Printable · GCSE Higher · ages 14-16
Statistics worksheet — GCSE Higher
Fifteen questions across the statistics statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Statistics worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) An outlier from the damaged wing, not the trend. — That bird's point lies a long way from the rising trend followed by every other bird, and its low wingspan is explained by the damaged wing rather than by its age — it is an outlier caused by an unusual factor, not part of the general relationship between age and wingspan, so it should not be used when drawing the line of best fit. Saying every point must be used ignores that an outlier caused by a separate, identifiable factor can rightly be set aside. Saying it shows no correlation ignores that the other 19 points do show a clear rising trend; one outlier does not remove that. Saying it proves the line is inaccurate confuses one unusual bird with a fault in the line itself, when the line correctly describes the trend followed by the rest of the data.
- (d) 19 kg — Method: estimate the mean of grouped data by multiplying each class's midpoint by its frequency, adding the four totals, then dividing by the total frequency. Working: the midpoints are 5, 15, 25 and 35 kg. The weighted totals are 11 × 5 = 55, 5 × 15 = 75, 5 × 25 = 125 and 9 × 35 = 315, which add to 570. Dividing by the 30 dogs gives an estimate of 570 ÷ 30 = 19 kg. Giving 5 kg reads off the midpoint of the modal class, 0 < m ≤ 10, the class with the most dogs — but the class with the most dogs is not where the mean falls, and neither is a substitute for actually calculating it. Giving 20 kg averages the four midpoints, (5 + 15 + 25 + 35) ÷ 4, treating every class as equally likely and ignoring that far more dogs are in the lightest and heaviest classes than in the middle two. Giving 570 kg stops after finding the correct weighted total and forgets the final division by the 30 dogs. Always weight each midpoint by its own frequency, and always finish by dividing by the total frequency, not the number of classes.
- (b) £1,000 — Wages take up 150° out of 360°, so the amount spent on wages is 150 ÷ 360 × 2400 = £1,000. Choosing £600 uses the repairs angle, 90°, instead of the wages angle: 90 ÷ 360 × 2400 = 600. Choosing £3,600 treats the angle in degrees as if it were a percentage, 150 ÷ 100 × 2400 = 3600, instead of dividing by 360°. Choosing £800 uses the angle for the 'other costs' sector, 360 − 90 − 150 = 120°, instead of the wages sector: 120 ÷ 360 × 2400 = 800.
- (c) 27 — Method: a frequency is the area of the part of the bar being asked about, so frequency = frequency density × the width of that part. Working: the part asked about runs from 20 to 35, so its width is 35 − 20 = 15 metres; the frequency density there is 1.8 per metre, so the estimate is 1.8 × 15 = 27. Answer: about 27 throws. The distractors: 72 comes from taking the whole bar, 1.8 × 40, and so counting every throw from 20 up to 60; 1.8 comes from reading the height of the bar as a frequency, when a height is a density and only an area is a count; 63 comes from using the upper value 35 as the width, 1.8 × 35, instead of the width 35 − 20.
- (d) 25% — First find the number of fruit cakes: 80 − 34 − 26 = 20. Then write this as a percentage of the total: 20 ÷ 80 × 100 = 25%. Giving 20% comes from reporting the count of fruit cakes, 20, directly as a percentage, without dividing by the total of 80 first. Giving 32.5% computes the percentage of chocolate cakes instead of fruit cakes: 26 ÷ 80 × 100 = 32.5%. Giving 42.5% computes the percentage of sponge cakes instead of fruit cakes: 34 ÷ 80 × 100 = 42.5%.
