Printable · GCSE Higher · ages 14-16
Statistics worksheet — GCSE Higher
Fifteen questions across the statistics statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Statistics worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 15 — Year 11 has 50 − 28 = 22 pupils in total. Of the 22 pupils who walk in total, 15 are in Year 10, so 22 − 15 = 7 Year 11 pupils walk. Subtracting that from the Year 11 total gives 22 − 7 = 15 Year 11 pupils who are driven. Choosing 28 takes the whole school's driven total, 50 − 22 = 28, and treats it as if it were Year 11's alone, without separating the year groups. Choosing 7 correctly finds how many Year 11 pupils walk but stops there, giving that figure instead of the number who are driven. Choosing 35 comes from 50 − 15, subtracting the Year 10 walkers from the whole school total rather than working within Year 11.
- (b) Q was faster on average and more consistent — Method: compare the medians for the average and the interquartile ranges for the spread, remembering that a shorter time is faster and a smaller interquartile range means more consistent. Working: the median for class Q is 35 seconds against 38 seconds for class P, so class Q was faster on average; the interquartile range for class P is 46 − 24 = 22 seconds and for class Q it is 44 − 30 = 14 seconds, so class Q's times are more tightly grouped. Answer: class Q was faster on average and more consistent. The distractors: calling Q slower comes from comparing the lower quartiles, 30 against 24, as though a quartile were the average; calling Q less consistent comes from using the gap between the median and the upper quartile as the spread, 44 − 35 = 9 against 46 − 38 = 8, instead of the full interquartile range; the statement that Q was both slower and less consistent comes from making both of those mistakes together.
- (a) Drawing 60 names at random from a list of all 1200 pupils — Method: a sample is random when every member of the population has the same chance of being chosen and nobody, including the pupils themselves, can influence who ends up in it; test each method against that. Working: drawing names from a list of all 1200 pupils gives each pupil the same chance, 60 out of 1200, whatever their year group, class or opinion, so the method is random. Answer: drawing 60 names at random from a list of all 1200 pupils. The distractors: asking the pupils who volunteer is self-selection, and the pupils with the strongest views volunteer first, so they decide the sample; asking the pupils nearest the door is convenience sampling, which reaches only those who happen to be in one place at one time; asking two Year 10 classes samples a cluster, so every pupil in the other year groups has no chance of being chosen at all.
- (c) 42 — Method: find the target cumulative frequency, 90% of the total, locate the class it falls in from the plotted points, then interpolate: lower boundary, plus the extra distance needed into the class divided by the class's frequency, times its width. Working: 90% of 320 is 0.9 × 320 = 288. The plotted points show a cumulative frequency of 280 at d = 40 and 320 at d = 50, so the class 40 ≤ d < 50 has frequency 320 − 280 = 40 and width 50 − 40 = 10, and 288 falls inside it. The extra distance needed into the class is 288 − 280 = 8, and 8 ÷ 40 × 10 = 2, so the diameter is 40 + 2 = 42. Answer: the estimated diameter is 42 mm. Watch which point and which class the interpolation actually uses: reading off d = 40, the plotted point just below the target, instead of interpolating the extra 8 ball bearings into the next 10 mm, stops one step short of the true answer; finding the diameter below which only 10% lie instead of 90% gives a target of 0.1 × 320 = 32, which falls in the class 10 ≤ d < 20 — the extra distance into that class is 32 − 30 = 2, and 2 ÷ 60 × 10 = 0.3, so this route gives 10 + 0.3 = 10.3, the bottom decile rather than the top 90%; and interpolating within the class 30 ≤ d < 40 instead of 40 ≤ d < 50, as though 288 had not yet reached a cumulative frequency of 280, treats the extra distance as 288 − 190 = 98, and 98 ÷ 90 × 10 = 10.9, giving 30 + 10.9 = 40.9, one class too early.
