Printable · GCSE Higher · ages 14-16
Statistics worksheet — GCSE Higher
Fifteen questions across the statistics statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Statistics worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) 16 — Method: on a box plot the interquartile range is the width of the box itself, upper quartile take away lower quartile. Working: the upper quartile is 38 and the lower quartile is 22, so 38 − 22 = 16. Answer: the interquartile range is 16 years. Watch which part of the box plot you are reading: the whole line from whisker to whisker gives the range, 61 − 15 = 46; the left half of the box alone gives median take away lower quartile, 29 − 22 = 7; and the right half of the box alone gives upper quartile take away median, 38 − 29 = 9 — neither half is the interquartile range on its own.
- (c) 90 — Method: the height of a bar is its frequency density, so twice as tall means twice the frequency density — not twice the frequency, because the two classes have different widths. Then frequency = frequency density × class width. Working: the first bar has frequency density 3 per cm, so the second has frequency density 2 × 3 = 6 per cm; the class 30 ≤ x < 45 is 45 − 30 = 15 cm wide, so its frequency is 6 × 15 = 90. Answer: 90 rods. The distractors: 120 comes from doubling the first bar's frequency instead of its height — the first class holds 3 × 20 = 60 rods, and doubling that ignores the fact that the second class is narrower; 45 comes from using the first bar's frequency density, 3, for the second bar, 3 × 15, and so never using the information that it is twice as tall; 6 comes from stopping at the frequency density of the taller bar and quoting a height as though it were a count.
- (a) 27 — Method: turn the mean into a total using total = mean × number of values, then subtract the numbers that are already known. Working: four numbers with a mean of 18 have a total of 18 × 4 = 72; the three known numbers give 10 + 15 + 20 = 45; so x = 72 − 45 = 27. Answer: 27, and checking, (10 + 15 + 20 + 27) ÷ 4 = 72 ÷ 4 = 18. The distractors: 72 comes from stopping at the total the four numbers must reach and never subtracting the known three; 18 comes from assuming the missing number must equal the mean; 45 comes from stopping at the total of the three known numbers.
- (a) No, 150 pupils are a tenth of the school, chosen at random — Method: judge a sample on two things, whether every member of the population had the same chance of being chosen, and whether the sample is large enough to carry a pattern. Working: the 150 pupils were drawn from the register of every pupil in the school, so no year group or set is shut out and no pupil chooses to take part; and 150 ÷ 1,500 = 0.1, so one pupil in ten has been asked. A random sample of that share is ample for an estimate of how long the school's pupils spend on homework. Answer: no, because 150 pupils are a tenth of the school and were chosen at random. The distractors: saying a random sample always gives the exact school figure reaches the same verdict for a reason that is false, since a second random sample of 150 would give a slightly different mean; saying 150 pupils cannot be picked at random from 1,500 treats randomness as something only a whole population can have, when drawing names from the register is exactly how a random sample is taken; saying that only asking all 1,500 could show anything rejects sampling altogether, which would leave no way to study any population too large to count.
- (a) The means are equal, and Class B's marks are the more consistent because its range is smaller. — Method: comparing two distributions needs two things — a measure of average and a measure of spread — and each must be put into the context of the question. Working: both classes have a mean mark of 70, so on average the two classes scored the same; the range measures spread, and Class A's range of 30 marks is three times Class B's range of 10 marks, so Class B's marks sit closely around the mean while Class A's are far more spread out. Answer: the means are equal, and Class B's marks are the more consistent because its range is smaller. The distractors: the reply crediting Class A with more consistency reverses the meaning of the range, treating a larger range as tighter data when a larger range means more spread; the reply that Class A's mean mark is higher compares the wrong pair of figures, reading the range of 30 as an average; the reply that Class B's mean mark is higher reads the spread correctly but its claim about the means is false, since both means are 70.
