Printable · GCSE Higher · ages 14-16
Statistics worksheet — GCSE Higher
Fifteen questions across the statistics statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Statistics worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) 60 — Method: for n ordered values, the upper quartile sits at position 3(n + 1) ÷ 4, counting from the smallest. Working: n + 1 = 11 + 1 = 12; 3 × 12 = 36 and 36 ÷ 4 = 9, so the upper quartile is the 9th value in the list 40, 42, 45, 47, 50, 52, 55, 58, 60, 63, 65, which is 60. Answer: the upper quartile is 60 seconds. Watch which quartile you find: counting to the 6th value gives the median, 52, not the upper quartile; using 3 × 11 = 33 and 33 ÷ 4 = 8.25 without adding 1 to n first, then rounding down, reaches the 8th value, 58, not the 9th; and counting to the 3rd value uses the lower quartile's position, 45, the wrong end of the list.
- (d) 18 minutes — Method: the lower quartile is the 80 ÷ 4 = 20th value and the upper quartile is the 3 × 80 ÷ 4 = 60th value; locate each inside its class by linear interpolation, then subtract. Working: the 20th value lies between the running totals 8 and 28, so it is in the class 10 ≤ t < 20, which holds 20 journeys across 10 minutes, and it is the 20 − 8 = 12th of them, giving 10 + (12 ÷ 20) × 10 = 16 minutes; the 60th value lies between the running totals 52 and 72, so it is in the class 30 ≤ t < 40, which also holds 20 journeys across 10 minutes, and it is the 60 − 52 = 8th of them, giving 30 + (8 ÷ 20) × 10 = 34 minutes; subtracting, 34 − 16 = 18. Answer: an estimated interquartile range of 18 minutes. The distractors: 20 minutes comes from taking the lower boundaries of the two quartile classes, 30 − 10, which locates the classes but never the values inside them; 40 minutes comes from subtracting the two positions, 60 − 20, instead of the two times; 22 minutes comes from interpolating downwards from each upper boundary rather than upwards from each lower boundary, giving 20 − 6 = 14 and 40 − 4 = 36.
- (c) 72 — Method: on a histogram the frequency of a class is the area of its bar, so frequency = frequency density × class width. Working: the class 50 ≤ m < 80 has width 80 − 50 = 30 grams and a frequency density of 2.4 per gram, so the frequency is 2.4 × 30 = 72. Answer: 72 pebbles. The distractors: 192 comes from using the upper class boundary, 80, as the width, giving 2.4 × 80; 12.5 comes from dividing the width by the density, 30 ÷ 2.4, which reverses the area rule; 2.4 comes from reading the height of the bar as the frequency itself, the commonest mistake on histograms, where a height is a density and only an area is a count.
- (b) 74 marks — Method: the two groups are different sizes, so their means cannot simply be averaged — rebuild each group's total mark, add the totals and divide by all 50 pupils. Working: Group A scored 20 × 80 = 1600 marks and Group B scored 30 × 70 = 2100 marks, giving 1600 + 2100 = 3700 marks altogether, so the overall mean is 3700 ÷ 50 = 74 marks. Answer: 74 marks, which sits nearer to 70 than to 80 because the larger group scored 70. The distractors: 75 marks comes from averaging the two group means, (80 + 70) ÷ 2, as though the groups were the same size; 76 marks comes from attaching each mean to the other group's size, (20 × 70 + 30 × 80) ÷ 50; 150 marks comes from adding the two means together and never dividing at all.
- (a) Equal means; Class A is more consistent, smaller range. — Method: when two data sets share a measure of location, compare a measure of spread to say more about consistency. Working: both classes have the same mean mark, 14, so on average they performed equally well. Class A has the smaller range, 6, so its marks are more tightly grouped around 14 than Class B's marks, which vary by as much as 14. So Class A's marks were more consistent, even though neither class did better on average. Saying Class B did better because it has the bigger range confuses a wide spread with a high score — a big range describes variability, not performance. Saying Class A did better because it has the smaller range makes the same mistake in the other direction: the two classes are tied on the mean, so neither one 'did better'. Saying the classes cannot be compared because their means are equal misses the whole point of also comparing the range. Always compare both an average AND a spread before describing two data sets — either one alone tells only half the story.
