Printable · GCSE Higher · ages 14-16
Statistics worksheet — GCSE Higher
Fifteen questions across the statistics statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Statistics worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) 1.2 pupils per mark — Method: on a histogram whose class intervals are not all the same width the height of a bar is not the frequency but the frequency density, found by dividing the frequency of the class by the width of that class, so that the area of the bar represents the frequency. Working: the class 40 ≤ m < 60 holds 24 pupils, and its width is 60 − 40 = 20 marks, so the frequency density is 24 ÷ 20 = 1.2. Answer: 1.2 pupils per mark. The distractors: 24 pupils per mark comes from plotting the frequency itself as the height, which is only correct when every class has the same width; 2.4 pupils per mark comes from dividing by 10, the width of the narrowest class, instead of by the width of this class; 0.2 pupils per mark comes from dividing by the 120 pupils in the year group, which gives the proportion of pupils in the class and not a frequency density.
- (d) An outlier from the damaged wing, not the trend. — That bird's point lies a long way from the rising trend followed by every other bird, and its low wingspan is explained by the damaged wing rather than by its age — it is an outlier caused by an unusual factor, not part of the general relationship between age and wingspan, so it should not be used when drawing the line of best fit. Saying every point must be used ignores that an outlier caused by a separate, identifiable factor can rightly be set aside. Saying it shows no correlation ignores that the other 19 points do show a clear rising trend; one outlier does not remove that. Saying it proves the line is inaccurate confuses one unusual bird with a fault in the line itself, when the line correctly describes the trend followed by the rest of the data.
- (d) 4, 3, 2, 6 — Method: frequency density = frequency ÷ class width for each class in turn; do not assume the classes are all the same width. Working: the four classes have widths 10 − 0 = 10, 30 − 10 = 20, 45 − 30 = 15 and 50 − 45 = 5. Dividing each frequency by its own width gives 40 ÷ 10 = 4, 60 ÷ 20 = 3, 30 ÷ 15 = 2 and 30 ÷ 5 = 6. Answer: the frequency densities, in order, are 4, 3, 2 and 6. Watch the width of each class separately: treating the last class as if it were also 10 units wide, like the first, gives 30 ÷ 10 = 3 instead of 30 ÷ 5 = 6 — the classes here are deliberately unequal, so no width can be borrowed from another class; dividing the width by the frequency instead of the frequency by the width for the third class gives 15 ÷ 30 = 0.5 in place of 2, the formula the wrong way round; and reading the frequency column straight off the table, 40, 60, 30, 30, skips the division by width altogether and reports how many fish are in each class rather than how densely packed each bar is.
- (d) 210 — 350 − 150 = 200. 200 ÷ 10 = 20, so the gradient is 20. Using the point (5, 150): 20 × 5 = 100, so 150 − 100 = 50 is the intercept, giving the line y = 20x + 50. At x = 8: 20 × 8 = 160, and 160 + 50 = 210, so the estimated number of visitors is 210. Choosing 160 stops after 20 × 8 = 160 and forgets to add the intercept of 50. Choosing 250 comes from averaging the two given y-values: 150 + 350 = 500, and 500 ÷ 2 = 250, instead of using the line's equation. Choosing 240 assumes the visitors are directly proportional to the hours of sunshine using the first point, 150 × 8 ÷ 5 = 240, which ignores that the line does not pass through the origin.
- (d) 45 — Method: a cumulative frequency is a running total — it counts everybody in every class up to and including the one that ends at the value given. Working: the classes that lie wholly below 30 minutes are 0 ≤ t < 10, 10 ≤ t < 20 and 20 ≤ t < 30, with frequencies 6, 14 and 25, so the running total is 6 + 14 = 20 and then 20 + 25 = 45. Answer: 45 people took less than 30 minutes. The distractors: 25 comes from quoting the frequency of the class 20 ≤ t < 30 on its own instead of the running total; 65 comes from accumulating one class too many and including 30 ≤ t < 40, which is 45 + 20; 35 comes from accumulating from the top downwards, 15 + 20, which counts the people who took 30 minutes or more rather than fewer.
- (c) 156 cm — Method: to combine two groups' means, multiply each group's mean by its own number of pupils, add the two totals together, then divide by the total number of pupils in both groups. Working: 20 × 150 = 3,000 cm for the boys and 10 × 168 = 1,680 cm for the girls, giving a combined total of 3,000 + 1,680 = 4,680 cm. Dividing by all 30 pupils gives 4,680 ÷ 30 = 156 cm. Giving 159 cm averages the two means, (150 + 168) ÷ 2, treating the two groups as if they had the same number of pupils, when there are twice as many boys as girls. Giving 4,680 cm finds the correct combined total height but stops there, forgetting the final division by the 30 pupils. Giving 234 cm divides the combined total by 20, the number of boys only, forgetting that the total also includes the 10 girls. Always weight each mean by its own group size, and always divide by the TOTAL number of pupils in both groups combined.
- (c) 33 — Method: multiply the mean by the number of tests to get the total marks, then subtract the marks that are already known. Working: four tests with a mean of 29 give a total of 29 × 4 = 116 marks; the first three marks total 31 + 26 + 26 = 83; so the fourth mark is 116 − 83 = 33. Answer: 33, and checking, (31 + 26 + 26 + 33) ÷ 4 = 116 ÷ 4 = 29. The distractors: 116 comes from stopping at the total for all four tests; 29 comes from assuming the missing mark must be the mean itself; 4 comes from multiplying the mean by 3, the number of marks given, leaving 87 − 83 = 4.
