Printable · GCSE Higher · ages 14-16
Statistics worksheet — GCSE Higher
Fifteen questions across the statistics statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Statistics worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) 16 — Method: on a box plot the interquartile range is the width of the box itself, upper quartile take away lower quartile. Working: the upper quartile is 38 and the lower quartile is 22, so 38 − 22 = 16. Answer: the interquartile range is 16 years. Watch which part of the box plot you are reading: the whole line from whisker to whisker gives the range, 61 − 15 = 46; the left half of the box alone gives median take away lower quartile, 29 − 22 = 7; and the right half of the box alone gives upper quartile take away median, 38 − 29 = 9 — neither half is the interquartile range on its own.
- (a) Equal means; Class A is more consistent, smaller range. — Method: when two data sets share a measure of location, compare a measure of spread to say more about consistency. Working: both classes have the same mean mark, 14, so on average they performed equally well. Class A has the smaller range, 6, so its marks are more tightly grouped around 14 than Class B's marks, which vary by as much as 14. So Class A's marks were more consistent, even though neither class did better on average. Saying Class B did better because it has the bigger range confuses a wide spread with a high score — a big range describes variability, not performance. Saying Class A did better because it has the smaller range makes the same mistake in the other direction: the two classes are tied on the mean, so neither one 'did better'. Saying the classes cannot be compared because their means are equal misses the whole point of also comparing the range. Always compare both an average AND a spread before describing two data sets — either one alone tells only half the story.
- (c) Because every pupil has an equal chance of being picked — Method: whether a sample represents its population is decided by the selection method, not by the size of the sample, so ask whether the method gives every member of the population the same chance of being chosen. Working: the names are drawn at random from a list of all 10,000 pupils, so each pupil has the same chance, 500 out of 10,000, of being drawn, and no group of pupils is more likely to appear than any other; that is what keeps bias out of the sample. Answer: because every pupil has an equal chance of being picked. The distractors: the reply about 5% treats the sampling fraction as the test of fairness, but a badly chosen 5% is still biased and a well chosen 1% is not; the reply about 500 being large enough makes size the test instead, which is the same mistake in another form, since a large sample drawn from one school would still misrepresent the city; the reply about the most willing pupils describes self-selection, which hands the choice of who is in the sample to the pupils who feel most strongly about the question.
- (b) Q was faster on average and more consistent — Method: compare the medians for the average and the interquartile ranges for the spread, remembering that a shorter time is faster and a smaller interquartile range means more consistent. Working: the median for class Q is 35 seconds against 38 seconds for class P, so class Q was faster on average; the interquartile range for class P is 46 − 24 = 22 seconds and for class Q it is 44 − 30 = 14 seconds, so class Q's times are more tightly grouped. Answer: class Q was faster on average and more consistent. The distractors: calling Q slower comes from comparing the lower quartiles, 30 against 24, as though a quartile were the average; calling Q less consistent comes from using the gap between the median and the upper quartile as the spread, 44 − 35 = 9 against 46 − 38 = 8, instead of the full interquartile range; the statement that Q was both slower and less consistent comes from making both of those mistakes together.
- (d) 44 — Method: a cumulative frequency counts everything below a value, so the frequency of a class is the running total at the top of the class minus the running total at the bottom of it. Working: the running total below 20 kg is 96 and the running total below 10 kg is 52, so the number of boxes in the class 10 ≤ m < 20 is 96 − 52 = 44. Answer: 44 boxes. The distractors: 96 comes from quoting the running total at 20 kg itself, which counts every box below 20 kg rather than only those in this class; 34 comes from subtracting the wrong pair, 52 − 18, which gives the class 5 ≤ m < 10 instead; 54 comes from subtracting from the grand total, 150 − 96, which gives the boxes of 20 kg or more.
