Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 30 cm — The tile's side length must be a common factor of 90 and 120. The factors of 90 include 1, 2, 3, 5, 6, 9, 10, 15, 18, 30, 45, 90; the factors of 120 include 1, 2, 3, 4, 5, 6, 8, 10, 12, 15, 20, 24, 30, 40, 60, 120. The highest number common to both lists is 30, so the largest square tile has a side length of 30 cm. Picking 15 cm, a common factor but not the largest, gives tiles that are smaller than necessary. Picking 10 cm, also a common factor but smaller still, wastes even more of the possible tile size. Working out the lowest common multiple instead of the highest common factor gives 360 cm, a length far bigger than either side of the patio. So the largest square tile Ben can use has a side length of 30 cm.
- (c) 2700 cm² — Convert both lengths to the same unit before multiplying: 0.6 m = 60 cm. The area is 45 × 60 = 2700 cm². Multiplying without converting 0.6 m to centimetres at all, treating it as 0.6 cm, gives 45 × 0.6 = 27 cm². Converting 0.6 m to centimetres by multiplying by 10 instead of 100 gives 6 cm, and 45 × 6 = 270 cm². Converting 0.6 m to centimetres by multiplying by 1000 instead of 100 gives 600 cm, and 45 × 600 = 27000 cm².
- (d) 72a⁷ — Method: a power outside brackets applies to every factor inside them, and multiplying two powers of the same letter adds their indices. Working: (3a²)² = 3² × a⁴ = 9a⁴, and (2a)³ = 2³ × a³ = 8a³. Multiplying the two results gives 9 × 8 = 72 for the number and 4 + 3 = 7 for the index of a. Answer: 72a⁷. The distractors: 36a⁷ comes from squaring the 2 in (2a)³ instead of cubing it, giving 4a³ and then 9 × 4; 72a¹² comes from multiplying the indices 4 and 3 when the two terms are multiplied, instead of adding them; 17a⁷ comes from adding the coefficients 9 and 8 rather than multiplying them.
- (b) 3²⁰ is larger — Method: two powers with different bases and different indices can be compared once they are rewritten with a common index, which is possible whenever the indices share a factor. Working: 30 and 20 have a highest common factor of 10, so 2³⁰ = (2³)¹⁰ = 8¹⁰ and 3²⁰ = (3²)¹⁰ = 9¹⁰. Both are now tenth powers, and since 9 is larger than 8, 9¹⁰ is larger than 8¹⁰. Answer: 3²⁰ is larger. The distractors: 2³⁰ is larger comes from comparing only the indices and choosing the power with the bigger index; They are equal comes from multiplying base by index, 2 × 30 and 3 × 20, and finding 60 each time; They cannot be compared without a calculator comes from assuming that powers this large can only be ranked by evaluating them in full.
- (a) 1/3 — Method: find the total fraction eaten, then subtract it from the whole pizza. Working: together they eat 5/12 + 3/12 = 8/12, so the fraction left is 12/12 − 8/12 = 4/12 = 1/3. Answer: 1/3. 2/3 comes from giving the fraction eaten instead of the fraction left. 7/12 comes from only subtracting Ben's slices and forgetting Mia's. 1/2 comes from comparing the 4 slices left with the 8 slices eaten, 4/8, a part-to-part comparison instead of comparing with the whole pizza of 12 slices.
- (c) 0.001 — Method: a negative index means 'one over' the positive power, so $10^{-3}$ means one over $10^{3}$. Working: ten cubed is 1000, and one over 1000 is 0.001. 1000 comes from ignoring the negative sign and working out ten cubed instead of its reciprocal. −1000 comes from ignoring what the negative index does to the size, while still writing a negative sign on the large value. −0.001 comes from correctly finding the size, 0.001, but wrongly keeping a negative sign because the index was negative. Answer: 0.001.
- (c) £8.20 — Method: find the total cost, then subtract from the amount paid. Working: 35 × £1.48 = £51.80. Amount paid = 3 × £20 = £60.00. Change = £60.00 − £51.80 = £8.20. Answer: £8.20. (£58.52 comes from forgetting to multiply the price by the 35 litres and subtracting only £1.48 from £60. £7.50 comes from rounding £1.48 up to £1.50 before multiplying, giving a total of £52.50 instead of £51.80. £9.20 comes from miscarrying in the pence column when subtracting £51.80 from £60.00.)
