Printable · GCSE Higher · ages 14-16
Statistics worksheet — GCSE Higher
Fifteen questions across the statistics statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Statistics worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) 120, unreliable — x = 25 is outside 1 to 12 — The line of best fit is y = 4x + 20. 4 × 25 = 100, and 100 + 20 = 120, so the estimate is y = 120. But x = 25 lies far outside the plotted range of 1 to 12 years, so this is an extrapolation, and the estimate is not reliable. Reaching 100 instead of 120 comes from 4 × 25 = 100 with the intercept of 20 left out — still correctly flagged as unreliable, but the wrong value. Calling the estimate reliable simply because it was calculated correctly, giving 120, wrongly assumes that a correct calculation is automatically trustworthy, ignoring that x = 25 lies far beyond the data actually collected. Reaching 68, from 4 × 12 = 48 and 48 + 20 = 68, substitutes x = 12, the top of the plotted range, instead of the assistant's actual x = 25, and wrongly calls that reliable because 12 lies inside the range.
- (a) (30, 60) — Method: a cumulative frequency point is plotted at the upper boundary of its class, paired with the running total of all the frequencies up to and including that class. Working: the running totals are 7, then 7 + 19 = 26, then 26 + 34 = 60, then 60 + 40 = 100; the class 20 ≤ t < 30 has upper boundary 30, and the running total there is 60. Answer: the point for that class is plotted at 30 seconds against a cumulative frequency of 60. The distractors: (25, 60) comes from plotting at the class midpoint, which is what a frequency polygon uses and not what a cumulative frequency diagram uses; (30, 34) comes from plotting the class frequency, 34, rather than the running total; (20, 60) comes from plotting at the lower boundary of the class, which would claim that 60 calls took less than 20 seconds when only 26 did.
- (b) Treat them as outliers and check them before deciding — Method: a point lying a long way from the pattern the rest of the data make is called an outlier, and an outlier is investigated before anything is done with it, because it may be an error in the data or it may be a genuine but unusual case. Working: 48 of the 50 points lie close to the rising line of best fit, so the trend is set by those 48; the two remaining points do not follow it, so they are identified as outliers and checked — a mistake in measuring or recording would be corrected, while a genuine reading would be kept and reported. Answer: treat them as outliers and check them before deciding what to do with them. The distractors: deleting them at once assumes that every point far from the line must be an error, which throws away real data; moving the line so that it passes through them assumes a line of best fit must touch particular points, when it is drawn to follow all 50; taking them as proof that there is no correlation lets two points overturn the pattern that the other 48 agree on.
- (d) 25 — Method: the median is estimated at position n ÷ 2 in the cumulative frequency table, then interpolated across the class it falls in: lower boundary, plus the fraction of the way through the class, times the class width. Working: there are 80 sacks, so the median sits at position 80 ÷ 2 = 40. Before the class 20 ≤ m < 30 the cumulative frequency is 22, and by the end of it, it is 58, so this class holds the 40th sack; its frequency is 58 − 22 = 36 and its width is 30 − 20 = 10. The extra distance needed into the class is 40 − 22 = 18, and 18 ÷ 36 × 10 = 5, so the median is 20 + 5 = 25. Answer: the estimated median mass is 25 kg. Watch which numbers the interpolation uses: reading off just the lower boundary of the median class, 20, ignores how far into that class the 40th sack actually falls; treating n ÷ 2 = 40 itself as the median mass mistakes a position in the list for a mass in kilograms; and using the target position, 40, as the extra distance into the class instead of subtracting the sacks already counted changes the calculation to 20 + 40 ÷ 36 × 10. That comes to 20 + 11.1 = 31.1, overshooting the class because it never subtracts the 22 sacks already counted before it.
