Printable · GCSE Higher · ages 14-16
Statistics worksheet — GCSE Higher
Fifteen questions across the statistics statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Statistics worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 22 — Method: the two subject totals overlap, because every pupil who passed both subjects has been counted once in the maths total and once again in the science total; adding the totals therefore counts those pupils twice, and the overlap has to be taken off once. Working: 18 + 12 = 30, and the 8 pupils who passed both have been counted twice in that 30, so the number who passed at least one subject is 30 − 8 = 22. Answer: 22 pupils, a count of pupils, and it is less than the 30 in the class, which leaves 8 pupils who passed neither. The distractors: 30 comes from adding the two subject totals and never removing the overlap, so it counts the 8 pupils twice; 14 comes from taking the 8 away twice, 18 + 12 − 8 − 8, removing an overlap that was only counted twice once too often; 18 comes from writing down the larger of the two subject totals on its own, which leaves out every pupil who passed science but not maths.
- (b) 13 — The total is 50, and the two known parts are 22 (tea) and 15 (coffee), so 50 − 22 − 15 = 13 hot chocolates. Choosing 28 comes from 50 − 22, subtracting only the tea and forgetting the coffee. Choosing 35 comes from 50 − 15, subtracting only the coffee and forgetting the tea. Choosing 37 comes from 22 + 15, which finds how many drinks were tea or coffee, not the number left over for hot chocolate.
- (a) The means are equal, and Class B's marks are the more consistent because its range is smaller. — Method: comparing two distributions needs two things — a measure of average and a measure of spread — and each must be put into the context of the question. Working: both classes have a mean mark of 70, so on average the two classes scored the same; the range measures spread, and Class A's range of 30 marks is three times Class B's range of 10 marks, so Class B's marks sit closely around the mean while Class A's are far more spread out. Answer: the means are equal, and Class B's marks are the more consistent because its range is smaller. The distractors: the reply crediting Class A with more consistency reverses the meaning of the range, treating a larger range as tighter data when a larger range means more spread; the reply that Class A's mean mark is higher compares the wrong pair of figures, reading the range of 30 as an average; the reply that Class B's mean mark is higher reads the spread correctly but its claim about the means is false, since both means are 70.
- (a) £16,000 — Method: first find the quarter with the highest sales figure, then subtract quarter 1's sales from it — remembering that every figure is given in THOUSANDS of pounds. Working: the highest sales figure is quarter 2, at £34,000 (34 thousand pounds). The increase from quarter 1 is £34,000 − £18,000 = £16,000. Giving £34,000 reads off the highest sales figure on its own, without subtracting quarter 1's sales — that is the highest quarter's total, not the increase. Giving £12,000 uses quarter 3's sales, 30, the SECOND-highest figure, instead of quarter 2's 34, the actual highest — 30 − 18 = 12, but quarter 3 is not the quarter with the highest sales. Giving £16 gets the subtraction right, 34 − 18 = 16, but forgets that every figure in the question is in thousands of pounds, so the increase is £16,000, not £16. Always identify the correct quarter FIRST, and always check the units the numbers are given in before writing your final answer.
- (a) 1.24 — Method: for data given as a frequency table, the mean is Σfx ÷ Σf — multiply each value by its frequency, add the results, then divide by the total frequency. Working: 0 × 6 = 0. 1 × 10 = 10. 2 × 6 = 12. 3 × 3 = 9. So Σfx = 0 + 10 + 12 + 9 = 31. The total frequency is Σf = 6 + 10 + 6 + 3 = 25. Mean = 31 ÷ 25 = 1.24 siblings. Averaging the frequency column itself, (6 + 10 + 6 + 3) ÷ 4 = 6.25, mixes up the frequencies with the values they belong to. Writing down 1, the number of siblings with the highest frequency, gives the mode, not the mean. Writing down 31 stops after finding Σfx and forgets to divide by the total frequency, 25. Always divide Σfx by Σf — never stop at the top of the fraction.
