Printable · GCSE Higher · ages 14-16
Statistics worksheet — GCSE Higher
Fifteen questions across the statistics statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Statistics worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) 75 — Method: the number in a class is the area of its bar, frequency density × class width, so work out the frequency of each class that lies at or above 10 minutes and add them. Working: the class 10 ≤ t < 25 is 15 minutes wide with a frequency density of 3.2, giving 3.2 × 15 = 48 members; the class 25 ≤ t < 55 is 30 minutes wide with a frequency density of 0.9, giving 0.9 × 30 = 27 members; the total charged is 48 + 27 = 75. Answer: 75 members pay the extra charge. The distractors: 4.1 comes from adding the two frequency densities, 3.2 + 0.9, as though each height were a count; 93 comes from including the class 0 ≤ t < 10 as well, 1.8 × 10 = 18 added to 48 and 27, which charges every member; 27 comes from using only the class 25 ≤ t < 55 and forgetting that 10 ≤ t < 25 is also at or above 10 minutes.
- (c) 20 kg ≤ mass < 30 kg — The modal class is the class with the highest frequency. Reading the plotted points, the frequencies are 6, 10, 16, 6 and 2, so the highest frequency is 16, plotted at the midpoint 25. A class of width 10 centred on 25 runs from 25 − 5 = 20 to 25 + 5 = 30, so the modal class is 20 kg ≤ mass < 30 kg. Writing '25 kg' gives only the midpoint, not the class — the modal class is an interval, not a single value. '10 kg ≤ mass < 20 kg' is the class before the peak, centred on 15, which has frequency 10, not the highest. '30 kg ≤ mass < 40 kg' is the class after the peak, centred on 35, which has frequency 6, not the highest.
- (c) 33 — Method: multiply the mean by the number of tests to get the total marks, then subtract the marks that are already known. Working: four tests with a mean of 29 give a total of 29 × 4 = 116 marks; the first three marks total 31 + 26 + 26 = 83; so the fourth mark is 116 − 83 = 33. Answer: 33, and checking, (31 + 26 + 26 + 33) ÷ 4 = 116 ÷ 4 = 29. The distractors: 116 comes from stopping at the total for all four tests; 29 comes from assuming the missing mark must be the mean itself; 4 comes from multiplying the mean by 3, the number of marks given, leaving 87 − 83 = 4.
- (a) Equal means; Class A is more consistent, smaller range. — Method: when two data sets share a measure of location, compare a measure of spread to say more about consistency. Working: both classes have the same mean mark, 14, so on average they performed equally well. Class A has the smaller range, 6, so its marks are more tightly grouped around 14 than Class B's marks, which vary by as much as 14. So Class A's marks were more consistent, even though neither class did better on average. Saying Class B did better because it has the bigger range confuses a wide spread with a high score — a big range describes variability, not performance. Saying Class A did better because it has the smaller range makes the same mistake in the other direction: the two classes are tied on the mean, so neither one 'did better'. Saying the classes cannot be compared because their means are equal misses the whole point of also comparing the range. Always compare both an average AND a spread before describing two data sets — either one alone tells only half the story.
- (c) 20 ≤ h < 40 — Method: with 80 values the lower quartile is the 80 ÷ 4 = 20th value in order, so build a running total until it first reaches 20. Working: the running totals are 14, then 14 + 22 = 36, then 52, then 80; the 20th plant is past 14 but not past 36, so it lies in the second class. Answer: the lower quartile lies in the class 20 ≤ h < 40. The distractors: 0 ≤ h < 20 comes from believing that the bottom quarter of the data must all sit in the first class, when that class holds only 14 of the 80 plants; 40 ≤ h < 50 comes from using the position 80 ÷ 2 = 40 and so locating the median rather than the lower quartile; 50 ≤ h < 80 comes from counting 20 plants down from the tallest instead of up from the shortest, which locates the upper quartile at the 60th plant.
