Printable · GCSE Higher · ages 14-16
Statistics worksheet — GCSE Higher
Fifteen questions across the statistics statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Statistics worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) Equal means; Class A is more consistent, smaller range. — Method: when two data sets share a measure of location, compare a measure of spread to say more about consistency. Working: both classes have the same mean mark, 14, so on average they performed equally well. Class A has the smaller range, 6, so its marks are more tightly grouped around 14 than Class B's marks, which vary by as much as 14. So Class A's marks were more consistent, even though neither class did better on average. Saying Class B did better because it has the bigger range confuses a wide spread with a high score — a big range describes variability, not performance. Saying Class A did better because it has the smaller range makes the same mistake in the other direction: the two classes are tied on the mean, so neither one 'did better'. Saying the classes cannot be compared because their means are equal misses the whole point of also comparing the range. Always compare both an average AND a spread before describing two data sets — either one alone tells only half the story.
- (a) Drawing 60 names at random from a list of all 1200 pupils — Method: a sample is random when every member of the population has the same chance of being chosen and nobody, including the pupils themselves, can influence who ends up in it; test each method against that. Working: drawing names from a list of all 1200 pupils gives each pupil the same chance, 60 out of 1200, whatever their year group, class or opinion, so the method is random. Answer: drawing 60 names at random from a list of all 1200 pupils. The distractors: asking the pupils who volunteer is self-selection, and the pupils with the strongest views volunteer first, so they decide the sample; asking the pupils nearest the door is convenience sampling, which reaches only those who happen to be in one place at one time; asking two Year 10 classes samples a cluster, so every pupil in the other year groups has no chance of being chosen at all.
- (c) 0.5 per gram — Method: turn the two known bars into frequencies using area, subtract from the total to find how many letters are left, then divide that frequency by the width of the last class to get its height. Working: the first bar covers 50 g at a frequency density of 1.2, giving 1.2 × 50 = 60 letters, and the second covers 50 g at 1.8, giving 1.8 × 50 = 90 letters; together that is 60 + 90 = 150 letters, so 200 − 150 = 50 letters remain; the class 100 ≤ m < 200 is 100 g wide, so its frequency density is 50 ÷ 100 = 0.5 per gram. Answer: 0.5 per gram. The distractors: 0.25 per gram comes from dividing the remaining 50 letters by the upper class boundary, 200, instead of by the class width of 100; 2 per gram comes from dividing the class width by the frequency, 100 ÷ 50, reversing the formula; 1.4 per gram comes from subtracting only the first bar's 60 letters, leaving 140, and then dividing by 100.
- (a) 1.6 — Method: on a histogram the height of a bar is the frequency density, and frequency density = frequency ÷ class width. Working: the class 15 ≤ t < 30 runs from 15 to 30, so its width is 30 − 15 = 15 minutes; the frequency is 24, so the frequency density is 24 ÷ 15 = 1.6. Answer: 1.6 people per minute. The distractors: 360 comes from multiplying the frequency by the class width, 24 × 15, which uses the area rule backwards — area gives the frequency, so the frequency must be divided by the width to give the height; 0.625 comes from dividing the class width by the frequency, 15 ÷ 24, reversing the formula; 0.8 comes from dividing by the upper class boundary, 24 ÷ 30, instead of by the width of the class.
- (c) 75 — Method: the number in a class is the area of its bar, frequency density × class width, so work out the frequency of each class that lies at or above 10 minutes and add them. Working: the class 10 ≤ t < 25 is 15 minutes wide with a frequency density of 3.2, giving 3.2 × 15 = 48 members; the class 25 ≤ t < 55 is 30 minutes wide with a frequency density of 0.9, giving 0.9 × 30 = 27 members; the total charged is 48 + 27 = 75. Answer: 75 members pay the extra charge. The distractors: 4.1 comes from adding the two frequency densities, 3.2 + 0.9, as though each height were a count; 93 comes from including the class 0 ≤ t < 10 as well, 1.8 × 10 = 18 added to 48 and 27, which charges every member; 27 comes from using only the class 25 ≤ t < 55 and forgetting that 10 ≤ t < 25 is also at or above 10 minutes.
