Printable · GCSE Higher · ages 14-16
Number worksheet — GCSE Higher
Fifteen questions across the number statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Number worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) 0.7, 0.72, 3/4 — Method: numbers written in different forms cannot be compared as they stand, so every fraction is turned into a decimal by dividing the numerator by the denominator, and the decimals are then compared place by place from the left. Working: 3/4 means 3 ÷ 4 = 0.75, so the three values to compare are 0.7, 0.75 and 0.72; written to two decimal places they are 0.70, 0.75 and 0.72, and the hundredths digits 0, 5 and 2 put 0.70 first, 0.72 next and 0.75 last; written again in the forms the question used, the order from smallest is 0.7, then 0.72, then 3/4. Answer: 0.7, 0.72, 3/4. The distractors: 3/4, 0.7, 0.72 comes from turning 3/4 into 0.34 by writing the numerator and the denominator as the two digits after the point, which makes the fraction the smallest of the three; 0.72, 3/4, 0.7 comes from the belief that the more digits a decimal has the smaller it must be, which puts both 0.72 and 0.75 below 0.7 and 0.72 below 0.75; 3/4, 0.72, 0.7 comes from comparing the three values correctly but listing them largest first, against an instruction to start with the smallest.
- (c) −5 — Method: the bracket is worked out first, then the multiplication and the division, which stand as separate parts, and the subtraction that joins them is carried out last; subtracting a negative is the same as adding. Working: (−3) + 5 = 2, so the product is 2 × (−4) = −8; the division gives (−6) ÷ 2 = −3; joining them gives −8 − (−3) = −8 + 3 = −5. Answer: −5. The distractors: −11 comes from taking away 3 instead of taking away −3, giving −8 − 3 = −11; −1 comes from working from left to right once the bracket is done, giving −8 − (−6) = −2 and then −2 ÷ 2 = −1; 11 comes from treating the first product as positive because it was worked out from a bracket, giving 8 − (−3) = 11.
- (b) (2 + 3) × 5 − 1 — 2 + 3 = 5, then 5 × 5 = 25, then 25 − 1 = 24, so the brackets belong around 2 + 3. Placing them around 5 − 1 instead gives 5 − 1 = 4, then 3 × 4 = 12, then 2 + 12 = 14. Leaving the multiplication bracketed instead changes nothing, because it already had priority: 3 × 5 = 15, then 2 + 15 = 17, then 17 − 1 = 16. Bracketing both 2 + 3 and 5 − 1 uses two pairs instead of the one asked for: 2 + 3 = 5, 5 − 1 = 4, then 5 × 4 = 20.
- (b) 400 — Method: round each number to the nearest 100, then subtract the rounded values. Working: 812 rounds to 800 (nearest 100) and 397 rounds to 400 (nearest 100). 800 − 400 = 400. Answer: 400. 500 comes from rounding 397 down to 300 instead of up to the nearest 100, 400. 300 comes from rounding 812 down to 700 instead of up to the nearest 100, 800. 415 is the exact value of 812 − 397, found without rounding first, so it is not an estimate — the spreadsheet's answer of 315 is too far from the estimate of 400 to be correct.
- (c) 12.3 ≤ t < 12.4 — Method: truncating cuts the later digits off instead of rounding them, so nothing is ever pushed upwards. The displayed value is therefore the smallest the time can be, and the time can run up to, but not reach, the next value the display can show. Working: the display reads 12.3, so the actual time is at least 12.3 seconds; as soon as the time reaches 12.3 + 0.1 = 12.4 seconds the display would read 12.4, so 12.4 is not included. Answer: 12.3 ≤ t < 12.4. The distractors: 12.25 ≤ t < 12.35 is the interval for a time rounded to 1 decimal place, and this display does not round; 12.3 < t ≤ 12.4 excludes the one value the display certainly allows and includes the one it rules out; 12.3 ≤ t ≤ 12.4 treats 12.4 seconds as possible, but at 12.4 seconds the display would no longer read 12.3.
- (d) 2/25 — Method: write the decimal over 100 using its two decimal places, then simplify. Working: 0.08 = 8/100 = 2/25 (dividing both numerator and denominator by 4). Answer: 2/25. The student's fraction, 8/10, comes from ignoring the zero in the tenths column and reading 0.08 as though it were 0.8; it simplifies to 4/5. 1/125 comes from writing the decimal over 1000 instead of 100, as if there were three decimal places. 25/2 comes from flipping the correct fraction upside down.
- (d) 6 + 2√3 — Multiply √3 by each term in the bracket separately. First term: √3 × 2 = 2√3. Second term: √3 × √12 = √(3 × 12) = √36 = 6. Adding the two results in the order they were found, and writing the whole-number term first, gives 6 + 2√3. Adding the numbers under the root for the second term instead of multiplying them (3 + 12 = 15) gives √15 in place of 6, leading to √15 + 2√3. Multiplying √3 by the 2 but never distributing to the √12 term at all leaves just 2√3. Treating √3 × 2 as if the 3 were multiplied by the 2 inside the root, √3 × 2 → √6, while still getting the second term correct, gives 6 + √6.
