Printable · GCSE Higher · ages 14-16
Statistics worksheet — GCSE Higher
Fifteen questions across the statistics statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Statistics worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) 648 kg — Method: to estimate a total from a sample, multiply the sample's mean by the number of items in the whole population, then check the units the question asks for. Working: 32.4 g × 20,000 = 648,000 g. Converting to kilograms, 648,000 ÷ 1,000 = 648 kg. This is only an estimate, not an exact total, because it assumes every one of the 20,000 packets has exactly the sample mean mass, when in reality individual packets vary above and below it. Giving 1.62 kg multiplies the mean by 50, the SAMPLE size, instead of by 20,000, the number of packets actually made that day — this finds the total mass of the 50 sampled packets, not the day's production. Giving 32.4 kg treats the sample mean itself, in grams, as if it already were the day's total mass in kilograms, skipping the scaling up altogether. Giving 648,000 kg correctly scales the mean up to the whole day's production but never converts the answer from grams to kilograms, leaving it 1,000 times too large. Always scale a sample's mean up by the SIZE OF THE WHOLE POPULATION, and always finish by checking the units the question asks for.
- (d) An outlier from the damaged wing, not the trend. — That bird's point lies a long way from the rising trend followed by every other bird, and its low wingspan is explained by the damaged wing rather than by its age — it is an outlier caused by an unusual factor, not part of the general relationship between age and wingspan, so it should not be used when drawing the line of best fit. Saying every point must be used ignores that an outlier caused by a separate, identifiable factor can rightly be set aside. Saying it shows no correlation ignores that the other 19 points do show a clear rising trend; one outlier does not remove that. Saying it proves the line is inaccurate confuses one unusual bird with a fault in the line itself, when the line correctly describes the trend followed by the rest of the data.
- (d) 25 — Method: the median is estimated at position n ÷ 2 in the cumulative frequency table, then interpolated across the class it falls in: lower boundary, plus the fraction of the way through the class, times the class width. Working: there are 80 sacks, so the median sits at position 80 ÷ 2 = 40. Before the class 20 ≤ m < 30 the cumulative frequency is 22, and by the end of it, it is 58, so this class holds the 40th sack; its frequency is 58 − 22 = 36 and its width is 30 − 20 = 10. The extra distance needed into the class is 40 − 22 = 18, and 18 ÷ 36 × 10 = 5, so the median is 20 + 5 = 25. Answer: the estimated median mass is 25 kg. Watch which numbers the interpolation uses: reading off just the lower boundary of the median class, 20, ignores how far into that class the 40th sack actually falls; treating n ÷ 2 = 40 itself as the median mass mistakes a position in the list for a mass in kilograms; and using the target position, 40, as the extra distance into the class instead of subtracting the sacks already counted changes the calculation to 20 + 40 ÷ 36 × 10. That comes to 20 + 11.1 = 31.1, overshooting the class because it never subtracts the 22 sacks already counted before it.
- (b) 1 — Method: for data in a frequency table, find the position of the median using (n + 1) ÷ 2, then read off the value at that position from the cumulative frequencies. Working: there are 19 pupils, so the median is the 10th value. The cumulative frequencies are 7 (up to 0 pets), 10 (up to 1 pet), 14 (up to 2 pets) and 19 (up to 3 pets). The 10th value falls at the end of the '1 pet' group, so the median is 1 pet. Giving 0 pets is the mode — the category with the highest frequency, 7 — not the median. Giving 3, the highest number of pets minus the lowest, finds the range, a different statistic entirely. Giving 19 states the total number of pupils, not a number of pets at all. Find the middle POSITION first, then read off the value it belongs to — do not confuse it with the mode, the range or the total.
