Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 8 × 10³ — Method: divide the capacity of the card by the size of one photograph, dividing the coefficients and subtracting the indices, then bring the coefficient back into the range 1 to 10. Working: 3.2 ÷ 4 = 0.8 and 10 − 6 = 4, which gives 0.8 × 10⁴; a coefficient of 0.8 is smaller than 1, so the decimal point moves one place to the right and the index falls by 1. Answer: 8 × 10³. The distractors: 8 × 10⁴ comes from correcting 0.8 to 8 without reducing the index, which makes the answer ten times too large; 1.28 × 10¹⁷ comes from multiplying the two numbers instead of dividing them, since 3.2 × 4 = 12.8 and 10 + 6 = 16; 8 × 10¹⁵ comes from dividing the coefficients but adding the indices instead of subtracting them.
- (a) £177.60 — Total raised = 240 × £1.85 = £444.00. The hospital receives 40% of this: £444.00 × 0.4 = £177.60. A candidate who works out the remaining 60% instead of the 40% given away gets £266.40. A candidate who forgets to find the percentage and gives the full total gets £444.00. A candidate who halves 40% by mistake and uses 20% gets £88.80.
- (c) 6.3 × 10⁷ — To add numbers in standard form, first write them with the same power of 10. 6 × 10⁷ = 60 × 10⁶, so the sum is 60 × 10⁶ + 3 × 10⁶ = 63 × 10⁶ = 6.3 × 10⁷. A candidate who added the A values without adjusting for the different powers worked out 6 + 3 = 9 and kept the larger power, writing 9 × 10⁷. A candidate who added the powers of 10 as if multiplying wrote 9 × 10¹³. A candidate who added the A values but used the smaller power wrote 9 × 10⁶.
- (a) 7/8, 17/20, 0.8, 78% — Method: convert every value to a decimal, then order the decimals from largest to smallest. Working: 7/8 = 0.875, 17/20 = 0.85, 0.8 = 0.8, 78% = 0.78. Ordering from largest to smallest gives 7/8, 17/20, 0.8, 78%. Answer: 7/8, 17/20, 0.8, 78%. '78%, 0.8, 17/20, 7/8' comes from ordering the converted decimals from smallest to largest instead of largest to smallest. '17/20, 7/8, 0.8, 78%' comes from converting 17/20 incorrectly as larger than 7/8, for example treating 17/20 as 0.87 instead of 0.85, swapping the top two. '7/8, 0.8, 17/20, 78%' comes from converting 17/20 incorrectly as equal to 0.8, swapping the middle two.
- (a) 2 × 3² × 5 — Method: divide repeatedly by the smallest prime number until only prime factors remain. Working: 90 ÷ 2 = 45, 45 ÷ 3 = 15, 15 ÷ 3 = 5, and 5 is prime, so 90 = 2 × 3 × 3 × 5, written as 2 × 3² × 5. 2 × 3 × 15 stops before the 15 is broken down into 3 × 5, so it is not fully factorised. 3 × 3 × 10 stops before the 10 is broken down into 2 × 5. 2 × 45 stops after only one division. Answer: 2 × 3² × 5.
- (a) 0.0069 — Leading zeros are not significant, so the significant figures in 0.006852 start at 6: 6, 8, 5, 2. Rounding to 2 significant figures means keeping 6 and 8, and looking at the next digit, 5, to decide whether to round up. Since 5 rounds up, the second significant figure increases from 8 to 9: 0.006852 rounds to 0.0069. A candidate who rounded to 1 significant figure instead of 2 wrote 0.007. A candidate who rounded to 3 significant figures instead of 2 wrote 0.00685. A candidate who did not round up despite the next digit being 5 wrote 0.0068.
- (d) 4/3 — Method: the product of two negative numbers is positive, so work with 2/5 × 10/3 and then simplify. Multiply the numerators together and the denominators together. Working: 2 × 10 = 20 and 5 × 3 = 15, giving 20/15; both 20 and 15 divide by 5, so 20/15 = 4/3. Answer: 4/3. The distractors: −4/3 has the arithmetic right but keeps a minus sign, from treating negative × negative as negative; 3/25 comes from turning the second fraction upside down and multiplying, which divides instead of multiplying and gives 2/5 × 3/10 = 6/50; −56/15 comes from adding the two fractions instead of multiplying them, giving −6/15 − 50/15.
- (a) 8.35 ≤ L < 8.45 — Method: a length rounded to 1 decimal place lies within half of 0.1 cm, that is 0.05 cm, of the value written down. The lower limit is included because it rounds up to that value, and the upper limit is excluded because it rounds up to the next value instead. Working: 8.4 − 0.05 = 8.35 and 8.4 + 0.05 = 8.45, so a length of 8.35 cm still rounds to 8.4 cm while a length of 8.45 cm rounds to 8.5 cm. Answer: 8.35 ≤ L < 8.45. The distractors: 8.3 ≤ L < 8.5 goes a whole 0.1 cm either side instead of half of it; 8.35 < L ≤ 8.45 has the two limits the wrong way round, excluding the length that does round to 8.4 cm and including the one that does not; 8.4 ≤ L < 8.5 is the interval for a length truncated to 1 decimal place, not one rounded to it.