- (c) 15 — Method: the interquartile range is the upper quartile take away the lower quartile, IQR = Q3 − Q1. Working: n + 1 = 15 + 1 = 16, so the lower quartile sits at position 16 ÷ 4 = 4, the 4th value in the list, which is 12; the upper quartile sits at position 3 × 4 = 12, the 12th value, which is 27. So 27 − 12 = 15. Answer: the interquartile range is 15 minutes. Watch which values you use and which way round: taking the smallest time away from the largest, 34 − 5 = 29, finds the range, which uses every value between the extremes rather than just the middle half; taking the median away from the upper quartile instead of the lower quartile, 27 − 19 = 8, swaps the median in for the lower quartile; and reversing the subtraction, 12 − 27 = −15, finds the right two values but in the wrong order — an interquartile range is never negative.
- (c) 20 kg ≤ mass < 30 kg — The modal class is the class with the highest frequency. Reading the plotted points, the frequencies are 6, 10, 16, 6 and 2, so the highest frequency is 16, plotted at the midpoint 25. A class of width 10 centred on 25 runs from 25 − 5 = 20 to 25 + 5 = 30, so the modal class is 20 kg ≤ mass < 30 kg. Writing '25 kg' gives only the midpoint, not the class — the modal class is an interval, not a single value. '10 kg ≤ mass < 20 kg' is the class before the peak, centred on 15, which has frequency 10, not the highest. '30 kg ≤ mass < 40 kg' is the class after the peak, centred on 35, which has frequency 6, not the highest.
- (c) No — 8 from one class is too small to represent the school. — Method: judge reliability by asking whether the sample is both large enough, and spread across the population, relative to what it is meant to represent. Working: 8 pupils is a tiny fraction of the school's 1,000 pupils, and all 8 come from a single class rather than a range of year groups, so the sample is both too small and too narrow to represent the whole school reliably. She is not right. Saying any sample size gives an equally reliable estimate ignores that reliability generally improves with a larger, more representative sample. Saying the method is unreliable because it was not done online is not a reason connected to sample size or representativeness at all. Saying 8 is reliable because it is more than half her class compares the sample to the wrong population — the school has 1,000 pupils, not one class. Always judge a sample's size against the population it is meant to represent, not against a smaller group within it.
- (a) 150 bulbs — Method: assume the proportion faulty in a random sample is the proportion faulty in the whole day's output, and scale the sample up to the population. Working: the sample of 80 has to be scaled up to 4,000 bulbs, and 4,000 ÷ 80 = 50, so the day's output is 50 sample-sized batches. Each batch is expected to contain the same 3 faulty bulbs, so the estimate is 3 × 50 = 150. Answer: 150 bulbs, and it is an estimate, because another sample of 80 would probably contain a different number of faulty bulbs. The distractors: 50 bulbs is the scale factor 4,000 ÷ 80 written down as though it were the answer, so it reports how many batches there are rather than how many faulty bulbs; 120 bulbs comes from reading 3 out of 80 as 3%, then taking 0.03 × 4,000 = 120, but 3 out of 80 is 3.75%; 240 bulbs comes from 3 × 80 = 240, multiplying the faulty bulbs by the size of the sample instead of by the scale factor, which uses the 80 twice and the 4,000 not at all.
- (d) 19 kg — Method: estimate the mean of grouped data by multiplying each class's midpoint by its frequency, adding the four totals, then dividing by the total frequency. Working: the midpoints are 5, 15, 25 and 35 kg. The weighted totals are 11 × 5 = 55, 5 × 15 = 75, 5 × 25 = 125 and 9 × 35 = 315, which add to 570. Dividing by the 30 dogs gives an estimate of 570 ÷ 30 = 19 kg. Giving 5 kg reads off the midpoint of the modal class, 0 < m ≤ 10, the class with the most dogs — but the class with the most dogs is not where the mean falls, and neither is a substitute for actually calculating it. Giving 20 kg averages the four midpoints, (5 + 15 + 25 + 35) ÷ 4, treating every class as equally likely and ignoring that far more dogs are in the lightest and heaviest classes than in the middle two. Giving 570 kg stops after finding the correct weighted total and forgets the final division by the 30 dogs. Always weight each midpoint by its own frequency, and always finish by dividing by the total frequency, not the number of classes.
- (d) 29 — Method: with an even number of values there is no single middle value, so the median is the mean of the two values either side of the middle. Working: the six numbers are already in order and 6 ÷ 2 = 3, so the middle pair are the third and fourth values, 22 and 36; their mean is (22 + 36) ÷ 2 = 58 ÷ 2 = 29. Answer: 29, which lies between the two middle values as a median of an even data set must. The distractors: 22 comes from taking the lower of the two middle values and stopping there instead of averaging the pair; 36 comes from taking the larger value of that pair because it sits just past the halfway point of the list; 34 comes from working out the range, 47 − 13, instead of a measure of centre.
- (a) A vertical line chart (discrete numerical data) — The number of pets is discrete numerical data — whole-number values such as 0, 1, 2, 3 or 4 — recorded for one variable, so a vertical line chart is the chart specified for this kind of data. A bar chart is used for categorical data, such as favourite colour, not numerical values counted like this. A pie chart shows proportions of a whole and does not show the frequency of each separate value. A scatter graph compares two different variables against each other, and only one variable, the number of pets, is recorded here.
- (a) 27 — Method: turn the mean into a total using total = mean × number of values, then subtract the numbers that are already known. Working: four numbers with a mean of 18 have a total of 18 × 4 = 72; the three known numbers give 10 + 15 + 20 = 45; so x = 72 − 45 = 27. Answer: 27, and checking, (10 + 15 + 20 + 27) ÷ 4 = 72 ÷ 4 = 18. The distractors: 72 comes from stopping at the total the four numbers must reach and never subtracting the known three; 18 comes from assuming the missing number must equal the mean; 45 comes from stopping at the total of the three known numbers.
Build your own mix at the worksheet builder.