- (c) No, the mode here is the lowest value of the nine — Method: an average is meant to stand for the data as a whole, so test any proposed average by asking how many values it sits near. Working: the value 4 appears three times and every other count appears once, so 4 is indeed the mode. But those three hours are the quiet ones at the start of the day, and the other six counts run from 11 up to 25; putting the nine counts in order, the middle one is the fifth, which is 13. So the mode sits at the very bottom of the data, with six of the nine hours far above it. Answer: no, because the mode here is the lowest value of the nine, so it describes the quiet opening hours rather than a typical hour. The distractors: saying the mode can only be used when no value repeats reverses the definition, since a mode exists only because a value does repeat; saying the mode is the value that occurs most often is a correct definition, but being the commonest value does not make a value typical when it lies at one end of the data; saying the mode is the best average for any list of numbers ignores the fact that mean, median and mode each describe a population well in different circumstances.
- (d) 23.57 °C — Method: add all seven temperatures, divide by the number of readings and round only at the end. Working: 22 + 24 + 23 + 25 + 26 + 21 + 24 = 165, and 165 ÷ 7 = 23.5714…, which rounds to 23.57 to 2 decimal places. Answer: 23.57 °C. The distractors: 24 °C comes from writing down the mode, the only temperature recorded twice, instead of the mean; 27.5 °C comes from dividing the total by 6 instead of by the 7 days recorded; 5 °C comes from working out the range, 26 − 21, which is a measure of spread and not an average.
- (c) Because every pupil has an equal chance of being picked — Method: whether a sample represents its population is decided by the selection method, not by the size of the sample, so ask whether the method gives every member of the population the same chance of being chosen. Working: the names are drawn at random from a list of all 10,000 pupils, so each pupil has the same chance, 500 out of 10,000, of being drawn, and no group of pupils is more likely to appear than any other; that is what keeps bias out of the sample. Answer: because every pupil has an equal chance of being picked. The distractors: the reply about 5% treats the sampling fraction as the test of fairness, but a badly chosen 5% is still biased and a well chosen 1% is not; the reply about 500 being large enough makes size the test instead, which is the same mistake in another form, since a large sample drawn from one school would still misrepresent the city; the reply about the most willing pupils describes self-selection, which hands the choice of who is in the sample to the pupils who feel most strongly about the question.
- (b) Treat them as outliers and check them before deciding — Method: a point lying a long way from the pattern the rest of the data make is called an outlier, and an outlier is investigated before anything is done with it, because it may be an error in the data or it may be a genuine but unusual case. Working: 48 of the 50 points lie close to the rising line of best fit, so the trend is set by those 48; the two remaining points do not follow it, so they are identified as outliers and checked — a mistake in measuring or recording would be corrected, while a genuine reading would be kept and reported. Answer: treat them as outliers and check them before deciding what to do with them. The distractors: deleting them at once assumes that every point far from the line must be an error, which throws away real data; moving the line so that it passes through them assumes a line of best fit must touch particular points, when it is drawn to follow all 50; taking them as proof that there is no correlation lets two points overturn the pattern that the other 48 agree on.
- (b) £1,000 — Wages take up 150° out of 360°, so the amount spent on wages is 150 ÷ 360 × 2400 = £1,000. Choosing £600 uses the repairs angle, 90°, instead of the wages angle: 90 ÷ 360 × 2400 = 600. Choosing £3,600 treats the angle in degrees as if it were a percentage, 150 ÷ 100 × 2400 = 3600, instead of dividing by 360°. Choosing £800 uses the angle for the 'other costs' sector, 360 − 90 − 150 = 120°, instead of the wages sector: 120 ÷ 360 × 2400 = 800.
- (c) 76 — Method: the frequency of each class is the area of its bar, frequency density × class width, so work out all three frequencies and add them. Working: the widths are 5, 10 and 25 kg, so the frequencies are 4 × 5 = 20, 2.6 × 10 = 26 and 1.2 × 25 = 30; the total is 20 + 26 + 30 = 76. Answer: 76 dogs. The distractors: 7.8 comes from adding the three frequency densities, 4 + 2.6 + 1.2, treating each height as though it were a count; 107 comes from using each upper class boundary as the width, giving 4 × 5, 2.6 × 15 and 1.2 × 40; 39 comes from using the first class width, 5, for every bar, which ignores the unequal intervals and gives 20 + 13 + 6.
