Printable · GCSE Higher · ages 14-16
Statistics worksheet — GCSE Higher
Fifteen questions across the statistics statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Statistics worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) Equal means; Class A is more consistent, smaller range. — Method: when two data sets share a measure of location, compare a measure of spread to say more about consistency. Working: both classes have the same mean mark, 14, so on average they performed equally well. Class A has the smaller range, 6, so its marks are more tightly grouped around 14 than Class B's marks, which vary by as much as 14. So Class A's marks were more consistent, even though neither class did better on average. Saying Class B did better because it has the bigger range confuses a wide spread with a high score — a big range describes variability, not performance. Saying Class A did better because it has the smaller range makes the same mistake in the other direction: the two classes are tied on the mean, so neither one 'did better'. Saying the classes cannot be compared because their means are equal misses the whole point of also comparing the range. Always compare both an average AND a spread before describing two data sets — either one alone tells only half the story.
- (d) 300 pupils — Method: an estimate for a whole population is made by finding the proportion in the sample and applying that same proportion to the population. Working: in the sample 30 of the 50 pupils prefer sport, a proportion of 30 ÷ 50 = 0.6, and applying that proportion to the school gives 0.6 × 500 = 300 pupils. Answer: 300 pupils, and it is only an estimate, because a different random sample of 50 would give a slightly different figure. The distractors: 200 pupils comes from scaling up the 20 pupils in the sample who did not prefer sport, 20 × 10, which answers the opposite question; 150 pupils comes from reading 30 out of 50 as 30% and taking 30% of 500; 60 pupils comes from working out the proportion correctly as 60% and then writing the 60 down as a number of pupils instead of applying it to the 500.
- (c) 15 — Method: the interquartile range is the upper quartile take away the lower quartile, IQR = Q3 − Q1. Working: n + 1 = 15 + 1 = 16, so the lower quartile sits at position 16 ÷ 4 = 4, the 4th value in the list, which is 12; the upper quartile sits at position 3 × 4 = 12, the 12th value, which is 27. So 27 − 12 = 15. Answer: the interquartile range is 15 minutes. Watch which values you use and which way round: taking the smallest time away from the largest, 34 − 5 = 29, finds the range, which uses every value between the extremes rather than just the middle half; taking the median away from the upper quartile instead of the lower quartile, 27 − 19 = 8, swaps the median in for the lower quartile; and reversing the subtraction, 12 − 27 = −15, finds the right two values but in the wrong order — an interquartile range is never negative.
- (a) Drawing 60 names at random from a list of all 1200 pupils — Method: a sample is random when every member of the population has the same chance of being chosen and nobody, including the pupils themselves, can influence who ends up in it; test each method against that. Working: drawing names from a list of all 1200 pupils gives each pupil the same chance, 60 out of 1200, whatever their year group, class or opinion, so the method is random. Answer: drawing 60 names at random from a list of all 1200 pupils. The distractors: asking the pupils who volunteer is self-selection, and the pupils with the strongest views volunteer first, so they decide the sample; asking the pupils nearest the door is convenience sampling, which reaches only those who happen to be in one place at one time; asking two Year 10 classes samples a cluster, so every pupil in the other year groups has no chance of being chosen at all.
- (d) 44 — Method: a cumulative frequency counts everything below a value, so the frequency of a class is the running total at the top of the class minus the running total at the bottom of it. Working: the running total below 20 kg is 96 and the running total below 10 kg is 52, so the number of boxes in the class 10 ≤ m < 20 is 96 − 52 = 44. Answer: 44 boxes. The distractors: 96 comes from quoting the running total at 20 kg itself, which counts every box below 20 kg rather than only those in this class; 34 comes from subtracting the wrong pair, 52 − 18, which gives the class 5 ≤ m < 10 instead; 54 comes from subtracting from the grand total, 150 − 96, which gives the boxes of 20 kg or more.
