Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) 63 — 10% of 180 = 18, so 5% = 9. 35% = (3 × 18) + 9 = 54 + 9 = 63. A candidate who uses 25% instead of 35% gets 45. A candidate who doubles 35% to get 70% by mistake gets 126. A candidate who subtracts 35 from 180 instead of finding a percentage gets 145.
- (a) 1/3 — To subtract these fractions, first write 3/4 with a denominator of 12: 3/4 = 9/12. Then 9/12 − 5/12 = 4/12, which simplifies to 1/3. Subtracting the numerators and the denominators separately, (3 − 5)/(4 − 12), gives −2/−8, which simplifies to 1/4. Changing 3/4 to twelfths by only changing the denominator, without scaling the numerator to match, gives 3/12 − 5/12 = −2/12, which simplifies to −1/6. Adding the fractions instead of subtracting them, 9/12 + 5/12, gives 14/12, which simplifies to 7/6.
- (b) 24 — List multiples of 8 and of 12: multiples of 8 are 8, 16, 24, 32; multiples of 12 are 12, 24, 36. The lowest number in both lists is 24, so the lighthouses next flash together after 24 minutes. Multiplying the two numbers together, 8 × 12, gives 96, which double-counts the common factor of 4 shared by 8 and 12. Working out the highest common factor instead of the lowest common multiple gives 4, far too soon a time for both lighthouses to line up again. Adding the two numbers, 8 + 12, gives 20, which is not even a multiple of either 8 or 12. So the lighthouses next flash together after 24 minutes.
- (a) 36 — Method: for the highest common factor, take the LOWER power of each prime that appears in both numbers. Working: for 2, the lower power is 2² (from 108); for 3, the lower power is 3² (from 72), so the highest common factor is 2² × 3² = 4 × 9 = 36. 216 comes from taking the higher power of each prime instead, 2³ × 3³ = 8 × 27 = 216, which gives the lowest common multiple, not the highest common factor. 108 is simply one of the two numbers, not their highest common factor. 6 comes from multiplying the primes without any powers at all, 2 × 3 = 6. Answer: 36.
- (c) 12.44 — The error intervals are 155.5 ≤ mass < 156.5 and 11.5 ≤ volume < 12.5. To make a quotient as small as possible, use the SMALLEST possible numerator together with the LARGEST possible denominator: 155.5 ÷ 12.5 = 12.44 g/cm³. Using the lower bound for both mass and volume, 155.5 ÷ 11.5 ≈ 13.52, forgets that dividing by a smaller number makes the result bigger, not smaller — that pairing does not give a minimum at all. Dividing the two given rounded values directly, 156 ÷ 12 = 13, ignores that both measurements have their own error interval. Using the upper bound of mass with the upper bound of volume, 156.5 ÷ 12.5 = 12.52, takes both bounds the same way round; it is neither the minimum nor the maximum, since the maximum needs the largest mass with the smallest volume, 156.5 ÷ 11.5 ≈ 13.61.
- (b) 4 m — Blue fabric is 3 parts and this equals 1.5 m, so one part is 1.5 ÷ 3 = 0.5 m. Yellow fabric is 5 parts, so it is 5 × 0.5 = 2.5 m. The total length is 1.5 + 2.5 = 4 m. 2.5 m is the length of yellow fabric only, without adding the blue fabric back in. 1.5 m is just the given length of blue fabric, with the yellow fabric never worked out. 2.4 m comes from swapping the ratio, treating blue as 5 parts and yellow as 3 parts, giving one part as 1.5 ÷ 5 = 0.3 m and yellow as 3 × 0.3 = 0.9 m, then adding 1.5 + 0.9 = 2.4.
- (c) 0.0479 — Method: round each option to 2 significant figures and check which one gives 0.048. Working: for 0.0479, the first two significant figures are 4 and 7; the next digit is 9, so 7 rounds up to 8, giving 0.048. For 0.0485, the first two significant figures are 4 and 8; the next digit is 5, so 8 rounds up to 9, giving 0.049, not 0.048. 0.052 already has exactly 2 significant figures, 5 and 2, so it stays as 0.052 and does not round to 0.048 at all. 0.04 has only 1 significant figure, so it is already less precise than the 2 significant figures asked for. Answer: 0.0479.