- (a) x⁶ — Method: work through the powers in order — multiplying powers of the same base means adding indices, and dividing powers of the same base means subtracting indices. Working: first, x⁵ × x³ = x⁸ (adding 5 and 3); then x⁸ ÷ x² = x⁶ (subtracting 2 from 8). x⁴ comes from swapping the two rules — subtracting for the multiplication, 5 − 3 = 2, and then adding for the division, 2 + 2 = 4. x¹⁰ comes from adding all three indices, 5 + 3 + 2 = 10, treating the division the same as a multiplication. 6x comes from correctly reaching a total index of 6 but then writing it as a coefficient of x instead of as its power. Answer: x⁶.
- (c) 9π cm² — The area of a circle is π × r². With a radius of 3 cm this is π × 3² = 9π cm², and this is exact because π has not been replaced by any approximation. Writing 28.3 cm² replaces π with a rounded decimal value, 3.14, and then rounds the result again, so it is only an approximation. Writing 28.26 cm² uses π ≈ 3.14 without a final rounding step, but this is still only an approximation of 9π, not the exact value. Writing 27 cm² comes from replacing π with the rough approximation 3, which is even further from the true value.
- (a) 1,500 ≤ m < 2,500 — Method: a four-digit figure written to 1 significant figure has been rounded to the nearest 1,000, so the mass lies within half of 1,000, that is 500, of the figure given. Working: 2,000 − 500 = 1,500 and 2,000 + 500 = 2,500. The lower limit is included, because 1,500 kg rounds up to 2,000 kg to 1 significant figure, while 2,500 kg rounds up to 3,000 kg, so the upper limit is not. Answer: 1,500 ≤ m < 2,500. The distractors: 1,950 ≤ m < 2,050 comes from rounding to the nearest 100 instead of to 1 significant figure; 1,000 ≤ m < 3,000 goes a whole 1,000 either side instead of half of it; 1,500 < m ≤ 2,500 has the two limits the wrong way round.
- (b) 17 — Roots and powers are worked out first: √25 = 5 and 4² = 16. Division comes next: 12 ÷ 3 = 4. Then addition and subtraction, left to right: 5 + 16 − 4 = 17. A candidate who treated 4² as 4 × 2 = 8, multiplying the base by the exponent instead of squaring it, worked out 5 + 8 − 4 = 9. A candidate who did not evaluate the root and used 25 itself worked out 25 + 16 − 4 = 37. A candidate who ignored the priority of division and worked through 5 + 16 − 12 ÷ 3 strictly left to right got 5 + 16 = 21, then 21 − 12 = 9, then 9 ÷ 3 = 3.
- (a) to the nearest centimetre — Method: the error interval of a rounded measurement runs from half a unit below the stated value to half a unit above it, so the width of the interval is one whole unit of the accuracy used. Working: the interval runs from 24.5 to 25.5, a width of 25.5 − 24.5 = 1, so the unit of accuracy is 1 cm; the stated value is the midpoint, 25 cm, and 25 correct to the nearest centimetre is exactly what gives 24.5 ≤ L < 25.5. Answer: to the nearest centimetre. To the nearest 0.5 cm comes from reading the half-unit, 0.5, as the accuracy itself instead of doubling it back to the full unit. To 1 decimal place comes from seeing the bounds written with one decimal place and taking that as the accuracy, but the bounds of a value given to 1 decimal place would be only 0.05 either side. To the nearest 10 cm comes from confusing the size of the value, about 25, with the unit it was rounded to; rounding to the nearest 10 cm would give an interval 5 cm either side of the stated value.
- (c) An under-estimate, by 8 — Method: work out the exact product, then compare it with the estimate; an estimate that is smaller than the exact value is an under-estimate, and the difference between them is the size of the error. Working: 48 × 21 = 48 × 20 + 48 = 960 + 48 = 1,008, and 1,008 − 1,000 = 8, so the estimate falls short. Answer: an under-estimate, by 8. The distractors: an over-estimate by 8 has the size of the error right but the direction wrong, and comes from assuming that rounding 48 up to 50 must push the estimate above the exact value, without allowing for 21 being rounded down; an over-estimate by 19 comes from working out 48 × 21 as 48 × 20 + 21 = 981, adding a 21 where another 48 belongs; the claim that the estimate is exactly right comes from arguing that one number was rounded up and the other down, so the two changes must cancel.
- (a) 7 — Method: BIDMAS deals with the index first, then the multiplication, then the subtraction. Working: (−2)² = (−2) × (−2) = 4, then 3 × 4 = 12, and finally 12 − 5 = 7. Answer: 7. The distractors: −17 comes from squaring only the 2 and keeping the minus sign, giving 3 × (−4) = −12 and then −12 − 5 = −17; 31 comes from multiplying before applying the index, giving (3 × (−2))² = (−6)² = 36 and then 36 − 5 = 31; −3 comes from carrying out the subtraction before the multiplication, giving 3 × (4 − 5) = 3 × (−1) = −3.
Build your own mix at the worksheet builder.