- (c) 0.5 per gram — Method: turn the two known bars into frequencies using area, subtract from the total to find how many letters are left, then divide that frequency by the width of the last class to get its height. Working: the first bar covers 50 g at a frequency density of 1.2, giving 1.2 × 50 = 60 letters, and the second covers 50 g at 1.8, giving 1.8 × 50 = 90 letters; together that is 60 + 90 = 150 letters, so 200 − 150 = 50 letters remain; the class 100 ≤ m < 200 is 100 g wide, so its frequency density is 50 ÷ 100 = 0.5 per gram. Answer: 0.5 per gram. The distractors: 0.25 per gram comes from dividing the remaining 50 letters by the upper class boundary, 200, instead of by the class width of 100; 2 per gram comes from dividing the class width by the frequency, 100 ÷ 50, reversing the formula; 1.4 per gram comes from subtracting only the first bar's 60 letters, leaving 140, and then dividing by 100.
- (b) 5.5 kg — Method: with an even number of values the median is the mean of the two middle values, taken once the data are in order of size. Working: the eight masses are already in order and 8 ÷ 2 = 4, so the middle pair are the 4th and 5th values, 5 kg and 6 kg; the median is (5 + 6) ÷ 2 = 5.5 kg. Answer: 5.5 kg. The distractors: 5 kg comes from reading the 4th value and stopping there instead of averaging the middle pair; 8 kg comes from working out the range, 11 − 3, which measures spread rather than centre; 4 kg comes from writing down the modal mass, the only value that occurs twice, instead of the median.
- (c) Class X has the higher median and the wider spread — Method: compare the two box plots statistic by statistic — median for location, and the interquartile range for spread — checking the true value of each rather than assuming a pattern. Working: Class X's median is 60 and Class Y's is 58, so Class X's median is the higher one. Class X's interquartile range is 70 − 45 = 25 and Class Y's is 65 − 50 = 15 (and the ranges follow the same order: 95 − 20 = 75 against 80 − 35 = 45), so Class X also has the wider spread. Answer: Class X has both the higher median and the wider spread. Watch that each half of a compound statement is checked separately: claiming Class Y has the higher median and the wider spread gets both comparisons backwards; claiming Class X has the higher median but the narrower spread keeps the median right while reading the spread the wrong way round; and claiming Class Y has the higher median but the narrower spread swaps the median comparison while getting the spread right.
- (a) Equal means; Class A is more consistent, smaller range. — Method: when two data sets share a measure of location, compare a measure of spread to say more about consistency. Working: both classes have the same mean mark, 14, so on average they performed equally well. Class A has the smaller range, 6, so its marks are more tightly grouped around 14 than Class B's marks, which vary by as much as 14. So Class A's marks were more consistent, even though neither class did better on average. Saying Class B did better because it has the bigger range confuses a wide spread with a high score — a big range describes variability, not performance. Saying Class A did better because it has the smaller range makes the same mistake in the other direction: the two classes are tied on the mean, so neither one 'did better'. Saying the classes cannot be compared because their means are equal misses the whole point of also comparing the range. Always compare both an average AND a spread before describing two data sets — either one alone tells only half the story.
- (c) 33 — Method: multiply the mean by the number of tests to get the total marks, then subtract the marks that are already known. Working: four tests with a mean of 29 give a total of 29 × 4 = 116 marks; the first three marks total 31 + 26 + 26 = 83; so the fourth mark is 116 − 83 = 33. Answer: 33, and checking, (31 + 26 + 26 + 33) ÷ 4 = 116 ÷ 4 = 29. The distractors: 116 comes from stopping at the total for all four tests; 29 comes from assuming the missing mark must be the mean itself; 4 comes from multiplying the mean by 3, the number of marks given, leaving 87 − 83 = 4.