- (c) Because every pupil has an equal chance of being picked — Method: whether a sample represents its population is decided by the selection method, not by the size of the sample, so ask whether the method gives every member of the population the same chance of being chosen. Working: the names are drawn at random from a list of all 10,000 pupils, so each pupil has the same chance, 500 out of 10,000, of being drawn, and no group of pupils is more likely to appear than any other; that is what keeps bias out of the sample. Answer: because every pupil has an equal chance of being picked. The distractors: the reply about 5% treats the sampling fraction as the test of fairness, but a badly chosen 5% is still biased and a well chosen 1% is not; the reply about 500 being large enough makes size the test instead, which is the same mistake in another form, since a large sample drawn from one school would still misrepresent the city; the reply about the most willing pupils describes self-selection, which hands the choice of who is in the sample to the pupils who feel most strongly about the question.
- (b) On average a plant grew 1.5 cm taller for each extra day — Method: in the equation of a line, the number multiplying x is the gradient, and a gradient states the change in y produced by an increase of 1 in x, read in the units of the two axes. Working: here x is measured in days and y in centimetres, so the gradient 1.5 carries the units centimetres per day. Testing it on the line, 5 days gives 1.5 × 5 + 4 = 11.5 cm and 6 days gives 1.5 × 6 + 4 = 13 cm, a rise of 1.5 cm for the one extra day. Answer: on average a plant grew 1.5 cm taller for each extra day of watering. The distractors: 1.5 cm as the height before any watering is the value of y when x is 0, which is the other number in the equation, 4 cm, so this swaps the gradient and the intercept; 1.5 cm as the gap between the tallest and the shortest plant reads the gradient as a range, when a range is a difference between two of the 16 plants and a gradient is a rate; 1.5 days for each extra centimetre inverts the rate, dividing days by centimetres instead of centimetres by days, and the line gives 1 cm of growth in two thirds of a day.
- (c) A histogram, with frequency density up the vertical axis — Method: decide which diagram makes area stand for frequency, which is the property the question asks for. Working: on a histogram the vertical axis is frequency density, so the area of a bar is frequency density × class width, and that product is the frequency; this is exactly what is wanted, and it is what allows classes of unequal width to be shown fairly. Answer: a histogram, with frequency density up the vertical axis. The distractors: a bar chart plots frequency as the height, so with unequal widths a wide class would cover far more area than a narrow class holding the same number of batteries, and area would measure nothing; a cumulative frequency diagram plots running totals against upper class boundaries, so a point on it gives how many lie below a value rather than how many lie in a class; a pie chart shows each class as a share of the whole 300 and loses the class widths entirely, so no area on it is tied to a scale of hours.
- (b) 5 ≤ m < 10 — Method: with 60 values the median is the 60 ÷ 2 = 30th value in order, so build a running total until it first reaches 30. Working: the running totals are 22 after the first class, 22 + 20 = 42 after the second, 51 after the third, 56 after the fourth and 60 after the fifth; the 30th parcel is past 22 but not past 42, so it lies in the second class. Answer: the median lies in the class 5 ≤ m < 10. The distractors: 0 ≤ m < 5 comes from giving the class with the greatest frequency, 22, which is the modal class and not the median class; 10 ≤ m < 20 comes from choosing the middle class in the list of five instead of counting to the middle value; 20 ≤ m < 30 comes from halving the range of the data, 50 ÷ 2 = 25, and giving the class that contains 25 kg rather than the class that contains the 30th parcel.