- (b) 55 — Method: count the classes that lie wholly above 8 minutes, then use linear interpolation for the class that 8 cuts through, assuming the delays in that class are spread evenly. Working: the class 10 ≤ d < 20 lies wholly above 8 and holds 25 buses; the value 8 lies in the class 5 ≤ d < 10, which is 5 minutes wide and holds 75 buses, and the part above 8 runs from 8 to 10, a width of 2, so the estimated share is (2 ÷ 5) × 75 = 30 buses; the estimate is 30 + 25 = 55. Answer: about 55 refunds. The distractors: 100 comes from adding the whole of the class 5 ≤ d < 10, 75 + 25, and so refunding buses only 5 minutes late; 25 comes from using only the class 10 ≤ d < 20 and ignoring the part class that 8 minutes cuts through; 70 comes from taking the part of the class from 5 up to 8 instead of from 8 up to 10, giving (3 ÷ 5) × 75 = 45 and then 45 + 25.
- (c) The class with times from 10 up to 20 — Method: to find the median class from a histogram, first turn each bar's frequency density into a frequency using density × class width, build up the cumulative frequency, and find the first class whose cumulative frequency reaches or passes n ÷ 2. Working: the four classes have widths 10, 10, 20 and 20, so their frequencies are 5 × 10 = 50, 2 × 10 = 20, 1.5 × 20 = 30 and 1 × 20 = 20, which add to the 120 visitors stated. The median sits at position 120 ÷ 2 = 60. The cumulative frequency is 50 after the first class and 50 + 20 = 70 after the second, so the 60th visitor is reached during the second class. Answer: the median lies in the class 10 ≤ t < 20. Watch which class each shortcut lands on: the tallest bar belongs to the first class, with the highest frequency density, 5 — but the tallest bar shows where visitors are packed most densely, not where the middle visitor falls, and picking it lands one class too early, at 0 ≤ t < 10; taking half of the total TIME span instead of half of the total NUMBER of visitors, 60 minutes ÷ 2 = 30 minutes, lands in the class 20 ≤ t < 40, confusing a value on the horizontal axis with a position in the data; and using the full 120 visitors as the target position, rather than 120 ÷ 2 = 60, reaches all the way to the last class, 40 ≤ t < 60, treating the whole data set's size as though it were the position of a single middle value.
- (c) 28 — Method: multiply the number of whole symbols by the value of one symbol, then add the value of any half symbol shown. Working: 3 whole symbols represent 3 × 8 = 24 cars. The half symbol represents 4 cars. Total cars sold in March = 24 + 4 = 28. Leaving out the half symbol, 3 × 8 = 24, undercounts by exactly the value of that half symbol. Treating the half symbol as if it were a full symbol, 4 × 8 = 32, overcounts because it doubles the value the half symbol is worth. Giving 3.5 reports the number of symbols shown, not the number of cars they represent — the key still needs to be applied. Always apply the key to every symbol shown, including a half symbol, rather than reading off the symbol count itself.
- (b) 5 ≤ m < 10 — Method: with 60 values the median is the 60 ÷ 2 = 30th value in order, so build a running total until it first reaches 30. Working: the running totals are 22 after the first class, 22 + 20 = 42 after the second, 51 after the third, 56 after the fourth and 60 after the fifth; the 30th parcel is past 22 but not past 42, so it lies in the second class. Answer: the median lies in the class 5 ≤ m < 10. The distractors: 0 ≤ m < 5 comes from giving the class with the greatest frequency, 22, which is the modal class and not the median class; 10 ≤ m < 20 comes from choosing the middle class in the list of five instead of counting to the middle value; 20 ≤ m < 30 comes from halving the range of the data, 50 ÷ 2 = 25, and giving the class that contains 25 kg rather than the class that contains the 30th parcel.
- (d) Full-time workers, as most are at work at that time — Method: a sample is biased when the method of contact makes part of the population much less likely to be reached, so test each group against where its members actually are between 10 am and 2 pm on a weekday, and test each stated reason against the facts. Working: those hours are the middle of the working day, so people in full-time employment are at work and not beside a landline telephone, while people who are retired and people who are unemployed are far more likely to be at home and are reached at the usual rate; the method therefore collects far fewer replies from full-time workers than their share of the adult population the council is consulting. Answer: full-time workers, as most are at work at that time. The distractors: the reply naming retired people rests on the false claim that most retired people are at work in the daytime, when in fact a daytime call reaches them more easily than anyone; the reply naming unemployed people rests on the false claim that they are out during the day, when they too are among the easiest people to reach by a daytime call; the reply naming children rests on the false claim that children are at home at 11 am on a Tuesday, when they are at school and so are not reached by the call at all, and school-age children are in any case not the adults whose views the council is collecting.