- (a) No, 150 pupils are a tenth of the school, chosen at random — Method: judge a sample on two things, whether every member of the population had the same chance of being chosen, and whether the sample is large enough to carry a pattern. Working: the 150 pupils were drawn from the register of every pupil in the school, so no year group or set is shut out and no pupil chooses to take part; and 150 ÷ 1,500 = 0.1, so one pupil in ten has been asked. A random sample of that share is ample for an estimate of how long the school's pupils spend on homework. Answer: no, because 150 pupils are a tenth of the school and were chosen at random. The distractors: saying a random sample always gives the exact school figure reaches the same verdict for a reason that is false, since a second random sample of 150 would give a slightly different mean; saying 150 pupils cannot be picked at random from 1,500 treats randomness as something only a whole population can have, when drawing names from the register is exactly how a random sample is taken; saying that only asking all 1,500 could show anything rejects sampling altogether, which would leave no way to study any population too large to count.
- (c) 145 g — Method: find the position of the median from the total frequency, locate the class that contains it, then use linear interpolation inside that class, assuming the apples in it are spread evenly. Working: the median is the 100 ÷ 2 = 50th apple; the running totals are 10, then 10 + 30 = 40, then 40 + 40 = 80, so the 50th apple lies in the class 140 ≤ m < 160; it is the 50 − 40 = 10th of the 40 apples in that class, and the class is 20 g wide, so the median is 140 + (10 ÷ 40) × 20 = 140 + 5 = 145. Answer: an estimated median of 145 g. The distractors: 150 g comes from giving the midpoint of the class that contains the median instead of interpolating inside it; 140 g comes from stopping at the lower boundary of that class, which locates the class but not the value; 155 g comes from measuring the 5 g step down from the upper boundary, 160 − 5, instead of up from the lower boundary.
- (d) 19 kg — Method: estimate the mean of grouped data by multiplying each class's midpoint by its frequency, adding the four totals, then dividing by the total frequency. Working: the midpoints are 5, 15, 25 and 35 kg. The weighted totals are 11 × 5 = 55, 5 × 15 = 75, 5 × 25 = 125 and 9 × 35 = 315, which add to 570. Dividing by the 30 dogs gives an estimate of 570 ÷ 30 = 19 kg. Giving 5 kg reads off the midpoint of the modal class, 0 < m ≤ 10, the class with the most dogs — but the class with the most dogs is not where the mean falls, and neither is a substitute for actually calculating it. Giving 20 kg averages the four midpoints, (5 + 15 + 25 + 35) ÷ 4, treating every class as equally likely and ignoring that far more dogs are in the lightest and heaviest classes than in the middle two. Giving 570 kg stops after finding the correct weighted total and forgets the final division by the 30 dogs. Always weight each midpoint by its own frequency, and always finish by dividing by the total frequency, not the number of classes.
- (d) Only internet users reach the website; others are excluded. — Method: a sample is biased when it systematically leaves out part of the population, or systematically over-represents another part. Working: anyone without internet access, or who does not visit the council's website, has NO chance of being included — the sample is drawn only from internet-using residents, which is not the whole town. Saying too many people might respond because the survey is free confuses bias with sample size — bias is about who CAN be reached, not how many respond. Saying people might lie describes a different problem, response honesty, not who was sampled in the first place. Saying online surveys cannot be anonymous is not a reason connected to bias at all. A sample is biased when part of the population has no chance of being included, whatever the reason for that.
- (d) 300 pupils — Method: an estimate for a whole population is made by finding the proportion in the sample and applying that same proportion to the population. Working: in the sample 30 of the 50 pupils prefer sport, a proportion of 30 ÷ 50 = 0.6, and applying that proportion to the school gives 0.6 × 500 = 300 pupils. Answer: 300 pupils, and it is only an estimate, because a different random sample of 50 would give a slightly different figure. The distractors: 200 pupils comes from scaling up the 20 pupils in the sample who did not prefer sport, 20 × 10, which answers the opposite question; 150 pupils comes from reading 30 out of 50 as 30% and taking 30% of 500; 60 pupils comes from working out the proportion correctly as 60% and then writing the 60 down as a number of pupils instead of applying it to the 500.
