Printable · GCSE Higher · ages 14-16
Statistics worksheet — GCSE Higher
Fifteen questions across the statistics statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Statistics worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) 13 — The total is 50, and the two known parts are 22 (tea) and 15 (coffee), so 50 − 22 − 15 = 13 hot chocolates. Choosing 28 comes from 50 − 22, subtracting only the tea and forgetting the coffee. Choosing 35 comes from 50 − 15, subtracting only the coffee and forgetting the tea. Choosing 37 comes from 22 + 15, which finds how many drinks were tea or coffee, not the number left over for hot chocolate.
- (a) 62.5 — Method: a mean cannot be averaged with a new value — rebuild the total, add the new value to it, then divide by the new count. Working: three numbers with a mean of 50 have a total of 50 × 3 = 150; adding 100 makes the total 150 + 100 = 250; there are now 4 numbers, so the new mean is 250 ÷ 4 = 62.5. Answer: 62.5. The distractors: 75 comes from averaging the old mean with the new value, (50 + 100) ÷ 2, which ignores that three numbers pull against one; 50 comes from assuming an extra value leaves the mean unchanged; 37.5 comes from dividing the old total of 150 by the new count of 4, adding the new value to the count but not to the total.
- (c) 33 — Method: multiply the mean by the number of tests to get the total marks, then subtract the marks that are already known. Working: four tests with a mean of 29 give a total of 29 × 4 = 116 marks; the first three marks total 31 + 26 + 26 = 83; so the fourth mark is 116 − 83 = 33. Answer: 33, and checking, (31 + 26 + 26 + 33) ÷ 4 = 116 ÷ 4 = 29. The distractors: 116 comes from stopping at the total for all four tests; 29 comes from assuming the missing mark must be the mean itself; 4 comes from multiplying the mean by 3, the number of marks given, leaving 87 − 83 = 4.
- (d) 29 — Method: with an even number of values there is no single middle value, so the median is the mean of the two values either side of the middle. Working: the six numbers are already in order and 6 ÷ 2 = 3, so the middle pair are the third and fourth values, 22 and 36; their mean is (22 + 36) ÷ 2 = 58 ÷ 2 = 29. Answer: 29, which lies between the two middle values as a median of an even data set must. The distractors: 22 comes from taking the lower of the two middle values and stopping there instead of averaging the pair; 36 comes from taking the larger value of that pair because it sits just past the halfway point of the list; 34 comes from working out the range, 47 − 13, instead of a measure of centre.
- (c) 27 — Method: a frequency is the area of the part of the bar being asked about, so frequency = frequency density × the width of that part. Working: the part asked about runs from 20 to 35, so its width is 35 − 20 = 15 metres; the frequency density there is 1.8 per metre, so the estimate is 1.8 × 15 = 27. Answer: about 27 throws. The distractors: 72 comes from taking the whole bar, 1.8 × 40, and so counting every throw from 20 up to 60; 1.8 comes from reading the height of the bar as a frequency, when a height is a density and only an area is a count; 63 comes from using the upper value 35 as the width, 1.8 × 35, instead of the width 35 − 20.
- (d) 1100 — Method: to combine two samples of different sizes, add the faulty counts together and add the sample sizes together before scaling up, rather than treating the two samples separately. Working: the combined sample found 34 + 21 = 55 scratched cases out of 100 + 50 = 150 cases checked, a proportion of 55 ÷ 150. Applying that proportion to the week's production of 3,000 gives an estimate of 55 ÷ 150 × 3000 = 1100 scratched cases. Averaging the two shifts' proportions instead of combining their totals, (34 ÷ 100 + 21 ÷ 50) ÷ 2 = 0.38, gives 0.38 × 3000 = 1140 — this treats the two samples as equally weighted even though Shift A checked twice as many cases as Shift B. Using only Shift A's sample, 34 ÷ 100 × 3000 = 1020, ignores Shift B's cases completely. Using only Shift B's sample, 21 ÷ 50 × 3000 = 1260, ignores Shift A's cases completely. When two samples are different sizes, combine their totals before finding the proportion — do not average the two proportions, and do not use only one shift's sample.
