Printable · GCSE Higher · ages 14-16
Statistics worksheet — GCSE Higher
Fifteen questions across the statistics statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Statistics worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 1.6 — Method: on a histogram the height of a bar is the frequency density, and frequency density = frequency ÷ class width. Working: the class 15 ≤ t < 30 runs from 15 to 30, so its width is 30 − 15 = 15 minutes; the frequency is 24, so the frequency density is 24 ÷ 15 = 1.6. Answer: 1.6 people per minute. The distractors: 360 comes from multiplying the frequency by the class width, 24 × 15, which uses the area rule backwards — area gives the frequency, so the frequency must be divided by the width to give the height; 0.625 comes from dividing the class width by the frequency, 15 ÷ 24, reversing the formula; 0.8 comes from dividing by the upper class boundary, 24 ÷ 30, instead of by the width of the class.
- (c) A histogram, with frequency density up the vertical axis — Method: decide which diagram makes area stand for frequency, which is the property the question asks for. Working: on a histogram the vertical axis is frequency density, so the area of a bar is frequency density × class width, and that product is the frequency; this is exactly what is wanted, and it is what allows classes of unequal width to be shown fairly. Answer: a histogram, with frequency density up the vertical axis. The distractors: a bar chart plots frequency as the height, so with unequal widths a wide class would cover far more area than a narrow class holding the same number of batteries, and area would measure nothing; a cumulative frequency diagram plots running totals against upper class boundaries, so a point on it gives how many lie below a value rather than how many lie in a class; a pie chart shows each class as a share of the whole 300 and loses the class widths entirely, so no area on it is tied to a scale of hours.
- (b) 4 — The difference, Bristol minus Leeds, on each day is: Monday 4 − 3 = 1, Tuesday 4 − 5 = −1, Wednesday 6 − 2 = 4, Thursday 2 − 4 = −2. The greatest amount by which Bristol exceeded Leeds is 4 hours, on Wednesday. Choosing 1 takes Monday's smaller positive difference instead of the greatest one. Choosing 2 takes the size of Thursday's difference, but that is the amount by which Leeds exceeded Bristol, the opposite direction to the one asked for. Choosing 6 takes Bristol's raw figure on Wednesday without subtracting Leeds's 2 hours first.
- (b) 1 — Method: for data in a frequency table, find the position of the median using (n + 1) ÷ 2, then read off the value at that position from the cumulative frequencies. Working: there are 19 pupils, so the median is the 10th value. The cumulative frequencies are 7 (up to 0 pets), 10 (up to 1 pet), 14 (up to 2 pets) and 19 (up to 3 pets). The 10th value falls at the end of the '1 pet' group, so the median is 1 pet. Giving 0 pets is the mode — the category with the highest frequency, 7 — not the median. Giving 3, the highest number of pets minus the lowest, finds the range, a different statistic entirely. Giving 19 states the total number of pupils, not a number of pets at all. Find the middle POSITION first, then read off the value it belongs to — do not confuse it with the mode, the range or the total.
- (b) 13 — The total is 50, and the two known parts are 22 (tea) and 15 (coffee), so 50 − 22 − 15 = 13 hot chocolates. Choosing 28 comes from 50 − 22, subtracting only the tea and forgetting the coffee. Choosing 35 comes from 50 − 15, subtracting only the coffee and forgetting the tea. Choosing 37 comes from 22 + 15, which finds how many drinks were tea or coffee, not the number left over for hot chocolate.
- (d) 1.2 pupils per mark — Method: on a histogram whose class intervals are not all the same width the height of a bar is not the frequency but the frequency density, found by dividing the frequency of the class by the width of that class, so that the area of the bar represents the frequency. Working: the class 40 ≤ m < 60 holds 24 pupils, and its width is 60 − 40 = 20 marks, so the frequency density is 24 ÷ 20 = 1.2. Answer: 1.2 pupils per mark. The distractors: 24 pupils per mark comes from plotting the frequency itself as the height, which is only correct when every class has the same width; 2.4 pupils per mark comes from dividing by 10, the width of the narrowest class, instead of by the width of this class; 0.2 pupils per mark comes from dividing by the 120 pupils in the year group, which gives the proportion of pupils in the class and not a frequency density.
