Printable · GCSE Higher · ages 14-16
Statistics worksheet — GCSE Higher
Fifteen questions across the statistics statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Statistics worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) 13 — The total is 50, and the two known parts are 22 (tea) and 15 (coffee), so 50 − 22 − 15 = 13 hot chocolates. Choosing 28 comes from 50 − 22, subtracting only the tea and forgetting the coffee. Choosing 35 comes from 50 − 15, subtracting only the coffee and forgetting the tea. Choosing 37 comes from 22 + 15, which finds how many drinks were tea or coffee, not the number left over for hot chocolate.
- (c) 145 g — Method: find the position of the median from the total frequency, locate the class that contains it, then use linear interpolation inside that class, assuming the apples in it are spread evenly. Working: the median is the 100 ÷ 2 = 50th apple; the running totals are 10, then 10 + 30 = 40, then 40 + 40 = 80, so the 50th apple lies in the class 140 ≤ m < 160; it is the 50 − 40 = 10th of the 40 apples in that class, and the class is 20 g wide, so the median is 140 + (10 ÷ 40) × 20 = 140 + 5 = 145. Answer: an estimated median of 145 g. The distractors: 150 g comes from giving the midpoint of the class that contains the median instead of interpolating inside it; 140 g comes from stopping at the lower boundary of that class, which locates the class but not the value; 155 g comes from measuring the 5 g step down from the upper boundary, 160 − 5, instead of up from the lower boundary.
- (c) 28 — Method: multiply the number of whole symbols by the value of one symbol, then add the value of any half symbol shown. Working: 3 whole symbols represent 3 × 8 = 24 cars. The half symbol represents 4 cars. Total cars sold in March = 24 + 4 = 28. Leaving out the half symbol, 3 × 8 = 24, undercounts by exactly the value of that half symbol. Treating the half symbol as if it were a full symbol, 4 × 8 = 32, overcounts because it doubles the value the half symbol is worth. Giving 3.5 reports the number of symbols shown, not the number of cars they represent — the key still needs to be applied. Always apply the key to every symbol shown, including a half symbol, rather than reading off the symbol count itself.
- (d) 1.2 pupils per mark — Method: on a histogram whose class intervals are not all the same width the height of a bar is not the frequency but the frequency density, found by dividing the frequency of the class by the width of that class, so that the area of the bar represents the frequency. Working: the class 40 ≤ m < 60 holds 24 pupils, and its width is 60 − 40 = 20 marks, so the frequency density is 24 ÷ 20 = 1.2. Answer: 1.2 pupils per mark. The distractors: 24 pupils per mark comes from plotting the frequency itself as the height, which is only correct when every class has the same width; 2.4 pupils per mark comes from dividing by 10, the width of the narrowest class, instead of by the width of this class; 0.2 pupils per mark comes from dividing by the 120 pupils in the year group, which gives the proportion of pupils in the class and not a frequency density.
- (a) 40 — Method: the mean is the total divided by how many values there are, so rearranging gives total = mean × number of values. Working: the mean is 8 and there are 5 numbers, so the total is 8 × 5 = 40. Answer: 40, and checking, 40 ÷ 5 = 8, which is the mean given. The distractors: 13 comes from adding the mean and the count, 8 + 5, instead of multiplying them; 1.6 comes from dividing the mean by the count, 8 ÷ 5, which reverses the relationship; 8 comes from quoting the mean itself as the total, which is only true when there is a single number.
- (d) 300 pupils — Method: an estimate for a whole population is made by finding the proportion in the sample and applying that same proportion to the population. Working: in the sample 30 of the 50 pupils prefer sport, a proportion of 30 ÷ 50 = 0.6, and applying that proportion to the school gives 0.6 × 500 = 300 pupils. Answer: 300 pupils, and it is only an estimate, because a different random sample of 50 would give a slightly different figure. The distractors: 200 pupils comes from scaling up the 20 pupils in the sample who did not prefer sport, 20 × 10, which answers the opposite question; 150 pupils comes from reading 30 out of 50 as 30% and taking 30% of 500; 60 pupils comes from working out the proportion correctly as 60% and then writing the 60 down as a number of pupils instead of applying it to the 500.
