Printable · GCSE Higher · ages 14-16
Statistics worksheet — GCSE Higher
Fifteen questions across the statistics statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Statistics worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) 210 — 350 − 150 = 200. 200 ÷ 10 = 20, so the gradient is 20. Using the point (5, 150): 20 × 5 = 100, so 150 − 100 = 50 is the intercept, giving the line y = 20x + 50. At x = 8: 20 × 8 = 160, and 160 + 50 = 210, so the estimated number of visitors is 210. Choosing 160 stops after 20 × 8 = 160 and forgets to add the intercept of 50. Choosing 250 comes from averaging the two given y-values: 150 + 350 = 500, and 500 ÷ 2 = 250, instead of using the line's equation. Choosing 240 assumes the visitors are directly proportional to the hours of sunshine using the first point, 150 × 8 ÷ 5 = 240, which ignores that the line does not pass through the origin.
- (a) Equal means; Class A is more consistent, smaller range. — Method: when two data sets share a measure of location, compare a measure of spread to say more about consistency. Working: both classes have the same mean mark, 14, so on average they performed equally well. Class A has the smaller range, 6, so its marks are more tightly grouped around 14 than Class B's marks, which vary by as much as 14. So Class A's marks were more consistent, even though neither class did better on average. Saying Class B did better because it has the bigger range confuses a wide spread with a high score — a big range describes variability, not performance. Saying Class A did better because it has the smaller range makes the same mistake in the other direction: the two classes are tied on the mean, so neither one 'did better'. Saying the classes cannot be compared because their means are equal misses the whole point of also comparing the range. Always compare both an average AND a spread before describing two data sets — either one alone tells only half the story.
- (a) x = 0 gives y = −20: a negative number sold — The y-intercept is the value the line predicts when x = 0: y = 3 × 0 − 20 = −20. A kiosk cannot sell a negative number of ice creams, so this is not a sensible estimate. The 3 in the equation is the gradient, not the intercept, so an option claiming x = 0 gives y = 3 has swapped the two numbers around — substituting x = 0 makes the 3x term equal 0, leaving −20, not 3. The danger of extrapolating to very high temperatures is a real issue with this line, but it is a different issue from the y-intercept, so it does not answer this question. And whether x = 0 could occur on a trading day is beside the point: the model still makes that prediction, and it is the prediction itself, −20, that is impossible.
- (b) Q was faster on average and more consistent — Method: compare the medians for the average and the interquartile ranges for the spread, remembering that a shorter time is faster and a smaller interquartile range means more consistent. Working: the median for class Q is 35 seconds against 38 seconds for class P, so class Q was faster on average; the interquartile range for class P is 46 − 24 = 22 seconds and for class Q it is 44 − 30 = 14 seconds, so class Q's times are more tightly grouped. Answer: class Q was faster on average and more consistent. The distractors: calling Q slower comes from comparing the lower quartiles, 30 against 24, as though a quartile were the average; calling Q less consistent comes from using the gap between the median and the upper quartile as the spread, 44 − 35 = 9 against 46 − 38 = 8, instead of the full interquartile range; the statement that Q was both slower and less consistent comes from making both of those mistakes together.
- (c) No, the mode here is the lowest value of the nine — Method: an average is meant to stand for the data as a whole, so test any proposed average by asking how many values it sits near. Working: the value 4 appears three times and every other count appears once, so 4 is indeed the mode. But those three hours are the quiet ones at the start of the day, and the other six counts run from 11 up to 25; putting the nine counts in order, the middle one is the fifth, which is 13. So the mode sits at the very bottom of the data, with six of the nine hours far above it. Answer: no, because the mode here is the lowest value of the nine, so it describes the quiet opening hours rather than a typical hour. The distractors: saying the mode can only be used when no value repeats reverses the definition, since a mode exists only because a value does repeat; saying the mode is the value that occurs most often is a correct definition, but being the commonest value does not make a value typical when it lies at one end of the data; saying the mode is the best average for any list of numbers ignores the fact that mean, median and mode each describe a population well in different circumstances.