- (c) No, 90 cm is far outside the heights on the graph — Method: a line of best fit describes the trend only across the stretch of data it was drawn through; predicting beyond that stretch is extrapolation, and nothing in the data supports it. Working: the heights used to draw this line run from 150 cm to 180 cm, all of them Year 10 pupils, while 90 cm is 60 cm below the shortest of them and belongs to a two-year-old child, whose build follows no trend the graph has measured. Substituting anyway gives 0.9 × 90 − 85 = −4, a mass of −4 kg, which cannot exist. Answer: no, because 90 cm is far outside the heights on the graph. The distractors: saying a line of best fit cannot be used to predict at all throws away its main purpose, since a prediction made between the plotted values is perfectly sound; saying the line passes through all 20 points misdescribes a line of best fit, which is drawn to follow the trend of the points and will normally pass through few of them; saying the equation works for any value put into it treats an equation fitted to Year 10 heights as a law of nature, and the mass of −4 kg shows what that assumption produces.
- (b) 135 — Method: use the sample to find the PROPORTION of left-handed pupils, then apply that same proportion to the whole school population. Working: in the sample, 6 out of 40 pupils are left-handed, a proportion of 6 ÷ 40 = 0.15. Applying that proportion to the school's 900 pupils gives an estimate of 0.15 × 900 = 135 pupils. Giving 6 simply repeats the number of left-handed pupils IN THE SAMPLE, without scaling up to the whole school at all. Multiplying the population by the number of left-handed pupils in the sample without first dividing by the sample size, 900 × 6 = 5400, badly overestimates — that is more pupils than the whole school has. Dividing the population by the sample size but forgetting to multiply by the number of left-handed pupils found, 900 ÷ 40 = 22.5, finds the scale factor but stops one step short of using it. Always find the proportion in the sample first, then scale that same proportion up to the population.
- (a) A vertical line chart (discrete numerical data) — The number of pets is discrete numerical data — whole-number values such as 0, 1, 2, 3 or 4 — recorded for one variable, so a vertical line chart is the chart specified for this kind of data. A bar chart is used for categorical data, such as favourite colour, not numerical values counted like this. A pie chart shows proportions of a whole and does not show the frequency of each separate value. A scatter graph compares two different variables against each other, and only one variable, the number of pets, is recorded here.
- (c) 72° — The angle is 12 ÷ 60 × 360 = 72°. Choosing 150° divides football's frequency of 25 instead of badminton's 12: 25 ÷ 60 × 360 = 150. Choosing 20° finds badminton as a percentage of the members, 12 ÷ 60 × 100 = 20, rather than an angle in degrees. Choosing 90° uses 48, the total of the other three activities, as the total instead of the full 60 members: 12 ÷ 48 × 360 = 90.
- (d) 45 — Method: convert the angle into a fraction of the full circle, 360°, then apply that fraction to the total number of shoppers. Working: the card sector is 90° out of 360°, a fraction of 90 ÷ 360 = 0.25. Applying that fraction to the 180 shoppers gives 0.25 × 180 = 45 shoppers. Giving 90 states the angle itself, not a number of shoppers — the angle first has to be converted into a fraction. Using the remaining angle, 360 − 90 = 270°, and scaling that, 270 ÷ 360 × 180 = 135, finds the number who did NOT pay by card, not the number who did. Dividing 360 by 90, 360 ÷ 90 = 4, finds how many equal 90° sectors fit in the circle, a fact about the pie chart's shape, not about the shoppers at all. Always convert the angle to a fraction of 360° first, and apply that same fraction to the total number of people.
- (c) Branch A waits longer, and Branch A is more consistent — Method: compare the two branches using a measure of location (the median) for who waits longer, and a measure of spread (the interquartile range) for who is more consistent — a smaller interquartile range means more consistent. Working: Branch A's median, 12 minutes, is higher than Branch B's, 9 minutes, so Branch A's customers wait longer on average. Branch A's interquartile range, 5 minutes, is smaller than Branch B's, 11 minutes, so Branch A's waiting times vary less. Answer: Branch A waits longer, and Branch A is also the more consistent of the two. Watch that each half of the comparison uses the right statistic and reads it correctly: swapping both readings gives Branch B the longer wait and the greater consistency, when neither is true; keeping the median comparison right but reading a larger interquartile range as 'more consistent' has the direction of spread backwards; and swapping only the median comparison keeps the correct branch for consistency but gives the wrong branch the longer wait.
