Printable · GCSE Higher · ages 14-16
Statistics worksheet — GCSE Higher
Fifteen questions across the statistics statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Statistics worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) 20 kg ≤ mass < 30 kg — The modal class is the class with the highest frequency. Reading the plotted points, the frequencies are 6, 10, 16, 6 and 2, so the highest frequency is 16, plotted at the midpoint 25. A class of width 10 centred on 25 runs from 25 − 5 = 20 to 25 + 5 = 30, so the modal class is 20 kg ≤ mass < 30 kg. Writing '25 kg' gives only the midpoint, not the class — the modal class is an interval, not a single value. '10 kg ≤ mass < 20 kg' is the class before the peak, centred on 15, which has frequency 10, not the highest. '30 kg ≤ mass < 40 kg' is the class after the peak, centred on 35, which has frequency 6, not the highest.
- (b) 60 — Method: for n ordered values, the upper quartile sits at position 3(n + 1) ÷ 4, counting from the smallest. Working: n + 1 = 11 + 1 = 12; 3 × 12 = 36 and 36 ÷ 4 = 9, so the upper quartile is the 9th value in the list 40, 42, 45, 47, 50, 52, 55, 58, 60, 63, 65, which is 60. Answer: the upper quartile is 60 seconds. Watch which quartile you find: counting to the 6th value gives the median, 52, not the upper quartile; using 3 × 11 = 33 and 33 ÷ 4 = 8.25 without adding 1 to n first, then rounding down, reaches the 8th value, 58, not the 9th; and counting to the 3rd value uses the lower quartile's position, 45, the wrong end of the list.
- (a) £16,000 — Method: first find the quarter with the highest sales figure, then subtract quarter 1's sales from it — remembering that every figure is given in THOUSANDS of pounds. Working: the highest sales figure is quarter 2, at £34,000 (34 thousand pounds). The increase from quarter 1 is £34,000 − £18,000 = £16,000. Giving £34,000 reads off the highest sales figure on its own, without subtracting quarter 1's sales — that is the highest quarter's total, not the increase. Giving £12,000 uses quarter 3's sales, 30, the SECOND-highest figure, instead of quarter 2's 34, the actual highest — 30 − 18 = 12, but quarter 3 is not the quarter with the highest sales. Giving £16 gets the subtraction right, 34 − 18 = 16, but forgets that every figure in the question is in thousands of pounds, so the increase is £16,000, not £16. Always identify the correct quarter FIRST, and always check the units the numbers are given in before writing your final answer.
- (d) 45 — Method: a cumulative frequency is a running total — it counts everybody in every class up to and including the one that ends at the value given. Working: the classes that lie wholly below 30 minutes are 0 ≤ t < 10, 10 ≤ t < 20 and 20 ≤ t < 30, with frequencies 6, 14 and 25, so the running total is 6 + 14 = 20 and then 20 + 25 = 45. Answer: 45 people took less than 30 minutes. The distractors: 25 comes from quoting the frequency of the class 20 ≤ t < 30 on its own instead of the running total; 65 comes from accumulating one class too many and including 30 ≤ t < 40, which is 45 + 20; 35 comes from accumulating from the top downwards, 15 + 20, which counts the people who took 30 minutes or more rather than fewer.
- (c) Yes — with an estimate of 320, above the 250 limit. — Method: scale the sample proportion up to the whole batch to get an estimate, then compare that estimate with the 250 limit to reach a decision. Working: in the sample, 4 out of 50 boards are faulty, a proportion of 4 ÷ 50 = 0.08. Applying that proportion to the batch of 4,000 gives an estimate of 0.08 × 4000 = 320 faulty boards. Since 320 is more than 250, the factory should scrap the batch. Inverting the proportion, 50 ÷ 4 = 12.5, and treating that as a percentage of the batch, 12.5% × 4000 = 500, still gives 'yes' but from the wrong fraction, so it overstates the estimate. Comparing the raw number of faulty boards found in the sample, 4, directly with the 250 limit skips the scaling up to the batch altogether, and 4 is nowhere near 250, so that route wrongly says 'no'. Dividing the batch by the sample size, 4000 ÷ 50 = 80, finds how many samples of 50 fit into the batch but stops before multiplying by the 4 faulty boards found, so it also wrongly says 'no'. Always find the proportion in the sample first, scale it up to the whole batch, and only then compare the estimate with the limit given.
