Printable · GCSE Higher · ages 14-16
Averages, spread and comparing distributions worksheet — GCSE Higher
Fifteen questions on "averages, spread and comparing distributions" — DfE statement S4. Print it, or print three versions so neighbours cannot copy by letter; the key gives the letter for each version.
part Higher
Answer key: Averages, spread and comparing distributions worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) 10 — Method: work out the mean that can be found straight away, then use total = mean × number of values on the group of three to find the missing number. Working: the mean of 15 and 25 is (15 + 25) ÷ 2 = 40 ÷ 2 = 20, so the group of three must also have a mean of 20; three numbers with a mean of 20 have a total of 20 × 3 = 60, and 20 + 30 = 50 of that total is already accounted for, so x = 60 − 50 = 10. Answer: 10, and checking, (10 + 20 + 30) ÷ 3 = 20. The distractors: 20 comes from working out the mean the two groups share and writing that down as x; −10 comes from dividing the group of three by 2 instead of by 3, which gives x + 50 = 40; 70 comes from reading the total 15 + 25 = 40 as the mean of the pair, which sets the target total at 120 and leaves x = 70.
- (c) Route 2, because its interquartile range is smaller — Method: for a journey where turning up on time matters, what matters is not the typical (median) time but how predictable it is — a smaller interquartile range means the middle half of journeys cluster closer together. Working: Route 1's median, 34 minutes, is in fact lower than Route 2's, 41 minutes, so Route 1 is faster on average; but Route 1's interquartile range, 22 minutes, is far larger than Route 2's, 6 minutes, so Route 1's times are much less predictable. Answer: Priya should choose Route 2, because its interquartile range is smaller, even though it is slower on average. Watch which statistic answers the question actually asked: Route 1 does not have the smaller interquartile range, Route 2 does, so picking Route 1 for that reason misreads the table; Route 1's median genuinely is the lower one, but a lower median answers 'which is faster', not 'which is more reliable'; and Route 2's median is not the lower one, so that claim about Route 2 is simply false.
- (d) 16 — Method: rearrange interquartile range = upper quartile − lower quartile to make the lower quartile the subject: lower quartile = upper quartile − interquartile range, then check the answer sits in the right place in the list. Working: there are 11 values, so 11 + 1 = 12; the upper quartile sits at position 3 × 12 ÷ 4 = 9, which is 35, and x sits at position 12 ÷ 4 = 3, which is the lower quartile. So x = 35 − 19 = 16, and 16 does sit between the 2nd value, 9, and the 4th value, 17, as it should. Answer: x = 16. Watch how you rearrange and where you count to: adding instead of subtracting, 35 + 19 = 54, treats the interquartile range as something added on rather than a gap taken away; subtracting in the wrong order, 19 − 35 = −16, finds the right two numbers but flips the sign; and counting to the 8th value instead of the 9th treats 31 as the upper quartile, giving 31 − 19 = 12, one position short of where the upper quartile actually sits.
- (c) 33 — Method: multiply the mean by the number of tests to get the total marks, then subtract the marks that are already known. Working: four tests with a mean of 29 give a total of 29 × 4 = 116 marks; the first three marks total 31 + 26 + 26 = 83; so the fourth mark is 116 − 83 = 33. Answer: 33, and checking, (31 + 26 + 26 + 33) ÷ 4 = 116 ÷ 4 = 29. The distractors: 116 comes from stopping at the total for all four tests; 29 comes from assuming the missing mark must be the mean itself; 4 comes from multiplying the mean by 3, the number of marks given, leaving 87 − 83 = 4.