- (a) 26 — Method: a line of best fit lets one quantity be predicted from the other, so the score is substituted into the equation of the line and the resulting inequality is solved for the number of hours. Working: a score of at least 80 means 2.5x + 15 ≥ 80; taking 15 from both sides gives 2.5x ≥ 65, and dividing both sides by 2.5 gives x ≥ 26, so the least whole number of hours is 26. Checking, 2.5 × 26 + 15 = 80, which does reach the target. Answer: 26 hours — and this is only an estimate, because a line of best fit predicts a trend rather than an individual result, and a prediction made outside the range of hours the pupils actually revised for would be an extrapolation and less reliable still. The distractors: 27 comes from reaching 26 and then rounding up again, although 26 hours already gives a score of exactly 80; 32 comes from 80 ÷ 2.5, which ignores the 15 in the equation of the line; 38 comes from (80 + 15) ÷ 2.5, that is from adding the 15 instead of subtracting it when rearranging.
- (b) A person's shoe size and their favourite colour — A person's shoe size is not linked to which colour they prefer, so these two show no correlation. The other three pairs are all genuinely correlated: distance travelled and fuel used rise together, which is positive correlation; hours of revision and test score generally rise together, which is also positive correlation; and as outdoor temperature rises, fewer woolly hats are sold, which is negative correlation. Negative correlation is still a real relationship between two variables — it is not the same thing as no relationship at all, so the temperature and hats pair is not the answer to this question.
- (a) No, the size of the fire affects both of the quantities — Method: correlation says that two quantities change together; a claim that one of them produces the other is a further claim, and it needs evidence that a scatter graph on its own cannot give. Working: the graph does show strong positive correlation, so more engines did go with greater damage. But neither quantity was set by the researchers: both were decided by how large the fire was. A large blaze brings many appliances and also destroys a great deal, while a small one brings few and destroys little, so a third quantity is driving both of the recorded ones. Answer: no, because the size of the fire affects both of the quantities. The distractors: saying the correlation is negative contradicts the graph, which shows the two quantities rising together, and reaching the right verdict from a false reading of the data is not the reason the mark is for; saying that strong positive correlation shows one quantity causes the other is the assumption the question exists to test, and no strength of correlation can establish cause; saying the points lie close to the line of best fit describes how strong the correlation is, and strength and cause are different matters entirely.
- (a) The median, as the one very large wage does not move it — Method: an average describes a population well when it sits close to most of the values, so compare what each average does when one value lies far from the rest. Working: in order the wages are 420, 440, 460, 480 and 1,500, so the median is the third of the five, £460. The mean uses every wage: 420 + 440 + 460 + 480 + 1,500 = 3,300 and 3,300 ÷ 5 = 660, so the mean is £660. Four of the five people earn less than £660, and the nearest of those four wages is £180 below it, so £660 describes nobody at the garage; £460 sits inside the group of four similar wages. Answer: the median, as the one very large wage does not move it, while that same wage drags the mean £200 above the median. The distractors: saying the median is always larger than the mean is an invented rule, and here the median £460 is smaller than the mean £660; saying the mean is the only average that uses all five wages is true as far as it goes, but using a value and being dragged by it are the same thing when that value is £1,500; saying £660 lies between the smallest and largest wage is true of every mean ever calculated, so it proves nothing about whether this one is typical.
- (d) 25 ≤ t < 45 — Method: the height of a bar on a histogram is the frequency density, so work out frequency ÷ class width for every class and compare the four heights. Working: 20 ÷ 10 = 2 for the first class; 12 ÷ 15 = 0.8 for the second; 50 ÷ 20 = 2.5 for the third; 60 ÷ 30 = 2 for the fourth. Answer: the largest of 2, 0.8, 2.5 and 2 is 2.5, so the tallest bar is the one for 25 ≤ t < 45. The distractors: 45 ≤ t < 75 comes from picking the class with the greatest frequency, 60, and treating a frequency as a height — but that class is three times as wide, so its 60 competitors are spread thinly; 10 ≤ t < 25 comes from dividing the class width by the frequency, 15 ÷ 12, and picking the largest of those reversed values; 0 ≤ t < 10 comes from assuming the narrowest class must always give the tallest bar, which is only true when the frequencies are equal.
