Printable · GCSE Higher · ages 14-16
Statistics worksheet — GCSE Higher
Fifteen questions across the statistics statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Statistics worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) (30, 60) — Method: a cumulative frequency point is plotted at the upper boundary of its class, paired with the running total of all the frequencies up to and including that class. Working: the running totals are 7, then 7 + 19 = 26, then 26 + 34 = 60, then 60 + 40 = 100; the class 20 ≤ t < 30 has upper boundary 30, and the running total there is 60. Answer: the point for that class is plotted at 30 seconds against a cumulative frequency of 60. The distractors: (25, 60) comes from plotting at the class midpoint, which is what a frequency polygon uses and not what a cumulative frequency diagram uses; (30, 34) comes from plotting the class frequency, 34, rather than the running total; (20, 60) comes from plotting at the lower boundary of the class, which would claim that 60 calls took less than 20 seconds when only 26 did.
- (c) No, the mode here is the lowest value of the nine — Method: an average is meant to stand for the data as a whole, so test any proposed average by asking how many values it sits near. Working: the value 4 appears three times and every other count appears once, so 4 is indeed the mode. But those three hours are the quiet ones at the start of the day, and the other six counts run from 11 up to 25; putting the nine counts in order, the middle one is the fifth, which is 13. So the mode sits at the very bottom of the data, with six of the nine hours far above it. Answer: no, because the mode here is the lowest value of the nine, so it describes the quiet opening hours rather than a typical hour. The distractors: saying the mode can only be used when no value repeats reverses the definition, since a mode exists only because a value does repeat; saying the mode is the value that occurs most often is a correct definition, but being the commonest value does not make a value typical when it lies at one end of the data; saying the mode is the best average for any list of numbers ignores the fact that mean, median and mode each describe a population well in different circumstances.
- (c) 145 g — Method: find the position of the median from the total frequency, locate the class that contains it, then use linear interpolation inside that class, assuming the apples in it are spread evenly. Working: the median is the 100 ÷ 2 = 50th apple; the running totals are 10, then 10 + 30 = 40, then 40 + 40 = 80, so the 50th apple lies in the class 140 ≤ m < 160; it is the 50 − 40 = 10th of the 40 apples in that class, and the class is 20 g wide, so the median is 140 + (10 ÷ 40) × 20 = 140 + 5 = 145. Answer: an estimated median of 145 g. The distractors: 150 g comes from giving the midpoint of the class that contains the median instead of interpolating inside it; 140 g comes from stopping at the lower boundary of that class, which locates the class but not the value; 155 g comes from measuring the 5 g step down from the upper boundary, 160 − 5, instead of up from the lower boundary.
- (c) The data show a link only; a third factor may affect both — Method: a study of this kind measures two quantities and reports how they change together; deciding that one of them produces the other is a further claim, and it needs evidence that the measurements alone cannot give. Working: the study shows that more coffee goes with better concentration, which is a positive correlation; but a third factor that was never measured, such as how motivated someone is, could raise both the coffee drinking and the concentration, and the concentration could equally be what leads to the extra coffee. Answer: the data show a link only, because a third factor may be affecting both quantities, so no claim about cause can be made. The distractors: calling the conclusion safe because the correlation is positive treats the direction of a correlation as proof of cause, which no direction can give; calling it wrong because the correlation is negative misreads the direction of the relationship, since the study reports both quantities rising together; saying the two quantities are not linked denies the correlation the study actually found, when what fails is only the claim about cause.
- (c) 20 ≤ h < 40 — Method: with 80 values the lower quartile is the 80 ÷ 4 = 20th value in order, so build a running total until it first reaches 20. Working: the running totals are 14, then 14 + 22 = 36, then 52, then 80; the 20th plant is past 14 but not past 36, so it lies in the second class. Answer: the lower quartile lies in the class 20 ≤ h < 40. The distractors: 0 ≤ h < 20 comes from believing that the bottom quarter of the data must all sit in the first class, when that class holds only 14 of the 80 plants; 40 ≤ h < 50 comes from using the position 80 ÷ 2 = 40 and so locating the median rather than the lower quartile; 50 ≤ h < 80 comes from counting 20 plants down from the tallest instead of up from the shortest, which locates the upper quartile at the 60th plant.
