Printable · GCSE Higher · ages 14-16
Statistics worksheet — GCSE Higher
Fifteen questions across the statistics statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Statistics worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) 120, unreliable — x = 25 is outside 1 to 12 — The line of best fit is y = 4x + 20. 4 × 25 = 100, and 100 + 20 = 120, so the estimate is y = 120. But x = 25 lies far outside the plotted range of 1 to 12 years, so this is an extrapolation, and the estimate is not reliable. Reaching 100 instead of 120 comes from 4 × 25 = 100 with the intercept of 20 left out — still correctly flagged as unreliable, but the wrong value. Calling the estimate reliable simply because it was calculated correctly, giving 120, wrongly assumes that a correct calculation is automatically trustworthy, ignoring that x = 25 lies far beyond the data actually collected. Reaching 68, from 4 × 12 = 48 and 48 + 20 = 68, substitutes x = 12, the top of the plotted range, instead of the assistant's actual x = 25, and wrongly calls that reliable because 12 lies inside the range.
- (a) No, the size of the fire affects both of the quantities — Method: correlation says that two quantities change together; a claim that one of them produces the other is a further claim, and it needs evidence that a scatter graph on its own cannot give. Working: the graph does show strong positive correlation, so more engines did go with greater damage. But neither quantity was set by the researchers: both were decided by how large the fire was. A large blaze brings many appliances and also destroys a great deal, while a small one brings few and destroys little, so a third quantity is driving both of the recorded ones. Answer: no, because the size of the fire affects both of the quantities. The distractors: saying the correlation is negative contradicts the graph, which shows the two quantities rising together, and reaching the right verdict from a false reading of the data is not the reason the mark is for; saying that strong positive correlation shows one quantity causes the other is the assumption the question exists to test, and no strength of correlation can establish cause; saying the points lie close to the line of best fit describes how strong the correlation is, and strength and cause are different matters entirely.
- (b) £11.00 — 1.5 × 6 = 9, and 9 + 2 = 11, so the estimated cost is £11.00. Choosing £9.00 stops after 1.5 × 6 = 9 and forgets to add the £2. Choosing £12.00 adds the mass and the constant first and then multiplies: 6 + 2 = 8, and 8 × 1.5 = 12.00. Choosing £13.50 swaps the gradient and the intercept, using y = 2x + 1.5 instead: 2 × 6 = 12, and 12 + 1.5 = 13.50.
- (b) £1,000 — Wages take up 150° out of 360°, so the amount spent on wages is 150 ÷ 360 × 2400 = £1,000. Choosing £600 uses the repairs angle, 90°, instead of the wages angle: 90 ÷ 360 × 2400 = 600. Choosing £3,600 treats the angle in degrees as if it were a percentage, 150 ÷ 100 × 2400 = 3600, instead of dividing by 360°. Choosing £800 uses the angle for the 'other costs' sector, 360 − 90 − 150 = 120°, instead of the wages sector: 120 ÷ 360 × 2400 = 800.
- (a) A vertical line chart (discrete numerical data) — The number of pets is discrete numerical data — whole-number values such as 0, 1, 2, 3 or 4 — recorded for one variable, so a vertical line chart is the chart specified for this kind of data. A bar chart is used for categorical data, such as favourite colour, not numerical values counted like this. A pie chart shows proportions of a whole and does not show the frequency of each separate value. A scatter graph compares two different variables against each other, and only one variable, the number of pets, is recorded here.
- (b) 6 — Method: frequency density = frequency ÷ class width. Working: the class 12 ≤ h < 18 has width 18 − 12 = 6, so frequency density = 36 ÷ 6 = 6. Answer: the frequency density is 6 seedlings per cm. Watch which numbers you use: taking the lower bound, 12, as the width instead of 18 − 12 = 6 gives 36 ÷ 12 = 3; dividing the total number of seedlings, 90, rather than this class's frequency, 36, by the width gives 90 ÷ 6 = 15, a density that belongs to no single class; and multiplying instead of dividing gives 36 × 6 = 216, far too large a density for so narrow a class.
