Printable · GCSE Higher · ages 14-16
Statistics worksheet — GCSE Higher
Fifteen questions across the statistics statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Statistics worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (b) All 2,000 members of the sports centre. — Method: in a survey, the population is the whole group the survey is trying to find out about, and the sample is the smaller group actually asked. Working: this survey wants to know what the sports centre's members think, so the population is every one of the 2,000 members — whether or not they were personally asked. Saying the population is the 100 members who were asked names the sample, not the population; the sample is drawn FROM the population, so it is smaller than it, not the same as it. Saying the population is everybody who lives in Ipswich widens the group far beyond who the survey is actually about — plenty of Ipswich residents are not members of the sports centre at all, so they are outside this survey altogether. Saying the population is the members who say they are unhappy confuses the population with a result of the survey: whether a member turns out to be happy or unhappy is something the survey finds out, not part of the definition of who is being studied. The population is always the whole group the question is about, before any sampling or any results come in.
- (c) No, the mode here is the lowest value of the nine — Method: an average is meant to stand for the data as a whole, so test any proposed average by asking how many values it sits near. Working: the value 4 appears three times and every other count appears once, so 4 is indeed the mode. But those three hours are the quiet ones at the start of the day, and the other six counts run from 11 up to 25; putting the nine counts in order, the middle one is the fifth, which is 13. So the mode sits at the very bottom of the data, with six of the nine hours far above it. Answer: no, because the mode here is the lowest value of the nine, so it describes the quiet opening hours rather than a typical hour. The distractors: saying the mode can only be used when no value repeats reverses the definition, since a mode exists only because a value does repeat; saying the mode is the value that occurs most often is a correct definition, but being the commonest value does not make a value typical when it lies at one end of the data; saying the mode is the best average for any list of numbers ignores the fact that mean, median and mode each describe a population well in different circumstances.
- (c) The mean, because every value counts towards it, so 100 pulls it from 7 up to about 20.3. — Method: work each measure out before the extra value is added and again afterwards, then compare the size of the two changes. Working: before, the six values total 42, so the mean is 42 ÷ 6 = 7, and the middle pair 6 and 8 give a median of (6 + 8) ÷ 2 = 7; after, the seven values total 142, so the mean is 142 ÷ 7 = 20.29 to 2 decimal places, while the median is now the 4th of the seven ordered values, which is 8; the mean has moved by about 13.3 and the median by 1. Answer: the mean, because every value counts towards it, so 100 pulls it from 7 up to about 20.3 — this is why the median is often preferred when a data set contains an outlier. The distractors: the reply that the mean rises by 100 adds the extra value to the mean instead of adding it to the total; the reply that the median moves to 12 takes the largest of the original values as the new middle instead of counting to the 4th of the seven values; the reply about even and odd counts quotes a rule that does not exist, since the median moved because a very large value was added, not because the count of values changed.
- (c) No — 8 from one class is too small to represent the school. — Method: judge reliability by asking whether the sample is both large enough, and spread across the population, relative to what it is meant to represent. Working: 8 pupils is a tiny fraction of the school's 1,000 pupils, and all 8 come from a single class rather than a range of year groups, so the sample is both too small and too narrow to represent the whole school reliably. She is not right. Saying any sample size gives an equally reliable estimate ignores that reliability generally improves with a larger, more representative sample. Saying the method is unreliable because it was not done online is not a reason connected to sample size or representativeness at all. Saying 8 is reliable because it is more than half her class compares the sample to the wrong population — the school has 1,000 pupils, not one class. Always judge a sample's size against the population it is meant to represent, not against a smaller group within it.
- (b) 13 — The total is 50, and the two known parts are 22 (tea) and 15 (coffee), so 50 − 22 − 15 = 13 hot chocolates. Choosing 28 comes from 50 − 22, subtracting only the tea and forgetting the coffee. Choosing 35 comes from 50 − 15, subtracting only the coffee and forgetting the tea. Choosing 37 comes from 22 + 15, which finds how many drinks were tea or coffee, not the number left over for hot chocolate.
- (c) A histogram, with frequency density up the vertical axis — Method: decide which diagram makes area stand for frequency, which is the property the question asks for. Working: on a histogram the vertical axis is frequency density, so the area of a bar is frequency density × class width, and that product is the frequency; this is exactly what is wanted, and it is what allows classes of unequal width to be shown fairly. Answer: a histogram, with frequency density up the vertical axis. The distractors: a bar chart plots frequency as the height, so with unequal widths a wide class would cover far more area than a narrow class holding the same number of batteries, and area would measure nothing; a cumulative frequency diagram plots running totals against upper class boundaries, so a point on it gives how many lie below a value rather than how many lie in a class; a pie chart shows each class as a share of the whole 300 and loses the class widths entirely, so no area on it is tied to a scale of hours.
- (a) 62.5 — Method: a mean cannot be averaged with a new value — rebuild the total, add the new value to it, then divide by the new count. Working: three numbers with a mean of 50 have a total of 50 × 3 = 150; adding 100 makes the total 150 + 100 = 250; there are now 4 numbers, so the new mean is 250 ÷ 4 = 62.5. Answer: 62.5. The distractors: 75 comes from averaging the old mean with the new value, (50 + 100) ÷ 2, which ignores that three numbers pull against one; 50 comes from assuming an extra value leaves the mean unchanged; 37.5 comes from dividing the old total of 150 by the new count of 4, adding the new value to the count but not to the total.
- (d) 29 — Method: with an even number of values there is no single middle value, so the median is the mean of the two values either side of the middle. Working: the six numbers are already in order and 6 ÷ 2 = 3, so the middle pair are the third and fourth values, 22 and 36; their mean is (22 + 36) ÷ 2 = 58 ÷ 2 = 29. Answer: 29, which lies between the two middle values as a median of an even data set must. The distractors: 22 comes from taking the lower of the two middle values and stopping there instead of averaging the pair; 36 comes from taking the larger value of that pair because it sits just past the halfway point of the list; 34 comes from working out the range, 47 − 13, instead of a measure of centre.
