Printable · GCSE Higher · ages 14-16
Statistics worksheet — GCSE Higher
Fifteen questions across the statistics statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Statistics worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) 5.5 kg — Method: with an even number of values the median is the mean of the two middle values, taken once the data are in order of size. Working: the eight masses are already in order and 8 ÷ 2 = 4, so the middle pair are the 4th and 5th values, 5 kg and 6 kg; the median is (5 + 6) ÷ 2 = 5.5 kg. Answer: 5.5 kg. The distractors: 5 kg comes from reading the 4th value and stopping there instead of averaging the middle pair; 8 kg comes from working out the range, 11 − 3, which measures spread rather than centre; 4 kg comes from writing down the modal mass, the only value that occurs twice, instead of the median.
- (d) 648 kg — Method: to estimate a total from a sample, multiply the sample's mean by the number of items in the whole population, then check the units the question asks for. Working: 32.4 g × 20,000 = 648,000 g. Converting to kilograms, 648,000 ÷ 1,000 = 648 kg. This is only an estimate, not an exact total, because it assumes every one of the 20,000 packets has exactly the sample mean mass, when in reality individual packets vary above and below it. Giving 1.62 kg multiplies the mean by 50, the SAMPLE size, instead of by 20,000, the number of packets actually made that day — this finds the total mass of the 50 sampled packets, not the day's production. Giving 32.4 kg treats the sample mean itself, in grams, as if it already were the day's total mass in kilograms, skipping the scaling up altogether. Giving 648,000 kg correctly scales the mean up to the whole day's production but never converts the answer from grams to kilograms, leaving it 1,000 times too large. Always scale a sample's mean up by the SIZE OF THE WHOLE POPULATION, and always finish by checking the units the question asks for.
- (a) Leeds has a higher median and a greater range than York. — In order, Leeds's temperatures are 14, 16, 18, 19 and 23, so the median is the middle value, 18, and the range is 23 − 14 = 9. York's temperatures in order are 15, 17, 17, 18 and 18, so the median is 17, and the range is 18 − 15 = 3. Since 18 is higher than 17, and 9 is greater than 3, Leeds has both the higher median and the greater range. Choosing 'Leeds has a higher median but a smaller range than York' gets the median comparison right but the range comparison backwards — Leeds's range of 9 is actually greater than York's range of 3. Choosing 'York has a higher median and a greater range than Leeds' reverses both comparisons. Choosing 'York has a higher median but a smaller range than Leeds' reverses the median comparison; York's median of 17 is lower than Leeds's 18, even though it is correct that York's range is the smaller one.
- (b) 4 — The difference, Bristol minus Leeds, on each day is: Monday 4 − 3 = 1, Tuesday 4 − 5 = −1, Wednesday 6 − 2 = 4, Thursday 2 − 4 = −2. The greatest amount by which Bristol exceeded Leeds is 4 hours, on Wednesday. Choosing 1 takes Monday's smaller positive difference instead of the greatest one. Choosing 2 takes the size of Thursday's difference, but that is the amount by which Leeds exceeded Bristol, the opposite direction to the one asked for. Choosing 6 takes Bristol's raw figure on Wednesday without subtracting Leeds's 2 hours first.
- (d) An outlier from the damaged wing, not the trend. — That bird's point lies a long way from the rising trend followed by every other bird, and its low wingspan is explained by the damaged wing rather than by its age — it is an outlier caused by an unusual factor, not part of the general relationship between age and wingspan, so it should not be used when drawing the line of best fit. Saying every point must be used ignores that an outlier caused by a separate, identifiable factor can rightly be set aside. Saying it shows no correlation ignores that the other 19 points do show a clear rising trend; one outlier does not remove that. Saying it proves the line is inaccurate confuses one unusual bird with a fault in the line itself, when the line correctly describes the trend followed by the rest of the data.
- (d) 16 — Method: on a box plot the interquartile range is the width of the box itself, upper quartile take away lower quartile. Working: the upper quartile is 38 and the lower quartile is 22, so 38 − 22 = 16. Answer: the interquartile range is 16 years. Watch which part of the box plot you are reading: the whole line from whisker to whisker gives the range, 61 − 15 = 46; the left half of the box alone gives median take away lower quartile, 29 − 22 = 7; and the right half of the box alone gives upper quartile take away median, 38 − 29 = 9 — neither half is the interquartile range on its own.
- (a) 27 — Method: turn the mean into a total using total = mean × number of values, then subtract the numbers that are already known. Working: four numbers with a mean of 18 have a total of 18 × 4 = 72; the three known numbers give 10 + 15 + 20 = 45; so x = 72 − 45 = 27. Answer: 27, and checking, (10 + 15 + 20 + 27) ÷ 4 = 72 ÷ 4 = 18. The distractors: 72 comes from stopping at the total the four numbers must reach and never subtracting the known three; 18 comes from assuming the missing number must equal the mean; 45 comes from stopping at the total of the three known numbers.
- (b) 60 — Method: for n ordered values, the upper quartile sits at position 3(n + 1) ÷ 4, counting from the smallest. Working: n + 1 = 11 + 1 = 12; 3 × 12 = 36 and 36 ÷ 4 = 9, so the upper quartile is the 9th value in the list 40, 42, 45, 47, 50, 52, 55, 58, 60, 63, 65, which is 60. Answer: the upper quartile is 60 seconds. Watch which quartile you find: counting to the 6th value gives the median, 52, not the upper quartile; using 3 × 11 = 33 and 33 ÷ 4 = 8.25 without adding 1 to n first, then rounding down, reaches the 8th value, 58, not the 9th; and counting to the 3rd value uses the lower quartile's position, 45, the wrong end of the list.