- (a) 49 — Method: add the frequencies of the classes that lie wholly below 35 seconds, then use linear interpolation for the class that 35 cuts through, assuming the calls in that class are spread evenly across it. Working: below 30 seconds there are 15 + 24 = 39 calls; the value 35 lies in the class 30 ≤ t < 50, which is 20 seconds wide and holds 40 calls, and 35 is 35 − 30 = 5 seconds into it, so the estimated share is (5 ÷ 20) × 40 = 10 calls; the estimate is 39 + 10 = 49. Answer: about 49 calls met the target. The distractors: 79 comes from adding the whole of the class 30 ≤ t < 50, 39 + 40, and so counting calls of up to 50 seconds as being under 35; 39 comes from stopping at the class boundary 30 and ignoring the part class altogether; 69 comes from measuring the part of the class from 35 up to 50 instead of from 30 up to 35, giving (15 ÷ 20) × 40 = 30 and then 39 + 30.
- (c) 72° — The angle is 12 ÷ 60 × 360 = 72°. Choosing 150° divides football's frequency of 25 instead of badminton's 12: 25 ÷ 60 × 360 = 150. Choosing 20° finds badminton as a percentage of the members, 12 ÷ 60 × 100 = 20, rather than an angle in degrees. Choosing 90° uses 48, the total of the other three activities, as the total instead of the full 60 members: 12 ÷ 48 × 360 = 90.
- (c) 46 — Method: the cumulative frequency table gives the number of runners below each time; to find the number at or above a time, subtract that cumulative frequency from the total. Working: the cumulative frequency for t < 40 is 74, so 120 runners in total take away the 74 who finished in under 40 minutes: 120 − 74 = 46. Answer: 46 runners took 40 minutes or longer. Watch which boundary and which subtraction you use: reading off t < 50 instead of t < 40 and subtracting, 120 − 110 = 10, answers a different question, '50 minutes or longer'; giving 74 itself as the answer reports how many finished below 40 minutes, the opposite of what was asked; and subtracting the two nearby cumulative frequencies, 110 − 74 = 36, finds how many took between 40 and 50 minutes, not everyone from 40 minutes upward.
- (d) 23.57 °C — Method: add all seven temperatures, divide by the number of readings and round only at the end. Working: 22 + 24 + 23 + 25 + 26 + 21 + 24 = 165, and 165 ÷ 7 = 23.5714…, which rounds to 23.57 to 2 decimal places. Answer: 23.57 °C. The distractors: 24 °C comes from writing down the mode, the only temperature recorded twice, instead of the mean; 27.5 °C comes from dividing the total by 6 instead of by the 7 days recorded; 5 °C comes from working out the range, 26 − 21, which is a measure of spread and not an average.
- (d) 60 — Method: on a histogram the frequency of a class is its frequency density × its class width, and the frequencies of all the classes add up to the total, so turn each labelled bar into a frequency and subtract their total from 250. Working: 10 ≤ age < 20 has width 20 − 10 = 10, so its frequency is 4.5 × 10 = 45; 20 ≤ age < 35 has width 35 − 20 = 15, so its frequency is 6 × 15 = 90; 50 ≤ age < 70 has width 70 − 50 = 20, so its frequency is 2.75 × 20 = 55. Those three come to 45 + 90 + 55 = 190, and the total is 250, so the missing frequency is 250 − 190 = 60. Answer: the class 35 ≤ age < 50 has 60 members. Watch what you do with the total and the three frequencies you have found: giving the total, 250, as the answer forgets that three bars have already accounted for some of the members; giving 190, the total of the other three classes, reports how many members are not in this class rather than how many are; and leaving one of the three out of the subtraction, for example 45 + 90 = 135 and 250 − 135 = 115, still owes the class at 50 ≤ age < 70 its 55 members.