- (c) The mean, because every value counts towards it, so 100 pulls it from 7 up to about 20.3. — Method: work each measure out before the extra value is added and again afterwards, then compare the size of the two changes. Working: before, the six values total 42, so the mean is 42 ÷ 6 = 7, and the middle pair 6 and 8 give a median of (6 + 8) ÷ 2 = 7; after, the seven values total 142, so the mean is 142 ÷ 7 = 20.29 to 2 decimal places, while the median is now the 4th of the seven ordered values, which is 8; the mean has moved by about 13.3 and the median by 1. Answer: the mean, because every value counts towards it, so 100 pulls it from 7 up to about 20.3 — this is why the median is often preferred when a data set contains an outlier. The distractors: the reply that the mean rises by 100 adds the extra value to the mean instead of adding it to the total; the reply that the median moves to 12 takes the largest of the original values as the new middle instead of counting to the 4th of the seven values; the reply about even and odd counts quotes a rule that does not exist, since the median moved because a very large value was added, not because the count of values changed.
- (a) A vertical line chart (discrete numerical data) — The number of pets is discrete numerical data — whole-number values such as 0, 1, 2, 3 or 4 — recorded for one variable, so a vertical line chart is the chart specified for this kind of data. A bar chart is used for categorical data, such as favourite colour, not numerical values counted like this. A pie chart shows proportions of a whole and does not show the frequency of each separate value. A scatter graph compares two different variables against each other, and only one variable, the number of pets, is recorded here.
- (b) 55 — Method: count the classes that lie wholly above 8 minutes, then use linear interpolation for the class that 8 cuts through, assuming the delays in that class are spread evenly. Working: the class 10 ≤ d < 20 lies wholly above 8 and holds 25 buses; the value 8 lies in the class 5 ≤ d < 10, which is 5 minutes wide and holds 75 buses, and the part above 8 runs from 8 to 10, a width of 2, so the estimated share is (2 ÷ 5) × 75 = 30 buses; the estimate is 30 + 25 = 55. Answer: about 55 refunds. The distractors: 100 comes from adding the whole of the class 5 ≤ d < 10, 75 + 25, and so refunding buses only 5 minutes late; 25 comes from using only the class 10 ≤ d < 20 and ignoring the part class that 8 minutes cuts through; 70 comes from taking the part of the class from 5 up to 8 instead of from 8 up to 10, giving (3 ÷ 5) × 75 = 45 and then 45 + 25.
- (b) 29 — There are 40 − 24 = 16 males, and 15 of them prefer cardio, so 16 − 15 = 1 male prefers weights. There are 24 females, and 10 prefer weights, so 24 − 10 = 14 females prefer cardio. Altogether, 15 + 14 = 29 people prefer cardio. Choosing 15 only counts the males who prefer cardio and forgets the females. Choosing 11 adds the two weights figures, 1 + 10 = 11, instead of the two cardio figures. Choosing 30 comes from 40 − 10, subtracting only the number of females who prefer weights from the grand total, rather than finding both cardio sub-totals separately.
- (a) No, the size of the fire affects both of the quantities — Method: correlation says that two quantities change together; a claim that one of them produces the other is a further claim, and it needs evidence that a scatter graph on its own cannot give. Working: the graph does show strong positive correlation, so more engines did go with greater damage. But neither quantity was set by the researchers: both were decided by how large the fire was. A large blaze brings many appliances and also destroys a great deal, while a small one brings few and destroys little, so a third quantity is driving both of the recorded ones. Answer: no, because the size of the fire affects both of the quantities. The distractors: saying the correlation is negative contradicts the graph, which shows the two quantities rising together, and reaching the right verdict from a false reading of the data is not the reason the mark is for; saying that strong positive correlation shows one quantity causes the other is the assumption the question exists to test, and no strength of correlation can establish cause; saying the points lie close to the line of best fit describes how strong the correlation is, and strength and cause are different matters entirely.
- (d) 25% — First find the number of fruit cakes: 80 − 34 − 26 = 20. Then write this as a percentage of the total: 20 ÷ 80 × 100 = 25%. Giving 20% comes from reporting the count of fruit cakes, 20, directly as a percentage, without dividing by the total of 80 first. Giving 32.5% computes the percentage of chocolate cakes instead of fruit cakes: 26 ÷ 80 × 100 = 32.5%. Giving 42.5% computes the percentage of sponge cakes instead of fruit cakes: 34 ÷ 80 × 100 = 42.5%.