- (a) 1.24 — Method: for data given as a frequency table, the mean is Σfx ÷ Σf — multiply each value by its frequency, add the results, then divide by the total frequency. Working: 0 × 6 = 0. 1 × 10 = 10. 2 × 6 = 12. 3 × 3 = 9. So Σfx = 0 + 10 + 12 + 9 = 31. The total frequency is Σf = 6 + 10 + 6 + 3 = 25. Mean = 31 ÷ 25 = 1.24 siblings. Averaging the frequency column itself, (6 + 10 + 6 + 3) ÷ 4 = 6.25, mixes up the frequencies with the values they belong to. Writing down 1, the number of siblings with the highest frequency, gives the mode, not the mean. Writing down 31 stops after finding Σfx and forgets to divide by the total frequency, 25. Always divide Σfx by Σf — never stop at the top of the fraction.
- (a) x = 0 gives y = −20: a negative number sold — The y-intercept is the value the line predicts when x = 0: y = 3 × 0 − 20 = −20. A kiosk cannot sell a negative number of ice creams, so this is not a sensible estimate. The 3 in the equation is the gradient, not the intercept, so an option claiming x = 0 gives y = 3 has swapped the two numbers around — substituting x = 0 makes the 3x term equal 0, leaving −20, not 3. The danger of extrapolating to very high temperatures is a real issue with this line, but it is a different issue from the y-intercept, so it does not answer this question. And whether x = 0 could occur on a trading day is beside the point: the model still makes that prediction, and it is the prediction itself, −20, that is impossible.
- (c) 72 — Method: on a histogram the frequency of a class is the area of its bar, so frequency = frequency density × class width. Working: the class 50 ≤ m < 80 has width 80 − 50 = 30 grams and a frequency density of 2.4 per gram, so the frequency is 2.4 × 30 = 72. Answer: 72 pebbles. The distractors: 192 comes from using the upper class boundary, 80, as the width, giving 2.4 × 80; 12.5 comes from dividing the width by the density, 30 ÷ 2.4, which reverses the area rule; 2.4 comes from reading the height of the bar as the frequency itself, the commonest mistake on histograms, where a height is a density and only an area is a count.
- (c) Route 2, because its interquartile range is smaller — Method: for a journey where turning up on time matters, what matters is not the typical (median) time but how predictable it is — a smaller interquartile range means the middle half of journeys cluster closer together. Working: Route 1's median, 34 minutes, is in fact lower than Route 2's, 41 minutes, so Route 1 is faster on average; but Route 1's interquartile range, 22 minutes, is far larger than Route 2's, 6 minutes, so Route 1's times are much less predictable. Answer: Priya should choose Route 2, because its interquartile range is smaller, even though it is slower on average. Watch which statistic answers the question actually asked: Route 1 does not have the smaller interquartile range, Route 2 does, so picking Route 1 for that reason misreads the table; Route 1's median genuinely is the lower one, but a lower median answers 'which is faster', not 'which is more reliable'; and Route 2's median is not the lower one, so that claim about Route 2 is simply false.
- (a) 1.6 — Method: on a histogram the height of a bar is the frequency density, and frequency density = frequency ÷ class width. Working: the class 15 ≤ t < 30 runs from 15 to 30, so its width is 30 − 15 = 15 minutes; the frequency is 24, so the frequency density is 24 ÷ 15 = 1.6. Answer: 1.6 people per minute. The distractors: 360 comes from multiplying the frequency by the class width, 24 × 15, which uses the area rule backwards — area gives the frequency, so the frequency must be divided by the width to give the height; 0.625 comes from dividing the class width by the frequency, 15 ÷ 24, reversing the formula; 0.8 comes from dividing by the upper class boundary, 24 ÷ 30, instead of by the width of the class.
