Printable · GCSE Higher · ages 14-16
Statistics worksheet — GCSE Higher
Fifteen questions across the statistics statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Statistics worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) The data show a link only; a third factor may affect both — Method: a study of this kind measures two quantities and reports how they change together; deciding that one of them produces the other is a further claim, and it needs evidence that the measurements alone cannot give. Working: the study shows that more coffee goes with better concentration, which is a positive correlation; but a third factor that was never measured, such as how motivated someone is, could raise both the coffee drinking and the concentration, and the concentration could equally be what leads to the extra coffee. Answer: the data show a link only, because a third factor may be affecting both quantities, so no claim about cause can be made. The distractors: calling the conclusion safe because the correlation is positive treats the direction of a correlation as proof of cause, which no direction can give; calling it wrong because the correlation is negative misreads the direction of the relationship, since the study reports both quantities rising together; saying the two quantities are not linked denies the correlation the study actually found, when what fails is only the claim about cause.
- (d) An outlier from the damaged wing, not the trend. — That bird's point lies a long way from the rising trend followed by every other bird, and its low wingspan is explained by the damaged wing rather than by its age — it is an outlier caused by an unusual factor, not part of the general relationship between age and wingspan, so it should not be used when drawing the line of best fit. Saying every point must be used ignores that an outlier caused by a separate, identifiable factor can rightly be set aside. Saying it shows no correlation ignores that the other 19 points do show a clear rising trend; one outlier does not remove that. Saying it proves the line is inaccurate confuses one unusual bird with a fault in the line itself, when the line correctly describes the trend followed by the rest of the data.
- (c) 28 — Method: multiply the number of whole symbols by the value of one symbol, then add the value of any half symbol shown. Working: 3 whole symbols represent 3 × 8 = 24 cars. The half symbol represents 4 cars. Total cars sold in March = 24 + 4 = 28. Leaving out the half symbol, 3 × 8 = 24, undercounts by exactly the value of that half symbol. Treating the half symbol as if it were a full symbol, 4 × 8 = 32, overcounts because it doubles the value the half symbol is worth. Giving 3.5 reports the number of symbols shown, not the number of cars they represent — the key still needs to be applied. Always apply the key to every symbol shown, including a half symbol, rather than reading off the symbol count itself.
- (d) Full-time workers, as most are at work at that time — Method: a sample is biased when the method of contact makes part of the population much less likely to be reached, so test each group against where its members actually are between 10 am and 2 pm on a weekday, and test each stated reason against the facts. Working: those hours are the middle of the working day, so people in full-time employment are at work and not beside a landline telephone, while people who are retired and people who are unemployed are far more likely to be at home and are reached at the usual rate; the method therefore collects far fewer replies from full-time workers than their share of the adult population the council is consulting. Answer: full-time workers, as most are at work at that time. The distractors: the reply naming retired people rests on the false claim that most retired people are at work in the daytime, when in fact a daytime call reaches them more easily than anyone; the reply naming unemployed people rests on the false claim that they are out during the day, when they too are among the easiest people to reach by a daytime call; the reply naming children rests on the false claim that children are at home at 11 am on a Tuesday, when they are at school and so are not reached by the call at all, and school-age children are in any case not the adults whose views the council is collecting.
- (d) 300 pupils — Method: an estimate for a whole population is made by finding the proportion in the sample and applying that same proportion to the population. Working: in the sample 30 of the 50 pupils prefer sport, a proportion of 30 ÷ 50 = 0.6, and applying that proportion to the school gives 0.6 × 500 = 300 pupils. Answer: 300 pupils, and it is only an estimate, because a different random sample of 50 would give a slightly different figure. The distractors: 200 pupils comes from scaling up the 20 pupils in the sample who did not prefer sport, 20 × 10, which answers the opposite question; 150 pupils comes from reading 30 out of 50 as 30% and taking 30% of 500; 60 pupils comes from working out the proportion correctly as 60% and then writing the 60 down as a number of pupils instead of applying it to the 500.