- (a) No, 150 pupils are a tenth of the school, chosen at random — Method: judge a sample on two things, whether every member of the population had the same chance of being chosen, and whether the sample is large enough to carry a pattern. Working: the 150 pupils were drawn from the register of every pupil in the school, so no year group or set is shut out and no pupil chooses to take part; and 150 ÷ 1,500 = 0.1, so one pupil in ten has been asked. A random sample of that share is ample for an estimate of how long the school's pupils spend on homework. Answer: no, because 150 pupils are a tenth of the school and were chosen at random. The distractors: saying a random sample always gives the exact school figure reaches the same verdict for a reason that is false, since a second random sample of 150 would give a slightly different mean; saying 150 pupils cannot be picked at random from 1,500 treats randomness as something only a whole population can have, when drawing names from the register is exactly how a random sample is taken; saying that only asking all 1,500 could show anything rejects sampling altogether, which would leave no way to study any population too large to count.
- (c) Because every pupil has an equal chance of being picked — Method: whether a sample represents its population is decided by the selection method, not by the size of the sample, so ask whether the method gives every member of the population the same chance of being chosen. Working: the names are drawn at random from a list of all 10,000 pupils, so each pupil has the same chance, 500 out of 10,000, of being drawn, and no group of pupils is more likely to appear than any other; that is what keeps bias out of the sample. Answer: because every pupil has an equal chance of being picked. The distractors: the reply about 5% treats the sampling fraction as the test of fairness, but a badly chosen 5% is still biased and a well chosen 1% is not; the reply about 500 being large enough makes size the test instead, which is the same mistake in another form, since a large sample drawn from one school would still misrepresent the city; the reply about the most willing pupils describes self-selection, which hands the choice of who is in the sample to the pupils who feel most strongly about the question.
- (b) Town B — higher median and smaller IQR — Method: 'higher and more consistent' needs two comparisons — the median for typical price, and the interquartile range for spread, with a smaller interquartile range meaning more consistent. Working: Town B's median, £235,000, is higher than Town A's, £220,000. Town A's interquartile range is 310 − 180 = 130 and Town B's is 260 − 175 = 85, so Town B's interquartile range is the smaller of the two. Answer: Town B has both the higher median and the smaller interquartile range, so it is the town with higher, more consistent prices. Watch which combination of median and interquartile range each statement claims, and for which town: claiming Town A has the higher median and the smaller interquartile range gets both comparisons wrong, since Town B leads on both; claiming Town A has the higher median (still wrong) but the larger interquartile range at least reads the spread correctly, without it rescuing the false median claim; and claiming Town B has the higher median (correct) but the larger interquartile range misreads the spread — Town B's interquartile range is the smaller of the two, not the larger.
- (c) Yes — with an estimate of 320, above the 250 limit. — Method: scale the sample proportion up to the whole batch to get an estimate, then compare that estimate with the 250 limit to reach a decision. Working: in the sample, 4 out of 50 boards are faulty, a proportion of 4 ÷ 50 = 0.08. Applying that proportion to the batch of 4,000 gives an estimate of 0.08 × 4000 = 320 faulty boards. Since 320 is more than 250, the factory should scrap the batch. Inverting the proportion, 50 ÷ 4 = 12.5, and treating that as a percentage of the batch, 12.5% × 4000 = 500, still gives 'yes' but from the wrong fraction, so it overstates the estimate. Comparing the raw number of faulty boards found in the sample, 4, directly with the 250 limit skips the scaling up to the batch altogether, and 4 is nowhere near 250, so that route wrongly says 'no'. Dividing the batch by the sample size, 4000 ÷ 50 = 80, finds how many samples of 50 fit into the batch but stops before multiplying by the 4 faulty boards found, so it also wrongly says 'no'. Always find the proportion in the sample first, scale it up to the whole batch, and only then compare the estimate with the limit given.
Build your own mix at the worksheet builder.