Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 10 °C — Method: work out the coldest and warmest of the four temperatures, then subtract to find the difference. Working: the coldest temperature is Sam's, −9 °C, and the warmest is Alex's, 1 °C. The difference is 1 − (−9) = 1 + 9 = 10. Answer: 10 °C. 8 °C comes from working out 1 − 9 = −8 and reporting 8, dropping the negative sign on −9 instead of turning the subtraction into an addition. 3 °C comes from comparing the wrong pair, Sam's −9 °C and Ben's −6 °C, instead of the coldest and the warmest: −6 − (−9) = 3. 7 °C comes from comparing Ben's −6 °C with Alex's 1 °C, mistakenly treating Ben's reading as the coldest instead of Sam's.
- (b) 7 — Method: trap the number between the two square numbers on either side of it, then decide which of them it is nearer to. Working: 6² = 36 and 7² = 49, so √45 lies between 6 and 7; 49 − 45 = 4 while 45 − 36 = 9, so 45 is nearer to 49. Answer: 7. The distractors: 6 comes from taking the square number below 45 and stopping there, without checking which of 36 and 49 is nearer; 22.5 comes from halving 45 instead of looking for the number that multiplies by itself to give 45; 2,025 comes from squaring 45 instead of taking its square root.
- (a) 1/2, 3/5, 2/3, 5/6 — Convert all four fractions to a common denominator of 30: 2/3 is 20/30, 3/5 is 18/30, 5/6 is 25/30, and 1/2 is 15/30. Ordering by these numerators, smallest to largest, gives 15/30, 18/30, 20/30, 25/30, which is 1/2, 3/5, 2/3, 5/6. Ordering by the size of the numerator in the original fractions, 1, 2, 3, 5, rather than converting to a common denominator, gives the wrong order 1/2, 2/3, 3/5, 5/6, because it ignores that the denominators are different. Ordering largest to smallest instead of smallest to largest, as the question asks, gives 5/6, 2/3, 3/5, 1/2. Using the rule "the bigger the denominator, the smaller the fraction" to place the last two, so that 5/6 is put below 2/3 because 6 is bigger than 3, gives 1/2, 3/5, 5/6, 2/3 — that rule only holds when the numerators are the same, and here 20/30 really is smaller than 25/30. So the correct order, smallest to largest, is 1/2, 3/5, 2/3, 5/6.
- (a) 2a²b³ — Method: a fourth root applies to every factor inside it, and taking the fourth root of a power divides that power's index by 4. Working: 2 × 2 × 2 × 2 = 16, so the fourth root of 16 is 2; 8 ÷ 4 = 2 gives a², and 12 ÷ 4 = 3 gives b³. Answer: 2a²b³. The distractors: 2a⁴b⁶ comes from halving both indices, treating every root sign as a square root; 4a²b³ comes from taking the square root of 16 while dividing the letters' indices by 4; 2a²b⁴ comes from dividing b's index by 3 instead of by 4, as though b sat under a cube root.
- (c) 0.001 — Method: a negative index means 'one over' the positive power, so $10^{-3}$ means one over $10^{3}$. Working: ten cubed is 1000, and one over 1000 is 0.001. 1000 comes from ignoring the negative sign and working out ten cubed instead of its reciprocal. −1000 comes from ignoring what the negative index does to the size, while still writing a negative sign on the large value. −0.001 comes from correctly finding the size, 0.001, but wrongly keeping a negative sign because the index was negative. Answer: 0.001.
- (c) 0.7, 0.72, 3/4 — Method: numbers written in different forms cannot be compared as they stand, so every fraction is turned into a decimal by dividing the numerator by the denominator, and the decimals are then compared place by place from the left. Working: 3/4 means 3 ÷ 4 = 0.75, so the three values to compare are 0.7, 0.75 and 0.72; written to two decimal places they are 0.70, 0.75 and 0.72, and the hundredths digits 0, 5 and 2 put 0.70 first, 0.72 next and 0.75 last; written again in the forms the question used, the order from smallest is 0.7, then 0.72, then 3/4. Answer: 0.7, 0.72, 3/4. The distractors: 3/4, 0.7, 0.72 comes from turning 3/4 into 0.34 by writing the numerator and the denominator as the two digits after the point, which makes the fraction the smallest of the three; 0.72, 3/4, 0.7 comes from the belief that the more digits a decimal has the smaller it must be, which puts both 0.72 and 0.75 below 0.7 and 0.72 below 0.75; 3/4, 0.72, 0.7 comes from comparing the three values correctly but listing them largest first, against an instruction to start with the smallest.
- (c) 5 — 0.2 = 1/5, and turning the fraction upside down gives the reciprocal 5/1 = 5. Writing −0.2 mistakes the reciprocal for the negative of the number. Working out 1 − 0.2 = 0.8 mistakes the reciprocal for subtracting the number from 1. Writing 0.5 is the reciprocal of 2, not of 0.2 — a place-value slip that drops the decimal, since 1 ÷ 0.2 = 5 while 1 ÷ 2 = 0.5.
