Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) 2700 cm² — Convert both lengths to the same unit before multiplying: 0.6 m = 60 cm. The area is 45 × 60 = 2700 cm². Multiplying without converting 0.6 m to centimetres at all, treating it as 0.6 cm, gives 45 × 0.6 = 27 cm². Converting 0.6 m to centimetres by multiplying by 10 instead of 100 gives 6 cm, and 45 × 6 = 270 cm². Converting 0.6 m to centimetres by multiplying by 1000 instead of 100 gives 600 cm, and 45 × 600 = 27000 cm².
- (a) 28.8 km/h — A compound unit is converted one part at a time. There are 3600 seconds in an hour, so in one hour the cyclist travels 8 × 3600 = 28 800 metres. There are 1000 metres in a kilometre, so 28 800 m = 28 800 ÷ 1000 = 28.8 km/h. 28 800 km/h leaves the distance in metres, 0.48 km/h converts the seconds to minutes rather than to hours, and 2.22 km/h divides by 3.6 instead of multiplying.
- (b) 750,000,000 — Method: multiplying by 10⁸ moves the decimal point eight places to the right, and every empty place is filled with a zero. Working: 10⁸ = 100,000,000, and moving the decimal point in 7.5 eight places to the right gives 7.5 × 100,000,000. Answer: 750,000,000. The distractors: 7,500,000,000 comes from removing the decimal point first to make 75 and then writing eight zeros after it, which carries the digits one place too far; 600 comes from reading 10⁸ as 10 × 8 = 80 and working out 7.5 × 80; 0.000000075 comes from moving the decimal point eight places to the left, as though the index were negative.
- (c) 3 — Method: the index counts how many times the coefficient has been multiplied by 10, which is the number of places the decimal point moves from the end of the number to just after the first significant digit. Working: 2,000 = 2 × 1,000, and 1,000 = 10 × 10 × 10, which is three tens. Answer: 3. The distractors: 4 comes from counting the four digits of 2,000 rather than the three places the decimal point moves; 2 comes from copying the coefficient 2 into the index; −3 comes from making the index negative, which would describe a number smaller than 1 rather than two thousand.
- (a) 7/8 — Method: write the decimal over the power of ten that matches the number of digits after the point, then divide the numerator and the denominator by their highest common factor. Working: 0.875 has three digits after the point, so it is 875 thousandths and can be written as 875/1000; the highest common factor of 875 and 1000 is 125, and 875 ÷ 125 = 7 with 1000 ÷ 125 = 8. Answer: 7/8. The distractors: 8/7 comes from cancelling correctly but writing the two parts the wrong way round; 9/10 comes from rounding 0.875 to one decimal place as 0.9 before converting; 7/80 comes from counting four decimal places instead of three and using a denominator of 10000, giving 875/10000.
- (d) 24 — Method: the three parts of the deal are chosen independently, so every sandwich can be taken with every snack and every one of those pairs with every drink; the product rule multiplies the number of choices in each part. Working: there are 4 choices of sandwich and each can be taken with any of the 3 snacks, giving 4 × 3 = 12 sandwich-and-snack pairs; each of those pairs can be completed with either of the 2 drinks, so the number of meal deals is 12 × 2 = 24. Answer: 24. The distractors: 9 comes from adding the choices, 4 + 3 + 2, instead of multiplying them, and a candidate who adds writes that total down as the count; 12 comes from multiplying the sandwiches by the snacks and never bringing the drink into the count at all; 27 comes from adding the items on the menu to get 9 and then multiplying that by the 3 parts of the deal, which counts the menu rather than the combinations.
- (b) 0.83333... — Divide 5 by 6 using long division. 5.000... ÷ 6: 50 ÷ 6 = 8 remainder 2, giving the first decimal digit 8. Bring down a 0 to make 20, and 20 ÷ 6 = 3 remainder 2 — the remainder 2 has reappeared, so from here the digit 3 repeats forever. This gives 5/6 = 0.83333... . Stopping after two decimal places and writing 0.83 treats the division as if it terminated, when the remainder never reaches zero. Shifting the decimal point one place too far to the left gives 0.083333..., the same digits divided by an extra power of ten. A slip in the long division itself, misreading a remainder, can produce the wrong repeating digit, 0.85555... .
- (b) 4 — Method: the cube root of a number is the value that multiplies by itself three times to give that number. Working: 4 × 4 × 4 = 64, so ∛64 = 4. Answer: 4. (8 comes from finding the square root of 64 instead of the cube root. 192 comes from multiplying 64 by 3 instead of finding the number that cubes to 64. 21.3 comes from dividing 64 by 3 instead of finding its cube root.)
