Printable · GCSE Higher · ages 14-16
Statistics worksheet — GCSE Higher
Fifteen questions across the statistics statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Statistics worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) On average a plant grew 1.5 cm taller for each extra day — Method: in the equation of a line, the number multiplying x is the gradient, and a gradient states the change in y produced by an increase of 1 in x, read in the units of the two axes. Working: here x is measured in days and y in centimetres, so the gradient 1.5 carries the units centimetres per day. Testing it on the line, 5 days gives 1.5 × 5 + 4 = 11.5 cm and 6 days gives 1.5 × 6 + 4 = 13 cm, a rise of 1.5 cm for the one extra day. Answer: on average a plant grew 1.5 cm taller for each extra day of watering. The distractors: 1.5 cm as the height before any watering is the value of y when x is 0, which is the other number in the equation, 4 cm, so this swaps the gradient and the intercept; 1.5 cm as the gap between the tallest and the shortest plant reads the gradient as a range, when a range is a difference between two of the 16 plants and a gradient is a rate; 1.5 days for each extra centimetre inverts the rate, dividing days by centimetres instead of centimetres by days, and the line gives 1 cm of growth in two thirds of a day.
- (c) No, the mode here is the lowest value of the nine — Method: an average is meant to stand for the data as a whole, so test any proposed average by asking how many values it sits near. Working: the value 4 appears three times and every other count appears once, so 4 is indeed the mode. But those three hours are the quiet ones at the start of the day, and the other six counts run from 11 up to 25; putting the nine counts in order, the middle one is the fifth, which is 13. So the mode sits at the very bottom of the data, with six of the nine hours far above it. Answer: no, because the mode here is the lowest value of the nine, so it describes the quiet opening hours rather than a typical hour. The distractors: saying the mode can only be used when no value repeats reverses the definition, since a mode exists only because a value does repeat; saying the mode is the value that occurs most often is a correct definition, but being the commonest value does not make a value typical when it lies at one end of the data; saying the mode is the best average for any list of numbers ignores the fact that mean, median and mode each describe a population well in different circumstances.
- (d) 300 pupils — Method: an estimate for a whole population is made by finding the proportion in the sample and applying that same proportion to the population. Working: in the sample 30 of the 50 pupils prefer sport, a proportion of 30 ÷ 50 = 0.6, and applying that proportion to the school gives 0.6 × 500 = 300 pupils. Answer: 300 pupils, and it is only an estimate, because a different random sample of 50 would give a slightly different figure. The distractors: 200 pupils comes from scaling up the 20 pupils in the sample who did not prefer sport, 20 × 10, which answers the opposite question; 150 pupils comes from reading 30 out of 50 as 30% and taking 30% of 500; 60 pupils comes from working out the proportion correctly as 60% and then writing the 60 down as a number of pupils instead of applying it to the 500.
- (d) Correlation is a link; causation is one causing the other — Method: the two words describe different claims — one is about a pattern in the data, the other is about what produced that pattern. Working: correlation says only that two quantities tend to change together, which is something a scatter graph can display; causation says that a change in one quantity actually brings about the change in the other, which needs evidence a scatter graph cannot supply, because a third quantity may be driving both. Answer: correlation is a link between the quantities, while causation is one quantity causing the change in another. The distractors: the statement giving causation as the link and correlation as the cause simply swaps the two words over; the statement that the words mean the same thing is the classic error of reading a correlation as proof of cause; the statement that a scatter graph shows causation but not correlation reverses what a scatter graph can do, since the pattern it displays is exactly the correlation.