- (c) 15 — Method: the interquartile range is the upper quartile take away the lower quartile, IQR = Q3 − Q1. Working: n + 1 = 15 + 1 = 16, so the lower quartile sits at position 16 ÷ 4 = 4, the 4th value in the list, which is 12; the upper quartile sits at position 3 × 4 = 12, the 12th value, which is 27. So 27 − 12 = 15. Answer: the interquartile range is 15 minutes. Watch which values you use and which way round: taking the smallest time away from the largest, 34 − 5 = 29, finds the range, which uses every value between the extremes rather than just the middle half; taking the median away from the upper quartile instead of the lower quartile, 27 − 19 = 8, swaps the median in for the lower quartile; and reversing the subtraction, 12 − 27 = −15, finds the right two values but in the wrong order — an interquartile range is never negative.
- (d) 29 — Method: with an even number of values there is no single middle value, so the median is the mean of the two values either side of the middle. Working: the six numbers are already in order and 6 ÷ 2 = 3, so the middle pair are the third and fourth values, 22 and 36; their mean is (22 + 36) ÷ 2 = 58 ÷ 2 = 29. Answer: 29, which lies between the two middle values as a median of an even data set must. The distractors: 22 comes from taking the lower of the two middle values and stopping there instead of averaging the pair; 36 comes from taking the larger value of that pair because it sits just past the halfway point of the list; 34 comes from working out the range, 47 − 13, instead of a measure of centre.
- (c) The mean, because every value counts towards it, so 100 pulls it from 7 up to about 20.3. — Method: work each measure out before the extra value is added and again afterwards, then compare the size of the two changes. Working: before, the six values total 42, so the mean is 42 ÷ 6 = 7, and the middle pair 6 and 8 give a median of (6 + 8) ÷ 2 = 7; after, the seven values total 142, so the mean is 142 ÷ 7 = 20.29 to 2 decimal places, while the median is now the 4th of the seven ordered values, which is 8; the mean has moved by about 13.3 and the median by 1. Answer: the mean, because every value counts towards it, so 100 pulls it from 7 up to about 20.3 — this is why the median is often preferred when a data set contains an outlier. The distractors: the reply that the mean rises by 100 adds the extra value to the mean instead of adding it to the total; the reply that the median moves to 12 takes the largest of the original values as the new middle instead of counting to the 4th of the seven values; the reply about even and odd counts quotes a rule that does not exist, since the median moved because a very large value was added, not because the count of values changed.
- (a) 62.5 — Method: a mean cannot be averaged with a new value — rebuild the total, add the new value to it, then divide by the new count. Working: three numbers with a mean of 50 have a total of 50 × 3 = 150; adding 100 makes the total 150 + 100 = 250; there are now 4 numbers, so the new mean is 250 ÷ 4 = 62.5. Answer: 62.5. The distractors: 75 comes from averaging the old mean with the new value, (50 + 100) ÷ 2, which ignores that three numbers pull against one; 50 comes from assuming an extra value leaves the mean unchanged; 37.5 comes from dividing the old total of 150 by the new count of 4, adding the new value to the count but not to the total.
- (a) 27 — Method: turn the mean into a total using total = mean × number of values, then subtract the numbers that are already known. Working: four numbers with a mean of 18 have a total of 18 × 4 = 72; the three known numbers give 10 + 15 + 20 = 45; so x = 72 − 45 = 27. Answer: 27, and checking, (10 + 15 + 20 + 27) ÷ 4 = 72 ÷ 4 = 18. The distractors: 72 comes from stopping at the total the four numbers must reach and never subtracting the known three; 18 comes from assuming the missing number must equal the mean; 45 comes from stopping at the total of the three known numbers.
- (c) Branch A waits longer, and Branch A is more consistent — Method: compare the two branches using a measure of location (the median) for who waits longer, and a measure of spread (the interquartile range) for who is more consistent — a smaller interquartile range means more consistent. Working: Branch A's median, 12 minutes, is higher than Branch B's, 9 minutes, so Branch A's customers wait longer on average. Branch A's interquartile range, 5 minutes, is smaller than Branch B's, 11 minutes, so Branch A's waiting times vary less. Answer: Branch A waits longer, and Branch A is also the more consistent of the two. Watch that each half of the comparison uses the right statistic and reads it correctly: swapping both readings gives Branch B the longer wait and the greater consistency, when neither is true; keeping the median comparison right but reading a larger interquartile range as 'more consistent' has the direction of spread backwards; and swapping only the median comparison keeps the correct branch for consistency but gives the wrong branch the longer wait.