- (a) (30, 60) — Method: a cumulative frequency point is plotted at the upper boundary of its class, paired with the running total of all the frequencies up to and including that class. Working: the running totals are 7, then 7 + 19 = 26, then 26 + 34 = 60, then 60 + 40 = 100; the class 20 ≤ t < 30 has upper boundary 30, and the running total there is 60. Answer: the point for that class is plotted at 30 seconds against a cumulative frequency of 60. The distractors: (25, 60) comes from plotting at the class midpoint, which is what a frequency polygon uses and not what a cumulative frequency diagram uses; (30, 34) comes from plotting the class frequency, 34, rather than the running total; (20, 60) comes from plotting at the lower boundary of the class, which would claim that 60 calls took less than 20 seconds when only 26 did.
- (c) 76 marks — Method: a mean of means only works when the groups are the same size, so rebuild each class's total mark, add the totals and divide by the number of pupils altogether. Working: Class A scored 30 × 72 = 2160 marks and Class B scored 20 × 82 = 1640 marks, giving 2160 + 1640 = 3800 marks between 50 pupils, so the overall mean is 3800 ÷ 50 = 76 marks. Answer: 76 marks. The distractors: 77 marks comes from averaging the two class means, (72 + 82) ÷ 2, which ignores the different class sizes; 78 marks comes from attaching each mean to the other class's size, (30 × 82 + 20 × 72) ÷ 50; 3800 marks comes from stopping at the combined total and never dividing by 50.
- (a) 150 bulbs — Method: assume the proportion faulty in a random sample is the proportion faulty in the whole day's output, and scale the sample up to the population. Working: the sample of 80 has to be scaled up to 4,000 bulbs, and 4,000 ÷ 80 = 50, so the day's output is 50 sample-sized batches. Each batch is expected to contain the same 3 faulty bulbs, so the estimate is 3 × 50 = 150. Answer: 150 bulbs, and it is an estimate, because another sample of 80 would probably contain a different number of faulty bulbs. The distractors: 50 bulbs is the scale factor 4,000 ÷ 80 written down as though it were the answer, so it reports how many batches there are rather than how many faulty bulbs; 120 bulbs comes from reading 3 out of 80 as 3%, then taking 0.03 × 4,000 = 120, but 3 out of 80 is 3.75%; 240 bulbs comes from 3 × 80 = 240, multiplying the faulty bulbs by the size of the sample instead of by the scale factor, which uses the 80 twice and the 4,000 not at all.
- (b) 55 — Method: count the classes that lie wholly above 8 minutes, then use linear interpolation for the class that 8 cuts through, assuming the delays in that class are spread evenly. Working: the class 10 ≤ d < 20 lies wholly above 8 and holds 25 buses; the value 8 lies in the class 5 ≤ d < 10, which is 5 minutes wide and holds 75 buses, and the part above 8 runs from 8 to 10, a width of 2, so the estimated share is (2 ÷ 5) × 75 = 30 buses; the estimate is 30 + 25 = 55. Answer: about 55 refunds. The distractors: 100 comes from adding the whole of the class 5 ≤ d < 10, 75 + 25, and so refunding buses only 5 minutes late; 25 comes from using only the class 10 ≤ d < 20 and ignoring the part class that 8 minutes cuts through; 70 comes from taking the part of the class from 5 up to 8 instead of from 8 up to 10, giving (3 ÷ 5) × 75 = 45 and then 45 + 25.