- (a) 40 — Method: the mean is the total divided by how many values there are, so rearranging gives total = mean × number of values. Working: the mean is 8 and there are 5 numbers, so the total is 8 × 5 = 40. Answer: 40, and checking, 40 ÷ 5 = 8, which is the mean given. The distractors: 13 comes from adding the mean and the count, 8 + 5, instead of multiplying them; 1.6 comes from dividing the mean by the count, 8 ÷ 5, which reverses the relationship; 8 comes from quoting the mean itself as the total, which is only true when there is a single number.
- (b) Treat them as outliers and check them before deciding — Method: a point lying a long way from the pattern the rest of the data make is called an outlier, and an outlier is investigated before anything is done with it, because it may be an error in the data or it may be a genuine but unusual case. Working: 48 of the 50 points lie close to the rising line of best fit, so the trend is set by those 48; the two remaining points do not follow it, so they are identified as outliers and checked — a mistake in measuring or recording would be corrected, while a genuine reading would be kept and reported. Answer: treat them as outliers and check them before deciding what to do with them. The distractors: deleting them at once assumes that every point far from the line must be an error, which throws away real data; moving the line so that it passes through them assumes a line of best fit must touch particular points, when it is drawn to follow all 50; taking them as proof that there is no correlation lets two points overturn the pattern that the other 48 agree on.
- (d) No, the range uses only the fastest and slowest time — Method: check what the range is built from, then look at what it leaves out. Working: both teams have a fastest time of 20 seconds and a slowest of 40 seconds, so both ranges are 40 − 20 = 20 seconds and Tomás has that part right. But the range is calculated from those two values alone. Six of Team A's seven times lie between 20 and 25 seconds, with a single time far out at 40; Team B is the other way round, with six of its seven times at 30 seconds or more and a single time far out at 20. So Team A bunches at the fast end and Team B at the slow end. The two patterns are quite different, and the range cannot see the difference because the five middle times never enter the calculation. Answer: no, because the range uses only the fastest and slowest time. The distractors: comparing the means answers a different question, since a mean measures position rather than spread, and two sets with the same spread can have different means; saying that equal ranges mean equal spread is the very assumption that fails here; saying that seven times each forces the spreads to match confuses the size of a data set with how its values are arranged inside it.
- (d) Both the mean and the range increase. — The original mean is 150 + 152 + 155 + 158 + 160 = 775, and 775 ÷ 5 = 155 cm; the original range is 160 − 150 = 10 cm. Including the new height of 170 cm gives a new total of 775 + 170 = 945, and 945 ÷ 6 = 157.5 cm, which is higher than 155 cm, and a new range of 170 − 150 = 20 cm, which is higher than 10 cm, so both the mean and the range increase. Saying the range stays the same ignores that 170 cm is a new, higher maximum than the old 160 cm. Saying the mean stays the same ignores that 170 cm is above the original mean of 155 cm, which pulls the average up. Saying both decrease is the opposite of what happens here.
- (c) Club members probably eat differently from most people — Method: a sample is biased when the group it is drawn from differs from the population in the very thing the survey is measuring, so compare the subgroup with the population on that quantity. Working: the survey measures eating habits, and people who join a sports club take more exercise than average and are known to eat differently from the town as a whole, so their replies pull the results away from the true picture for the town however many of them are asked. Answer: club members probably eat differently from most people. The distractors: the reply about the number of members treats bias as a question of size, but a large biased sample is still biased; the reply that the members were picked at random is false, since the council picked a club rather than picking residents, and it confuses bias with non-response; the reply that everyone asked lives in the town notes something true of the members but draws the false conclusion that the sample therefore covers the town, when a sample must reflect a population and not merely be taken from inside it.
Build your own mix at the worksheet builder.