- (a) 1,400 and 1,240, so combine the samples for one estimate — Method: scale each sample up to the whole stock, then use the fact that a larger sample gives a more reliable estimate than a smaller one. Working: the first sample gives 35 ÷ 50 = 0.7 and 0.7 × 2,000 = 1,400 paperbacks; the second gives 31 ÷ 50 = 0.62 and 0.62 × 2,000 = 1,240 paperbacks. Two random samples of the same size are expected to differ a little, so neither estimate is wrong. Putting the two together gives 35 + 31 = 66 paperbacks in 100 books, and 66 ÷ 100 = 0.66 with 0.66 × 2,000 = 1,320, an estimate resting on twice as many books as either volunteer checked. Answer: 1,400 and 1,240, so combine the samples for one estimate. The distractors: keeping 1,400 because it is larger picks an estimate by its size, when both samples held 50 books and neither has a stronger claim; saying a volunteer must have miscounted assumes two random samples ought to agree exactly, which is precisely what random sampling does not promise; 1,750 and 1,550 come from 35 × 50 = 1,750 and 31 × 50 = 1,550, multiplying each count by the size of the sample instead of scaling by 2,000 ÷ 50.
- (c) 72 — Method: on a histogram the frequency of a class is the area of its bar, so frequency = frequency density × class width. Working: the class 50 ≤ m < 80 has width 80 − 50 = 30 grams and a frequency density of 2.4 per gram, so the frequency is 2.4 × 30 = 72. Answer: 72 pebbles. The distractors: 192 comes from using the upper class boundary, 80, as the width, giving 2.4 × 80; 12.5 comes from dividing the width by the density, 30 ÷ 2.4, which reverses the area rule; 2.4 comes from reading the height of the bar as the frequency itself, the commonest mistake on histograms, where a height is a density and only an area is a count.
- (c) 90 — Method: the height of a bar is its frequency density, so twice as tall means twice the frequency density — not twice the frequency, because the two classes have different widths. Then frequency = frequency density × class width. Working: the first bar has frequency density 3 per cm, so the second has frequency density 2 × 3 = 6 per cm; the class 30 ≤ x < 45 is 45 − 30 = 15 cm wide, so its frequency is 6 × 15 = 90. Answer: 90 rods. The distractors: 120 comes from doubling the first bar's frequency instead of its height — the first class holds 3 × 20 = 60 rods, and doubling that ignores the fact that the second class is narrower; 45 comes from using the first bar's frequency density, 3, for the second bar, 3 × 15, and so never using the information that it is twice as tall; 6 comes from stopping at the frequency density of the taller bar and quoting a height as though it were a count.
- (c) 28 — Method: multiply the number of whole symbols by the value of one symbol, then add the value of any half symbol shown. Working: 3 whole symbols represent 3 × 8 = 24 cars. The half symbol represents 4 cars. Total cars sold in March = 24 + 4 = 28. Leaving out the half symbol, 3 × 8 = 24, undercounts by exactly the value of that half symbol. Treating the half symbol as if it were a full symbol, 4 × 8 = 32, overcounts because it doubles the value the half symbol is worth. Giving 3.5 reports the number of symbols shown, not the number of cars they represent — the key still needs to be applied. Always apply the key to every symbol shown, including a half symbol, rather than reading off the symbol count itself.
- (a) 62.5 — Method: a mean cannot be averaged with a new value — rebuild the total, add the new value to it, then divide by the new count. Working: three numbers with a mean of 50 have a total of 50 × 3 = 150; adding 100 makes the total 150 + 100 = 250; there are now 4 numbers, so the new mean is 250 ÷ 4 = 62.5. Answer: 62.5. The distractors: 75 comes from averaging the old mean with the new value, (50 + 100) ÷ 2, which ignores that three numbers pull against one; 50 comes from assuming an extra value leaves the mean unchanged; 37.5 comes from dividing the old total of 150 by the new count of 4, adding the new value to the count but not to the total.