- (d) Route 1, as its times vary by 6 minutes rather than 20 — Method: work out an average and a measure of spread for each route, then decide which matters to a commuter who must arrive on time every day. Working: for Route 1, 22 + 23 + 24 + 24 + 25 + 25 + 26 + 26 + 27 + 28 = 250 and 250 ÷ 10 = 25, so the mean is 25 minutes, and the range is 28 − 22 = 6 minutes. For Route 2, 18 + 19 + 20 + 20 + 21 + 22 + 26 + 30 + 36 + 38 = 250 and 250 ÷ 10 = 25, so the mean is also 25 minutes, but the range is 38 − 18 = 20 minutes. The means give no reason to prefer either route; the spreads do, because a commuter who must never be late has to allow for the worst day, which is 28 minutes on Route 1 and 38 minutes on Route 2. Answer: Route 1, as its times vary by 6 minutes rather than 20. The distractors: saying Route 2 has the lower mean assumes that its quicker-looking early times must pull the average down, when both routes total 250 minutes over the ten days; choosing Route 2 for its fastest journey of 18 minutes judges a route by its best day, and the commuter has to survive its worst; saying either route will do uses the equal means and ignores the spread altogether, which is the one thing that separates the two routes.
- (c) The median, £160,000, as one very high price lifts the mean — Method: find both averages, then choose the one that sits closer to the bulk of the data. Working: in order the prices are 140,000, 150,000, 160,000, 170,000 and 580,000, so the median is the third of the five, £160,000. For the mean, 140,000 + 150,000 + 160,000 + 170,000 + 580,000 = 1,200,000 and 1,200,000 ÷ 5 = 240,000, so the mean is £240,000. Four of the five houses sold for £170,000 or less, so a reader told that a typical price is £240,000 would expect to pay at least £70,000 more than any of those four cost. Answer: the median, £160,000, as one very high price lifts the mean. The distractors: £580,000 is the middle value of the list as it is printed, which is the median only when the values have first been put in order; £240,000 is the mean, chosen on the ground that a median ignores three of the five prices, but a median uses all five to find which one is central and is then untroubled by how extreme the outer values are; £155,000 comes from deleting the £580,000 house and taking the mean of what is left, since 140,000 + 150,000 + 160,000 + 170,000 = 620,000 and 620,000 ÷ 4 = 155,000, but a real sale may not be thrown away merely for being large.
- (b) A person's shoe size and their favourite colour — A person's shoe size is not linked to which colour they prefer, so these two show no correlation. The other three pairs are all genuinely correlated: distance travelled and fuel used rise together, which is positive correlation; hours of revision and test score generally rise together, which is also positive correlation; and as outdoor temperature rises, fewer woolly hats are sold, which is negative correlation. Negative correlation is still a real relationship between two variables — it is not the same thing as no relationship at all, so the temperature and hats pair is not the answer to this question.
- (a) The means are equal, and Class B's marks are the more consistent because its range is smaller. — Method: comparing two distributions needs two things — a measure of average and a measure of spread — and each must be put into the context of the question. Working: both classes have a mean mark of 70, so on average the two classes scored the same; the range measures spread, and Class A's range of 30 marks is three times Class B's range of 10 marks, so Class B's marks sit closely around the mean while Class A's are far more spread out. Answer: the means are equal, and Class B's marks are the more consistent because its range is smaller. The distractors: the reply crediting Class A with more consistency reverses the meaning of the range, treating a larger range as tighter data when a larger range means more spread; the reply that Class A's mean mark is higher compares the wrong pair of figures, reading the range of 30 as an average; the reply that Class B's mean mark is higher reads the spread correctly but its claim about the means is false, since both means are 70.
- (c) Neither causes the other; sunshine links both. — Both ice cream sales and sunburn cases tend to rise on hot, sunny days, so the amount of sunshine is a third factor linked to both — neither variable causes the other. Saying ice cream sales cause the sunburn assumes a causal link in one direction that the correlation alone cannot establish. Saying sunburn cases cause the ice cream sales assumes the reverse causal link, which is no more justified. Saying a strong correlation always means causation is the general error this question is testing: correlation, however strong, does not by itself prove that one variable causes the other.
Build your own mix at the worksheet builder.