- (c) No, 90 cm is far outside the heights on the graph — Method: a line of best fit describes the trend only across the stretch of data it was drawn through; predicting beyond that stretch is extrapolation, and nothing in the data supports it. Working: the heights used to draw this line run from 150 cm to 180 cm, all of them Year 10 pupils, while 90 cm is 60 cm below the shortest of them and belongs to a two-year-old child, whose build follows no trend the graph has measured. Substituting anyway gives 0.9 × 90 − 85 = −4, a mass of −4 kg, which cannot exist. Answer: no, because 90 cm is far outside the heights on the graph. The distractors: saying a line of best fit cannot be used to predict at all throws away its main purpose, since a prediction made between the plotted values is perfectly sound; saying the line passes through all 20 points misdescribes a line of best fit, which is drawn to follow the trend of the points and will normally pass through few of them; saying the equation works for any value put into it treats an equation fitted to Year 10 heights as a law of nature, and the mass of −4 kg shows what that assumption produces.
- (c) Club members probably eat differently from most people — Method: a sample is biased when the group it is drawn from differs from the population in the very thing the survey is measuring, so compare the subgroup with the population on that quantity. Working: the survey measures eating habits, and people who join a sports club take more exercise than average and are known to eat differently from the town as a whole, so their replies pull the results away from the true picture for the town however many of them are asked. Answer: club members probably eat differently from most people. The distractors: the reply about the number of members treats bias as a question of size, but a large biased sample is still biased; the reply that the members were picked at random is false, since the council picked a club rather than picking residents, and it confuses bias with non-response; the reply that everyone asked lives in the town notes something true of the members but draws the false conclusion that the sample therefore covers the town, when a sample must reflect a population and not merely be taken from inside it.
- (c) 15 — Method: the interquartile range is the upper quartile take away the lower quartile, IQR = Q3 − Q1. Working: n + 1 = 15 + 1 = 16, so the lower quartile sits at position 16 ÷ 4 = 4, the 4th value in the list, which is 12; the upper quartile sits at position 3 × 4 = 12, the 12th value, which is 27. So 27 − 12 = 15. Answer: the interquartile range is 15 minutes. Watch which values you use and which way round: taking the smallest time away from the largest, 34 − 5 = 29, finds the range, which uses every value between the extremes rather than just the middle half; taking the median away from the upper quartile instead of the lower quartile, 27 − 19 = 8, swaps the median in for the lower quartile; and reversing the subtraction, 12 − 27 = −15, finds the right two values but in the wrong order — an interquartile range is never negative.
- (c) 33 — Method: multiply the mean by the number of tests to get the total marks, then subtract the marks that are already known. Working: four tests with a mean of 29 give a total of 29 × 4 = 116 marks; the first three marks total 31 + 26 + 26 = 83; so the fourth mark is 116 − 83 = 33. Answer: 33, and checking, (31 + 26 + 26 + 33) ÷ 4 = 116 ÷ 4 = 29. The distractors: 116 comes from stopping at the total for all four tests; 29 comes from assuming the missing mark must be the mean itself; 4 comes from multiplying the mean by 3, the number of marks given, leaving 87 − 83 = 4.
- (d) 44 — Method: a cumulative frequency counts everything below a value, so the frequency of a class is the running total at the top of the class minus the running total at the bottom of it. Working: the running total below 20 kg is 96 and the running total below 10 kg is 52, so the number of boxes in the class 10 ≤ m < 20 is 96 − 52 = 44. Answer: 44 boxes. The distractors: 96 comes from quoting the running total at 20 kg itself, which counts every box below 20 kg rather than only those in this class; 34 comes from subtracting the wrong pair, 52 − 18, which gives the class 5 ≤ m < 10 instead; 54 comes from subtracting from the grand total, 150 − 96, which gives the boxes of 20 kg or more.