- (d) 38, and fairly confident, as 12 °C is inside the range — Method: substitute the forecast temperature into the equation of the line of best fit, then judge the prediction by where that temperature sits among the data the line was drawn from. Working: putting x = 12 into y = −3x + 74 gives −3 × 12 + 74 = 38, so the line predicts 38 hot chocolates. The recorded temperatures run from 4 °C to 18 °C, and 12 °C lies inside that interval, so this is interpolation, the safer kind of prediction. Answer: 38, and fairly confident, as 12 °C is inside the range; the owner should still expect the true figure to differ a little, since the points only lie near the line and not on it. The distractors: being completely certain treats a line of best fit as a rule that fixes each day's sales, when it describes a trend that individual days depart from; saying 12 °C is outside the range misreads the interval 4 °C to 18 °C, and the wrong warning would be attached to a sound prediction; 110 comes from −3 × 12 being taken as +36, giving 36 + 74 = 110, which loses the negative gradient and so predicts that a warm day sells more hot chocolate than a cold one.
- (b) A person's shoe size and their favourite colour — A person's shoe size is not linked to which colour they prefer, so these two show no correlation. The other three pairs are all genuinely correlated: distance travelled and fuel used rise together, which is positive correlation; hours of revision and test score generally rise together, which is also positive correlation; and as outdoor temperature rises, fewer woolly hats are sold, which is negative correlation. Negative correlation is still a real relationship between two variables — it is not the same thing as no relationship at all, so the temperature and hats pair is not the answer to this question.
- (a) (30, 60) — Method: a cumulative frequency point is plotted at the upper boundary of its class, paired with the running total of all the frequencies up to and including that class. Working: the running totals are 7, then 7 + 19 = 26, then 26 + 34 = 60, then 60 + 40 = 100; the class 20 ≤ t < 30 has upper boundary 30, and the running total there is 60. Answer: the point for that class is plotted at 30 seconds against a cumulative frequency of 60. The distractors: (25, 60) comes from plotting at the class midpoint, which is what a frequency polygon uses and not what a cumulative frequency diagram uses; (30, 34) comes from plotting the class frequency, 34, rather than the running total; (20, 60) comes from plotting at the lower boundary of the class, which would claim that 60 calls took less than 20 seconds when only 26 did.
- (d) 19 kg — Method: estimate the mean of grouped data by multiplying each class's midpoint by its frequency, adding the four totals, then dividing by the total frequency. Working: the midpoints are 5, 15, 25 and 35 kg. The weighted totals are 11 × 5 = 55, 5 × 15 = 75, 5 × 25 = 125 and 9 × 35 = 315, which add to 570. Dividing by the 30 dogs gives an estimate of 570 ÷ 30 = 19 kg. Giving 5 kg reads off the midpoint of the modal class, 0 < m ≤ 10, the class with the most dogs — but the class with the most dogs is not where the mean falls, and neither is a substitute for actually calculating it. Giving 20 kg averages the four midpoints, (5 + 15 + 25 + 35) ÷ 4, treating every class as equally likely and ignoring that far more dogs are in the lightest and heaviest classes than in the middle two. Giving 570 kg stops after finding the correct weighted total and forgets the final division by the 30 dogs. Always weight each midpoint by its own frequency, and always finish by dividing by the total frequency, not the number of classes.
- (c) 75 — Method: the number in a class is the area of its bar, frequency density × class width, so work out the frequency of each class that lies at or above 10 minutes and add them. Working: the class 10 ≤ t < 25 is 15 minutes wide with a frequency density of 3.2, giving 3.2 × 15 = 48 members; the class 25 ≤ t < 55 is 30 minutes wide with a frequency density of 0.9, giving 0.9 × 30 = 27 members; the total charged is 48 + 27 = 75. Answer: 75 members pay the extra charge. The distractors: 4.1 comes from adding the two frequency densities, 3.2 + 0.9, as though each height were a count; 93 comes from including the class 0 ≤ t < 10 as well, 1.8 × 10 = 18 added to 48 and 27, which charges every member; 27 comes from using only the class 25 ≤ t < 55 and forgetting that 10 ≤ t < 25 is also at or above 10 minutes.
Build your own mix at the worksheet builder.