- (d) 19 kg — Method: estimate the mean of grouped data by multiplying each class's midpoint by its frequency, adding the four totals, then dividing by the total frequency. Working: the midpoints are 5, 15, 25 and 35 kg. The weighted totals are 11 × 5 = 55, 5 × 15 = 75, 5 × 25 = 125 and 9 × 35 = 315, which add to 570. Dividing by the 30 dogs gives an estimate of 570 ÷ 30 = 19 kg. Giving 5 kg reads off the midpoint of the modal class, 0 < m ≤ 10, the class with the most dogs — but the class with the most dogs is not where the mean falls, and neither is a substitute for actually calculating it. Giving 20 kg averages the four midpoints, (5 + 15 + 25 + 35) ÷ 4, treating every class as equally likely and ignoring that far more dogs are in the lightest and heaviest classes than in the middle two. Giving 570 kg stops after finding the correct weighted total and forgets the final division by the 30 dogs. Always weight each midpoint by its own frequency, and always finish by dividing by the total frequency, not the number of classes.
- (c) 156 cm — Method: to combine two groups' means, multiply each group's mean by its own number of pupils, add the two totals together, then divide by the total number of pupils in both groups. Working: 20 × 150 = 3,000 cm for the boys and 10 × 168 = 1,680 cm for the girls, giving a combined total of 3,000 + 1,680 = 4,680 cm. Dividing by all 30 pupils gives 4,680 ÷ 30 = 156 cm. Giving 159 cm averages the two means, (150 + 168) ÷ 2, treating the two groups as if they had the same number of pupils, when there are twice as many boys as girls. Giving 4,680 cm finds the correct combined total height but stops there, forgetting the final division by the 30 pupils. Giving 234 cm divides the combined total by 20, the number of boys only, forgetting that the total also includes the 10 girls. Always weight each mean by its own group size, and always divide by the TOTAL number of pupils in both groups combined.
- (c) 90 — Method: the height of a bar is its frequency density, so twice as tall means twice the frequency density — not twice the frequency, because the two classes have different widths. Then frequency = frequency density × class width. Working: the first bar has frequency density 3 per cm, so the second has frequency density 2 × 3 = 6 per cm; the class 30 ≤ x < 45 is 45 − 30 = 15 cm wide, so its frequency is 6 × 15 = 90. Answer: 90 rods. The distractors: 120 comes from doubling the first bar's frequency instead of its height — the first class holds 3 × 20 = 60 rods, and doubling that ignores the fact that the second class is narrower; 45 comes from using the first bar's frequency density, 3, for the second bar, 3 × 15, and so never using the information that it is twice as tall; 6 comes from stopping at the frequency density of the taller bar and quoting a height as though it were a count.
- (b) On average a plant grew 1.5 cm taller for each extra day — Method: in the equation of a line, the number multiplying x is the gradient, and a gradient states the change in y produced by an increase of 1 in x, read in the units of the two axes. Working: here x is measured in days and y in centimetres, so the gradient 1.5 carries the units centimetres per day. Testing it on the line, 5 days gives 1.5 × 5 + 4 = 11.5 cm and 6 days gives 1.5 × 6 + 4 = 13 cm, a rise of 1.5 cm for the one extra day. Answer: on average a plant grew 1.5 cm taller for each extra day of watering. The distractors: 1.5 cm as the height before any watering is the value of y when x is 0, which is the other number in the equation, 4 cm, so this swaps the gradient and the intercept; 1.5 cm as the gap between the tallest and the shortest plant reads the gradient as a range, when a range is a difference between two of the 16 plants and a gradient is a rate; 1.5 days for each extra centimetre inverts the rate, dividing days by centimetres instead of centimetres by days, and the line gives 1 cm of growth in two thirds of a day.
Build your own mix at the worksheet builder.