- (a) Minutes a candle has burned and length remaining — As a candle burns for longer, less of it remains, so these two variables move in opposite directions as one increases — that is negative correlation. A pupil's shoe size generally increases as they get older, so age and shoe size show positive correlation, not negative, since both rise together. A football team's shirt colour is not a numerical quantity linked to how many matches it wins, so shirt colour and number of wins show no correlation at all. The number of letters in a pupil's name has no real connection to their ability in maths, so that pair also shows no correlation.
- (a) 26 — Method: a line of best fit lets one quantity be predicted from the other, so the score is substituted into the equation of the line and the resulting inequality is solved for the number of hours. Working: a score of at least 80 means 2.5x + 15 ≥ 80; taking 15 from both sides gives 2.5x ≥ 65, and dividing both sides by 2.5 gives x ≥ 26, so the least whole number of hours is 26. Checking, 2.5 × 26 + 15 = 80, which does reach the target. Answer: 26 hours — and this is only an estimate, because a line of best fit predicts a trend rather than an individual result, and a prediction made outside the range of hours the pupils actually revised for would be an extrapolation and less reliable still. The distractors: 27 comes from reaching 26 and then rounding up again, although 26 hours already gives a score of exactly 80; 32 comes from 80 ÷ 2.5, which ignores the 15 in the equation of the line; 38 comes from (80 + 15) ÷ 2.5, that is from adding the 15 instead of subtracting it when rearranging.
- (b) On average a plant grew 1.5 cm taller for each extra day — Method: in the equation of a line, the number multiplying x is the gradient, and a gradient states the change in y produced by an increase of 1 in x, read in the units of the two axes. Working: here x is measured in days and y in centimetres, so the gradient 1.5 carries the units centimetres per day. Testing it on the line, 5 days gives 1.5 × 5 + 4 = 11.5 cm and 6 days gives 1.5 × 6 + 4 = 13 cm, a rise of 1.5 cm for the one extra day. Answer: on average a plant grew 1.5 cm taller for each extra day of watering. The distractors: 1.5 cm as the height before any watering is the value of y when x is 0, which is the other number in the equation, 4 cm, so this swaps the gradient and the intercept; 1.5 cm as the gap between the tallest and the shortest plant reads the gradient as a range, when a range is a difference between two of the 16 plants and a gradient is a rate; 1.5 days for each extra centimetre inverts the rate, dividing days by centimetres instead of centimetres by days, and the line gives 1 cm of growth in two thirds of a day.
- (d) 648 kg — Method: to estimate a total from a sample, multiply the sample's mean by the number of items in the whole population, then check the units the question asks for. Working: 32.4 g × 20,000 = 648,000 g. Converting to kilograms, 648,000 ÷ 1,000 = 648 kg. This is only an estimate, not an exact total, because it assumes every one of the 20,000 packets has exactly the sample mean mass, when in reality individual packets vary above and below it. Giving 1.62 kg multiplies the mean by 50, the SAMPLE size, instead of by 20,000, the number of packets actually made that day — this finds the total mass of the 50 sampled packets, not the day's production. Giving 32.4 kg treats the sample mean itself, in grams, as if it already were the day's total mass in kilograms, skipping the scaling up altogether. Giving 648,000 kg correctly scales the mean up to the whole day's production but never converts the answer from grams to kilograms, leaving it 1,000 times too large. Always scale a sample's mean up by the SIZE OF THE WHOLE POPULATION, and always finish by checking the units the question asks for.
- (b) 74 marks — Method: the two groups are different sizes, so their means cannot simply be averaged — rebuild each group's total mark, add the totals and divide by all 50 pupils. Working: Group A scored 20 × 80 = 1600 marks and Group B scored 30 × 70 = 2100 marks, giving 1600 + 2100 = 3700 marks altogether, so the overall mean is 3700 ÷ 50 = 74 marks. Answer: 74 marks, which sits nearer to 70 than to 80 because the larger group scored 70. The distractors: 75 marks comes from averaging the two group means, (80 + 70) ÷ 2, as though the groups were the same size; 76 marks comes from attaching each mean to the other group's size, (20 × 70 + 30 × 80) ÷ 50; 150 marks comes from adding the two means together and never dividing at all.
