Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) 9π cm² — The area of a circle is π × r². With a radius of 3 cm this is π × 3² = 9π cm², and this is exact because π has not been replaced by any approximation. Writing 28.3 cm² replaces π with a rounded decimal value, 3.14, and then rounds the result again, so it is only an approximation. Writing 28.26 cm² uses π ≈ 3.14 without a final rounding step, but this is still only an approximation of 9π, not the exact value. Writing 27 cm² comes from replacing π with the rough approximation 3, which is even further from the true value.
- (d) x⁽¹⁄²⁾ — Method: dividing two powers of the same letter subtracts the index of the divisor from the index of the term being divided, and fractional indices are subtracted like any other fractions. Working: 3/4 − 1/4 = 2/4, which simplifies to 1/2, so the result is x⁽¹⁄²⁾. Answer: x⁽¹⁄²⁾. The distractors: x comes from adding the indices, 3/4 + 1/4 = 1, as though the powers were being multiplied; x³ comes from dividing the indices, so that 3/4 divided by 1/4 gives 3; x⁽³⁄¹⁶⁾ comes from multiplying the indices, 3/4 × 1/4.
- (d) 1/4 — Method: deal with the fractional index first, then the negative sign. Working: $8^{2/3} = (\sqrt[3]{8})^2 = 2^2 = 4$. A negative index means take the reciprocal of that result, so $8^{-2/3} = \frac{1}{8^{2/3}} = \frac{1}{4}$. Answer: 1/4. A candidate who evaluates $8^{2/3}$ correctly but forgets the negative sign entirely gets 4 — they have dropped the instruction to take a reciprocal. A candidate who takes the reciprocal step but applies it as a sign change to the finished number instead of inverting it gets −4. A candidate who multiplies 8 by −2/3, treating the index as an ordinary factor rather than a power, gets −16/3.
- (c) An under-estimate, by 8 — Method: work out the exact product, then compare it with the estimate; an estimate that is smaller than the exact value is an under-estimate, and the difference between them is the size of the error. Working: 48 × 21 = 48 × 20 + 48 = 960 + 48 = 1,008, and 1,008 − 1,000 = 8, so the estimate falls short. Answer: an under-estimate, by 8. The distractors: an over-estimate by 8 has the size of the error right but the direction wrong, and comes from assuming that rounding 48 up to 50 must push the estimate above the exact value, without allowing for 21 being rounded down; an over-estimate by 19 comes from working out 48 × 21 as 48 × 20 + 21 = 981, adding a 21 where another 48 belongs; the claim that the estimate is exactly right comes from arguing that one number was rounded up and the other down, so the two changes must cancel.
- (c) 6 — 2 × 3 = 6, then 36 ÷ 6 = 6. Ignoring the brackets and working left to right gives 36 ÷ 2 = 18, then 18 × 3 = 54. Multiplying by the bracket instead of dividing by it gives 2 × 3 = 6, then 36 × 6 = 216. Dividing by only the 2 inside the bracket, and ignoring the × 3, gives 36 ÷ 2 = 18.
- (b) 3²⁰ is larger — Method: two powers with different bases and different indices can be compared once they are rewritten with a common index, which is possible whenever the indices share a factor. Working: 30 and 20 have a highest common factor of 10, so 2³⁰ = (2³)¹⁰ = 8¹⁰ and 3²⁰ = (3²)¹⁰ = 9¹⁰. Both are now tenth powers, and since 9 is larger than 8, 9¹⁰ is larger than 8¹⁰. Answer: 3²⁰ is larger. The distractors: 2³⁰ is larger comes from comparing only the indices and choosing the power with the bigger index; They are equal comes from multiplying base by index, 2 × 30 and 3 × 20, and finding 60 each time; They cannot be compared without a calculator comes from assuming that powers this large can only be ranked by evaluating them in full.
- (a) 1/2, 3/5, 2/3, 5/6 — Convert all four fractions to a common denominator of 30: 2/3 is 20/30, 3/5 is 18/30, 5/6 is 25/30, and 1/2 is 15/30. Ordering by these numerators, smallest to largest, gives 15/30, 18/30, 20/30, 25/30, which is 1/2, 3/5, 2/3, 5/6. Ordering by the size of the numerator in the original fractions, 1, 2, 3, 5, rather than converting to a common denominator, gives the wrong order 1/2, 2/3, 3/5, 5/6, because it ignores that the denominators are different. Ordering largest to smallest instead of smallest to largest, as the question asks, gives 5/6, 2/3, 3/5, 1/2. Using the rule "the bigger the denominator, the smaller the fraction" to place the last two, so that 5/6 is put below 2/3 because 6 is bigger than 3, gives 1/2, 3/5, 5/6, 2/3 — that rule only holds when the numerators are the same, and here 20/30 really is smaller than 25/30. So the correct order, smallest to largest, is 1/2, 3/5, 2/3, 5/6.
