Printable · GCSE Higher · ages 14-16
Statistics worksheet — GCSE Higher
Fifteen questions across the statistics statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Statistics worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) 3 — Method: the height of a bar is its frequency density, frequency ÷ class width, so work out both heights and divide one by the other. Working: the class 0 ≤ t < 4 is 4 minutes wide and holds 30 visits, so its frequency density is 30 ÷ 4 = 7.5 per minute; the class 4 ≤ t < 20 is 16 minutes wide and holds 40 visits, so its frequency density is 40 ÷ 16 = 2.5 per minute; dividing the heights, 7.5 ÷ 2.5 = 3. Answer: the first bar is 3 times as tall. The distractors: 0.75 comes from comparing the frequencies, 30 ÷ 40, as though the frequencies were the heights, which is the mistake the unequal widths are there to expose; 4 comes from comparing the class widths, 16 ÷ 4, instead of the heights; 5 comes from subtracting the two frequency densities, 7.5 − 2.5, which answers how much taller rather than how many times taller.
- (d) 4, 3, 2, 6 — Method: frequency density = frequency ÷ class width for each class in turn; do not assume the classes are all the same width. Working: the four classes have widths 10 − 0 = 10, 30 − 10 = 20, 45 − 30 = 15 and 50 − 45 = 5. Dividing each frequency by its own width gives 40 ÷ 10 = 4, 60 ÷ 20 = 3, 30 ÷ 15 = 2 and 30 ÷ 5 = 6. Answer: the frequency densities, in order, are 4, 3, 2 and 6. Watch the width of each class separately: treating the last class as if it were also 10 units wide, like the first, gives 30 ÷ 10 = 3 instead of 30 ÷ 5 = 6 — the classes here are deliberately unequal, so no width can be borrowed from another class; dividing the width by the frequency instead of the frequency by the width for the third class gives 15 ÷ 30 = 0.5 in place of 2, the formula the wrong way round; and reading the frequency column straight off the table, 40, 60, 30, 30, skips the division by width altogether and reports how many fish are in each class rather than how densely packed each bar is.
- (d) Both the mean and the range increase. — The original mean is 150 + 152 + 155 + 158 + 160 = 775, and 775 ÷ 5 = 155 cm; the original range is 160 − 150 = 10 cm. Including the new height of 170 cm gives a new total of 775 + 170 = 945, and 945 ÷ 6 = 157.5 cm, which is higher than 155 cm, and a new range of 170 − 150 = 20 cm, which is higher than 10 cm, so both the mean and the range increase. Saying the range stays the same ignores that 170 cm is a new, higher maximum than the old 160 cm. Saying the mean stays the same ignores that 170 cm is above the original mean of 155 cm, which pulls the average up. Saying both decrease is the opposite of what happens here.
- (c) 72° — The angle is 12 ÷ 60 × 360 = 72°. Choosing 150° divides football's frequency of 25 instead of badminton's 12: 25 ÷ 60 × 360 = 150. Choosing 20° finds badminton as a percentage of the members, 12 ÷ 60 × 100 = 20, rather than an angle in degrees. Choosing 90° uses 48, the total of the other three activities, as the total instead of the full 60 members: 12 ÷ 48 × 360 = 90.
- (b) 120, unreliable — x = 25 is outside 1 to 12 — The line of best fit is y = 4x + 20. 4 × 25 = 100, and 100 + 20 = 120, so the estimate is y = 120. But x = 25 lies far outside the plotted range of 1 to 12 years, so this is an extrapolation, and the estimate is not reliable. Reaching 100 instead of 120 comes from 4 × 25 = 100 with the intercept of 20 left out — still correctly flagged as unreliable, but the wrong value. Calling the estimate reliable simply because it was calculated correctly, giving 120, wrongly assumes that a correct calculation is automatically trustworthy, ignoring that x = 25 lies far beyond the data actually collected. Reaching 68, from 4 × 12 = 48 and 48 + 20 = 68, substitutes x = 12, the top of the plotted range, instead of the assistant's actual x = 25, and wrongly calls that reliable because 12 lies inside the range.