- (b) 364 — Divide in stages using multiples of 12. 12 × 300 = 3600, leaving a remainder of 4368 − 3600 = 768. Then 12 × 64 = 768, so 4368 ÷ 12 = 300 + 64 = 364. Placing the decimal point as though dividing 436.8 by 12 gives 36.4. Transposing the last two digits of 364 gives 346. Working out 768 ÷ 12 as 4 instead of 64, losing the tens digit, and adding 300 + 4 gives 304. So 4368 ÷ 12 = 364.
- (a) 91 is not prime, because 91 = 7 × 13. — Check 91 for prime factors up to its square root, which is just under 10: 91 ÷ 7 = 13, and both 7 and 13 are prime, so 91 = 7 × 13 and 91 is not a prime number. Checking only 2, 3 and 5 misses that 7 also needs to be tried — 91 is odd, its digits do not sum to a multiple of 3 (9 + 1 = 10), and it does not end in 0 or 5, so those three checks alone wrongly suggest it is prime. Assuming any odd number ending in 1 must be prime ignores that 91 = 7 × 13 is a counterexample. Misapplying the digit-sum test for 3 by miscounting 9 + 1 as a multiple of 3 wrongly concludes 91 is divisible by 3, when the correct digit sum, 10, is not a multiple of 3. So 91 is not prime, because 91 = 7 × 13.
- (b) 3 — Method: list all valid two-digit numbers that can be made without starting with 0, then keep only the ones that are multiples of 5. Working: the two-digit numbers possible are 30, 35, 50 and 53. A number is a multiple of 5 only if it ends in 0 or 5: 30 ends in 0, 35 ends in 5, 50 ends in 0, but 53 ends in 3. So there are 3 multiples of 5. Answer: 3. 4 comes from including 53 as a multiple of 5 without checking that its last digit is not 0 or 5. 2 comes from leaving out 50, wrongly assuming 0 cannot be used as the second digit either. 6 comes from listing every two-digit arrangement of the three digits, including ones that start with 0, without applying either restriction.
- (a) 1,850 — Method: find the error interval, then check which value falls outside it. Working: half of 100 is 50, so the actual number of visitors, v, satisfies 1,750 ≤ v < 1,850. 1,850 sits exactly on the excluded upper boundary, since a value of 1,850 would round to 1,900, not 1,800. Answer: 1,850. (1,750 is a genuine possible value — it sits at the included lower boundary. 1,799 is a genuine possible value, just below the upper boundary. 1,760 is a genuine possible value, well inside the interval.)
- (b) 93.9975 — Each measurement was rounded to 1 decimal place, so the error is half of 0.1: length is 12.35 ≤ L < 12.45, and width is 7.45 ≤ W < 7.55. The upper bound for the area comes from multiplying the upper bounds of both dimensions: 12.45 × 7.55 = 93.9975 m². Using the lower bound of both dimensions instead, 12.35 × 7.45 = 92.0075 m², gives the lower bound of the area rather than the upper one. Multiplying the two given rounded values directly, 12.4 × 7.5 = 93, forgets that a rounded measurement is not exact and needs its own error interval. Bounding only the length and leaving the width at its given value, 12.45 × 7.5 = 93.375, misses that the width also has an upper bound of its own.
- (b) 3/50 — Method: write the decimal over the power of ten that matches the number of digits after the point, counting every digit including a zero, then divide the numerator and the denominator by their highest common factor. Working: 0.06 has two digits after the point, so it is 6 hundredths and can be written as 6/100; the highest common factor of 6 and 100 is 2, and 6 ÷ 2 = 3 with 100 ÷ 2 = 50. Answer: 3/50. The distractors: 3/5 comes from ignoring the zero straight after the point and converting 0.6 instead, giving 6/10, which cancels to 3/5; 3/500 comes from counting three decimal places instead of two and writing 6/1000, which cancels to 3/500; 1/6 comes from putting 1 over the digits after the point, as though 0.06 meant one sixth.
- (b) −0.7 < −0.25 — Method: compare the two negative decimals by their distance from zero on a number line. Working: −0.7 is 0.7 away from zero and −0.25 is 0.25 away from zero, so −0.7 is further from zero in the negative direction, making it the smaller number. Answer: −0.7 < −0.25 is true. "−0.7 > −0.25" comes from comparing 0.7 and 0.25 as if both numbers were positive, ignoring the negative signs. "−0.7 = −0.25" comes from assuming the two numbers are equal because they are both negative decimals. "−0.7 ≥ −0.25" combines the false statement "−0.7 > −0.25" with the false statement "−0.7 = −0.25".
Build your own mix at the worksheet builder.