- (d) Correlation is a link; causation is one causing the other — Method: the two words describe different claims — one is about a pattern in the data, the other is about what produced that pattern. Working: correlation says only that two quantities tend to change together, which is something a scatter graph can display; causation says that a change in one quantity actually brings about the change in the other, which needs evidence a scatter graph cannot supply, because a third quantity may be driving both. Answer: correlation is a link between the quantities, while causation is one quantity causing the change in another. The distractors: the statement giving causation as the link and correlation as the cause simply swaps the two words over; the statement that the words mean the same thing is the classic error of reading a correlation as proof of cause; the statement that a scatter graph shows causation but not correlation reverses what a scatter graph can do, since the pattern it displays is exactly the correlation.
- (d) An outlier from the damaged wing, not the trend. — That bird's point lies a long way from the rising trend followed by every other bird, and its low wingspan is explained by the damaged wing rather than by its age — it is an outlier caused by an unusual factor, not part of the general relationship between age and wingspan, so it should not be used when drawing the line of best fit. Saying every point must be used ignores that an outlier caused by a separate, identifiable factor can rightly be set aside. Saying it shows no correlation ignores that the other 19 points do show a clear rising trend; one outlier does not remove that. Saying it proves the line is inaccurate confuses one unusual bird with a fault in the line itself, when the line correctly describes the trend followed by the rest of the data.
- (c) 76 marks — Method: a mean of means only works when the groups are the same size, so rebuild each class's total mark, add the totals and divide by the number of pupils altogether. Working: Class A scored 30 × 72 = 2160 marks and Class B scored 20 × 82 = 1640 marks, giving 2160 + 1640 = 3800 marks between 50 pupils, so the overall mean is 3800 ÷ 50 = 76 marks. Answer: 76 marks. The distractors: 77 marks comes from averaging the two class means, (72 + 82) ÷ 2, which ignores the different class sizes; 78 marks comes from attaching each mean to the other class's size, (30 × 82 + 20 × 72) ÷ 50; 3800 marks comes from stopping at the combined total and never dividing by 50.
- (d) £15.50 — 2 × 6 = 12, and 12 + 3.50 = 15.50, so the estimated fare is £15.50. Choosing £12.00 stops after 2 × 6 = 12 and forgets to add the £3.50. Choosing £19.00 adds the distance and the constant first and then multiplies: 6 + 3.50 = 9.50, and 9.50 × 2 = 19.00, applying the ×2 to the whole sum instead of only to the distance. Choosing £13.00 multiplies only the constant term by 2 instead of the distance: 2 × 3.50 = 7, and 7 + 6 = 13.00.
- (d) Full-time workers, as most are at work at that time — Method: a sample is biased when the method of contact makes part of the population much less likely to be reached, so test each group against where its members actually are between 10 am and 2 pm on a weekday, and test each stated reason against the facts. Working: those hours are the middle of the working day, so people in full-time employment are at work and not beside a landline telephone, while people who are retired and people who are unemployed are far more likely to be at home and are reached at the usual rate; the method therefore collects far fewer replies from full-time workers than their share of the adult population the council is consulting. Answer: full-time workers, as most are at work at that time. The distractors: the reply naming retired people rests on the false claim that most retired people are at work in the daytime, when in fact a daytime call reaches them more easily than anyone; the reply naming unemployed people rests on the false claim that they are out during the day, when they too are among the easiest people to reach by a daytime call; the reply naming children rests on the false claim that children are at home at 11 am on a Tuesday, when they are at school and so are not reached by the call at all, and school-age children are in any case not the adults whose views the council is collecting.
- (d) 25 ≤ t < 45 — Method: the height of a bar on a histogram is the frequency density, so work out frequency ÷ class width for every class and compare the four heights. Working: 20 ÷ 10 = 2 for the first class; 12 ÷ 15 = 0.8 for the second; 50 ÷ 20 = 2.5 for the third; 60 ÷ 30 = 2 for the fourth. Answer: the largest of 2, 0.8, 2.5 and 2 is 2.5, so the tallest bar is the one for 25 ≤ t < 45. The distractors: 45 ≤ t < 75 comes from picking the class with the greatest frequency, 60, and treating a frequency as a height — but that class is three times as wide, so its 60 competitors are spread thinly; 10 ≤ t < 25 comes from dividing the class width by the frequency, 15 ÷ 12, and picking the largest of those reversed values; 0 ≤ t < 10 comes from assuming the narrowest class must always give the tallest bar, which is only true when the frequencies are equal.
