Printable · GCSE Higher · ages 14-16
Statistics worksheet — GCSE Higher
Fifteen questions across the statistics statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Statistics worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) The data show a link only; a third factor may affect both — Method: a study of this kind measures two quantities and reports how they change together; deciding that one of them produces the other is a further claim, and it needs evidence that the measurements alone cannot give. Working: the study shows that more coffee goes with better concentration, which is a positive correlation; but a third factor that was never measured, such as how motivated someone is, could raise both the coffee drinking and the concentration, and the concentration could equally be what leads to the extra coffee. Answer: the data show a link only, because a third factor may be affecting both quantities, so no claim about cause can be made. The distractors: calling the conclusion safe because the correlation is positive treats the direction of a correlation as proof of cause, which no direction can give; calling it wrong because the correlation is negative misreads the direction of the relationship, since the study reports both quantities rising together; saying the two quantities are not linked denies the correlation the study actually found, when what fails is only the claim about cause.
- (d) An outlier from the damaged wing, not the trend. — That bird's point lies a long way from the rising trend followed by every other bird, and its low wingspan is explained by the damaged wing rather than by its age — it is an outlier caused by an unusual factor, not part of the general relationship between age and wingspan, so it should not be used when drawing the line of best fit. Saying every point must be used ignores that an outlier caused by a separate, identifiable factor can rightly be set aside. Saying it shows no correlation ignores that the other 19 points do show a clear rising trend; one outlier does not remove that. Saying it proves the line is inaccurate confuses one unusual bird with a fault in the line itself, when the line correctly describes the trend followed by the rest of the data.
- (a) x = 0 gives y = −20: a negative number sold — The y-intercept is the value the line predicts when x = 0: y = 3 × 0 − 20 = −20. A kiosk cannot sell a negative number of ice creams, so this is not a sensible estimate. The 3 in the equation is the gradient, not the intercept, so an option claiming x = 0 gives y = 3 has swapped the two numbers around — substituting x = 0 makes the 3x term equal 0, leaving −20, not 3. The danger of extrapolating to very high temperatures is a real issue with this line, but it is a different issue from the y-intercept, so it does not answer this question. And whether x = 0 could occur on a trading day is beside the point: the model still makes that prediction, and it is the prediction itself, −20, that is impossible.
- (c) Neither causes the other; sunshine links both. — Both ice cream sales and sunburn cases tend to rise on hot, sunny days, so the amount of sunshine is a third factor linked to both — neither variable causes the other. Saying ice cream sales cause the sunburn assumes a causal link in one direction that the correlation alone cannot establish. Saying sunburn cases cause the ice cream sales assumes the reverse causal link, which is no more justified. Saying a strong correlation always means causation is the general error this question is testing: correlation, however strong, does not by itself prove that one variable causes the other.
- (a) 26 — Method: a line of best fit lets one quantity be predicted from the other, so the score is substituted into the equation of the line and the resulting inequality is solved for the number of hours. Working: a score of at least 80 means 2.5x + 15 ≥ 80; taking 15 from both sides gives 2.5x ≥ 65, and dividing both sides by 2.5 gives x ≥ 26, so the least whole number of hours is 26. Checking, 2.5 × 26 + 15 = 80, which does reach the target. Answer: 26 hours — and this is only an estimate, because a line of best fit predicts a trend rather than an individual result, and a prediction made outside the range of hours the pupils actually revised for would be an extrapolation and less reliable still. The distractors: 27 comes from reaching 26 and then rounding up again, although 26 hours already gives a score of exactly 80; 32 comes from 80 ÷ 2.5, which ignores the 15 in the equation of the line; 38 comes from (80 + 15) ÷ 2.5, that is from adding the 15 instead of subtracting it when rearranging.
- (c) 76 — Method: the frequency of each class is the area of its bar, frequency density × class width, so work out all three frequencies and add them. Working: the widths are 5, 10 and 25 kg, so the frequencies are 4 × 5 = 20, 2.6 × 10 = 26 and 1.2 × 25 = 30; the total is 20 + 26 + 30 = 76. Answer: 76 dogs. The distractors: 7.8 comes from adding the three frequency densities, 4 + 2.6 + 1.2, treating each height as though it were a count; 107 comes from using each upper class boundary as the width, giving 4 × 5, 2.6 × 15 and 1.2 × 40; 39 comes from using the first class width, 5, for every bar, which ignores the unequal intervals and gives 20 + 13 + 6.
- (c) The mean, because every value counts towards it, so 100 pulls it from 7 up to about 20.3. — Method: work each measure out before the extra value is added and again afterwards, then compare the size of the two changes. Working: before, the six values total 42, so the mean is 42 ÷ 6 = 7, and the middle pair 6 and 8 give a median of (6 + 8) ÷ 2 = 7; after, the seven values total 142, so the mean is 142 ÷ 7 = 20.29 to 2 decimal places, while the median is now the 4th of the seven ordered values, which is 8; the mean has moved by about 13.3 and the median by 1. Answer: the mean, because every value counts towards it, so 100 pulls it from 7 up to about 20.3 — this is why the median is often preferred when a data set contains an outlier. The distractors: the reply that the mean rises by 100 adds the extra value to the mean instead of adding it to the total; the reply that the median moves to 12 takes the largest of the original values as the new middle instead of counting to the 4th of the seven values; the reply about even and odd counts quotes a rule that does not exist, since the median moved because a very large value was added, not because the count of values changed.
