Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 40 — Multiply the number of choices for each item: 4 × 5 × 2 = 40. 11 comes from adding the three numbers instead of multiplying them. 20 comes from multiplying only the crisps and chocolate bars, 4 × 5, and forgetting the drink. 10 comes from multiplying only the chocolate bars and drinks, 5 × 2, and forgetting the crisps.
- (d) 8 — Method: write $16^{3/4}$ as $(\sqrt[4]{16})^3$ — the denominator of the index gives the root, the numerator gives the power. Working: $\sqrt[4]{16} = 2$, so $16^{3/4} = 2^3 = 8$. Answer: 8. A candidate who multiplies 16 by 3/4 is treating the index as an ordinary factor and gets 12 — a fractional index is not a multiplier. A candidate who takes the square root instead of the fourth root and then cubes it works out $(\sqrt{16})^3 = 4^3$ and gets 64; the denominator 4 names a fourth root, not a square root. A candidate who takes the fourth root of 16 correctly but stops there, without cubing it, gets 2.
- (d) 1.6 × 10⁵ — 5.6 ÷ 3.5 = 1.6, and 7 − 2 = 5, so the average turnover per shop is 1.6 × 10⁵ pounds. Multiplying the exponents instead of subtracting them gives 7 × 2 = 14, so 1.6 × 10¹⁴. Adding the exponents instead of subtracting them gives 7 + 2 = 9, so 1.6 × 10⁹. Subtracting the coefficients instead of dividing them gives 5.6 − 3.5 = 2.1, so 2.1 × 10⁵.
- (a) 200 g — One quarter of 160 g is 40 g. Increasing the amount means adding this on: 160 + 40 = 200 g. Finding the increase, 1/4 of 160 = 40 g, but stopping there without adding it to the original amount leaves just 40 g. Using 4/5 instead of 5/4 as the scaling fraction, 160 × 4/5 = 128 g, actually decreases the amount rather than increasing it. Increasing by a half instead of a quarter, 160 + 80 = 240 g, uses the wrong fraction of 160.
- (a) 8.15 ≤ y < 8.25 — Rounding to 1 decimal place means the error interval spans half of 0.1, so 0.05, either side of 8.2: 8.2 − 0.05 = 8.15 and 8.2 + 0.05 = 8.25. The lower bound uses ≤ because 8.15 itself rounds to 8.2, but the upper bound uses < because 8.25 would round up to 8.3. So the error interval is 8.15 ≤ y < 8.25. A candidate who used the wrong rounding band gave 8.1 ≤ y < 8.2. A candidate who used a strict inequality at both ends wrote 8.15 < y < 8.25, wrongly excluding 8.15 itself. A candidate who added the full 0.1 instead of half of it wrote 8.2 ≤ y < 8.3.
- (d) 2 hours — Method: the time for a journey is the distance divided by the speed, so round the distance first and then divide by the speed. Working: 95 km rounds to 100 km, and 100 ÷ 50 = 2; the speed is in kilometres per hour, so the answer is a number of hours. Answer: 2 hours. The distractors: 1 hour comes from rounding the distance down to 50 km to match the speed, so that the journey looks like a single hour of driving; 30 minutes comes from dividing the speed by the distance, 50 ÷ 100, instead of the distance by the speed; 1 hour 54 minutes is the exact time, 95 ÷ 50 = 1.9 hours, worked out in full when the question asks for an estimate.
- (b) 0.58333... — Divide 7 by 12 using long division. 70 ÷ 12 = 5 remainder 10, so the first decimal digit is 5. Bring down a 0 to make 100: 100 ÷ 12 = 8 remainder 4, so the second digit is 8. Bring down a 0 to make 40: 40 ÷ 12 = 3 remainder 4, so the third digit is 3. Bring down a 0 to make 40 again — the remainder 4 has reappeared, so the digit 3 repeats forever from here. This gives 7/12 = 0.58333... . Stopping the division after two digits and writing 0.58 treats it as if it terminated, when the remainder is not yet zero. Misreading the pattern as a two-digit repeating block, '58', gives 0.585858..., which wrongly makes the 5 recur as well as the 3. A slip in the long division that carries the wrong remainder forward can make the second digit itself appear to repeat instead of the third, giving 0.588888... .
- (b) 2.1 m — The three pieces use 3 × 0.9 = 2.7 m of wood. Remaining wood = 4.8 − 2.7 = 2.1 m. A candidate who miscounts and only subtracts 2 pieces instead of 3 gets 4.8 − 1.8 = 3.0 m. A candidate who adds instead of subtracting gets 4.8 + 2.7 = 7.5 m. A candidate who gives the length used instead of the length remaining gets 2.7 m.