- (b) 120, unreliable — x = 25 is outside 1 to 12 — The line of best fit is y = 4x + 20. 4 × 25 = 100, and 100 + 20 = 120, so the estimate is y = 120. But x = 25 lies far outside the plotted range of 1 to 12 years, so this is an extrapolation, and the estimate is not reliable. Reaching 100 instead of 120 comes from 4 × 25 = 100 with the intercept of 20 left out — still correctly flagged as unreliable, but the wrong value. Calling the estimate reliable simply because it was calculated correctly, giving 120, wrongly assumes that a correct calculation is automatically trustworthy, ignoring that x = 25 lies far beyond the data actually collected. Reaching 68, from 4 × 12 = 48 and 48 + 20 = 68, substitutes x = 12, the top of the plotted range, instead of the assistant's actual x = 25, and wrongly calls that reliable because 12 lies inside the range.
- (c) 28 — Method: multiply the number of whole symbols by the value of one symbol, then add the value of any half symbol shown. Working: 3 whole symbols represent 3 × 8 = 24 cars. The half symbol represents 4 cars. Total cars sold in March = 24 + 4 = 28. Leaving out the half symbol, 3 × 8 = 24, undercounts by exactly the value of that half symbol. Treating the half symbol as if it were a full symbol, 4 × 8 = 32, overcounts because it doubles the value the half symbol is worth. Giving 3.5 reports the number of symbols shown, not the number of cars they represent — the key still needs to be applied. Always apply the key to every symbol shown, including a half symbol, rather than reading off the symbol count itself.
- (a) Minutes a candle has burned and length remaining — As a candle burns for longer, less of it remains, so these two variables move in opposite directions as one increases — that is negative correlation. A pupil's shoe size generally increases as they get older, so age and shoe size show positive correlation, not negative, since both rise together. A football team's shirt colour is not a numerical quantity linked to how many matches it wins, so shirt colour and number of wins show no correlation at all. The number of letters in a pupil's name has no real connection to their ability in maths, so that pair also shows no correlation.
- (c) Yes — with an estimate of 320, above the 250 limit. — Method: scale the sample proportion up to the whole batch to get an estimate, then compare that estimate with the 250 limit to reach a decision. Working: in the sample, 4 out of 50 boards are faulty, a proportion of 4 ÷ 50 = 0.08. Applying that proportion to the batch of 4,000 gives an estimate of 0.08 × 4000 = 320 faulty boards. Since 320 is more than 250, the factory should scrap the batch. Inverting the proportion, 50 ÷ 4 = 12.5, and treating that as a percentage of the batch, 12.5% × 4000 = 500, still gives 'yes' but from the wrong fraction, so it overstates the estimate. Comparing the raw number of faulty boards found in the sample, 4, directly with the 250 limit skips the scaling up to the batch altogether, and 4 is nowhere near 250, so that route wrongly says 'no'. Dividing the batch by the sample size, 4000 ÷ 50 = 80, finds how many samples of 50 fit into the batch but stops before multiplying by the 4 faulty boards found, so it also wrongly says 'no'. Always find the proportion in the sample first, scale it up to the whole batch, and only then compare the estimate with the limit given.
- (c) No, 90 cm is far outside the heights on the graph — Method: a line of best fit describes the trend only across the stretch of data it was drawn through; predicting beyond that stretch is extrapolation, and nothing in the data supports it. Working: the heights used to draw this line run from 150 cm to 180 cm, all of them Year 10 pupils, while 90 cm is 60 cm below the shortest of them and belongs to a two-year-old child, whose build follows no trend the graph has measured. Substituting anyway gives 0.9 × 90 − 85 = −4, a mass of −4 kg, which cannot exist. Answer: no, because 90 cm is far outside the heights on the graph. The distractors: saying a line of best fit cannot be used to predict at all throws away its main purpose, since a prediction made between the plotted values is perfectly sound; saying the line passes through all 20 points misdescribes a line of best fit, which is drawn to follow the trend of the points and will normally pass through few of them; saying the equation works for any value put into it treats an equation fitted to Year 10 heights as a law of nature, and the mass of −4 kg shows what that assumption produces.