- (c) Branch A waits longer, and Branch A is more consistent — Method: compare the two branches using a measure of location (the median) for who waits longer, and a measure of spread (the interquartile range) for who is more consistent — a smaller interquartile range means more consistent. Working: Branch A's median, 12 minutes, is higher than Branch B's, 9 minutes, so Branch A's customers wait longer on average. Branch A's interquartile range, 5 minutes, is smaller than Branch B's, 11 minutes, so Branch A's waiting times vary less. Answer: Branch A waits longer, and Branch A is also the more consistent of the two. Watch that each half of the comparison uses the right statistic and reads it correctly: swapping both readings gives Branch B the longer wait and the greater consistency, when neither is true; keeping the median comparison right but reading a larger interquartile range as 'more consistent' has the direction of spread backwards; and swapping only the median comparison keeps the correct branch for consistency but gives the wrong branch the longer wait.
- (c) No, the mode here is the lowest value of the nine — Method: an average is meant to stand for the data as a whole, so test any proposed average by asking how many values it sits near. Working: the value 4 appears three times and every other count appears once, so 4 is indeed the mode. But those three hours are the quiet ones at the start of the day, and the other six counts run from 11 up to 25; putting the nine counts in order, the middle one is the fifth, which is 13. So the mode sits at the very bottom of the data, with six of the nine hours far above it. Answer: no, because the mode here is the lowest value of the nine, so it describes the quiet opening hours rather than a typical hour. The distractors: saying the mode can only be used when no value repeats reverses the definition, since a mode exists only because a value does repeat; saying the mode is the value that occurs most often is a correct definition, but being the commonest value does not make a value typical when it lies at one end of the data; saying the mode is the best average for any list of numbers ignores the fact that mean, median and mode each describe a population well in different circumstances.
- (d) 44 — Method: a cumulative frequency counts everything below a value, so the frequency of a class is the running total at the top of the class minus the running total at the bottom of it. Working: the running total below 20 kg is 96 and the running total below 10 kg is 52, so the number of boxes in the class 10 ≤ m < 20 is 96 − 52 = 44. Answer: 44 boxes. The distractors: 96 comes from quoting the running total at 20 kg itself, which counts every box below 20 kg rather than only those in this class; 34 comes from subtracting the wrong pair, 52 − 18, which gives the class 5 ≤ m < 10 instead; 54 comes from subtracting from the grand total, 150 − 96, which gives the boxes of 20 kg or more.
- (c) 10 — Method: work out the mean that can be found straight away, then use total = mean × number of values on the group of three to find the missing number. Working: the mean of 15 and 25 is (15 + 25) ÷ 2 = 40 ÷ 2 = 20, so the group of three must also have a mean of 20; three numbers with a mean of 20 have a total of 20 × 3 = 60, and 20 + 30 = 50 of that total is already accounted for, so x = 60 − 50 = 10. Answer: 10, and checking, (10 + 20 + 30) ÷ 3 = 20. The distractors: 20 comes from working out the mean the two groups share and writing that down as x; −10 comes from dividing the group of three by 2 instead of by 3, which gives x + 50 = 40; 70 comes from reading the total 15 + 25 = 40 as the mean of the pair, which sets the target total at 120 and leaves x = 70.
- (a) x = 0 gives y = −20: a negative number sold — The y-intercept is the value the line predicts when x = 0: y = 3 × 0 − 20 = −20. A kiosk cannot sell a negative number of ice creams, so this is not a sensible estimate. The 3 in the equation is the gradient, not the intercept, so an option claiming x = 0 gives y = 3 has swapped the two numbers around — substituting x = 0 makes the 3x term equal 0, leaving −20, not 3. The danger of extrapolating to very high temperatures is a real issue with this line, but it is a different issue from the y-intercept, so it does not answer this question. And whether x = 0 could occur on a trading day is beside the point: the model still makes that prediction, and it is the prediction itself, −20, that is impossible.
Build your own mix at the worksheet builder.