- (c) No, 90 cm is far outside the heights on the graph — Method: a line of best fit describes the trend only across the stretch of data it was drawn through; predicting beyond that stretch is extrapolation, and nothing in the data supports it. Working: the heights used to draw this line run from 150 cm to 180 cm, all of them Year 10 pupils, while 90 cm is 60 cm below the shortest of them and belongs to a two-year-old child, whose build follows no trend the graph has measured. Substituting anyway gives 0.9 × 90 − 85 = −4, a mass of −4 kg, which cannot exist. Answer: no, because 90 cm is far outside the heights on the graph. The distractors: saying a line of best fit cannot be used to predict at all throws away its main purpose, since a prediction made between the plotted values is perfectly sound; saying the line passes through all 20 points misdescribes a line of best fit, which is drawn to follow the trend of the points and will normally pass through few of them; saying the equation works for any value put into it treats an equation fitted to Year 10 heights as a law of nature, and the mass of −4 kg shows what that assumption produces.
- (c) No — 8 from one class is too small to represent the school. — Method: judge reliability by asking whether the sample is both large enough, and spread across the population, relative to what it is meant to represent. Working: 8 pupils is a tiny fraction of the school's 1,000 pupils, and all 8 come from a single class rather than a range of year groups, so the sample is both too small and too narrow to represent the whole school reliably. She is not right. Saying any sample size gives an equally reliable estimate ignores that reliability generally improves with a larger, more representative sample. Saying the method is unreliable because it was not done online is not a reason connected to sample size or representativeness at all. Saying 8 is reliable because it is more than half her class compares the sample to the wrong population — the school has 1,000 pupils, not one class. Always judge a sample's size against the population it is meant to represent, not against a smaller group within it.
- (d) 25 — Method: the median is estimated at position n ÷ 2 in the cumulative frequency table, then interpolated across the class it falls in: lower boundary, plus the fraction of the way through the class, times the class width. Working: there are 80 sacks, so the median sits at position 80 ÷ 2 = 40. Before the class 20 ≤ m < 30 the cumulative frequency is 22, and by the end of it, it is 58, so this class holds the 40th sack; its frequency is 58 − 22 = 36 and its width is 30 − 20 = 10. The extra distance needed into the class is 40 − 22 = 18, and 18 ÷ 36 × 10 = 5, so the median is 20 + 5 = 25. Answer: the estimated median mass is 25 kg. Watch which numbers the interpolation uses: reading off just the lower boundary of the median class, 20, ignores how far into that class the 40th sack actually falls; treating n ÷ 2 = 40 itself as the median mass mistakes a position in the list for a mass in kilograms; and using the target position, 40, as the extra distance into the class instead of subtracting the sacks already counted changes the calculation to 20 + 40 ÷ 36 × 10. That comes to 20 + 11.1 = 31.1, overshooting the class because it never subtracts the 22 sacks already counted before it.
- (d) 38, and fairly confident, as 12 °C is inside the range — Method: substitute the forecast temperature into the equation of the line of best fit, then judge the prediction by where that temperature sits among the data the line was drawn from. Working: putting x = 12 into y = −3x + 74 gives −3 × 12 + 74 = 38, so the line predicts 38 hot chocolates. The recorded temperatures run from 4 °C to 18 °C, and 12 °C lies inside that interval, so this is interpolation, the safer kind of prediction. Answer: 38, and fairly confident, as 12 °C is inside the range; the owner should still expect the true figure to differ a little, since the points only lie near the line and not on it. The distractors: being completely certain treats a line of best fit as a rule that fixes each day's sales, when it describes a trend that individual days depart from; saying 12 °C is outside the range misreads the interval 4 °C to 18 °C, and the wrong warning would be attached to a sound prediction; 110 comes from −3 × 12 being taken as +36, giving 36 + 74 = 110, which loses the negative gradient and so predicts that a warm day sells more hot chocolate than a cold one.
Build your own mix at the worksheet builder.