- (c) 10 — Method: work out the mean that can be found straight away, then use total = mean × number of values on the group of three to find the missing number. Working: the mean of 15 and 25 is (15 + 25) ÷ 2 = 40 ÷ 2 = 20, so the group of three must also have a mean of 20; three numbers with a mean of 20 have a total of 20 × 3 = 60, and 20 + 30 = 50 of that total is already accounted for, so x = 60 − 50 = 10. Answer: 10, and checking, (10 + 20 + 30) ÷ 3 = 20. The distractors: 20 comes from working out the mean the two groups share and writing that down as x; −10 comes from dividing the group of three by 2 instead of by 3, which gives x + 50 = 40; 70 comes from reading the total 15 + 25 = 40 as the mean of the pair, which sets the target total at 120 and leaves x = 70.
- (b) Treat them as outliers and check them before deciding — Method: a point lying a long way from the pattern the rest of the data make is called an outlier, and an outlier is investigated before anything is done with it, because it may be an error in the data or it may be a genuine but unusual case. Working: 48 of the 50 points lie close to the rising line of best fit, so the trend is set by those 48; the two remaining points do not follow it, so they are identified as outliers and checked — a mistake in measuring or recording would be corrected, while a genuine reading would be kept and reported. Answer: treat them as outliers and check them before deciding what to do with them. The distractors: deleting them at once assumes that every point far from the line must be an error, which throws away real data; moving the line so that it passes through them assumes a line of best fit must touch particular points, when it is drawn to follow all 50; taking them as proof that there is no correlation lets two points overturn the pattern that the other 48 agree on.
- (d) 1.2 pupils per mark — Method: on a histogram whose class intervals are not all the same width the height of a bar is not the frequency but the frequency density, found by dividing the frequency of the class by the width of that class, so that the area of the bar represents the frequency. Working: the class 40 ≤ m < 60 holds 24 pupils, and its width is 60 − 40 = 20 marks, so the frequency density is 24 ÷ 20 = 1.2. Answer: 1.2 pupils per mark. The distractors: 24 pupils per mark comes from plotting the frequency itself as the height, which is only correct when every class has the same width; 2.4 pupils per mark comes from dividing by 10, the width of the narrowest class, instead of by the width of this class; 0.2 pupils per mark comes from dividing by the 120 pupils in the year group, which gives the proportion of pupils in the class and not a frequency density.
- (a) (30, 60) — Method: a cumulative frequency point is plotted at the upper boundary of its class, paired with the running total of all the frequencies up to and including that class. Working: the running totals are 7, then 7 + 19 = 26, then 26 + 34 = 60, then 60 + 40 = 100; the class 20 ≤ t < 30 has upper boundary 30, and the running total there is 60. Answer: the point for that class is plotted at 30 seconds against a cumulative frequency of 60. The distractors: (25, 60) comes from plotting at the class midpoint, which is what a frequency polygon uses and not what a cumulative frequency diagram uses; (30, 34) comes from plotting the class frequency, 34, rather than the running total; (20, 60) comes from plotting at the lower boundary of the class, which would claim that 60 calls took less than 20 seconds when only 26 did.
- (a) The median, as the one very large wage does not move it — Method: an average describes a population well when it sits close to most of the values, so compare what each average does when one value lies far from the rest. Working: in order the wages are 420, 440, 460, 480 and 1,500, so the median is the third of the five, £460. The mean uses every wage: 420 + 440 + 460 + 480 + 1,500 = 3,300 and 3,300 ÷ 5 = 660, so the mean is £660. Four of the five people earn less than £660, and the nearest of those four wages is £180 below it, so £660 describes nobody at the garage; £460 sits inside the group of four similar wages. Answer: the median, as the one very large wage does not move it, while that same wage drags the mean £200 above the median. The distractors: saying the median is always larger than the mean is an invented rule, and here the median £460 is smaller than the mean £660; saying the mean is the only average that uses all five wages is true as far as it goes, but using a value and being dragged by it are the same thing when that value is £1,500; saying £660 lies between the smallest and largest wage is true of every mean ever calculated, so it proves nothing about whether this one is typical.