- (c) 1/4 — A negative index means the reciprocal of the positive power, so 2⁻² = 1 ÷ 2² = 1/4. Treating the negative sign as making the answer negative instead gives −(2²) = −4. Ignoring the negative sign altogether gives just 2² = 4. Finding the reciprocal correctly but then also applying a negative sign gives −1/4.
- (d) 2/25 — Method: write the decimal over 100 using its two decimal places, then simplify. Working: 0.08 = 8/100 = 2/25 (dividing both numerator and denominator by 4). Answer: 2/25. The student's fraction, 8/10, comes from ignoring the zero in the tenths column and reading 0.08 as though it were 0.8; it simplifies to 4/5. 1/125 comes from writing the decimal over 1000 instead of 100, as if there were three decimal places. 25/2 comes from flipping the correct fraction upside down.
- (a) 8,350 — Rounding to the nearest 100 means the true number can be up to half of 100, which is 50, below the recorded figure before it would round down to a lower hundred. The smallest possible number is therefore 8,400 − 50 = 8,350. Adding 50 instead of subtracting it gives 8,450, which is the upper end of the interval rather than the smallest value, and 8,450 is not itself possible because it would round up to 8,500. Subtracting a whole 100 instead of half of it gives 8,300, going too far below the recorded value. Subtracting 10 instead of half of the rounding unit gives 8,390, treating the rounding unit as 100 but the tolerance as only 10.
- (d) −1.4, −6/5, 0, 5/4, 1.3 — Method: convert the fractions 5/4 and −6/5 to decimals so every number is written the same way, then compare all five decimals. Working: 5/4 = 1.25 and −6/5 = −1.2. Comparing −1.4, −1.2, 0, 1.25 and 1.3 in size gives the order −1.4, −1.2, 0, 1.25, 1.3. Answer: −1.4, −6/5, 0, 5/4, 1.3. −6/5, −1.4, 0, 5/4, 1.3 swaps the two negative numbers, treating −6/5 as more negative than −1.4 even though −1.2 is closer to zero than −1.4. 1.3, 5/4, 0, −6/5, −1.4 lists the numbers from largest to smallest instead of smallest to largest. −1.4, −6/5, 0, 1.3, 5/4 swaps 5/4 and 1.3, comparing the numerator 5 directly with 1.3 instead of converting 5/4 to the decimal 1.25 first.
- (a) 10 — √49 = 7 and ∛27 = 3, so √49 + ∛27 = 7 + 3 = 10. Treating the cube root as dividing by 3 instead of finding the cube root gives 27 ÷ 3 = 9, then 7 + 9 = 16. Multiplying the two roots instead of adding them gives 7 × 3 = 21. Ignoring the cube root symbol and using 27 as it stands gives 7 + 27 = 34.
- (a) 12 — Method: build the number one place at a time, listing systematically: fix the tens digit, then run through every units digit that is still available. Working: any of the 4 digits can go in the tens place, and once it has been used only 3 digits are left for the units place, so there are 4 × 3 = 12 numbers; listing the numbers that begin with 1 gives 12, 13 and 14, and each of the other three starting digits gives 3 numbers in the same way. Answer: 12. The distractors: 16 comes from working out 4 × 4, which allows a digit to be used twice; 8 comes from multiplying the 4 digits by the 2 places in the number instead of multiplying the choices available at each place; 6 comes from treating a number and its reverse as the same, counting only the unordered pairs of digits.
- (c) (12 + 3π) cm — The perimeter of a quarter-circle is made up of two straight radii plus a quarter of the circumference. The two radii give 2 × 6 = 12 cm, and a quarter of the circumference is (1/4) × 2 × π × 6 = 3π cm, so the total perimeter is (12 + 3π) cm. Giving only the curved part, 3π cm, forgets the two straight edges entirely. Using the full circumference, 2 × π × 6 = 12π, instead of a quarter of it gives (12 + 12π) cm. Including only one radius instead of two gives (6 + 3π) cm.
- (b) 20 — Each length has its own error interval: 11.5 ≤ a < 12.5 and 6.5 ≤ b < 7.5. The upper bound of a sum is found by adding the upper bounds of both quantities: 12.5 + 7.5 = 20. Bounding only one of the two lengths and adding the other quantity's given value unbounded, 12.5 + 7 = 19.5, misses that both measurements carry their own uncertainty. Adding the lower bounds instead of the upper bounds, 11.5 + 6.5 = 18, gives the lower bound of the sum, not the upper one. Using a whole centimetre of error either side instead of half a centimetre, (12 + 1) + (7 + 1) = 21, comes from forgetting the error is half the rounding unit.
Build your own mix at the worksheet builder.