- (c) 18 — Method: for n ordered values, GCSE convention places the lower quartile at position (n + 1) ÷ 4, counting from the smallest value. Working: there are 11 marks, so n + 1 = 11 + 1 = 12 and 12 ÷ 4 = 3, so the lower quartile is the 3rd value in the ordered list 12, 15, 18, 21, 24, 27, 30, 33, 36, 39, 42, which is 18. Answer: the lower quartile is 18 marks. Watch the position you count to: dividing 11 ÷ 4 = 2.75 without adding 1 first, then rounding down, lands on the 2nd value, 15, not the 3rd; reaching for the middle of the whole list instead gives the median, 27, a different statistic; and averaging the 3rd and 4th values, 18 + 21 = 39 and 39 ÷ 2 = 19.5, borrows a method for an even split where it is not needed here.
- (c) 76 marks — Method: a mean of means only works when the groups are the same size, so rebuild each class's total mark, add the totals and divide by the number of pupils altogether. Working: Class A scored 30 × 72 = 2160 marks and Class B scored 20 × 82 = 1640 marks, giving 2160 + 1640 = 3800 marks between 50 pupils, so the overall mean is 3800 ÷ 50 = 76 marks. Answer: 76 marks. The distractors: 77 marks comes from averaging the two class means, (72 + 82) ÷ 2, which ignores the different class sizes; 78 marks comes from attaching each mean to the other class's size, (30 × 82 + 20 × 72) ÷ 50; 3800 marks comes from stopping at the combined total and never dividing by 50.
- (a) 40 — Method: the mean is the total divided by how many values there are, so rearranging gives total = mean × number of values. Working: the mean is 8 and there are 5 numbers, so the total is 8 × 5 = 40. Answer: 40, and checking, 40 ÷ 5 = 8, which is the mean given. The distractors: 13 comes from adding the mean and the count, 8 + 5, instead of multiplying them; 1.6 comes from dividing the mean by the count, 8 ÷ 5, which reverses the relationship; 8 comes from quoting the mean itself as the total, which is only true when there is a single number.
- (d) 23.57 °C — Method: add all seven temperatures, divide by the number of readings and round only at the end. Working: 22 + 24 + 23 + 25 + 26 + 21 + 24 = 165, and 165 ÷ 7 = 23.5714…, which rounds to 23.57 to 2 decimal places. Answer: 23.57 °C. The distractors: 24 °C comes from writing down the mode, the only temperature recorded twice, instead of the mean; 27.5 °C comes from dividing the total by 6 instead of by the 7 days recorded; 5 °C comes from working out the range, 26 − 21, which is a measure of spread and not an average.
- (c) Class X has the higher median and the wider spread — Method: compare the two box plots statistic by statistic — median for location, and the interquartile range for spread — checking the true value of each rather than assuming a pattern. Working: Class X's median is 60 and Class Y's is 58, so Class X's median is the higher one. Class X's interquartile range is 70 − 45 = 25 and Class Y's is 65 − 50 = 15 (and the ranges follow the same order: 95 − 20 = 75 against 80 − 35 = 45), so Class X also has the wider spread. Answer: Class X has both the higher median and the wider spread. Watch that each half of a compound statement is checked separately: claiming Class Y has the higher median and the wider spread gets both comparisons backwards; claiming Class X has the higher median but the narrower spread keeps the median right while reading the spread the wrong way round; and claiming Class Y has the higher median but the narrower spread swaps the median comparison while getting the spread right.
Build your own mix at the worksheet builder.