- (b) Town B — higher median and smaller IQR — Method: 'higher and more consistent' needs two comparisons — the median for typical price, and the interquartile range for spread, with a smaller interquartile range meaning more consistent. Working: Town B's median, £235,000, is higher than Town A's, £220,000. Town A's interquartile range is 310 − 180 = 130 and Town B's is 260 − 175 = 85, so Town B's interquartile range is the smaller of the two. Answer: Town B has both the higher median and the smaller interquartile range, so it is the town with higher, more consistent prices. Watch which combination of median and interquartile range each statement claims, and for which town: claiming Town A has the higher median and the smaller interquartile range gets both comparisons wrong, since Town B leads on both; claiming Town A has the higher median (still wrong) but the larger interquartile range at least reads the spread correctly, without it rescuing the false median claim; and claiming Town B has the higher median (correct) but the larger interquartile range misreads the spread — Town B's interquartile range is the smaller of the two, not the larger.
- (c) 76 — Method: the frequency of each class is the area of its bar, frequency density × class width, so work out all three frequencies and add them. Working: the widths are 5, 10 and 25 kg, so the frequencies are 4 × 5 = 20, 2.6 × 10 = 26 and 1.2 × 25 = 30; the total is 20 + 26 + 30 = 76. Answer: 76 dogs. The distractors: 7.8 comes from adding the three frequency densities, 4 + 2.6 + 1.2, treating each height as though it were a count; 107 comes from using each upper class boundary as the width, giving 4 × 5, 2.6 × 15 and 1.2 × 40; 39 comes from using the first class width, 5, for every bar, which ignores the unequal intervals and gives 20 + 13 + 6.
- (c) Route 2, because its interquartile range is smaller — Method: for a journey where turning up on time matters, what matters is not the typical (median) time but how predictable it is — a smaller interquartile range means the middle half of journeys cluster closer together. Working: Route 1's median, 34 minutes, is in fact lower than Route 2's, 41 minutes, so Route 1 is faster on average; but Route 1's interquartile range, 22 minutes, is far larger than Route 2's, 6 minutes, so Route 1's times are much less predictable. Answer: Priya should choose Route 2, because its interquartile range is smaller, even though it is slower on average. Watch which statistic answers the question actually asked: Route 1 does not have the smaller interquartile range, Route 2 does, so picking Route 1 for that reason misreads the table; Route 1's median genuinely is the lower one, but a lower median answers 'which is faster', not 'which is more reliable'; and Route 2's median is not the lower one, so that claim about Route 2 is simply false.
- (b) £11.00 — 1.5 × 6 = 9, and 9 + 2 = 11, so the estimated cost is £11.00. Choosing £9.00 stops after 1.5 × 6 = 9 and forgets to add the £2. Choosing £12.00 adds the mass and the constant first and then multiplies: 6 + 2 = 8, and 8 × 1.5 = 12.00. Choosing £13.50 swaps the gradient and the intercept, using y = 2x + 1.5 instead: 2 × 6 = 12, and 12 + 1.5 = 13.50.
- (c) 75 — Method: the number in a class is the area of its bar, frequency density × class width, so work out the frequency of each class that lies at or above 10 minutes and add them. Working: the class 10 ≤ t < 25 is 15 minutes wide with a frequency density of 3.2, giving 3.2 × 15 = 48 members; the class 25 ≤ t < 55 is 30 minutes wide with a frequency density of 0.9, giving 0.9 × 30 = 27 members; the total charged is 48 + 27 = 75. Answer: 75 members pay the extra charge. The distractors: 4.1 comes from adding the two frequency densities, 3.2 + 0.9, as though each height were a count; 93 comes from including the class 0 ≤ t < 10 as well, 1.8 × 10 = 18 added to 48 and 27, which charges every member; 27 comes from using only the class 25 ≤ t < 55 and forgetting that 10 ≤ t < 25 is also at or above 10 minutes.