- (c) 0.5 per gram — Method: turn the two known bars into frequencies using area, subtract from the total to find how many letters are left, then divide that frequency by the width of the last class to get its height. Working: the first bar covers 50 g at a frequency density of 1.2, giving 1.2 × 50 = 60 letters, and the second covers 50 g at 1.8, giving 1.8 × 50 = 90 letters; together that is 60 + 90 = 150 letters, so 200 − 150 = 50 letters remain; the class 100 ≤ m < 200 is 100 g wide, so its frequency density is 50 ÷ 100 = 0.5 per gram. Answer: 0.5 per gram. The distractors: 0.25 per gram comes from dividing the remaining 50 letters by the upper class boundary, 200, instead of by the class width of 100; 2 per gram comes from dividing the class width by the frequency, 100 ÷ 50, reversing the formula; 1.4 per gram comes from subtracting only the first bar's 60 letters, leaving 140, and then dividing by 100.
- (b) 5.5 kg — Method: with an even number of values the median is the mean of the two middle values, taken once the data are in order of size. Working: the eight masses are already in order and 8 ÷ 2 = 4, so the middle pair are the 4th and 5th values, 5 kg and 6 kg; the median is (5 + 6) ÷ 2 = 5.5 kg. Answer: 5.5 kg. The distractors: 5 kg comes from reading the 4th value and stopping there instead of averaging the middle pair; 8 kg comes from working out the range, 11 − 3, which measures spread rather than centre; 4 kg comes from writing down the modal mass, the only value that occurs twice, instead of the median.
- (a) No, 150 pupils are a tenth of the school, chosen at random — Method: judge a sample on two things, whether every member of the population had the same chance of being chosen, and whether the sample is large enough to carry a pattern. Working: the 150 pupils were drawn from the register of every pupil in the school, so no year group or set is shut out and no pupil chooses to take part; and 150 ÷ 1,500 = 0.1, so one pupil in ten has been asked. A random sample of that share is ample for an estimate of how long the school's pupils spend on homework. Answer: no, because 150 pupils are a tenth of the school and were chosen at random. The distractors: saying a random sample always gives the exact school figure reaches the same verdict for a reason that is false, since a second random sample of 150 would give a slightly different mean; saying 150 pupils cannot be picked at random from 1,500 treats randomness as something only a whole population can have, when drawing names from the register is exactly how a random sample is taken; saying that only asking all 1,500 could show anything rejects sampling altogether, which would leave no way to study any population too large to count.
- (c) Branch A waits longer, and Branch A is more consistent — Method: compare the two branches using a measure of location (the median) for who waits longer, and a measure of spread (the interquartile range) for who is more consistent — a smaller interquartile range means more consistent. Working: Branch A's median, 12 minutes, is higher than Branch B's, 9 minutes, so Branch A's customers wait longer on average. Branch A's interquartile range, 5 minutes, is smaller than Branch B's, 11 minutes, so Branch A's waiting times vary less. Answer: Branch A waits longer, and Branch A is also the more consistent of the two. Watch that each half of the comparison uses the right statistic and reads it correctly: swapping both readings gives Branch B the longer wait and the greater consistency, when neither is true; keeping the median comparison right but reading a larger interquartile range as 'more consistent' has the direction of spread backwards; and swapping only the median comparison keeps the correct branch for consistency but gives the wrong branch the longer wait.
- (d) 44 — Method: a cumulative frequency counts everything below a value, so the frequency of a class is the running total at the top of the class minus the running total at the bottom of it. Working: the running total below 20 kg is 96 and the running total below 10 kg is 52, so the number of boxes in the class 10 ≤ m < 20 is 96 − 52 = 44. Answer: 44 boxes. The distractors: 96 comes from quoting the running total at 20 kg itself, which counts every box below 20 kg rather than only those in this class; 34 comes from subtracting the wrong pair, 52 − 18, which gives the class 5 ≤ m < 10 instead; 54 comes from subtracting from the grand total, 150 − 96, which gives the boxes of 20 kg or more.