- (c) 72 — Method: on a histogram the frequency of a class is the area of its bar, so frequency = frequency density × class width. Working: the class 50 ≤ m < 80 has width 80 − 50 = 30 grams and a frequency density of 2.4 per gram, so the frequency is 2.4 × 30 = 72. Answer: 72 pebbles. The distractors: 192 comes from using the upper class boundary, 80, as the width, giving 2.4 × 80; 12.5 comes from dividing the width by the density, 30 ÷ 2.4, which reverses the area rule; 2.4 comes from reading the height of the bar as the frequency itself, the commonest mistake on histograms, where a height is a density and only an area is a count.
- (c) The median, £160,000, as one very high price lifts the mean — Method: find both averages, then choose the one that sits closer to the bulk of the data. Working: in order the prices are 140,000, 150,000, 160,000, 170,000 and 580,000, so the median is the third of the five, £160,000. For the mean, 140,000 + 150,000 + 160,000 + 170,000 + 580,000 = 1,200,000 and 1,200,000 ÷ 5 = 240,000, so the mean is £240,000. Four of the five houses sold for £170,000 or less, so a reader told that a typical price is £240,000 would expect to pay at least £70,000 more than any of those four cost. Answer: the median, £160,000, as one very high price lifts the mean. The distractors: £580,000 is the middle value of the list as it is printed, which is the median only when the values have first been put in order; £240,000 is the mean, chosen on the ground that a median ignores three of the five prices, but a median uses all five to find which one is central and is then untroubled by how extreme the outer values are; £155,000 comes from deleting the £580,000 house and taking the mean of what is left, since 140,000 + 150,000 + 160,000 + 170,000 = 620,000 and 620,000 ÷ 4 = 155,000, but a real sale may not be thrown away merely for being large.
- (a) 27 — Method: turn the mean into a total using total = mean × number of values, then subtract the numbers that are already known. Working: four numbers with a mean of 18 have a total of 18 × 4 = 72; the three known numbers give 10 + 15 + 20 = 45; so x = 72 − 45 = 27. Answer: 27, and checking, (10 + 15 + 20 + 27) ÷ 4 = 72 ÷ 4 = 18. The distractors: 72 comes from stopping at the total the four numbers must reach and never subtracting the known three; 18 comes from assuming the missing number must equal the mean; 45 comes from stopping at the total of the three known numbers.
- (c) Yes — with an estimate of 320, above the 250 limit. — Method: scale the sample proportion up to the whole batch to get an estimate, then compare that estimate with the 250 limit to reach a decision. Working: in the sample, 4 out of 50 boards are faulty, a proportion of 4 ÷ 50 = 0.08. Applying that proportion to the batch of 4,000 gives an estimate of 0.08 × 4000 = 320 faulty boards. Since 320 is more than 250, the factory should scrap the batch. Inverting the proportion, 50 ÷ 4 = 12.5, and treating that as a percentage of the batch, 12.5% × 4000 = 500, still gives 'yes' but from the wrong fraction, so it overstates the estimate. Comparing the raw number of faulty boards found in the sample, 4, directly with the 250 limit skips the scaling up to the batch altogether, and 4 is nowhere near 250, so that route wrongly says 'no'. Dividing the batch by the sample size, 4000 ÷ 50 = 80, finds how many samples of 50 fit into the batch but stops before multiplying by the 4 faulty boards found, so it also wrongly says 'no'. Always find the proportion in the sample first, scale it up to the whole batch, and only then compare the estimate with the limit given.
- (a) Minutes a candle has burned and length remaining — As a candle burns for longer, less of it remains, so these two variables move in opposite directions as one increases — that is negative correlation. A pupil's shoe size generally increases as they get older, so age and shoe size show positive correlation, not negative, since both rise together. A football team's shirt colour is not a numerical quantity linked to how many matches it wins, so shirt colour and number of wins show no correlation at all. The number of letters in a pupil's name has no real connection to their ability in maths, so that pair also shows no correlation.
- (c) 69 — Method: multiply the mean by the number of values to find the total, then subtract the total of the known values. Working: the total of all five scores is 68 × 5 = 340. The total of the four known scores is 55 + 62 + 74 + 80 = 271. The fifth score is 340 − 271 = 69. Subtracting the other way round, 271 − 340 = −69, gives the right size answer with the wrong sign. Guessing that the missing score simply equals the mean, 68, ignores that the four known scores are not themselves centred on 68. Multiplying the mean by 4 instead of 5, 68 × 4 = 272, then 272 − 271 = 1, undercounts how many scores there are. Always multiply the mean by the TOTAL number of values before subtracting.
- (b) 135 — Method: use the sample to find the PROPORTION of left-handed pupils, then apply that same proportion to the whole school population. Working: in the sample, 6 out of 40 pupils are left-handed, a proportion of 6 ÷ 40 = 0.15. Applying that proportion to the school's 900 pupils gives an estimate of 0.15 × 900 = 135 pupils. Giving 6 simply repeats the number of left-handed pupils IN THE SAMPLE, without scaling up to the whole school at all. Multiplying the population by the number of left-handed pupils in the sample without first dividing by the sample size, 900 × 6 = 5400, badly overestimates — that is more pupils than the whole school has. Dividing the population by the sample size but forgetting to multiply by the number of left-handed pupils found, 900 ÷ 40 = 22.5, finds the scale factor but stops one step short of using it. Always find the proportion in the sample first, then scale that same proportion up to the population.
Build your own mix at the worksheet builder.