Printable · GCSE Higher · ages 14-16
Statistics worksheet — GCSE Higher
Fifteen questions across the statistics statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Statistics worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) No, 90 cm is far outside the heights on the graph — Method: a line of best fit describes the trend only across the stretch of data it was drawn through; predicting beyond that stretch is extrapolation, and nothing in the data supports it. Working: the heights used to draw this line run from 150 cm to 180 cm, all of them Year 10 pupils, while 90 cm is 60 cm below the shortest of them and belongs to a two-year-old child, whose build follows no trend the graph has measured. Substituting anyway gives 0.9 × 90 − 85 = −4, a mass of −4 kg, which cannot exist. Answer: no, because 90 cm is far outside the heights on the graph. The distractors: saying a line of best fit cannot be used to predict at all throws away its main purpose, since a prediction made between the plotted values is perfectly sound; saying the line passes through all 20 points misdescribes a line of best fit, which is drawn to follow the trend of the points and will normally pass through few of them; saying the equation works for any value put into it treats an equation fitted to Year 10 heights as a law of nature, and the mass of −4 kg shows what that assumption produces.
- (d) An outlier from the damaged wing, not the trend. — That bird's point lies a long way from the rising trend followed by every other bird, and its low wingspan is explained by the damaged wing rather than by its age — it is an outlier caused by an unusual factor, not part of the general relationship between age and wingspan, so it should not be used when drawing the line of best fit. Saying every point must be used ignores that an outlier caused by a separate, identifiable factor can rightly be set aside. Saying it shows no correlation ignores that the other 19 points do show a clear rising trend; one outlier does not remove that. Saying it proves the line is inaccurate confuses one unusual bird with a fault in the line itself, when the line correctly describes the trend followed by the rest of the data.
- (b) Q was faster on average and more consistent — Method: compare the medians for the average and the interquartile ranges for the spread, remembering that a shorter time is faster and a smaller interquartile range means more consistent. Working: the median for class Q is 35 seconds against 38 seconds for class P, so class Q was faster on average; the interquartile range for class P is 46 − 24 = 22 seconds and for class Q it is 44 − 30 = 14 seconds, so class Q's times are more tightly grouped. Answer: class Q was faster on average and more consistent. The distractors: calling Q slower comes from comparing the lower quartiles, 30 against 24, as though a quartile were the average; calling Q less consistent comes from using the gap between the median and the upper quartile as the spread, 44 − 35 = 9 against 46 − 38 = 8, instead of the full interquartile range; the statement that Q was both slower and less consistent comes from making both of those mistakes together.
- (c) A histogram, with frequency density up the vertical axis — Method: decide which diagram makes area stand for frequency, which is the property the question asks for. Working: on a histogram the vertical axis is frequency density, so the area of a bar is frequency density × class width, and that product is the frequency; this is exactly what is wanted, and it is what allows classes of unequal width to be shown fairly. Answer: a histogram, with frequency density up the vertical axis. The distractors: a bar chart plots frequency as the height, so with unequal widths a wide class would cover far more area than a narrow class holding the same number of batteries, and area would measure nothing; a cumulative frequency diagram plots running totals against upper class boundaries, so a point on it gives how many lie below a value rather than how many lie in a class; a pie chart shows each class as a share of the whole 300 and loses the class widths entirely, so no area on it is tied to a scale of hours.
- (a) 40 — Method: the mean is the total divided by how many values there are, so rearranging gives total = mean × number of values. Working: the mean is 8 and there are 5 numbers, so the total is 8 × 5 = 40. Answer: 40, and checking, 40 ÷ 5 = 8, which is the mean given. The distractors: 13 comes from adding the mean and the count, 8 + 5, instead of multiplying them; 1.6 comes from dividing the mean by the count, 8 ÷ 5, which reverses the relationship; 8 comes from quoting the mean itself as the total, which is only true when there is a single number.
- (a) 150 bulbs — Method: assume the proportion faulty in a random sample is the proportion faulty in the whole day's output, and scale the sample up to the population. Working: the sample of 80 has to be scaled up to 4,000 bulbs, and 4,000 ÷ 80 = 50, so the day's output is 50 sample-sized batches. Each batch is expected to contain the same 3 faulty bulbs, so the estimate is 3 × 50 = 150. Answer: 150 bulbs, and it is an estimate, because another sample of 80 would probably contain a different number of faulty bulbs. The distractors: 50 bulbs is the scale factor 4,000 ÷ 80 written down as though it were the answer, so it reports how many batches there are rather than how many faulty bulbs; 120 bulbs comes from reading 3 out of 80 as 3%, then taking 0.03 × 4,000 = 120, but 3 out of 80 is 3.75%; 240 bulbs comes from 3 × 80 = 240, multiplying the faulty bulbs by the size of the sample instead of by the scale factor, which uses the 80 twice and the 4,000 not at all.
- (a) x = 0 gives y = −20: a negative number sold — The y-intercept is the value the line predicts when x = 0: y = 3 × 0 − 20 = −20. A kiosk cannot sell a negative number of ice creams, so this is not a sensible estimate. The 3 in the equation is the gradient, not the intercept, so an option claiming x = 0 gives y = 3 has swapped the two numbers around — substituting x = 0 makes the 3x term equal 0, leaving −20, not 3. The danger of extrapolating to very high temperatures is a real issue with this line, but it is a different issue from the y-intercept, so it does not answer this question. And whether x = 0 could occur on a trading day is beside the point: the model still makes that prediction, and it is the prediction itself, −20, that is impossible.