- (b) £1,000 — Wages take up 150° out of 360°, so the amount spent on wages is 150 ÷ 360 × 2400 = £1,000. Choosing £600 uses the repairs angle, 90°, instead of the wages angle: 90 ÷ 360 × 2400 = 600. Choosing £3,600 treats the angle in degrees as if it were a percentage, 150 ÷ 100 × 2400 = 3600, instead of dividing by 360°. Choosing £800 uses the angle for the 'other costs' sector, 360 − 90 − 150 = 120°, instead of the wages sector: 120 ÷ 360 × 2400 = 800.
- (b) Q was faster on average and more consistent — Method: compare the medians for the average and the interquartile ranges for the spread, remembering that a shorter time is faster and a smaller interquartile range means more consistent. Working: the median for class Q is 35 seconds against 38 seconds for class P, so class Q was faster on average; the interquartile range for class P is 46 − 24 = 22 seconds and for class Q it is 44 − 30 = 14 seconds, so class Q's times are more tightly grouped. Answer: class Q was faster on average and more consistent. The distractors: calling Q slower comes from comparing the lower quartiles, 30 against 24, as though a quartile were the average; calling Q less consistent comes from using the gap between the median and the upper quartile as the spread, 44 − 35 = 9 against 46 − 38 = 8, instead of the full interquartile range; the statement that Q was both slower and less consistent comes from making both of those mistakes together.
- (c) 27 — Method: a frequency is the area of the part of the bar being asked about, so frequency = frequency density × the width of that part. Working: the part asked about runs from 20 to 35, so its width is 35 − 20 = 15 metres; the frequency density there is 1.8 per metre, so the estimate is 1.8 × 15 = 27. Answer: about 27 throws. The distractors: 72 comes from taking the whole bar, 1.8 × 40, and so counting every throw from 20 up to 60; 1.8 comes from reading the height of the bar as a frequency, when a height is a density and only an area is a count; 63 comes from using the upper value 35 as the width, 1.8 × 35, instead of the width 35 − 20.
- (c) No — median £505 at A vs £510 at B. — Branch A's seven wages in order are £480, £495, £500, £505, £510, £515 and £1,200, so the median, the 4th value, is £505. Branch B's in order are £480, £490, £500, £510, £520, £530 and £540, so the median is £510. Since £505 is lower than £510, the median wage is not higher at Branch A, so the claim is not fairly supported. Choosing 'Yes — mean £600.71 at A vs £510 at B' uses the mean: 480 + 495 + 500 + 505 + 510 + 515 + 1200 = 4205, and 4205 ÷ 7 = 600.71, a figure pulled upward by the £1,200 outlier that does not represent a typical wage. Choosing 'Yes — median £515 at A vs £510 at B' miscounts the middle position, taking the 6th wage, £515, instead of the correct 4th value, £505. Choosing 'Yes — highest wage £1,200 at A vs £540 at B' compares the highest wage at each branch rather than a measure of the typical, or average, wage.
- (d) Only internet users reach the website; others are excluded. — Method: a sample is biased when it systematically leaves out part of the population, or systematically over-represents another part. Working: anyone without internet access, or who does not visit the council's website, has NO chance of being included — the sample is drawn only from internet-using residents, which is not the whole town. Saying too many people might respond because the survey is free confuses bias with sample size — bias is about who CAN be reached, not how many respond. Saying people might lie describes a different problem, response honesty, not who was sampled in the first place. Saying online surveys cannot be anonymous is not a reason connected to bias at all. A sample is biased when part of the population has no chance of being included, whatever the reason for that.
- (d) 648 kg — Method: to estimate a total from a sample, multiply the sample's mean by the number of items in the whole population, then check the units the question asks for. Working: 32.4 g × 20,000 = 648,000 g. Converting to kilograms, 648,000 ÷ 1,000 = 648 kg. This is only an estimate, not an exact total, because it assumes every one of the 20,000 packets has exactly the sample mean mass, when in reality individual packets vary above and below it. Giving 1.62 kg multiplies the mean by 50, the SAMPLE size, instead of by 20,000, the number of packets actually made that day — this finds the total mass of the 50 sampled packets, not the day's production. Giving 32.4 kg treats the sample mean itself, in grams, as if it already were the day's total mass in kilograms, skipping the scaling up altogether. Giving 648,000 kg correctly scales the mean up to the whole day's production but never converts the answer from grams to kilograms, leaving it 1,000 times too large. Always scale a sample's mean up by the SIZE OF THE WHOLE POPULATION, and always finish by checking the units the question asks for.
- (b) 55 — Method: count the classes that lie wholly above 8 minutes, then use linear interpolation for the class that 8 cuts through, assuming the delays in that class are spread evenly. Working: the class 10 ≤ d < 20 lies wholly above 8 and holds 25 buses; the value 8 lies in the class 5 ≤ d < 10, which is 5 minutes wide and holds 75 buses, and the part above 8 runs from 8 to 10, a width of 2, so the estimated share is (2 ÷ 5) × 75 = 30 buses; the estimate is 30 + 25 = 55. Answer: about 55 refunds. The distractors: 100 comes from adding the whole of the class 5 ≤ d < 10, 75 + 25, and so refunding buses only 5 minutes late; 25 comes from using only the class 10 ≤ d < 20 and ignoring the part class that 8 minutes cuts through; 70 comes from taking the part of the class from 5 up to 8 instead of from 8 up to 10, giving (3 ÷ 5) × 75 = 45 and then 45 + 25.
- (b) A person's shoe size and their favourite colour — A person's shoe size is not linked to which colour they prefer, so these two show no correlation. The other three pairs are all genuinely correlated: distance travelled and fuel used rise together, which is positive correlation; hours of revision and test score generally rise together, which is also positive correlation; and as outdoor temperature rises, fewer woolly hats are sold, which is negative correlation. Negative correlation is still a real relationship between two variables — it is not the same thing as no relationship at all, so the temperature and hats pair is not the answer to this question.
Build your own mix at the worksheet builder.