- (a) 36 — Method: find the lowest common multiple of 6 and 9, then move up the list of common multiples until one is greater than 20. Working: the common multiples of 6 and 9 are 18, 36, 54 …. 18 is not greater than 20, so the next one, 36, is the smallest value of n that is greater than 20. 18 is the lowest common multiple itself, but it fails the 'greater than 20' condition. 54 is the common multiple after 36, one step too far. 27 is a multiple of 9 but not of 6, since 27 ÷ 6 is not a whole number. Answer: 36.
- (a) 2, 3, 4, 5 — Method: work out which whole numbers satisfy both parts of the inequality. Working: n ≥ 2 means n can be 2 or more; n < 6 means n must be less than 6, so 6 itself is not included. The whole numbers that fit both conditions are 2, 3, 4 and 5. Answer: 2, 3, 4, 5. 2, 3, 4, 5, 6 treats < 6 as ≤ 6 and wrongly includes 6. 3, 4, 5 treats ≥ 2 as > 2 and wrongly leaves out 2. 1, 2, 3, 4, 5 wrongly includes 1, which does not satisfy n ≥ 2.
- (a) The tape can only give the length to the nearest centimetre — Method: a measurement should never be written to a finer degree of accuracy than the instrument used can read. Working: the tape is marked in centimetres, so the smallest division Leah can read is 1 cm, which is 0.01 m and two decimal places in metres; writing 7.3157 m claims the length to the nearest tenth of a millimetre, four decimal places, which the markings cannot support. A record of 7.32 m, to the nearest centimetre, is what this tape justifies. Answer: The tape can only give the length to the nearest centimetre. The distractors: the nearest millimetre contradicts the markings described in the question, which are centimetres, and would still claim more accuracy than the tape offers; the rule that a length in metres must be written to 2 decimal places borrows the habit of writing money to the penny, when the accuracy of a length depends on the instrument; rounding to the nearest metre would throw away accuracy the tape genuinely provides.
- (d) £6 — First find 30% of £200, which is £60, then find 10% of that: £60 × 0.1 = £6. Adding the two percentages together instead of applying them one after the other, 10% + 30% = 40%, and finding 40% of £200 gives £80. Finding 30% of £200 = £60 correctly but stopping before applying the second percentage leaves £60 as the final answer. Finding only 10% of the original £200, ignoring the 30% entirely, gives £20.
- (b) 4.05 — Method: line up the decimal points (or place value columns) before adding. Working: 3.60 + 0.45 = 4.05. Answer: 4.05. 3.65 is Priya's answer, from adding the digits without lining up the place value columns, which effectively treats 0.45 as 0.05. 4.5 comes from rounding both numbers up first, 3.6 to 4 and 0.45 to 0.5, and adding those instead of adding the exact values. 0.81 comes from adding the digits 36 and 45 together to get 81, then placing the decimal point in the wrong position.
- (a) 36 kg — The mix is 3 + 5 = 8 equal shares, so the cement is 3/8 of the mass. One share is 96 ÷ 8 = 12 kg, and the cement is 3 shares: 3 × 12 = 36 kg. Working out 3/5 of 96 gives 57.6 kg, which uses the sand as the denominator instead of the whole mix; 60 kg is the mass of the sand; 12 kg is one share only.
- (c) 36 — Method: set the outcomes out in a grid with one die along the top and the other down the side, so that every cell of the grid is one outcome, and count the cells. Working: the red die can land in 6 ways, so the grid has 6 columns, and the blue die can also land in 6 ways, so the grid has 6 rows; the number of cells is 6 × 6 = 36. Answer: 36. The distractors: 12 comes from adding 6 and 6 instead of multiplying them; 6 comes from counting the outcomes of a single die and forgetting that the second die also has to land; 21 comes from treating the two dice as indistinguishable, so that a red 2 with a blue 3 and a red 3 with a blue 2 are counted as one outcome.
- (a) 8.15 ≤ y < 8.25 — Rounding to 1 decimal place means the error interval spans half of 0.1, so 0.05, either side of 8.2: 8.2 − 0.05 = 8.15 and 8.2 + 0.05 = 8.25. The lower bound uses ≤ because 8.15 itself rounds to 8.2, but the upper bound uses < because 8.25 would round up to 8.3. So the error interval is 8.15 ≤ y < 8.25. A candidate who used the wrong rounding band gave 8.1 ≤ y < 8.2. A candidate who used a strict inequality at both ends wrote 8.15 < y < 8.25, wrongly excluding 8.15 itself. A candidate who added the full 0.1 instead of half of it wrote 8.2 ≤ y < 8.3.
Build your own mix at the worksheet builder.