- (c) No — 8 from one class is too small to represent the school. — Method: judge reliability by asking whether the sample is both large enough, and spread across the population, relative to what it is meant to represent. Working: 8 pupils is a tiny fraction of the school's 1,000 pupils, and all 8 come from a single class rather than a range of year groups, so the sample is both too small and too narrow to represent the whole school reliably. She is not right. Saying any sample size gives an equally reliable estimate ignores that reliability generally improves with a larger, more representative sample. Saying the method is unreliable because it was not done online is not a reason connected to sample size or representativeness at all. Saying 8 is reliable because it is more than half her class compares the sample to the wrong population — the school has 1,000 pupils, not one class. Always judge a sample's size against the population it is meant to represent, not against a smaller group within it.
- (c) 22 kg — Method: multiply the mean by the number of parcels to rebuild the total mass, then subtract the masses that are known. Working: four parcels with a mean mass of 17 kg have a total mass of 17 × 4 = 68 kg; the three known parcels total 12 + 16 + 18 = 46 kg; so the fourth parcel has mass 68 − 46 = 22 kg. Answer: 22 kg. The distractors: 68 kg comes from stopping at the total mass of all four parcels; 17 kg comes from assuming the missing parcel must have the mean mass; 5 kg comes from multiplying the mean by 3, the number of parcels whose mass is given, leaving 51 − 46 = 5.
- (d) 16 — Method: rearrange interquartile range = upper quartile − lower quartile to make the lower quartile the subject: lower quartile = upper quartile − interquartile range, then check the answer sits in the right place in the list. Working: there are 11 values, so 11 + 1 = 12; the upper quartile sits at position 3 × 12 ÷ 4 = 9, which is 35, and x sits at position 12 ÷ 4 = 3, which is the lower quartile. So x = 35 − 19 = 16, and 16 does sit between the 2nd value, 9, and the 4th value, 17, as it should. Answer: x = 16. Watch how you rearrange and where you count to: adding instead of subtracting, 35 + 19 = 54, treats the interquartile range as something added on rather than a gap taken away; subtracting in the wrong order, 19 − 35 = −16, finds the right two numbers but flips the sign; and counting to the 8th value instead of the 9th treats 31 as the upper quartile, giving 31 − 19 = 12, one position short of where the upper quartile actually sits.
- (a) No, the size of the fire affects both of the quantities — Method: correlation says that two quantities change together; a claim that one of them produces the other is a further claim, and it needs evidence that a scatter graph on its own cannot give. Working: the graph does show strong positive correlation, so more engines did go with greater damage. But neither quantity was set by the researchers: both were decided by how large the fire was. A large blaze brings many appliances and also destroys a great deal, while a small one brings few and destroys little, so a third quantity is driving both of the recorded ones. Answer: no, because the size of the fire affects both of the quantities. The distractors: saying the correlation is negative contradicts the graph, which shows the two quantities rising together, and reaching the right verdict from a false reading of the data is not the reason the mark is for; saying that strong positive correlation shows one quantity causes the other is the assumption the question exists to test, and no strength of correlation can establish cause; saying the points lie close to the line of best fit describes how strong the correlation is, and strength and cause are different matters entirely.
- (c) 28 — Method: multiply the number of whole symbols by the value of one symbol, then add the value of any half symbol shown. Working: 3 whole symbols represent 3 × 8 = 24 cars. The half symbol represents 4 cars. Total cars sold in March = 24 + 4 = 28. Leaving out the half symbol, 3 × 8 = 24, undercounts by exactly the value of that half symbol. Treating the half symbol as if it were a full symbol, 4 × 8 = 32, overcounts because it doubles the value the half symbol is worth. Giving 3.5 reports the number of symbols shown, not the number of cars they represent — the key still needs to be applied. Always apply the key to every symbol shown, including a half symbol, rather than reading off the symbol count itself.
Build your own mix at the worksheet builder.