- (d) No, the range uses only the fastest and slowest time — Method: check what the range is built from, then look at what it leaves out. Working: both teams have a fastest time of 20 seconds and a slowest of 40 seconds, so both ranges are 40 − 20 = 20 seconds and Tomás has that part right. But the range is calculated from those two values alone. Six of Team A's seven times lie between 20 and 25 seconds, with a single time far out at 40; Team B is the other way round, with six of its seven times at 30 seconds or more and a single time far out at 20. So Team A bunches at the fast end and Team B at the slow end. The two patterns are quite different, and the range cannot see the difference because the five middle times never enter the calculation. Answer: no, because the range uses only the fastest and slowest time. The distractors: comparing the means answers a different question, since a mean measures position rather than spread, and two sets with the same spread can have different means; saying that equal ranges mean equal spread is the very assumption that fails here; saying that seven times each forces the spreads to match confuses the size of a data set with how its values are arranged inside it.
- (c) 145 g — Method: find the position of the median from the total frequency, locate the class that contains it, then use linear interpolation inside that class, assuming the apples in it are spread evenly. Working: the median is the 100 ÷ 2 = 50th apple; the running totals are 10, then 10 + 30 = 40, then 40 + 40 = 80, so the 50th apple lies in the class 140 ≤ m < 160; it is the 50 − 40 = 10th of the 40 apples in that class, and the class is 20 g wide, so the median is 140 + (10 ÷ 40) × 20 = 140 + 5 = 145. Answer: an estimated median of 145 g. The distractors: 150 g comes from giving the midpoint of the class that contains the median instead of interpolating inside it; 140 g comes from stopping at the lower boundary of that class, which locates the class but not the value; 155 g comes from measuring the 5 g step down from the upper boundary, 160 − 5, instead of up from the lower boundary.
- (d) 44 — Method: a cumulative frequency counts everything below a value, so the frequency of a class is the running total at the top of the class minus the running total at the bottom of it. Working: the running total below 20 kg is 96 and the running total below 10 kg is 52, so the number of boxes in the class 10 ≤ m < 20 is 96 − 52 = 44. Answer: 44 boxes. The distractors: 96 comes from quoting the running total at 20 kg itself, which counts every box below 20 kg rather than only those in this class; 34 comes from subtracting the wrong pair, 52 − 18, which gives the class 5 ≤ m < 10 instead; 54 comes from subtracting from the grand total, 150 − 96, which gives the boxes of 20 kg or more.
- (b) 13 — The total is 50, and the two known parts are 22 (tea) and 15 (coffee), so 50 − 22 − 15 = 13 hot chocolates. Choosing 28 comes from 50 − 22, subtracting only the tea and forgetting the coffee. Choosing 35 comes from 50 − 15, subtracting only the coffee and forgetting the tea. Choosing 37 comes from 22 + 15, which finds how many drinks were tea or coffee, not the number left over for hot chocolate.
- (a) 1.5 — Method: with an even number of values the median is the mean of the two middle values, which for 12 values are the 6th and the 7th once the data are in order. Working: the results are already in order, and 12 ÷ 2 = 6, so the middle pair are the 6th value, 1, and the 7th value, 2; the median is (1 + 2) ÷ 2 = 1.5. Answer: 1.5 brothers and sisters. The distractors: 1 comes from reading the 6th value and stopping there instead of averaging the middle pair; 2 comes from working out the mean, 24 ÷ 12, instead of the median; 6 comes from working out the range, 6 − 0, which measures spread rather than centre.
- (c) 76 — Method: the frequency of each class is the area of its bar, frequency density × class width, so work out all three frequencies and add them. Working: the widths are 5, 10 and 25 kg, so the frequencies are 4 × 5 = 20, 2.6 × 10 = 26 and 1.2 × 25 = 30; the total is 20 + 26 + 30 = 76. Answer: 76 dogs. The distractors: 7.8 comes from adding the three frequency densities, 4 + 2.6 + 1.2, treating each height as though it were a count; 107 comes from using each upper class boundary as the width, giving 4 × 5, 2.6 × 15 and 1.2 × 40; 39 comes from using the first class width, 5, for every bar, which ignores the unequal intervals and gives 20 + 13 + 6.
Build your own mix at the worksheet builder.