- (d) 25 ≤ t < 45 — Method: the height of a bar on a histogram is the frequency density, so work out frequency ÷ class width for every class and compare the four heights. Working: 20 ÷ 10 = 2 for the first class; 12 ÷ 15 = 0.8 for the second; 50 ÷ 20 = 2.5 for the third; 60 ÷ 30 = 2 for the fourth. Answer: the largest of 2, 0.8, 2.5 and 2 is 2.5, so the tallest bar is the one for 25 ≤ t < 45. The distractors: 45 ≤ t < 75 comes from picking the class with the greatest frequency, 60, and treating a frequency as a height — but that class is three times as wide, so its 60 competitors are spread thinly; 10 ≤ t < 25 comes from dividing the class width by the frequency, 15 ÷ 12, and picking the largest of those reversed values; 0 ≤ t < 10 comes from assuming the narrowest class must always give the tallest bar, which is only true when the frequencies are equal.
- (c) Class X has the higher median and the wider spread — Method: compare the two box plots statistic by statistic — median for location, and the interquartile range for spread — checking the true value of each rather than assuming a pattern. Working: Class X's median is 60 and Class Y's is 58, so Class X's median is the higher one. Class X's interquartile range is 70 − 45 = 25 and Class Y's is 65 − 50 = 15 (and the ranges follow the same order: 95 − 20 = 75 against 80 − 35 = 45), so Class X also has the wider spread. Answer: Class X has both the higher median and the wider spread. Watch that each half of a compound statement is checked separately: claiming Class Y has the higher median and the wider spread gets both comparisons backwards; claiming Class X has the higher median but the narrower spread keeps the median right while reading the spread the wrong way round; and claiming Class Y has the higher median but the narrower spread swaps the median comparison while getting the spread right.
- (a) The median, as the one very large wage does not move it — Method: an average describes a population well when it sits close to most of the values, so compare what each average does when one value lies far from the rest. Working: in order the wages are 420, 440, 460, 480 and 1,500, so the median is the third of the five, £460. The mean uses every wage: 420 + 440 + 460 + 480 + 1,500 = 3,300 and 3,300 ÷ 5 = 660, so the mean is £660. Four of the five people earn less than £660, and the nearest of those four wages is £180 below it, so £660 describes nobody at the garage; £460 sits inside the group of four similar wages. Answer: the median, as the one very large wage does not move it, while that same wage drags the mean £200 above the median. The distractors: saying the median is always larger than the mean is an invented rule, and here the median £460 is smaller than the mean £660; saying the mean is the only average that uses all five wages is true as far as it goes, but using a value and being dragged by it are the same thing when that value is £1,500; saying £660 lies between the smallest and largest wage is true of every mean ever calculated, so it proves nothing about whether this one is typical.
- (b) Treat them as outliers and check them before deciding — Method: a point lying a long way from the pattern the rest of the data make is called an outlier, and an outlier is investigated before anything is done with it, because it may be an error in the data or it may be a genuine but unusual case. Working: 48 of the 50 points lie close to the rising line of best fit, so the trend is set by those 48; the two remaining points do not follow it, so they are identified as outliers and checked — a mistake in measuring or recording would be corrected, while a genuine reading would be kept and reported. Answer: treat them as outliers and check them before deciding what to do with them. The distractors: deleting them at once assumes that every point far from the line must be an error, which throws away real data; moving the line so that it passes through them assumes a line of best fit must touch particular points, when it is drawn to follow all 50; taking them as proof that there is no correlation lets two points overturn the pattern that the other 48 agree on.
- (c) The data show a link only; a third factor may affect both — Method: a study of this kind measures two quantities and reports how they change together; deciding that one of them produces the other is a further claim, and it needs evidence that the measurements alone cannot give. Working: the study shows that more coffee goes with better concentration, which is a positive correlation; but a third factor that was never measured, such as how motivated someone is, could raise both the coffee drinking and the concentration, and the concentration could equally be what leads to the extra coffee. Answer: the data show a link only, because a third factor may be affecting both quantities, so no claim about cause can be made. The distractors: calling the conclusion safe because the correlation is positive treats the direction of a correlation as proof of cause, which no direction can give; calling it wrong because the correlation is negative misreads the direction of the relationship, since the study reports both quantities rising together; saying the two quantities are not linked denies the correlation the study actually found, when what fails is only the claim about cause.
Build your own mix at the worksheet builder.