- (c) The data show a link only; a third factor may affect both — Method: a study of this kind measures two quantities and reports how they change together; deciding that one of them produces the other is a further claim, and it needs evidence that the measurements alone cannot give. Working: the study shows that more coffee goes with better concentration, which is a positive correlation; but a third factor that was never measured, such as how motivated someone is, could raise both the coffee drinking and the concentration, and the concentration could equally be what leads to the extra coffee. Answer: the data show a link only, because a third factor may be affecting both quantities, so no claim about cause can be made. The distractors: calling the conclusion safe because the correlation is positive treats the direction of a correlation as proof of cause, which no direction can give; calling it wrong because the correlation is negative misreads the direction of the relationship, since the study reports both quantities rising together; saying the two quantities are not linked denies the correlation the study actually found, when what fails is only the claim about cause.
- (d) 19 kg — Method: estimate the mean of grouped data by multiplying each class's midpoint by its frequency, adding the four totals, then dividing by the total frequency. Working: the midpoints are 5, 15, 25 and 35 kg. The weighted totals are 11 × 5 = 55, 5 × 15 = 75, 5 × 25 = 125 and 9 × 35 = 315, which add to 570. Dividing by the 30 dogs gives an estimate of 570 ÷ 30 = 19 kg. Giving 5 kg reads off the midpoint of the modal class, 0 < m ≤ 10, the class with the most dogs — but the class with the most dogs is not where the mean falls, and neither is a substitute for actually calculating it. Giving 20 kg averages the four midpoints, (5 + 15 + 25 + 35) ÷ 4, treating every class as equally likely and ignoring that far more dogs are in the lightest and heaviest classes than in the middle two. Giving 570 kg stops after finding the correct weighted total and forgets the final division by the 30 dogs. Always weight each midpoint by its own frequency, and always finish by dividing by the total frequency, not the number of classes.
- (d) 1.2 pupils per mark — Method: on a histogram whose class intervals are not all the same width the height of a bar is not the frequency but the frequency density, found by dividing the frequency of the class by the width of that class, so that the area of the bar represents the frequency. Working: the class 40 ≤ m < 60 holds 24 pupils, and its width is 60 − 40 = 20 marks, so the frequency density is 24 ÷ 20 = 1.2. Answer: 1.2 pupils per mark. The distractors: 24 pupils per mark comes from plotting the frequency itself as the height, which is only correct when every class has the same width; 2.4 pupils per mark comes from dividing by 10, the width of the narrowest class, instead of by the width of this class; 0.2 pupils per mark comes from dividing by the 120 pupils in the year group, which gives the proportion of pupils in the class and not a frequency density.
- (a) 30 — Method: an outlier is a value that lies far away from the pattern set by the rest of the data, so compare each value with the group the others form. Working: five of the counts, 5, 7, 8, 9 and 11, lie within 6 of one another and the steps between them are 2, 1, 1 and 2; the remaining count of 30 is 19 above the nearest of them, so it is the value that does not belong to the pattern. Answer: 30. The distractors: 5 comes from picking the smallest value, on the idea that the odd one out must be at the bottom of the list; 11 comes from ordering the data and stopping one value short, taking the largest of the counts that sit close together; 8.5 comes from working out the median, (8 + 9) ÷ 2, and giving a measure of centre where a value standing apart was asked for.
- (c) 0.5 per gram — Method: turn the two known bars into frequencies using area, subtract from the total to find how many letters are left, then divide that frequency by the width of the last class to get its height. Working: the first bar covers 50 g at a frequency density of 1.2, giving 1.2 × 50 = 60 letters, and the second covers 50 g at 1.8, giving 1.8 × 50 = 90 letters; together that is 60 + 90 = 150 letters, so 200 − 150 = 50 letters remain; the class 100 ≤ m < 200 is 100 g wide, so its frequency density is 50 ÷ 100 = 0.5 per gram. Answer: 0.5 per gram. The distractors: 0.25 per gram comes from dividing the remaining 50 letters by the upper class boundary, 200, instead of by the class width of 100; 2 per gram comes from dividing the class width by the frequency, 100 ÷ 50, reversing the formula; 1.4 per gram comes from subtracting only the first bar's 60 letters, leaving 140, and then dividing by 100.
- (a) Minutes a candle has burned and length remaining — As a candle burns for longer, less of it remains, so these two variables move in opposite directions as one increases — that is negative correlation. A pupil's shoe size generally increases as they get older, so age and shoe size show positive correlation, not negative, since both rise together. A football team's shirt colour is not a numerical quantity linked to how many matches it wins, so shirt colour and number of wins show no correlation at all. The number of letters in a pupil's name has no real connection to their ability in maths, so that pair also shows no correlation.
- (b) 1 — Method: for data in a frequency table, find the position of the median using (n + 1) ÷ 2, then read off the value at that position from the cumulative frequencies. Working: there are 19 pupils, so the median is the 10th value. The cumulative frequencies are 7 (up to 0 pets), 10 (up to 1 pet), 14 (up to 2 pets) and 19 (up to 3 pets). The 10th value falls at the end of the '1 pet' group, so the median is 1 pet. Giving 0 pets is the mode — the category with the highest frequency, 7 — not the median. Giving 3, the highest number of pets minus the lowest, finds the range, a different statistic entirely. Giving 19 states the total number of pupils, not a number of pets at all. Find the middle POSITION first, then read off the value it belongs to — do not confuse it with the mode, the range or the total.
Build your own mix at the worksheet builder.