- (a) −4.5 °C — Order the temperatures by their actual value on a number line, remembering that a more negative number is further below zero and therefore colder: −4.5 °C is the coldest, since it is further below zero than −4.05 °C, −3.8 °C or 2 °C. Comparing the digits 405 and 45 as though the decimal points lined up, without padding −4.5 to match the number of decimal places in −4.05 first, makes −4.05 °C look like it has the bigger size, so it gets picked as the coldest by mistake — in fact −4.05 °C is closer to zero than −4.5 °C, not further from it. Picking −3.8 °C comes from choosing the negative reading with the smallest absolute value, forgetting that for negative numbers, a smaller absolute value means a warmer, less negative temperature, not a colder one. Picking 2 °C comes from ignoring the negative signs on the other three readings altogether and comparing raw digit sizes, when in fact any negative temperature is colder than any positive temperature. So the coldest temperature is −4.5 °C.
- (d) 72a⁷ — Method: a power outside brackets applies to every factor inside them, and multiplying two powers of the same letter adds their indices. Working: (3a²)² = 3² × a⁴ = 9a⁴, and (2a)³ = 2³ × a³ = 8a³. Multiplying the two results gives 9 × 8 = 72 for the number and 4 + 3 = 7 for the index of a. Answer: 72a⁷. The distractors: 36a⁷ comes from squaring the 2 in (2a)³ instead of cubing it, giving 4a³ and then 9 × 4; 72a¹² comes from multiplying the indices 4 and 3 when the two terms are multiplied, instead of adding them; 17a⁷ comes from adding the coefficients 9 and 8 rather than multiplying them.
- (d) 16π cm² — Method: for a circle, area = π × radius². Working: area = π × 4² = π × 16 = 16π cm². Answer: 16π cm². The student squared the radius but left out the π, which is why 16 cm² is not the exact area. 4π cm² comes from multiplying by the radius once instead of squaring it: π × 4 = 4π. 8π cm² comes from using the circumference formula 2 × π × radius instead of the area formula: 2 × π × 4 = 8π. 64π cm² comes from using the diameter (8 cm) as the radius in the area formula: π × 8² = 64π.
- (d) 2³ × 5² — Method: divide repeatedly by the smallest prime number, then write any repeated prime using a power. Working: 200 ÷ 2 = 100, 100 ÷ 2 = 50, 50 ÷ 2 = 25, 25 ÷ 5 = 5, and 5 is prime, so 200 = 2 × 2 × 2 × 5 × 5, written as 2³ × 5². 2² × 5³ swaps the two powers, giving 4 × 125 = 500, not 200. 2³ × 5 leaves out one of the two 5s, giving 8 × 5 = 40, not 200. 2 × 5³ leaves out two of the three 2s, giving 2 × 125 = 250, not 200. Answer: 2³ × 5².
- (a) 33.2 — The radius was rounded to 1 decimal place, so its error interval is 3.15 ≤ r < 3.25. The upper bound for the area uses the upper bound of the radius, squared: area = π × 3.25² ≈ 33.183, which rounds to 33.2 m² (3 s.f.). Using the given value of the radius directly instead of its upper bound, π × 3.2² ≈ 32.2, ignores that the radius itself has a range of possible values. Bounding the radius correctly but forgetting to square it, using area = π × 3.25 ≈ 10.2 instead of π × 3.25², drops the whole squaring step from the area formula. Using the LOWER bound of the radius instead of the upper one, π × 3.15² ≈ 31.2, finds the lower bound of the area, not the upper one.
- (c) 7 + 4√3 — Expand the brackets fully: (2 + √3)² = 2² + 2 × 2 × √3 + (√3)² = 4 + 4√3 + 3. Adding the two whole-number terms, 4 + 3 = 7, gives 7 + 4√3. Using (a + b)² = a² + b² and skipping the middle cross term entirely gives just 4 + 3 = 7, with no surd term at all. Treating (√3)² as if it stayed √3 rather than becoming 3, then merging it with the existing surd term, gives 4 + 5√3. Squaring only the surd term correctly but carrying the whole-number term as 2 instead of squaring it to 4 gives 2 + 3 + 4√3 = 5 + 4√3.
- (d) 9 — List all the factors of 36 in pairs that multiply to give 36: 1 × 36, 2 × 18, 3 × 12, 4 × 9, and 6 × 6. This gives the factors 1, 2, 3, 4, 6, 9, 12, 18 and 36 — nine factors in total, with 6 counted only once even though it appears in a pair with itself. Forgetting that 36 is itself a factor of 36 and leaving it off the list gives 8. Counting the number of factor pairs, five of them, rather than the number of individual factors gives 5. Treating the repeated pair 6 × 6 as two separate factors, 6 and 6 again, gives 10 instead of 9. So 36 has 9 factors.
Build your own mix at the worksheet builder.