- (c) 20 kg ≤ mass < 30 kg — The modal class is the class with the highest frequency. Reading the plotted points, the frequencies are 6, 10, 16, 6 and 2, so the highest frequency is 16, plotted at the midpoint 25. A class of width 10 centred on 25 runs from 25 − 5 = 20 to 25 + 5 = 30, so the modal class is 20 kg ≤ mass < 30 kg. Writing '25 kg' gives only the midpoint, not the class — the modal class is an interval, not a single value. '10 kg ≤ mass < 20 kg' is the class before the peak, centred on 15, which has frequency 10, not the highest. '30 kg ≤ mass < 40 kg' is the class after the peak, centred on 35, which has frequency 6, not the highest.
- (c) 28 — Method: multiply the number of whole symbols by the value of one symbol, then add the value of any half symbol shown. Working: 3 whole symbols represent 3 × 8 = 24 cars. The half symbol represents 4 cars. Total cars sold in March = 24 + 4 = 28. Leaving out the half symbol, 3 × 8 = 24, undercounts by exactly the value of that half symbol. Treating the half symbol as if it were a full symbol, 4 × 8 = 32, overcounts because it doubles the value the half symbol is worth. Giving 3.5 reports the number of symbols shown, not the number of cars they represent — the key still needs to be applied. Always apply the key to every symbol shown, including a half symbol, rather than reading off the symbol count itself.
- (c) 33 — Method: multiply the mean by the number of tests to get the total marks, then subtract the marks that are already known. Working: four tests with a mean of 29 give a total of 29 × 4 = 116 marks; the first three marks total 31 + 26 + 26 = 83; so the fourth mark is 116 − 83 = 33. Answer: 33, and checking, (31 + 26 + 26 + 33) ÷ 4 = 116 ÷ 4 = 29. The distractors: 116 comes from stopping at the total for all four tests; 29 comes from assuming the missing mark must be the mean itself; 4 comes from multiplying the mean by 3, the number of marks given, leaving 87 − 83 = 4.
- (c) 156 cm — Method: to combine two groups' means, multiply each group's mean by its own number of pupils, add the two totals together, then divide by the total number of pupils in both groups. Working: 20 × 150 = 3,000 cm for the boys and 10 × 168 = 1,680 cm for the girls, giving a combined total of 3,000 + 1,680 = 4,680 cm. Dividing by all 30 pupils gives 4,680 ÷ 30 = 156 cm. Giving 159 cm averages the two means, (150 + 168) ÷ 2, treating the two groups as if they had the same number of pupils, when there are twice as many boys as girls. Giving 4,680 cm finds the correct combined total height but stops there, forgetting the final division by the 30 pupils. Giving 234 cm divides the combined total by 20, the number of boys only, forgetting that the total also includes the 10 girls. Always weight each mean by its own group size, and always divide by the TOTAL number of pupils in both groups combined.
- (a) 26 — Method: a line of best fit lets one quantity be predicted from the other, so the score is substituted into the equation of the line and the resulting inequality is solved for the number of hours. Working: a score of at least 80 means 2.5x + 15 ≥ 80; taking 15 from both sides gives 2.5x ≥ 65, and dividing both sides by 2.5 gives x ≥ 26, so the least whole number of hours is 26. Checking, 2.5 × 26 + 15 = 80, which does reach the target. Answer: 26 hours — and this is only an estimate, because a line of best fit predicts a trend rather than an individual result, and a prediction made outside the range of hours the pupils actually revised for would be an extrapolation and less reliable still. The distractors: 27 comes from reaching 26 and then rounding up again, although 26 hours already gives a score of exactly 80; 32 comes from 80 ÷ 2.5, which ignores the 15 in the equation of the line; 38 comes from (80 + 15) ÷ 2.5, that is from adding the 15 instead of subtracting it when rearranging.
- (a) 1.5 — Method: with an even number of values the median is the mean of the two middle values, which for 12 values are the 6th and the 7th once the data are in order. Working: the results are already in order, and 12 ÷ 2 = 6, so the middle pair are the 6th value, 1, and the 7th value, 2; the median is (1 + 2) ÷ 2 = 1.5. Answer: 1.5 brothers and sisters. The distractors: 1 comes from reading the 6th value and stopping there instead of averaging the middle pair; 2 comes from working out the mean, 24 ÷ 12, instead of the median; 6 comes from working out the range, 6 − 0, which measures spread rather than centre.