- (d) No, the range uses only the fastest and slowest time — Method: check what the range is built from, then look at what it leaves out. Working: both teams have a fastest time of 20 seconds and a slowest of 40 seconds, so both ranges are 40 − 20 = 20 seconds and Tomás has that part right. But the range is calculated from those two values alone. Six of Team A's seven times lie between 20 and 25 seconds, with a single time far out at 40; Team B is the other way round, with six of its seven times at 30 seconds or more and a single time far out at 20. So Team A bunches at the fast end and Team B at the slow end. The two patterns are quite different, and the range cannot see the difference because the five middle times never enter the calculation. Answer: no, because the range uses only the fastest and slowest time. The distractors: comparing the means answers a different question, since a mean measures position rather than spread, and two sets with the same spread can have different means; saying that equal ranges mean equal spread is the very assumption that fails here; saying that seven times each forces the spreads to match confuses the size of a data set with how its values are arranged inside it.
- (a) 27 — Method: turn the mean into a total using total = mean × number of values, then subtract the numbers that are already known. Working: four numbers with a mean of 18 have a total of 18 × 4 = 72; the three known numbers give 10 + 15 + 20 = 45; so x = 72 − 45 = 27. Answer: 27, and checking, (10 + 15 + 20 + 27) ÷ 4 = 72 ÷ 4 = 18. The distractors: 72 comes from stopping at the total the four numbers must reach and never subtracting the known three; 18 comes from assuming the missing number must equal the mean; 45 comes from stopping at the total of the three known numbers.
- (c) No — 8 from one class is too small to represent the school. — Method: judge reliability by asking whether the sample is both large enough, and spread across the population, relative to what it is meant to represent. Working: 8 pupils is a tiny fraction of the school's 1,000 pupils, and all 8 come from a single class rather than a range of year groups, so the sample is both too small and too narrow to represent the whole school reliably. She is not right. Saying any sample size gives an equally reliable estimate ignores that reliability generally improves with a larger, more representative sample. Saying the method is unreliable because it was not done online is not a reason connected to sample size or representativeness at all. Saying 8 is reliable because it is more than half her class compares the sample to the wrong population — the school has 1,000 pupils, not one class. Always judge a sample's size against the population it is meant to represent, not against a smaller group within it.
- (d) 648 kg — Method: to estimate a total from a sample, multiply the sample's mean by the number of items in the whole population, then check the units the question asks for. Working: 32.4 g × 20,000 = 648,000 g. Converting to kilograms, 648,000 ÷ 1,000 = 648 kg. This is only an estimate, not an exact total, because it assumes every one of the 20,000 packets has exactly the sample mean mass, when in reality individual packets vary above and below it. Giving 1.62 kg multiplies the mean by 50, the SAMPLE size, instead of by 20,000, the number of packets actually made that day — this finds the total mass of the 50 sampled packets, not the day's production. Giving 32.4 kg treats the sample mean itself, in grams, as if it already were the day's total mass in kilograms, skipping the scaling up altogether. Giving 648,000 kg correctly scales the mean up to the whole day's production but never converts the answer from grams to kilograms, leaving it 1,000 times too large. Always scale a sample's mean up by the SIZE OF THE WHOLE POPULATION, and always finish by checking the units the question asks for.
- (b) A person's shoe size and their favourite colour — A person's shoe size is not linked to which colour they prefer, so these two show no correlation. The other three pairs are all genuinely correlated: distance travelled and fuel used rise together, which is positive correlation; hours of revision and test score generally rise together, which is also positive correlation; and as outdoor temperature rises, fewer woolly hats are sold, which is negative correlation. Negative correlation is still a real relationship between two variables — it is not the same thing as no relationship at all, so the temperature and hats pair is not the answer to this question.
- (b) 4 — The difference, Bristol minus Leeds, on each day is: Monday 4 − 3 = 1, Tuesday 4 − 5 = −1, Wednesday 6 − 2 = 4, Thursday 2 − 4 = −2. The greatest amount by which Bristol exceeded Leeds is 4 hours, on Wednesday. Choosing 1 takes Monday's smaller positive difference instead of the greatest one. Choosing 2 takes the size of Thursday's difference, but that is the amount by which Leeds exceeded Bristol, the opposite direction to the one asked for. Choosing 6 takes Bristol's raw figure on Wednesday without subtracting Leeds's 2 hours first.
Build your own mix at the worksheet builder.