- (a) £16,000 — Method: first find the quarter with the highest sales figure, then subtract quarter 1's sales from it — remembering that every figure is given in THOUSANDS of pounds. Working: the highest sales figure is quarter 2, at £34,000 (34 thousand pounds). The increase from quarter 1 is £34,000 − £18,000 = £16,000. Giving £34,000 reads off the highest sales figure on its own, without subtracting quarter 1's sales — that is the highest quarter's total, not the increase. Giving £12,000 uses quarter 3's sales, 30, the SECOND-highest figure, instead of quarter 2's 34, the actual highest — 30 − 18 = 12, but quarter 3 is not the quarter with the highest sales. Giving £16 gets the subtraction right, 34 − 18 = 16, but forgets that every figure in the question is in thousands of pounds, so the increase is £16,000, not £16. Always identify the correct quarter FIRST, and always check the units the numbers are given in before writing your final answer.
- (a) 1,400 and 1,240, so combine the samples for one estimate — Method: scale each sample up to the whole stock, then use the fact that a larger sample gives a more reliable estimate than a smaller one. Working: the first sample gives 35 ÷ 50 = 0.7 and 0.7 × 2,000 = 1,400 paperbacks; the second gives 31 ÷ 50 = 0.62 and 0.62 × 2,000 = 1,240 paperbacks. Two random samples of the same size are expected to differ a little, so neither estimate is wrong. Putting the two together gives 35 + 31 = 66 paperbacks in 100 books, and 66 ÷ 100 = 0.66 with 0.66 × 2,000 = 1,320, an estimate resting on twice as many books as either volunteer checked. Answer: 1,400 and 1,240, so combine the samples for one estimate. The distractors: keeping 1,400 because it is larger picks an estimate by its size, when both samples held 50 books and neither has a stronger claim; saying a volunteer must have miscounted assumes two random samples ought to agree exactly, which is precisely what random sampling does not promise; 1,750 and 1,550 come from 35 × 50 = 1,750 and 31 × 50 = 1,550, multiplying each count by the size of the sample instead of scaling by 2,000 ÷ 50.
- (a) 62.5 — Method: a mean cannot be averaged with a new value — rebuild the total, add the new value to it, then divide by the new count. Working: three numbers with a mean of 50 have a total of 50 × 3 = 150; adding 100 makes the total 150 + 100 = 250; there are now 4 numbers, so the new mean is 250 ÷ 4 = 62.5. Answer: 62.5. The distractors: 75 comes from averaging the old mean with the new value, (50 + 100) ÷ 2, which ignores that three numbers pull against one; 50 comes from assuming an extra value leaves the mean unchanged; 37.5 comes from dividing the old total of 150 by the new count of 4, adding the new value to the count but not to the total.
- (b) 1 — Method: for data in a frequency table, find the position of the median using (n + 1) ÷ 2, then read off the value at that position from the cumulative frequencies. Working: there are 19 pupils, so the median is the 10th value. The cumulative frequencies are 7 (up to 0 pets), 10 (up to 1 pet), 14 (up to 2 pets) and 19 (up to 3 pets). The 10th value falls at the end of the '1 pet' group, so the median is 1 pet. Giving 0 pets is the mode — the category with the highest frequency, 7 — not the median. Giving 3, the highest number of pets minus the lowest, finds the range, a different statistic entirely. Giving 19 states the total number of pupils, not a number of pets at all. Find the middle POSITION first, then read off the value it belongs to — do not confuse it with the mode, the range or the total.
Build your own mix at the worksheet builder.