- (a) No, the size of the fire affects both of the quantities — Method: correlation says that two quantities change together; a claim that one of them produces the other is a further claim, and it needs evidence that a scatter graph on its own cannot give. Working: the graph does show strong positive correlation, so more engines did go with greater damage. But neither quantity was set by the researchers: both were decided by how large the fire was. A large blaze brings many appliances and also destroys a great deal, while a small one brings few and destroys little, so a third quantity is driving both of the recorded ones. Answer: no, because the size of the fire affects both of the quantities. The distractors: saying the correlation is negative contradicts the graph, which shows the two quantities rising together, and reaching the right verdict from a false reading of the data is not the reason the mark is for; saying that strong positive correlation shows one quantity causes the other is the assumption the question exists to test, and no strength of correlation can establish cause; saying the points lie close to the line of best fit describes how strong the correlation is, and strength and cause are different matters entirely.
- (c) 156 cm — Method: to combine two groups' means, multiply each group's mean by its own number of pupils, add the two totals together, then divide by the total number of pupils in both groups. Working: 20 × 150 = 3,000 cm for the boys and 10 × 168 = 1,680 cm for the girls, giving a combined total of 3,000 + 1,680 = 4,680 cm. Dividing by all 30 pupils gives 4,680 ÷ 30 = 156 cm. Giving 159 cm averages the two means, (150 + 168) ÷ 2, treating the two groups as if they had the same number of pupils, when there are twice as many boys as girls. Giving 4,680 cm finds the correct combined total height but stops there, forgetting the final division by the 30 pupils. Giving 234 cm divides the combined total by 20, the number of boys only, forgetting that the total also includes the 10 girls. Always weight each mean by its own group size, and always divide by the TOTAL number of pupils in both groups combined.
- (d) 16 — Method: on a box plot the interquartile range is the width of the box itself, upper quartile take away lower quartile. Working: the upper quartile is 38 and the lower quartile is 22, so 38 − 22 = 16. Answer: the interquartile range is 16 years. Watch which part of the box plot you are reading: the whole line from whisker to whisker gives the range, 61 − 15 = 46; the left half of the box alone gives median take away lower quartile, 29 − 22 = 7; and the right half of the box alone gives upper quartile take away median, 38 − 29 = 9 — neither half is the interquartile range on its own.
- (d) 1.2 pupils per mark — Method: on a histogram whose class intervals are not all the same width the height of a bar is not the frequency but the frequency density, found by dividing the frequency of the class by the width of that class, so that the area of the bar represents the frequency. Working: the class 40 ≤ m < 60 holds 24 pupils, and its width is 60 − 40 = 20 marks, so the frequency density is 24 ÷ 20 = 1.2. Answer: 1.2 pupils per mark. The distractors: 24 pupils per mark comes from plotting the frequency itself as the height, which is only correct when every class has the same width; 2.4 pupils per mark comes from dividing by 10, the width of the narrowest class, instead of by the width of this class; 0.2 pupils per mark comes from dividing by the 120 pupils in the year group, which gives the proportion of pupils in the class and not a frequency density.
- (d) Correlation is a link; causation is one causing the other — Method: the two words describe different claims — one is about a pattern in the data, the other is about what produced that pattern. Working: correlation says only that two quantities tend to change together, which is something a scatter graph can display; causation says that a change in one quantity actually brings about the change in the other, which needs evidence a scatter graph cannot supply, because a third quantity may be driving both. Answer: correlation is a link between the quantities, while causation is one quantity causing the change in another. The distractors: the statement giving causation as the link and correlation as the cause simply swaps the two words over; the statement that the words mean the same thing is the classic error of reading a correlation as proof of cause; the statement that a scatter graph shows causation but not correlation reverses what a scatter graph can do, since the pattern it displays is exactly the correlation.
Build your own mix at the worksheet builder.