- (c) Because every pupil has an equal chance of being picked — Method: whether a sample represents its population is decided by the selection method, not by the size of the sample, so ask whether the method gives every member of the population the same chance of being chosen. Working: the names are drawn at random from a list of all 10,000 pupils, so each pupil has the same chance, 500 out of 10,000, of being drawn, and no group of pupils is more likely to appear than any other; that is what keeps bias out of the sample. Answer: because every pupil has an equal chance of being picked. The distractors: the reply about 5% treats the sampling fraction as the test of fairness, but a badly chosen 5% is still biased and a well chosen 1% is not; the reply about 500 being large enough makes size the test instead, which is the same mistake in another form, since a large sample drawn from one school would still misrepresent the city; the reply about the most willing pupils describes self-selection, which hands the choice of who is in the sample to the pupils who feel most strongly about the question.
- (d) 18 minutes — Method: the lower quartile is the 80 ÷ 4 = 20th value and the upper quartile is the 3 × 80 ÷ 4 = 60th value; locate each inside its class by linear interpolation, then subtract. Working: the 20th value lies between the running totals 8 and 28, so it is in the class 10 ≤ t < 20, which holds 20 journeys across 10 minutes, and it is the 20 − 8 = 12th of them, giving 10 + (12 ÷ 20) × 10 = 16 minutes; the 60th value lies between the running totals 52 and 72, so it is in the class 30 ≤ t < 40, which also holds 20 journeys across 10 minutes, and it is the 60 − 52 = 8th of them, giving 30 + (8 ÷ 20) × 10 = 34 minutes; subtracting, 34 − 16 = 18. Answer: an estimated interquartile range of 18 minutes. The distractors: 20 minutes comes from taking the lower boundaries of the two quartile classes, 30 − 10, which locates the classes but never the values inside them; 40 minutes comes from subtracting the two positions, 60 − 20, instead of the two times; 22 minutes comes from interpolating downwards from each upper boundary rather than upwards from each lower boundary, giving 20 − 6 = 14 and 40 − 4 = 36.
- (b) Q was faster on average and more consistent — Method: compare the medians for the average and the interquartile ranges for the spread, remembering that a shorter time is faster and a smaller interquartile range means more consistent. Working: the median for class Q is 35 seconds against 38 seconds for class P, so class Q was faster on average; the interquartile range for class P is 46 − 24 = 22 seconds and for class Q it is 44 − 30 = 14 seconds, so class Q's times are more tightly grouped. Answer: class Q was faster on average and more consistent. The distractors: calling Q slower comes from comparing the lower quartiles, 30 against 24, as though a quartile were the average; calling Q less consistent comes from using the gap between the median and the upper quartile as the spread, 44 − 35 = 9 against 46 − 38 = 8, instead of the full interquartile range; the statement that Q was both slower and less consistent comes from making both of those mistakes together.
- (d) No, the range uses only the fastest and slowest time — Method: check what the range is built from, then look at what it leaves out. Working: both teams have a fastest time of 20 seconds and a slowest of 40 seconds, so both ranges are 40 − 20 = 20 seconds and Tomás has that part right. But the range is calculated from those two values alone. Six of Team A's seven times lie between 20 and 25 seconds, with a single time far out at 40; Team B is the other way round, with six of its seven times at 30 seconds or more and a single time far out at 20. So Team A bunches at the fast end and Team B at the slow end. The two patterns are quite different, and the range cannot see the difference because the five middle times never enter the calculation. Answer: no, because the range uses only the fastest and slowest time. The distractors: comparing the means answers a different question, since a mean measures position rather than spread, and two sets with the same spread can have different means; saying that equal ranges mean equal spread is the very assumption that fails here; saying that seven times each forces the spreads to match confuses the size of a data set with how its values are arranged inside it.
- (d) Only internet users reach the website; others are excluded. — Method: a sample is biased when it systematically leaves out part of the population, or systematically over-represents another part. Working: anyone without internet access, or who does not visit the council's website, has NO chance of being included — the sample is drawn only from internet-using residents, which is not the whole town. Saying too many people might respond because the survey is free confuses bias with sample size — bias is about who CAN be reached, not how many respond. Saying people might lie describes a different problem, response honesty, not who was sampled in the first place. Saying online surveys cannot be anonymous is not a reason connected to bias at all. A sample is biased when part of the population has no chance of being included, whatever the reason for that.
Build your own mix at the worksheet builder.