- (a) £18 — Method: the percentage acts as an operator on the bill, and 15% can be built from 10% and 5%, where 5% is half of 10%. Working: 10% of £120 is £120 ÷ 10 = £12, and 5% is half of that, £6, so the charge is £12 + £6 = £18. Answer: £18. The distractors: £8 comes from reading 15% as one fifteenth and working out £120 ÷ 15 = £8; £12 comes from finding 10% of the bill and stopping there; £138 comes from finding the charge correctly and then giving the new total, £120 + £18, rather than the charge the question asks for.
- (b) 14 — Method: the greatest number of identical rows is the highest common factor of the two bulb totals, found by taking every prime factor the two totals share. Working: 42 = 2 × 3 × 7 and 56 = 2 × 2 × 2 × 7, so the prime factors common to both are 2 and 7, giving a highest common factor of 2 × 7 = 14. 2 comes from taking only the common factor 2 and forgetting the common factor 7. 7 comes from taking only the common factor 7 and forgetting the common factor 2. 168 is the lowest common multiple of 42 and 56, not their highest common factor. Answer: 14.
- (b) 5.1 — ∛130 lies between 5 and 6, since 125 < 130 < 216, and closer to 5 because 130 is much nearer 125 than 216. To pin down the first decimal place, test the midpoint of the tenth, 5.05: 5.05³ = 5.05 × 5.05 × 5.05 ≈ 128.79. Since 130 is greater than 128.79, ∛130 lies above 5.05, so it rounds to 5.1 rather than 5.0. Rounding down to 5.0, on the assumption that a value close to the lower bound 125 must round down, ignores that 5.05³ is already less than 130. Estimating 5.2 overshoots the true root: 5.2³ = 140.608, which is well above 130, so ∛130 cannot round to 5.2. Taking 6.0, the upper of the two whole numbers the root lies between, ignores that 130 is far nearer to 5³ = 125 than to 6³ = 216, so the root sits just above 5, not just below 6.
- (c) 6 — The units digit must be even, so it can be 2 or 8, giving 2 choices. The tens digit can then be any of the remaining 3 digits, since one digit has been used for the units. Multiply: 2 × 3 = 6. 12 comes from working out how many two-digit numbers can be made in total, 4 × 3 = 12, ignoring the requirement that the number is even. 8 comes from choosing the units digit from 2 options and then wrongly allowing any of the 4 digits again for the tens digit, 2 × 4 = 8, which lets a digit repeat. 2 comes from counting only the choices for the units digit and forgetting the tens digit.
- (b) 2⁵ — Method: a power outside brackets multiplies the index of every factor inside them, and dividing powers of the same base subtracts their indices. Working: (5² × 2³)³ = 5⁶ × 2⁹ and (5³ × 2²)² = 5⁶ × 2⁴. Dividing gives 5⁶⁻⁶ × 2⁹⁻⁴, and since 5⁰ = 1 the whole expression reduces to 2⁵. Answer: 2⁵. The distractors: 2² comes from adding the outside index to each inside index instead of multiplying, which gives 5⁵ × 2⁶ over 5⁵ × 2⁴; 2¹³ comes from adding the indices of 2 when dividing, 9 + 4, instead of subtracting them; 2 comes from applying the outside power to the first factor inside each bracket only, leaving 5⁶ × 2³ over 5⁶ × 2².
- (b) 14.5 ≤ l < 15.5 — A measurement given to the nearest metre could have been rounded from anywhere up to half a metre below or above it: 15 − 0.5 = 14.5 and 15 + 0.5 = 15.5. Every value from 14.5 up to (but not reaching) 15.5 rounds to 15, so the error interval is 14.5 ≤ l < 15.5, with the lower bound included and the upper bound excluded. Making both ends strict, 14.5 < l < 15.5, wrongly excludes 14.5 itself, even though 14.5 does round to 15. Making both ends inclusive, 14.5 ≤ l ≤ 15.5, wrongly includes 15.5, which actually rounds up to 16, not 15. Using a whole metre either side instead of half a metre, giving 14 ≤ l < 16, comes from forgetting that the error is only half the rounding unit.
- (d) 6 × 10⁷ — Method: the coefficients and the powers of ten are handled separately — multiply the coefficients, and add the indices because the powers share the base 10. Working: 2 × 3 = 6 for the coefficients, and 10³ × 10⁴ = 10⁷ for the powers; 6 lies between 1 and 10, so the coefficient needs no adjustment. Answer: 6 × 10⁷. The distractors: 5 × 10⁷ comes from adding the coefficients, 2 + 3, instead of multiplying them; 6 × 10¹² comes from multiplying the indices, 3 × 4, instead of adding them; 6 × 10¹ comes from subtracting the indices, 4 − 3, which is the rule for dividing rather than for multiplying.
- (d) 11 mm — Method: for a square, the side length is the square root of the area. Working: 11 × 11 = 121, so the side length is 11 mm. 60.5 mm comes from working out 121 ÷ 2 = 60.5, halving the area instead of finding its square root. 242 mm comes from working out 121 × 2 = 242, doubling the area instead of finding its square root. 22 mm comes from working out 11 × 2 = 22, doubling the correct side length. Answer: 11 mm.
Build your own mix at the worksheet builder.