- (c) The median, £160,000, as one very high price lifts the mean — Method: find both averages, then choose the one that sits closer to the bulk of the data. Working: in order the prices are 140,000, 150,000, 160,000, 170,000 and 580,000, so the median is the third of the five, £160,000. For the mean, 140,000 + 150,000 + 160,000 + 170,000 + 580,000 = 1,200,000 and 1,200,000 ÷ 5 = 240,000, so the mean is £240,000. Four of the five houses sold for £170,000 or less, so a reader told that a typical price is £240,000 would expect to pay at least £70,000 more than any of those four cost. Answer: the median, £160,000, as one very high price lifts the mean. The distractors: £580,000 is the middle value of the list as it is printed, which is the median only when the values have first been put in order; £240,000 is the mean, chosen on the ground that a median ignores three of the five prices, but a median uses all five to find which one is central and is then untroubled by how extreme the outer values are; £155,000 comes from deleting the £580,000 house and taking the mean of what is left, since 140,000 + 150,000 + 160,000 + 170,000 = 620,000 and 620,000 ÷ 4 = 155,000, but a real sale may not be thrown away merely for being large.
- (c) No, the mode here is the lowest value of the nine — Method: an average is meant to stand for the data as a whole, so test any proposed average by asking how many values it sits near. Working: the value 4 appears three times and every other count appears once, so 4 is indeed the mode. But those three hours are the quiet ones at the start of the day, and the other six counts run from 11 up to 25; putting the nine counts in order, the middle one is the fifth, which is 13. So the mode sits at the very bottom of the data, with six of the nine hours far above it. Answer: no, because the mode here is the lowest value of the nine, so it describes the quiet opening hours rather than a typical hour. The distractors: saying the mode can only be used when no value repeats reverses the definition, since a mode exists only because a value does repeat; saying the mode is the value that occurs most often is a correct definition, but being the commonest value does not make a value typical when it lies at one end of the data; saying the mode is the best average for any list of numbers ignores the fact that mean, median and mode each describe a population well in different circumstances.
- (a) 30 — Method: an outlier is a value that lies far away from the pattern set by the rest of the data, so compare each value with the group the others form. Working: five of the counts, 5, 7, 8, 9 and 11, lie within 6 of one another and the steps between them are 2, 1, 1 and 2; the remaining count of 30 is 19 above the nearest of them, so it is the value that does not belong to the pattern. Answer: 30. The distractors: 5 comes from picking the smallest value, on the idea that the odd one out must be at the bottom of the list; 11 comes from ordering the data and stopping one value short, taking the largest of the counts that sit close together; 8.5 comes from working out the median, (8 + 9) ÷ 2, and giving a measure of centre where a value standing apart was asked for.
- (b) All 2,000 members of the sports centre. — Method: in a survey, the population is the whole group the survey is trying to find out about, and the sample is the smaller group actually asked. Working: this survey wants to know what the sports centre's members think, so the population is every one of the 2,000 members — whether or not they were personally asked. Saying the population is the 100 members who were asked names the sample, not the population; the sample is drawn FROM the population, so it is smaller than it, not the same as it. Saying the population is everybody who lives in Ipswich widens the group far beyond who the survey is actually about — plenty of Ipswich residents are not members of the sports centre at all, so they are outside this survey altogether. Saying the population is the members who say they are unhappy confuses the population with a result of the survey: whether a member turns out to be happy or unhappy is something the survey finds out, not part of the definition of who is being studied. The population is always the whole group the question is about, before any sampling or any results come in.
- (d) 1.2 pupils per mark — Method: on a histogram whose class intervals are not all the same width the height of a bar is not the frequency but the frequency density, found by dividing the frequency of the class by the width of that class, so that the area of the bar represents the frequency. Working: the class 40 ≤ m < 60 holds 24 pupils, and its width is 60 − 40 = 20 marks, so the frequency density is 24 ÷ 20 = 1.2. Answer: 1.2 pupils per mark. The distractors: 24 pupils per mark comes from plotting the frequency itself as the height, which is only correct when every class has the same width; 2.4 pupils per mark comes from dividing by 10, the width of the narrowest class, instead of by the width of this class; 0.2 pupils per mark comes from dividing by the 120 pupils in the year group, which gives the proportion of pupils in the class and not a frequency density.
Build your own mix at the worksheet builder.