Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) 9/25 — Method: write the decimal over the matching power of ten, then divide the numerator and the denominator by their highest common factor. Working: 0.36 has two digits after the point, so 0.36 = 36/100; the highest common factor of 36 and 100 is 4, and 36 ÷ 4 = 9 with 100 ÷ 4 = 25; since 9 and 25 share no factor greater than 1, the fraction is fully cancelled. Answer: 9/25. The distractors: 3/10 comes from reading only the first digit after the point and converting 0.3; 9/50 comes from dividing the numerator by 4 but the denominator by only 2; 36/10 comes from counting one decimal place instead of two and writing the digits over 10.
- (b) No, the true mass could be as high as 852.5 kg — Method: find the upper bound of the true mass and compare it with the weight limit. Working: the display is correct to the nearest 5 kg, so half of 5 kg is 2.5 kg, and the true mass, m kg, satisfies 847.5 ≤ m < 852.5. Part of that interval lies above 850 kg, so the parcels are not definitely within the limit. Answer: the true mass could be as high as 852.5 kg, which is above the limit. ("Yes, the display reads 850 kg, which is not above the limit" compares the limit with the displayed value instead of with the largest value the true mass could take. "Yes, the true mass is at least 847.5 kg and at most 850 kg" uses the correct half unit below but caps the interval at the limit instead of at 852.5 kg. "No, 850 kg on the display rounds up to 855 kg" wrongly treats the displayed value as if it rounds again.)
- (b) 16π — Use the circumference formula C = 2πr to find the radius: 8π = 2πr, so r = 8π ÷ 2π = 4 cm. Then use the area formula A = πr²: A = π × 4² = 16π cm². Using C = πr instead of C = 2πr gives r = 8, and squaring that gives 64π. Finding r = 4 correctly but then substituting it back into the circumference formula instead of the area formula gives 2π × 4 = 8π. Finding r = 4 correctly but forgetting to square it in the area formula, using A = πr instead of A = πr², gives 4π.
- (a) 6 — Method: the two scoops sit in different places on the cone, so a cone is an ordered choice; the possibilities can be listed systematically or counted by multiplying the choices available at each stage. Working: there are 3 flavours for the bottom scoop, and once that flavour is used only 2 flavours remain for the top scoop, so there are 3 × 2 = 6 cones; listing them confirms this, since vanilla on the bottom allows mango or pistachio on top, mango on the bottom allows vanilla or pistachio, and pistachio on the bottom allows vanilla or mango. Answer: 6. The distractors: 3 comes from treating the two scoops as interchangeable, so that vanilla under mango and mango under vanilla are counted as one cone; 9 comes from allowing the same flavour to be used for both scoops, giving 3 × 3; 5 comes from adding the 3 choices for the bottom scoop to the 2 choices left for the top scoop instead of multiplying them.
- (c) Sam is correct — The leading zeros in 0.070268 are not significant, so the first three significant figures are 7, 0 and 2. The next digit along is 6, and since 6 is 5 or more, the third significant figure rounds up from 2 to 3, giving 0.0703. This means Sam's answer is correct. Writing 0.070 keeps only 2 significant figures, one short of what was asked. Writing 0.0702 ignores the digit 6 that follows and leaves the third figure unrounded. Writing 0.0704 rounds the third figure up twice, as if a later digit had also pushed it up.
- (a) to the nearest centimetre — Method: the error interval of a rounded measurement runs from half a unit below the stated value to half a unit above it, so the width of the interval is one whole unit of the accuracy used. Working: the interval runs from 24.5 to 25.5, a width of 25.5 − 24.5 = 1, so the unit of accuracy is 1 cm; the stated value is the midpoint, 25 cm, and 25 correct to the nearest centimetre is exactly what gives 24.5 ≤ L < 25.5. Answer: to the nearest centimetre. To the nearest 0.5 cm comes from reading the half-unit, 0.5, as the accuracy itself instead of doubling it back to the full unit. To 1 decimal place comes from seeing the bounds written with one decimal place and taking that as the accuracy, but the bounds of a value given to 1 decimal place would be only 0.05 either side. To the nearest 10 cm comes from confusing the size of the value, about 25, with the unit it was rounded to; rounding to the nearest 10 cm would give an interval 5 cm either side of the stated value.
- (a) 2, 3, 4, 5 — Method: work out which whole numbers satisfy both parts of the inequality. Working: n ≥ 2 means n can be 2 or more; n < 6 means n must be less than 6, so 6 itself is not included. The whole numbers that fit both conditions are 2, 3, 4 and 5. Answer: 2, 3, 4, 5. 2, 3, 4, 5, 6 treats < 6 as ≤ 6 and wrongly includes 6. 3, 4, 5 treats ≥ 2 as > 2 and wrongly leaves out 2. 1, 2, 3, 4, 5 wrongly includes 1, which does not satisfy n ≥ 2.
