Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) 16π — Use the circumference formula C = 2πr to find the radius: 8π = 2πr, so r = 8π ÷ 2π = 4 cm. Then use the area formula A = πr²: A = π × 4² = 16π cm². Using C = πr instead of C = 2πr gives r = 8, and squaring that gives 64π. Finding r = 4 correctly but then substituting it back into the circumference formula instead of the area formula gives 2π × 4 = 8π. Finding r = 4 correctly but forgetting to square it in the area formula, using A = πr instead of A = πr², gives 4π.
- (d) −1.4, −6/5, 0, 5/4, 1.3 — Method: convert the fractions 5/4 and −6/5 to decimals so every number is written the same way, then compare all five decimals. Working: 5/4 = 1.25 and −6/5 = −1.2. Comparing −1.4, −1.2, 0, 1.25 and 1.3 in size gives the order −1.4, −1.2, 0, 1.25, 1.3. Answer: −1.4, −6/5, 0, 5/4, 1.3. −6/5, −1.4, 0, 5/4, 1.3 swaps the two negative numbers, treating −6/5 as more negative than −1.4 even though −1.2 is closer to zero than −1.4. 1.3, 5/4, 0, −6/5, −1.4 lists the numbers from largest to smallest instead of smallest to largest. −1.4, −6/5, 0, 1.3, 5/4 swaps 5/4 and 1.3, comparing the numerator 5 directly with 1.3 instead of converting 5/4 to the decimal 1.25 first.
- (c) 62.35 ≤ r < 62.45 — Method: with a value rounded to 1 decimal place, the error interval reaches half of 0.1 either side. Working: half of 0.1 is 0.05, so the interval runs from 62.4 − 0.05 to 62.4 + 0.05. Answer: 62.35 ≤ r < 62.45. (62 ≤ r < 63 comes from rounding to the nearest whole number instead of 1 decimal place. 62.35 ≤ r ≤ 62.45 comes from including the upper bound with ≤ instead of excluding it with <. 62.3 ≤ r < 62.5 comes from using 0.1 either side instead of half of it.)
- (b) 9/25 — Method: write the decimal over the matching power of ten, then divide the numerator and the denominator by their highest common factor. Working: 0.36 has two digits after the point, so 0.36 = 36/100; the highest common factor of 36 and 100 is 4, and 36 ÷ 4 = 9 with 100 ÷ 4 = 25; since 9 and 25 share no factor greater than 1, the fraction is fully cancelled. Answer: 9/25. The distractors: 3/10 comes from reading only the first digit after the point and converting 0.3; 9/50 comes from dividing the numerator by 4 but the denominator by only 2; 36/10 comes from counting one decimal place instead of two and writing the digits over 10.
- (c) 12 — Method: division and multiplication have equal priority, so they are carried out in the order they are written, from left to right; a negative divided by a negative is positive. Working: (−36) ÷ (−6) = 6, and then 6 × 2 = 12. Answer: 12. The distractors: 3 comes from carrying out the multiplication first, (−6) × 2 = −12 followed by (−36) ÷ (−12) = 3; −12 comes from treating a negative divided by a negative as negative, giving −6 and then −6 × 2 = −12; 6 comes from stopping at the division and never carrying out the multiplication by 2.
- (c) −5 ≤ −5 — The symbol ≤ means 'less than or equal to', and −5 is equal to −5, so this statement is true. −3 ≥ −1 is false: a candidate who ignores the negative signs and compares 3 with 1 would wrongly think −3 is the bigger number, but on the number line −3 is smaller than −1. 0.4 < 2/5 is false because 2/5 converts to exactly 0.4, so the two values are equal, not one strictly less than the other — a candidate who assumes a fraction is automatically bigger than a similar-looking decimal without converting it would miss this. 7/10 ≤ 0.6 is false because 7/10 converts to 0.7, which is bigger than 0.6; a candidate who misplaces the decimal point and converts 7/10 as 0.07 would wrongly believe this statement is true.
- (a) 7 — Method: BIDMAS deals with the index first, then the multiplication, then the subtraction. Working: (−2)² = (−2) × (−2) = 4, then 3 × 4 = 12, and finally 12 − 5 = 7. Answer: 7. The distractors: −17 comes from squaring only the 2 and keeping the minus sign, giving 3 × (−4) = −12 and then −12 − 5 = −17; 31 comes from multiplying before applying the index, giving (3 × (−2))² = (−6)² = 36 and then 36 − 5 = 31; −3 comes from carrying out the subtraction before the multiplication, giving 3 × (4 − 5) = 3 × (−1) = −3.