- (a) 27 — Method: turn the mean into a total using total = mean × number of values, then subtract the numbers that are already known. Working: four numbers with a mean of 18 have a total of 18 × 4 = 72; the three known numbers give 10 + 15 + 20 = 45; so x = 72 − 45 = 27. Answer: 27, and checking, (10 + 15 + 20 + 27) ÷ 4 = 72 ÷ 4 = 18. The distractors: 72 comes from stopping at the total the four numbers must reach and never subtracting the known three; 18 comes from assuming the missing number must equal the mean; 45 comes from stopping at the total of the three known numbers.
- (d) 300 pupils — Method: an estimate for a whole population is made by finding the proportion in the sample and applying that same proportion to the population. Working: in the sample 30 of the 50 pupils prefer sport, a proportion of 30 ÷ 50 = 0.6, and applying that proportion to the school gives 0.6 × 500 = 300 pupils. Answer: 300 pupils, and it is only an estimate, because a different random sample of 50 would give a slightly different figure. The distractors: 200 pupils comes from scaling up the 20 pupils in the sample who did not prefer sport, 20 × 10, which answers the opposite question; 150 pupils comes from reading 30 out of 50 as 30% and taking 30% of 500; 60 pupils comes from working out the proportion correctly as 60% and then writing the 60 down as a number of pupils instead of applying it to the 500.
- (c) 90 — Method: the height of a bar is its frequency density, so twice as tall means twice the frequency density — not twice the frequency, because the two classes have different widths. Then frequency = frequency density × class width. Working: the first bar has frequency density 3 per cm, so the second has frequency density 2 × 3 = 6 per cm; the class 30 ≤ x < 45 is 45 − 30 = 15 cm wide, so its frequency is 6 × 15 = 90. Answer: 90 rods. The distractors: 120 comes from doubling the first bar's frequency instead of its height — the first class holds 3 × 20 = 60 rods, and doubling that ignores the fact that the second class is narrower; 45 comes from using the first bar's frequency density, 3, for the second bar, 3 × 15, and so never using the information that it is twice as tall; 6 comes from stopping at the frequency density of the taller bar and quoting a height as though it were a count.
- (c) 145 g — Method: find the position of the median from the total frequency, locate the class that contains it, then use linear interpolation inside that class, assuming the apples in it are spread evenly. Working: the median is the 100 ÷ 2 = 50th apple; the running totals are 10, then 10 + 30 = 40, then 40 + 40 = 80, so the 50th apple lies in the class 140 ≤ m < 160; it is the 50 − 40 = 10th of the 40 apples in that class, and the class is 20 g wide, so the median is 140 + (10 ÷ 40) × 20 = 140 + 5 = 145. Answer: an estimated median of 145 g. The distractors: 150 g comes from giving the midpoint of the class that contains the median instead of interpolating inside it; 140 g comes from stopping at the lower boundary of that class, which locates the class but not the value; 155 g comes from measuring the 5 g step down from the upper boundary, 160 − 5, instead of up from the lower boundary.
- (b) On average a plant grew 1.5 cm taller for each extra day — Method: in the equation of a line, the number multiplying x is the gradient, and a gradient states the change in y produced by an increase of 1 in x, read in the units of the two axes. Working: here x is measured in days and y in centimetres, so the gradient 1.5 carries the units centimetres per day. Testing it on the line, 5 days gives 1.5 × 5 + 4 = 11.5 cm and 6 days gives 1.5 × 6 + 4 = 13 cm, a rise of 1.5 cm for the one extra day. Answer: on average a plant grew 1.5 cm taller for each extra day of watering. The distractors: 1.5 cm as the height before any watering is the value of y when x is 0, which is the other number in the equation, 4 cm, so this swaps the gradient and the intercept; 1.5 cm as the gap between the tallest and the shortest plant reads the gradient as a range, when a range is a difference between two of the 16 plants and a gradient is a rate; 1.5 days for each extra centimetre inverts the rate, dividing days by centimetres instead of centimetres by days, and the line gives 1 cm of growth in two thirds of a day.
Build your own mix at the worksheet builder.