- (b) 9 — Method: a negative index means take the reciprocal of the base first and then apply the positive power. Working: the reciprocal of 1/3 is 3, so (1/3)⁻² = 3² = 3 × 3 = 9. Answer: 9. The distractors: 1/9 comes from ignoring the minus sign and squaring 1/3 as it stands; −9 comes from reading the negative index as a minus sign on the result; 6 comes from multiplying the denominator by the index, 3 × 2, instead of squaring the reciprocal.
- (c) 1,000 m² — Method: round each length to 1 significant figure, then use area of a rectangle = length × width on the rounded lengths. Working: 19.6 m rounds to 20 m and 48.3 m rounds to 50 m, so the estimate is 20 × 50 = 1,000 and the area is about 1,000 m². Answer: 1,000 m². The distractors: 800 m² comes from rounding 48.3 down to 40 when the digit after its first significant figure is 8 and sends it up to 50, giving 20 × 40 = 800; 140 m² is the perimeter of the rounded rectangle, 2 × 20 + 2 × 50 = 140, not its area; 70 m² comes from adding the rounded lengths, 20 + 50 = 70, instead of multiplying them.
- (d) 6,000,000 — Method: round each number to 1 significant figure, then subtract. Working: 8,340,000 rounds to 8,000,000 (1 s.f.); 1,950,000 rounds to 2,000,000 (1 s.f.); 8,000,000 − 2,000,000 = 6,000,000. Answer: 6,000,000. 6,390,000 is the exact difference, found without rounding the numbers first. 8,000,000 comes from rounding the population correctly but forgetting to subtract the capital's population at all. 6,300,000 comes from rounding 8,340,000 to the nearest hundred thousand, 8,300,000, instead of to 1 significant figure, then subtracting the correctly rounded 2,000,000.
- (a) 36 kg — The mix is 3 + 5 = 8 equal shares, so the cement is 3/8 of the mass. One share is 96 ÷ 8 = 12 kg, and the cement is 3 shares: 3 × 12 = 36 kg. Working out 3/5 of 96 gives 57.6 kg, which uses the sand as the denominator instead of the whole mix; 60 kg is the mass of the sand; 12 kg is one share only.
- (a) 11:20 — Method: find the flight time using time = distance ÷ speed, then add this to the departure time. Working: 2340 ÷ 780 = 3 hours; 08:20 + 3 hours = 11:20. Answer: 11:20. 08:40 comes from dividing speed by distance instead of distance by speed, giving a flight time of 1/3 hour (20 minutes) rather than 3 hours. 11:00 comes from adding the 3-hour flight time to the hour of the departure time only, 8 + 3 = 11, and losing the 20 minutes. 03:00 comes from finding the flight time correctly but giving it as a clock time on its own, forgetting to add it to the departure time.
- (a) 33.5 mph — Method: the smallest possible actual value is half the rounding unit below the given value. Working: half of 1 mph is 0.5 mph, so the smallest possible speed is 34 − 0.5 = 33.5 mph. Answer: 33.5 mph. (33 mph comes from subtracting the whole rounding unit, 1, instead of half of it. 34 mph comes from giving the rounded value itself rather than the lower bound. 34.5 mph comes from adding the half unit instead of subtracting it, giving the upper bound.)
- (a) 0.0069 — Leading zeros are not significant, so the significant figures in 0.006852 start at 6: 6, 8, 5, 2. Rounding to 2 significant figures means keeping 6 and 8, and looking at the next digit, 5, to decide whether to round up. Since 5 rounds up, the second significant figure increases from 8 to 9: 0.006852 rounds to 0.0069. A candidate who rounded to 1 significant figure instead of 2 wrote 0.007. A candidate who rounded to 3 significant figures instead of 2 wrote 0.00685. A candidate who did not round up despite the next digit being 5 wrote 0.0068.
- (a) 13/40 — Method: write the decimal over 1000 using its three decimal places, then simplify. Working: 0.325 = 325/1000 = 13/40 (dividing both numerator and denominator by 25). Answer: 13/40. 13/4 comes from writing the decimal over 100 instead of 1000, as if there were only two decimal places. 8/25 comes from rounding 0.325 down to 0.32 before converting. 3/8 comes from recalling the learned conversion 3/8 = 0.375 and matching it to 0.325 because both are three-place decimals beginning with 3, instead of converting the decimal given.
Build your own mix at the worksheet builder.