- (c) 2/5 — To find a fraction of a fraction, multiply them together: 3/5 × 2/3 = 6/15, which simplifies to 2/5. Multiplying only the numerators, 3 × 2 = 6, but adding the denominators, 5 + 3 = 8, instead of multiplying them gives 6/8, which simplifies to 3/4. Using only the fraction who study French, 3/5, and ignoring that a further fraction of them also study Spanish gives 3/5. Dividing by 2/3 instead of multiplying by it, using its reciprocal 3/2, gives 3/5 × 3/2 = 9/10.
- (b) 14.5 ≤ l < 15.5 — A measurement given to the nearest metre could have been rounded from anywhere up to half a metre below or above it: 15 − 0.5 = 14.5 and 15 + 0.5 = 15.5. Every value from 14.5 up to (but not reaching) 15.5 rounds to 15, so the error interval is 14.5 ≤ l < 15.5, with the lower bound included and the upper bound excluded. Making both ends strict, 14.5 < l < 15.5, wrongly excludes 14.5 itself, even though 14.5 does round to 15. Making both ends inclusive, 14.5 ≤ l ≤ 15.5, wrongly includes 15.5, which actually rounds up to 16, not 15. Using a whole metre either side instead of half a metre, giving 14 ≤ l < 16, comes from forgetting that the error is only half the rounding unit.
- (d) £143 — From 09:15 to 12:45 is 3 hours 30 minutes, which is 3.5 hours. The charge for the time is 3.5 × £28 = £98, and the call-out fee is added on once: £98 + £45 = £143. £98 leaves out the call-out fee altogether, £129 charges for 3 hours instead of 3.5 hours, and £255.50 adds the fee to the hourly rate before multiplying, which charges the £45 for every hour.
- (a) 200 g — One quarter of 160 g is 40 g. Increasing the amount means adding this on: 160 + 40 = 200 g. Finding the increase, 1/4 of 160 = 40 g, but stopping there without adding it to the original amount leaves just 40 g. Using 4/5 instead of 5/4 as the scaling fraction, 160 × 4/5 = 128 g, actually decreases the amount rather than increasing it. Increasing by a half instead of a quarter, 160 + 80 = 240 g, uses the wrong fraction of 160.
- (c) 5/8 — Method: write the decimal over 1000 using its three decimal places, then simplify. Working: 0.625 = 625/1000 = 5/8 (dividing both numerator and denominator by 125). Answer: 5/8. 25/4 comes from writing the decimal over 100 instead of 1000, as if there were only two decimal places. 31/50 comes from rounding 0.625 to 0.62 before converting. 8/5 comes from simplifying correctly to 5/8 and then writing the fraction upside down.
- (a) The tape can only give the length to the nearest centimetre — Method: a measurement should never be written to a finer degree of accuracy than the instrument used can read. Working: the tape is marked in centimetres, so the smallest division Leah can read is 1 cm, which is 0.01 m and two decimal places in metres; writing 7.3157 m claims the length to the nearest tenth of a millimetre, four decimal places, which the markings cannot support. A record of 7.32 m, to the nearest centimetre, is what this tape justifies. Answer: The tape can only give the length to the nearest centimetre. The distractors: the nearest millimetre contradicts the markings described in the question, which are centimetres, and would still claim more accuracy than the tape offers; the rule that a length in metres must be written to 2 decimal places borrows the habit of writing money to the penny, when the accuracy of a length depends on the instrument; rounding to the nearest metre would throw away accuracy the tape genuinely provides.
- (b) 0.83333... — Divide 5 by 6 using long division. 5.000... ÷ 6: 50 ÷ 6 = 8 remainder 2, giving the first decimal digit 8. Bring down a 0 to make 20, and 20 ÷ 6 = 3 remainder 2 — the remainder 2 has reappeared, so from here the digit 3 repeats forever. This gives 5/6 = 0.83333... . Stopping after two decimal places and writing 0.83 treats the division as if it terminated, when the remainder never reaches zero. Shifting the decimal point one place too far to the left gives 0.083333..., the same digits divided by an extra power of ten. A slip in the long division itself, misreading a remainder, can produce the wrong repeating digit, 0.85555... .
- (b) 4/9 — Method: double the butter part of the ratio, keeping flour the same, find the new total, then write butter's part over the new total. Working: the new ratio is flour : butter = 5 : 4, since butter doubles from 2 to 4. New total = 5 + 4 = 9. Fraction of butter = 4/9. Answer: 4/9. 2/9 comes from forgetting to double the butter part and using the original value 2 over the new total of 9. 4/7 comes from doubling the butter part correctly to 4 but keeping the old total of 7 instead of working out the new total. 2/5 comes from using the original ratio 5:2 directly as butter over flour without doubling anything.
Build your own mix at the worksheet builder.