- (c) 72 — Method: on a histogram the frequency of a class is the area of its bar, so frequency = frequency density × class width. Working: the class 50 ≤ m < 80 has width 80 − 50 = 30 grams and a frequency density of 2.4 per gram, so the frequency is 2.4 × 30 = 72. Answer: 72 pebbles. The distractors: 192 comes from using the upper class boundary, 80, as the width, giving 2.4 × 80; 12.5 comes from dividing the width by the density, 30 ÷ 2.4, which reverses the area rule; 2.4 comes from reading the height of the bar as the frequency itself, the commonest mistake on histograms, where a height is a density and only an area is a count.
- (c) Yes — £80 is above the boundary, £78 — Method: a value counts as an outlier when it lies more than 1.5 times the interquartile range beyond the nearer quartile; here that means checking it against upper quartile + 1.5 × interquartile range. Working: the interquartile range is 42 − 18 = 24. 1.5 × 24 = 36, and 42 + 36 = 78, so any saving above £78 is an outlier. Amara saved £80, and 80 is greater than 78. Answer: yes, Amara's saving is an outlier, because £80 is above the outlier boundary, £78. Watch how you build the boundary and what you compare it with: adding the two quartiles instead of subtracting them, 42 + 18 = 60, gives an interquartile range three times too big, and 42 + 1.5 × 60 = 42 + 90 = 132 puts the boundary so far out that £80 wrongly looks ordinary; comparing £80 with the upper quartile alone, £42, checks only that it lies in the top quarter of the data, which every value above £42 does, not that it lies unusually far beyond it; and adding the interquartile range on once instead of one and a half times, 42 + 24 = 66, uses the wrong multiplier, even though £80 still happens to clear that lower boundary too.
- (c) 145 g — Method: find the position of the median from the total frequency, locate the class that contains it, then use linear interpolation inside that class, assuming the apples in it are spread evenly. Working: the median is the 100 ÷ 2 = 50th apple; the running totals are 10, then 10 + 30 = 40, then 40 + 40 = 80, so the 50th apple lies in the class 140 ≤ m < 160; it is the 50 − 40 = 10th of the 40 apples in that class, and the class is 20 g wide, so the median is 140 + (10 ÷ 40) × 20 = 140 + 5 = 145. Answer: an estimated median of 145 g. The distractors: 150 g comes from giving the midpoint of the class that contains the median instead of interpolating inside it; 140 g comes from stopping at the lower boundary of that class, which locates the class but not the value; 155 g comes from measuring the 5 g step down from the upper boundary, 160 − 5, instead of up from the lower boundary.
- (d) 25% — First find the number of fruit cakes: 80 − 34 − 26 = 20. Then write this as a percentage of the total: 20 ÷ 80 × 100 = 25%. Giving 20% comes from reporting the count of fruit cakes, 20, directly as a percentage, without dividing by the total of 80 first. Giving 32.5% computes the percentage of chocolate cakes instead of fruit cakes: 26 ÷ 80 × 100 = 32.5%. Giving 42.5% computes the percentage of sponge cakes instead of fruit cakes: 34 ÷ 80 × 100 = 42.5%.
- (b) Q was faster on average and more consistent — Method: compare the medians for the average and the interquartile ranges for the spread, remembering that a shorter time is faster and a smaller interquartile range means more consistent. Working: the median for class Q is 35 seconds against 38 seconds for class P, so class Q was faster on average; the interquartile range for class P is 46 − 24 = 22 seconds and for class Q it is 44 − 30 = 14 seconds, so class Q's times are more tightly grouped. Answer: class Q was faster on average and more consistent. The distractors: calling Q slower comes from comparing the lower quartiles, 30 against 24, as though a quartile were the average; calling Q less consistent comes from using the gap between the median and the upper quartile as the spread, 44 − 35 = 9 against 46 − 38 = 8, instead of the full interquartile range; the statement that Q was both slower and less consistent comes from making both of those mistakes together.
Build your own mix at the worksheet builder.