- (d) 1.2 pupils per mark — Method: on a histogram whose class intervals are not all the same width the height of a bar is not the frequency but the frequency density, found by dividing the frequency of the class by the width of that class, so that the area of the bar represents the frequency. Working: the class 40 ≤ m < 60 holds 24 pupils, and its width is 60 − 40 = 20 marks, so the frequency density is 24 ÷ 20 = 1.2. Answer: 1.2 pupils per mark. The distractors: 24 pupils per mark comes from plotting the frequency itself as the height, which is only correct when every class has the same width; 2.4 pupils per mark comes from dividing by 10, the width of the narrowest class, instead of by the width of this class; 0.2 pupils per mark comes from dividing by the 120 pupils in the year group, which gives the proportion of pupils in the class and not a frequency density.
- (a) The means are equal, and Class B's marks are the more consistent because its range is smaller. — Method: comparing two distributions needs two things — a measure of average and a measure of spread — and each must be put into the context of the question. Working: both classes have a mean mark of 70, so on average the two classes scored the same; the range measures spread, and Class A's range of 30 marks is three times Class B's range of 10 marks, so Class B's marks sit closely around the mean while Class A's are far more spread out. Answer: the means are equal, and Class B's marks are the more consistent because its range is smaller. The distractors: the reply crediting Class A with more consistency reverses the meaning of the range, treating a larger range as tighter data when a larger range means more spread; the reply that Class A's mean mark is higher compares the wrong pair of figures, reading the range of 30 as an average; the reply that Class B's mean mark is higher reads the spread correctly but its claim about the means is false, since both means are 70.
- (d) 38, and fairly confident, as 12 °C is inside the range — Method: substitute the forecast temperature into the equation of the line of best fit, then judge the prediction by where that temperature sits among the data the line was drawn from. Working: putting x = 12 into y = −3x + 74 gives −3 × 12 + 74 = 38, so the line predicts 38 hot chocolates. The recorded temperatures run from 4 °C to 18 °C, and 12 °C lies inside that interval, so this is interpolation, the safer kind of prediction. Answer: 38, and fairly confident, as 12 °C is inside the range; the owner should still expect the true figure to differ a little, since the points only lie near the line and not on it. The distractors: being completely certain treats a line of best fit as a rule that fixes each day's sales, when it describes a trend that individual days depart from; saying 12 °C is outside the range misreads the interval 4 °C to 18 °C, and the wrong warning would be attached to a sound prediction; 110 comes from −3 × 12 being taken as +36, giving 36 + 74 = 110, which loses the negative gradient and so predicts that a warm day sells more hot chocolate than a cold one.
- (a) 62.5 — Method: a mean cannot be averaged with a new value — rebuild the total, add the new value to it, then divide by the new count. Working: three numbers with a mean of 50 have a total of 50 × 3 = 150; adding 100 makes the total 150 + 100 = 250; there are now 4 numbers, so the new mean is 250 ÷ 4 = 62.5. Answer: 62.5. The distractors: 75 comes from averaging the old mean with the new value, (50 + 100) ÷ 2, which ignores that three numbers pull against one; 50 comes from assuming an extra value leaves the mean unchanged; 37.5 comes from dividing the old total of 150 by the new count of 4, adding the new value to the count but not to the total.
- (b) 6 — Method: frequency density = frequency ÷ class width. Working: the class 12 ≤ h < 18 has width 18 − 12 = 6, so frequency density = 36 ÷ 6 = 6. Answer: the frequency density is 6 seedlings per cm. Watch which numbers you use: taking the lower bound, 12, as the width instead of 18 − 12 = 6 gives 36 ÷ 12 = 3; dividing the total number of seedlings, 90, rather than this class's frequency, 36, by the width gives 90 ÷ 6 = 15, a density that belongs to no single class; and multiplying instead of dividing gives 36 × 6 = 216, far too large a density for so narrow a class.
Build your own mix at the worksheet builder.