- (a) 30 — Method: an outlier is a value that lies far away from the pattern set by the rest of the data, so compare each value with the group the others form. Working: five of the counts, 5, 7, 8, 9 and 11, lie within 6 of one another and the steps between them are 2, 1, 1 and 2; the remaining count of 30 is 19 above the nearest of them, so it is the value that does not belong to the pattern. Answer: 30. The distractors: 5 comes from picking the smallest value, on the idea that the odd one out must be at the bottom of the list; 11 comes from ordering the data and stopping one value short, taking the largest of the counts that sit close together; 8.5 comes from working out the median, (8 + 9) ÷ 2, and giving a measure of centre where a value standing apart was asked for.
- (c) Class X has the higher median and the wider spread — Method: compare the two box plots statistic by statistic — median for location, and the interquartile range for spread — checking the true value of each rather than assuming a pattern. Working: Class X's median is 60 and Class Y's is 58, so Class X's median is the higher one. Class X's interquartile range is 70 − 45 = 25 and Class Y's is 65 − 50 = 15 (and the ranges follow the same order: 95 − 20 = 75 against 80 − 35 = 45), so Class X also has the wider spread. Answer: Class X has both the higher median and the wider spread. Watch that each half of a compound statement is checked separately: claiming Class Y has the higher median and the wider spread gets both comparisons backwards; claiming Class X has the higher median but the narrower spread keeps the median right while reading the spread the wrong way round; and claiming Class Y has the higher median but the narrower spread swaps the median comparison while getting the spread right.
- (c) 76 — Method: the frequency of each class is the area of its bar, frequency density × class width, so work out all three frequencies and add them. Working: the widths are 5, 10 and 25 kg, so the frequencies are 4 × 5 = 20, 2.6 × 10 = 26 and 1.2 × 25 = 30; the total is 20 + 26 + 30 = 76. Answer: 76 dogs. The distractors: 7.8 comes from adding the three frequency densities, 4 + 2.6 + 1.2, treating each height as though it were a count; 107 comes from using each upper class boundary as the width, giving 4 × 5, 2.6 × 15 and 1.2 × 40; 39 comes from using the first class width, 5, for every bar, which ignores the unequal intervals and gives 20 + 13 + 6.
- (a) 1.5 — Method: with an even number of values the median is the mean of the two middle values, which for 12 values are the 6th and the 7th once the data are in order. Working: the results are already in order, and 12 ÷ 2 = 6, so the middle pair are the 6th value, 1, and the 7th value, 2; the median is (1 + 2) ÷ 2 = 1.5. Answer: 1.5 brothers and sisters. The distractors: 1 comes from reading the 6th value and stopping there instead of averaging the middle pair; 2 comes from working out the mean, 24 ÷ 12, instead of the median; 6 comes from working out the range, 6 − 0, which measures spread rather than centre.
- (a) No, the size of the fire affects both of the quantities — Method: correlation says that two quantities change together; a claim that one of them produces the other is a further claim, and it needs evidence that a scatter graph on its own cannot give. Working: the graph does show strong positive correlation, so more engines did go with greater damage. But neither quantity was set by the researchers: both were decided by how large the fire was. A large blaze brings many appliances and also destroys a great deal, while a small one brings few and destroys little, so a third quantity is driving both of the recorded ones. Answer: no, because the size of the fire affects both of the quantities. The distractors: saying the correlation is negative contradicts the graph, which shows the two quantities rising together, and reaching the right verdict from a false reading of the data is not the reason the mark is for; saying that strong positive correlation shows one quantity causes the other is the assumption the question exists to test, and no strength of correlation can establish cause; saying the points lie close to the line of best fit describes how strong the correlation is, and strength and cause are different matters entirely.
- (c) No, the mode here is the lowest value of the nine — Method: an average is meant to stand for the data as a whole, so test any proposed average by asking how many values it sits near. Working: the value 4 appears three times and every other count appears once, so 4 is indeed the mode. But those three hours are the quiet ones at the start of the day, and the other six counts run from 11 up to 25; putting the nine counts in order, the middle one is the fifth, which is 13. So the mode sits at the very bottom of the data, with six of the nine hours far above it. Answer: no, because the mode here is the lowest value of the nine, so it describes the quiet opening hours rather than a typical hour. The distractors: saying the mode can only be used when no value repeats reverses the definition, since a mode exists only because a value does repeat; saying the mode is the value that occurs most often is a correct definition, but being the commonest value does not make a value typical when it lies at one end of the data; saying the mode is the best average for any list of numbers ignores the fact that mean, median and mode each describe a population well in different circumstances.
- (c) 72 — Method: on a histogram the frequency of a class is the area of its bar, so frequency = frequency density × class width. Working: the class 50 ≤ m < 80 has width 80 − 50 = 30 grams and a frequency density of 2.4 per gram, so the frequency is 2.4 × 30 = 72. Answer: 72 pebbles. The distractors: 192 comes from using the upper class boundary, 80, as the width, giving 2.4 × 80; 12.5 comes from dividing the width by the density, 30 ÷ 2.4, which reverses the area rule; 2.4 comes from reading the height of the bar as the frequency itself, the commonest mistake on histograms, where a height is a density and only an area is a count.
- (c) 27 — Method: a frequency is the area of the part of the bar being asked about, so frequency = frequency density × the width of that part. Working: the part asked about runs from 20 to 35, so its width is 35 − 20 = 15 metres; the frequency density there is 1.8 per metre, so the estimate is 1.8 × 15 = 27. Answer: about 27 throws. The distractors: 72 comes from taking the whole bar, 1.8 × 40, and so counting every throw from 20 up to 60; 1.8 comes from reading the height of the bar as a frequency, when a height is a density and only an area is a count; 63 comes from using the upper value 35 as the width, 1.8 × 35, instead of the width 35 − 20.
Build your own mix at the worksheet builder.