- (c) 2 — First write 1 1/2 as an improper fraction, 3/2. To divide by 3/4, multiply by its reciprocal, 4/3: 3/2 × 4/3 = 12/6 = 2. Dropping the whole number and dividing only the fractional part, 1/2 ÷ 3/4 = 1/2 × 4/3, gives 2/3. Multiplying by 3/4 directly instead of using its reciprocal, 3/2 × 3/4, gives 9/8. Using the reciprocal of the first fraction instead of the second, 2/3 × 3/4, gives 1/2.
- (a) 8.35 ≤ L < 8.45 — Method: a length rounded to 1 decimal place lies within half of 0.1 cm, that is 0.05 cm, of the value written down. The lower limit is included because it rounds up to that value, and the upper limit is excluded because it rounds up to the next value instead. Working: 8.4 − 0.05 = 8.35 and 8.4 + 0.05 = 8.45, so a length of 8.35 cm still rounds to 8.4 cm while a length of 8.45 cm rounds to 8.5 cm. Answer: 8.35 ≤ L < 8.45. The distractors: 8.3 ≤ L < 8.5 goes a whole 0.1 cm either side instead of half of it; 8.35 < L ≤ 8.45 has the two limits the wrong way round, excluding the length that does round to 8.4 cm and including the one that does not; 8.4 ≤ L < 8.5 is the interval for a length truncated to 1 decimal place, not one rounded to it.
- (c) 22 — Without restriction there are 6 × 4 = 24 combinations. Two specific combinations are not available, so subtract 2: 24 − 2 = 22. 24 comes from ignoring the restriction completely. 23 comes from subtracting only 1 of the 2 excluded combinations. 18 comes from removing the whole sport trim level, 6 × 3 = 18, instead of removing just the two excluded combinations.
- (b) 12 — Method: round the number of pupils to the nearest 10, divide by the number of passengers each minibus can carry, then round up because a part-full minibus still needs a whole vehicle. Working: 179 rounds to 180 (nearest 10); 180 ÷ 16 = 11.25; 11 minibuses only carry 176 passengers, so a 12th minibus is needed for the rest. Answer: 12. 11 comes from rounding 11.25 to the nearest whole number in the usual way, without checking that the leftover pupils still need transporting. 10 comes from rounding 179 down to 170 instead of to the nearest 10, 180. 180 comes from stopping after rounding the number of pupils, without dividing by the number of passengers each minibus carries at all.
- (a) 2.5 × 10⁷ — Method: place the decimal point so that the coefficient is at least 1 and less than 10, then count the places it has moved. Working: the digits give a coefficient of 2.5, and the decimal point travels from the end of 25,000,000 until it sits between the 2 and the 5, a move of 7 places. Answer: 2.5 × 10⁷. The distractors: 25 × 10⁶ is the same area but not in standard form, because the coefficient must be less than 10; 2.5 × 10⁸ comes from counting the eight digits of 25,000,000 instead of the seven places the decimal point moves; 2.5 × 10⁻⁷ comes from making the index negative because the decimal point was carried to the left.
- (c) 62.35 ≤ r < 62.45 — Method: with a value rounded to 1 decimal place, the error interval reaches half of 0.1 either side. Working: half of 0.1 is 0.05, so the interval runs from 62.4 − 0.05 to 62.4 + 0.05. Answer: 62.35 ≤ r < 62.45. (62 ≤ r < 63 comes from rounding to the nearest whole number instead of 1 decimal place. 62.35 ≤ r ≤ 62.45 comes from including the upper bound with ≤ instead of excluding it with <. 62.3 ≤ r < 62.5 comes from using 0.1 either side instead of half of it.)
- (a) 1/5 — Work out the bracket first: 2 + 3 = 5. The reciprocal of 5 is 1/5. A candidate who forgot to take the reciprocal and just gave the value of the bracket wrote 5. A candidate who took the reciprocal but made a sign error wrote −1/5. A candidate who found the reciprocal of each number separately and added them, treating reciprocal as if it distributes over addition, worked out 1/2 + 1/3 = 5/6.
- (a) the nearest whole number — The error intervals are 23.5 ≤ p < 24.5 and 5.5 ≤ q < 6.5. The minimum of p ÷ q is 23.5 ÷ 6.5 ≈ 3.615, and the maximum is 24.5 ÷ 5.5 ≈ 4.455. Both of these round to 4 at the nearest whole number, so the answer is guaranteed correct to the nearest whole number — but not to the nearest 0.1, since 3.615 rounds to 3.6 while 4.455 rounds to 4.5, which do not agree. Claiming the nearest 0.1 assumes every figure a calculator shows is trustworthy, without checking whether the bounds actually agree that far. Claiming only the nearest 10 badly understates how much can be guaranteed here, since both bounds already round to 4, not merely to 0. Saying no degree of accuracy can be guaranteed gives up before checking whether the bounds agree at any level at all.
Build your own mix at the worksheet builder.