- (b) All 2,000 members of the sports centre. — Method: in a survey, the population is the whole group the survey is trying to find out about, and the sample is the smaller group actually asked. Working: this survey wants to know what the sports centre's members think, so the population is every one of the 2,000 members — whether or not they were personally asked. Saying the population is the 100 members who were asked names the sample, not the population; the sample is drawn FROM the population, so it is smaller than it, not the same as it. Saying the population is everybody who lives in Ipswich widens the group far beyond who the survey is actually about — plenty of Ipswich residents are not members of the sports centre at all, so they are outside this survey altogether. Saying the population is the members who say they are unhappy confuses the population with a result of the survey: whether a member turns out to be happy or unhappy is something the survey finds out, not part of the definition of who is being studied. The population is always the whole group the question is about, before any sampling or any results come in.
- (b) Town B — higher median and smaller IQR — Method: 'higher and more consistent' needs two comparisons — the median for typical price, and the interquartile range for spread, with a smaller interquartile range meaning more consistent. Working: Town B's median, £235,000, is higher than Town A's, £220,000. Town A's interquartile range is 310 − 180 = 130 and Town B's is 260 − 175 = 85, so Town B's interquartile range is the smaller of the two. Answer: Town B has both the higher median and the smaller interquartile range, so it is the town with higher, more consistent prices. Watch which combination of median and interquartile range each statement claims, and for which town: claiming Town A has the higher median and the smaller interquartile range gets both comparisons wrong, since Town B leads on both; claiming Town A has the higher median (still wrong) but the larger interquartile range at least reads the spread correctly, without it rescuing the false median claim; and claiming Town B has the higher median (correct) but the larger interquartile range misreads the spread — Town B's interquartile range is the smaller of the two, not the larger.
- (d) 45 — Method: convert the angle into a fraction of the full circle, 360°, then apply that fraction to the total number of shoppers. Working: the card sector is 90° out of 360°, a fraction of 90 ÷ 360 = 0.25. Applying that fraction to the 180 shoppers gives 0.25 × 180 = 45 shoppers. Giving 90 states the angle itself, not a number of shoppers — the angle first has to be converted into a fraction. Using the remaining angle, 360 − 90 = 270°, and scaling that, 270 ÷ 360 × 180 = 135, finds the number who did NOT pay by card, not the number who did. Dividing 360 by 90, 360 ÷ 90 = 4, finds how many equal 90° sectors fit in the circle, a fact about the pie chart's shape, not about the shoppers at all. Always convert the angle to a fraction of 360° first, and apply that same fraction to the total number of people.
- (a) Minutes a candle has burned and length remaining — As a candle burns for longer, less of it remains, so these two variables move in opposite directions as one increases — that is negative correlation. A pupil's shoe size generally increases as they get older, so age and shoe size show positive correlation, not negative, since both rise together. A football team's shirt colour is not a numerical quantity linked to how many matches it wins, so shirt colour and number of wins show no correlation at all. The number of letters in a pupil's name has no real connection to their ability in maths, so that pair also shows no correlation.
- (d) 38, and fairly confident, as 12 °C is inside the range — Method: substitute the forecast temperature into the equation of the line of best fit, then judge the prediction by where that temperature sits among the data the line was drawn from. Working: putting x = 12 into y = −3x + 74 gives −3 × 12 + 74 = 38, so the line predicts 38 hot chocolates. The recorded temperatures run from 4 °C to 18 °C, and 12 °C lies inside that interval, so this is interpolation, the safer kind of prediction. Answer: 38, and fairly confident, as 12 °C is inside the range; the owner should still expect the true figure to differ a little, since the points only lie near the line and not on it. The distractors: being completely certain treats a line of best fit as a rule that fixes each day's sales, when it describes a trend that individual days depart from; saying 12 °C is outside the range misreads the interval 4 °C to 18 °C, and the wrong warning would be attached to a sound prediction; 110 comes from −3 × 12 being taken as +36, giving 36 + 74 = 110, which loses the negative gradient and so predicts that a warm day sells more hot chocolate than a cold one.
Build your own mix at the worksheet builder.