply by 3.6 (there are 3600 seconds in an hour and 1000 metres in a kilometre, and 3600 ÷ 1000 = 3.6): 25 × 3.6 = 90 km/h. Dividing by 3.6 instead of multiplying gives 25 ÷ 3.6 = 6.9 km/h (to 1 d.p.). Multiplying by 60 instead of 3.6, confusing the conversion from seconds to minutes with the conversion to hours, gives 25 × 60 = 1500 km/h. Multiplying by 3600 to convert seconds to hours but forgetting to convert metres to kilometres gives 25 × 3600 = 90000, which is a speed in metres per hour, not kilometres per hour.
- (b) 3 — Method: solving an index equation like this means finding how many factors of the base multiply together to give the number on the right. Working: 4¹ = 4, 4² = 16 and 4³ = 64, so three factors of 4 are needed. Answer: 3. The distractors: 4 comes from listing 4, 16 and 64 and counting the base itself as a step, which gives one more than the index; 6 comes from solving the equation with 2 as the base instead of 4, since 2⁶ = 64; 16 comes from dividing 64 by 4, treating the index as an instruction to divide.
- (d) x⁴ — Method: dividing two powers of the same letter subtracts the index of the divisor from the index of the term being divided. Working: six factors of x on the top and two on the bottom cancel in pairs, leaving 6 − 2 = 4 factors of x. Answer: x⁴. The distractors: x³ comes from dividing the indices, 6 ÷ 2, instead of subtracting them; x⁸ comes from adding the indices, 6 + 2, as though the powers were being multiplied; x¹² comes from multiplying the indices, 6 × 2, as though a power were being raised to a power.
- (a) 2/3 — Total parts = 6 + 4 + 5 = 15. Sopranos and altos together are not tenors: 6 + 4 = 10 parts, so the fraction is 10/15, which simplifies to 2/3. 1/3 comes from finding the fraction of tenors instead of the fraction that is not tenors. 2/5 comes from counting only the sopranos as not tenors and leaving the altos out. 4/9 comes from leaving sopranos out of the total, 4 + 5 = 9, and then using only the altos as the fraction that is not tenors.
- (a) 24 — Method: rearrange the relationship so that the lowest common multiple stands alone; it is the product of the two numbers divided by their highest common factor. Working: 48 = 2 × the lowest common multiple, so the lowest common multiple is 48 ÷ 2 = 24. Checking, 24 is in the 6 times table and in the 8 times table. Answer: 24. The distractors: 48 comes from giving the product of the two numbers and never dividing by the highest common factor; 96 comes from multiplying by the highest common factor instead of dividing by it; 12 comes from dividing by the highest common factor twice, once for each of the two numbers.
- (b) Yes, because 14.8 cm rounds to 15 cm to the nearest cm — Method: a recorded measurement is not an exact length; it stands for every length that rounds to it, so the two records agree if one rod can produce both. Working: Ben's record of 14.8 cm to the nearest 0.1 cm means the rod is between 14.75 cm and 14.85 cm, and 14.8 is nearer to 15 than to 14, so a rod of that length is recorded as 15 cm to the nearest centimetre. Both records can therefore come from the same rod. Answer: Yes, because 14.8 cm rounds to 15 cm to the nearest cm. The distractors: the claim that 14.8 cm rounds to 15.0 cm to 1 decimal place is false, since 14.8 cm is already written to 1 decimal place and stays 14.8 cm; the claim that it rounds to 14 cm is false, because 14.8 is 0.2 away from 15 and 0.8 away from 14; the claim that the two lengths are not the same treats each record as an exact length, when each is only a rounded record of one rod.
- (d) 12 — Method: if the bracelets are identical and no beads are left over, the number of bracelets must divide exactly into both totals, so it is the highest common factor of 24 and 36. Working: 24 = 2³ × 3 and 36 = 2² × 3²; taking the lower index of each shared prime gives 2² × 3 = 4 × 3 = 12. Each bracelet then has 2 red beads and 3 blue beads. Answer: 12. The distractors: 6 comes from taking each shared prime once rather than at its lower index, giving 2 × 3, which is a common factor but not the highest; 72 is the lowest common multiple of 24 and 36, from taking the higher index of each prime instead of the lower; 60 comes from adding the two bead totals instead of looking for a common factor.
Build your own mix at the worksheet builder.