- (b) All 2,000 members of the sports centre. — Method: in a survey, the population is the whole group the survey is trying to find out about, and the sample is the smaller group actually asked. Working: this survey wants to know what the sports centre's members think, so the population is every one of the 2,000 members — whether or not they were personally asked. Saying the population is the 100 members who were asked names the sample, not the population; the sample is drawn FROM the population, so it is smaller than it, not the same as it. Saying the population is everybody who lives in Ipswich widens the group far beyond who the survey is actually about — plenty of Ipswich residents are not members of the sports centre at all, so they are outside this survey altogether. Saying the population is the members who say they are unhappy confuses the population with a result of the survey: whether a member turns out to be happy or unhappy is something the survey finds out, not part of the definition of who is being studied. The population is always the whole group the question is about, before any sampling or any results come in.
- (c) Club members probably eat differently from most people — Method: a sample is biased when the group it is drawn from differs from the population in the very thing the survey is measuring, so compare the subgroup with the population on that quantity. Working: the survey measures eating habits, and people who join a sports club take more exercise than average and are known to eat differently from the town as a whole, so their replies pull the results away from the true picture for the town however many of them are asked. Answer: club members probably eat differently from most people. The distractors: the reply about the number of members treats bias as a question of size, but a large biased sample is still biased; the reply that the members were picked at random is false, since the council picked a club rather than picking residents, and it confuses bias with non-response; the reply that everyone asked lives in the town notes something true of the members but draws the false conclusion that the sample therefore covers the town, when a sample must reflect a population and not merely be taken from inside it.
- (d) 25 ≤ t < 45 — Method: the height of a bar on a histogram is the frequency density, so work out frequency ÷ class width for every class and compare the four heights. Working: 20 ÷ 10 = 2 for the first class; 12 ÷ 15 = 0.8 for the second; 50 ÷ 20 = 2.5 for the third; 60 ÷ 30 = 2 for the fourth. Answer: the largest of 2, 0.8, 2.5 and 2 is 2.5, so the tallest bar is the one for 25 ≤ t < 45. The distractors: 45 ≤ t < 75 comes from picking the class with the greatest frequency, 60, and treating a frequency as a height — but that class is three times as wide, so its 60 competitors are spread thinly; 10 ≤ t < 25 comes from dividing the class width by the frequency, 15 ÷ 12, and picking the largest of those reversed values; 0 ≤ t < 10 comes from assuming the narrowest class must always give the tallest bar, which is only true when the frequencies are equal.
- (c) 40 minutes — Method: for grouped data, estimate the mean using the midpoint of each class — multiply each midpoint by its frequency, add the results, then divide by the total frequency. Working: the midpoints are 10, 30, 50 and 70 minutes. 10 × 5 = 50. 30 × 10 = 300. 50 × 10 = 500. 70 × 5 = 350. Σfx = 50 + 300 + 500 + 350 = 1200. Σf = 5 + 10 + 10 + 5 = 30. Estimated mean = 1200 ÷ 30 = 40 minutes. Using the upper boundary of each class instead of the midpoint — 20 × 5 = 100, 40 × 10 = 400, 60 × 10 = 600, 80 × 5 = 400 — gives a total of 1500 and an estimate of 1500 ÷ 30 = 50 minutes, too high because a boundary is not the middle of the class. Averaging the frequencies themselves, 5, 10, 10 and 5, ignores the times altogether and gives 7.5. Stopping after Σfx = 1200 without dividing by the total frequency gives a number far too large to be a time in minutes. Always find the midpoint of each class before multiplying by the frequency, and always divide by Σf at the end.