- (c) 145 g — Method: find the position of the median from the total frequency, locate the class that contains it, then use linear interpolation inside that class, assuming the apples in it are spread evenly. Working: the median is the 100 ÷ 2 = 50th apple; the running totals are 10, then 10 + 30 = 40, then 40 + 40 = 80, so the 50th apple lies in the class 140 ≤ m < 160; it is the 50 − 40 = 10th of the 40 apples in that class, and the class is 20 g wide, so the median is 140 + (10 ÷ 40) × 20 = 140 + 5 = 145. Answer: an estimated median of 145 g. The distractors: 150 g comes from giving the midpoint of the class that contains the median instead of interpolating inside it; 140 g comes from stopping at the lower boundary of that class, which locates the class but not the value; 155 g comes from measuring the 5 g step down from the upper boundary, 160 − 5, instead of up from the lower boundary.
- (a) 1.24 — Method: for data given as a frequency table, the mean is Σfx ÷ Σf — multiply each value by its frequency, add the results, then divide by the total frequency. Working: 0 × 6 = 0. 1 × 10 = 10. 2 × 6 = 12. 3 × 3 = 9. So Σfx = 0 + 10 + 12 + 9 = 31. The total frequency is Σf = 6 + 10 + 6 + 3 = 25. Mean = 31 ÷ 25 = 1.24 siblings. Averaging the frequency column itself, (6 + 10 + 6 + 3) ÷ 4 = 6.25, mixes up the frequencies with the values they belong to. Writing down 1, the number of siblings with the highest frequency, gives the mode, not the mean. Writing down 31 stops after finding Σfx and forgets to divide by the total frequency, 25. Always divide Σfx by Σf — never stop at the top of the fraction.
- (a) The median, as the one very large wage does not move it — Method: an average describes a population well when it sits close to most of the values, so compare what each average does when one value lies far from the rest. Working: in order the wages are 420, 440, 460, 480 and 1,500, so the median is the third of the five, £460. The mean uses every wage: 420 + 440 + 460 + 480 + 1,500 = 3,300 and 3,300 ÷ 5 = 660, so the mean is £660. Four of the five people earn less than £660, and the nearest of those four wages is £180 below it, so £660 describes nobody at the garage; £460 sits inside the group of four similar wages. Answer: the median, as the one very large wage does not move it, while that same wage drags the mean £200 above the median. The distractors: saying the median is always larger than the mean is an invented rule, and here the median £460 is smaller than the mean £660; saying the mean is the only average that uses all five wages is true as far as it goes, but using a value and being dragged by it are the same thing when that value is £1,500; saying £660 lies between the smallest and largest wage is true of every mean ever calculated, so it proves nothing about whether this one is typical.
- (d) No, the range uses only the fastest and slowest time — Method: check what the range is built from, then look at what it leaves out. Working: both teams have a fastest time of 20 seconds and a slowest of 40 seconds, so both ranges are 40 − 20 = 20 seconds and Tomás has that part right. But the range is calculated from those two values alone. Six of Team A's seven times lie between 20 and 25 seconds, with a single time far out at 40; Team B is the other way round, with six of its seven times at 30 seconds or more and a single time far out at 20. So Team A bunches at the fast end and Team B at the slow end. The two patterns are quite different, and the range cannot see the difference because the five middle times never enter the calculation. Answer: no, because the range uses only the fastest and slowest time. The distractors: comparing the means answers a different question, since a mean measures position rather than spread, and two sets with the same spread can have different means; saying that equal ranges mean equal spread is the very assumption that fails here; saying that seven times each forces the spreads to match confuses the size of a data set with how its values are arranged inside it.
Build your own mix at the worksheet builder.