- (a) 1,850 — Method: find the error interval, then check which value falls outside it. Working: half of 100 is 50, so the actual number of visitors, v, satisfies 1,750 ≤ v < 1,850. 1,850 sits exactly on the excluded upper boundary, since a value of 1,850 would round to 1,900, not 1,800. Answer: 1,850. (1,750 is a genuine possible value — it sits at the included lower boundary. 1,799 is a genuine possible value, just below the upper boundary. 1,760 is a genuine possible value, well inside the interval.)
- (b) 1/9 — Method: let x stand for the recurring decimal, multiply by the power of ten that moves exactly one repeating block past the decimal point, subtract the original equation so that the recurring tail cancels, and solve the equation that is left. Working: let x = 0.111...; the repeating block is one digit long, so multiply by 10 to give 10x = 1.111...; subtracting the first equation from the second gives 10x − x = 1.111... − 0.111..., that is 9x = 1; dividing both sides by 9 gives x = 1/9. Answer: 1/9. The distractors: 1/10 comes from dividing by the multiplier 10 at the last step instead of by the 9 that is left in front of x; 1/11 comes from recalling the elevenths family instead of the ninths, although 1/11 = 0.0909... has a two-digit repeating block rather than a one-digit one; 11/100 comes from stopping the decimal after two digits and converting 0.11 into hundredths.
- (d) 1 × 10⁷ seconds — Method: the time for a journey is the distance divided by the speed, so round each number to 1 significant figure and then divide; dividing numbers in standard form means dividing the coefficients and subtracting the indices. Working: 3.1 × 10¹⁵ rounds to 3 × 10¹⁵ and 2.998 × 10⁸ rounds to 3 × 10⁸; 3 ÷ 3 = 1 for the coefficients, and 15 − 8 = 7 for the indices. Answer: about 1 × 10⁷ seconds. The distractors: 3 × 10⁷ seconds comes from subtracting the indices correctly but leaving the coefficient as 3 instead of dividing 3 by 3; 1 × 10⁻⁷ seconds comes from dividing the speed by the distance instead of the distance by the speed; 9 × 10²³ seconds comes from multiplying the two quantities instead of dividing them, since 3 × 3 = 9 and 15 + 8 = 23.
- (d) 9 — List all the factors of 36 in pairs that multiply to give 36: 1 × 36, 2 × 18, 3 × 12, 4 × 9, and 6 × 6. This gives the factors 1, 2, 3, 4, 6, 9, 12, 18 and 36 — nine factors in total, with 6 counted only once even though it appears in a pair with itself. Forgetting that 36 is itself a factor of 36 and leaving it off the list gives 8. Counting the number of factor pairs, five of them, rather than the number of individual factors gives 5. Treating the repeated pair 6 × 6 as two separate factors, 6 and 6 again, gives 10 instead of 9. So 36 has 9 factors.
- (d) 0.3 — Converting the fractions to decimals, 1/4 = 0.25 and 2/5 = 0.4, so any decimal between 0.25 and 0.4 is a valid answer, and 0.3 fits. Confusing 1/4 with 1/5 and converting it as 0.2 instead of 0.25 gives a value below the true lower bound. Confusing 2/5 with 1/2 and converting it as 0.5 instead of 0.4 gives a value above the true upper bound. Converting the fractions correctly but choosing a decimal above the true upper bound of 0.4 instead of between the two values gives 0.45.
- (c) −28 — 6² = 36 and 4³ = 64. Work out 36 − 64 = −28. A candidate who subtracts in the wrong order gets 64 − 36 = 28. A candidate who adds instead of subtracting gets 36 + 64 = 100. A candidate who multiplies the base by the exponent instead of raising the power (6 × 2 − 4 × 3 = 12 − 12) gets 0.
- (b) 16π — Use the circumference formula C = 2πr to find the radius: 8π = 2πr, so r = 8π ÷ 2π = 4 cm. Then use the area formula A = πr²: A = π × 4² = 16π cm². Using C = πr instead of C = 2πr gives r = 8, and squaring that gives 64π. Finding r = 4 correctly but then substituting it back into the circumference formula instead of the area formula gives 2π × 4 = 8π. Finding r = 4 correctly but forgetting to square it in the area formula, using A = πr instead of A = πr², gives 4π.
- (a) 24 — Method: rearrange the relationship so that the lowest common multiple stands alone; it is the product of the two numbers divided by their highest common factor. Working: 48 = 2 × the lowest common multiple, so the lowest common multiple is 48 ÷ 2 = 24. Checking, 24 is in the 6 times table and in the 8 times table. Answer: 24. The distractors: 48 comes from giving the product of the two numbers and never dividing by the highest common factor; 96 comes from multiplying by the highest common factor instead of dividing by it; 12 comes from dividing by the highest common factor twice, once for each of the two numbers.
Build your own mix at the worksheet builder.