- (b) 60 — Method: for n ordered values, the upper quartile sits at position 3(n + 1) ÷ 4, counting from the smallest. Working: n + 1 = 11 + 1 = 12; 3 × 12 = 36 and 36 ÷ 4 = 9, so the upper quartile is the 9th value in the list 40, 42, 45, 47, 50, 52, 55, 58, 60, 63, 65, which is 60. Answer: the upper quartile is 60 seconds. Watch which quartile you find: counting to the 6th value gives the median, 52, not the upper quartile; using 3 × 11 = 33 and 33 ÷ 4 = 8.25 without adding 1 to n first, then rounding down, reaches the 8th value, 58, not the 9th; and counting to the 3rd value uses the lower quartile's position, 45, the wrong end of the list.
- (d) 45 — Method: a cumulative frequency is a running total — it counts everybody in every class up to and including the one that ends at the value given. Working: the classes that lie wholly below 30 minutes are 0 ≤ t < 10, 10 ≤ t < 20 and 20 ≤ t < 30, with frequencies 6, 14 and 25, so the running total is 6 + 14 = 20 and then 20 + 25 = 45. Answer: 45 people took less than 30 minutes. The distractors: 25 comes from quoting the frequency of the class 20 ≤ t < 30 on its own instead of the running total; 65 comes from accumulating one class too many and including 30 ≤ t < 40, which is 45 + 20; 35 comes from accumulating from the top downwards, 15 + 20, which counts the people who took 30 minutes or more rather than fewer.
- (a) Equal means; Class A is more consistent, smaller range. — Method: when two data sets share a measure of location, compare a measure of spread to say more about consistency. Working: both classes have the same mean mark, 14, so on average they performed equally well. Class A has the smaller range, 6, so its marks are more tightly grouped around 14 than Class B's marks, which vary by as much as 14. So Class A's marks were more consistent, even though neither class did better on average. Saying Class B did better because it has the bigger range confuses a wide spread with a high score — a big range describes variability, not performance. Saying Class A did better because it has the smaller range makes the same mistake in the other direction: the two classes are tied on the mean, so neither one 'did better'. Saying the classes cannot be compared because their means are equal misses the whole point of also comparing the range. Always compare both an average AND a spread before describing two data sets — either one alone tells only half the story.
- (c) No — 8 from one class is too small to represent the school. — Method: judge reliability by asking whether the sample is both large enough, and spread across the population, relative to what it is meant to represent. Working: 8 pupils is a tiny fraction of the school's 1,000 pupils, and all 8 come from a single class rather than a range of year groups, so the sample is both too small and too narrow to represent the whole school reliably. She is not right. Saying any sample size gives an equally reliable estimate ignores that reliability generally improves with a larger, more representative sample. Saying the method is unreliable because it was not done online is not a reason connected to sample size or representativeness at all. Saying 8 is reliable because it is more than half her class compares the sample to the wrong population — the school has 1,000 pupils, not one class. Always judge a sample's size against the population it is meant to represent, not against a smaller group within it.
- (b) 29 — There are 40 − 24 = 16 males, and 15 of them prefer cardio, so 16 − 15 = 1 male prefers weights. There are 24 females, and 10 prefer weights, so 24 − 10 = 14 females prefer cardio. Altogether, 15 + 14 = 29 people prefer cardio. Choosing 15 only counts the males who prefer cardio and forgets the females. Choosing 11 adds the two weights figures, 1 + 10 = 11, instead of the two cardio figures. Choosing 30 comes from 40 − 10, subtracting only the number of females who prefer weights from the grand total, rather than finding both cardio sub-totals separately.
- (b) 5.5 kg — Method: with an even number of values the median is the mean of the two middle values, taken once the data are in order of size. Working: the eight masses are already in order and 8 ÷ 2 = 4, so the middle pair are the 4th and 5th values, 5 kg and 6 kg; the median is (5 + 6) ÷ 2 = 5.5 kg. Answer: 5.5 kg. The distractors: 5 kg comes from reading the 4th value and stopping there instead of averaging the middle pair; 8 kg comes from working out the range, 11 − 3, which measures spread rather than centre; 4 kg comes from writing down the modal mass, the only value that occurs twice, instead of the median.
Build your own mix at the worksheet builder.