Sample paper · GCSE Foundation · grades 1–5
GCSE Foundation sample Paper 1 (non-calculator)
The real Paper 1 is 1.5 hour 30 minutes and 80 marks, non-calculator, and all three papers carry equal weight. This sample is 20 original questions in the same content proportions as the Foundation qualification — number 25%, algebra 20%, ratio, proportion and rates of change 25%, geometry and measures 15%, probability 7.5%, statistics 7.5% — with no calculator-only items. AO1 / AO2 / AO3 at this tier: 50% / 25% / 25%.
Non-calculatorGCSE Foundation
Answer key: GCSE Foundation sample Paper 1 (non-calculator)
MathsUKwww.geekhero.co.uk
- (d) 19 — 2² = 4, then 4 × 4 = 16, then 3 + 16 = 19. Adding before multiplying gives 3 + 4 = 7, then 7 × 4 = 28 — multiplication comes before addition. Squaring the product instead of just the 2 gives 4 × 2 = 8, then 8² = 64, then 3 + 64 = 67. Working strictly left to right throughout gives 3 + 4 = 7, then 7 × 2 = 14, then 14² = 196.
- (d) 8(7x − 3) — Method: find the highest common factor of the two terms, write it in front of a bracket and divide each term by it. Working: 56 = 8 × 7 and 24 = 8 × 3, so the highest common factor is 8; dividing gives 56x ÷ 8 = 7x and 24 ÷ 8 = 3, and the subtraction sign stays between them. Answer: 8(7x − 3), which multiplies back out to 56x − 24. The distractors: 8(7x + 3) comes from dropping the minus sign of −24 while dividing; 8(56x − 3) comes from dividing only the number term by 8 and leaving 56x untouched inside the bracket; 8(7x − 16) comes from subtracting 8 from 24 instead of dividing 24 by 8.
- (b) 2000 cm³ — Method: a cm³ is smaller than a litre, so changing litres into cm³ means multiplying by the conversion factor 1000. Working: 2 × 1000 = 2000. Answer: 2000 cm³. The distractors: 200 cm³ comes from multiplying by 100 instead of 1000; 20 cm³ comes from multiplying by 10; 20000 cm³ comes from multiplying by 10 000.
- (a) 1/2 — cos 0° = 1 and sin 30° = 1/2, so cos 0° − sin 30° = 1 − 1/2 = 1/2. 1 comes from writing down cos 0° alone and forgetting to subtract sin 30°. 3/2 comes from adding the two values instead of subtracting. −1/2 comes from working out sin 30° − cos 0°, the two terms the wrong way round.
- (c) 0.5 — Method: count the favourable outcomes, write them over the total number of equally likely outcomes and then divide to turn the fraction into a decimal. Working: the odd scores are 1, 3 and 5, which is 3 of the 6 equally likely scores, so the probability is 3/6, and 3 ÷ 6 = 0.5. Answer: 0.5, the middle of the 0 to 1 probability scale. The distractors: 0.33 comes from listing only 3 and 5 as odd and working out 2 ÷ 6; 0.17 comes from giving the probability of one particular odd score, 1 ÷ 6; 0.3 comes from writing '3 out of 6' as 0.3, reading the 3 straight off as tenths instead of dividing.
- (b) Tea — Method: the mode is the category with the highest frequency. Working: tea has a frequency of 8, which is higher than coffee's 7, hot chocolate's 4 and juice's 1. Mode = tea. Coffee has the second-highest frequency, 7, not the highest, so it is not the mode. Hot chocolate, with a frequency of 4, and juice, with a frequency of 1, both have lower frequencies still. Always compare every frequency in the table before naming the mode — the highest number wins, however close the next one is.
- (a) 225 — Method: brackets are worked out before powers, so multiply the two numbers first and then square the result. Working: 3 × 5 = 15, and 15² = 15 × 15 = 225. Answer: 225. The distractors: 30 comes from doubling 15 instead of squaring it; 75 comes from squaring only the 5 and then working out 3 × 25; 34 comes from squaring each number separately and adding, 9 + 25, instead of multiplying inside the brackets first.
- (d) 8 — Method: compare the equation with y = mx + c, where c is the y-intercept. Working: in y = 3x + 8, the constant term is 8. Answer: the y-intercept is 8. 3 comes from confusing the y-intercept with the gradient. −8 comes from a sign error, treating the constant term as negative. 11 comes from wrongly adding the gradient and the constant term together.
- (d) 4.50 m² — 1 m² = 100 cm × 100 cm = 10,000 cm², so to convert cm² to m² you divide by 10,000: 45,000 ÷ 10,000 = 4.50 m². Dividing by 100 instead of 10,000, treating area like a length conversion, gives 45,000 ÷ 100 = 450.00 m², a common mistake since 1 m = 100 cm. Multiplying by 100 instead of dividing gives 45,000 × 100 = 4500000.00 m², using the conversion factor the wrong way round entirely. Dividing by 100,000 instead of 10,000 gives 0.45 m², an extra factor of 10 too far.
- (b) The radius — Method: each of the four names describes a line in a fixed position relative to the circle, so match the description in the question against those positions. Working: the line described has one end at the centre and its other end on the circle. A chord joins two points that both lie on the circle, so it is ruled out. A diameter joins two points on the circle by passing through the centre, so it is twice as long as the line described. A tangent touches the circle at exactly one point and never reaches the centre. The line with one end at the centre and one end on the circle is a radius. Answer: The radius. The distractors: The diameter comes from remembering only that the line involves the centre, and not noticing that it stops there instead of carrying on to the far side; The chord comes from seeing one end on the circle and assuming both ends are; The tangent comes from matching the phrase 'a point on the circle' to the line that touches at exactly one point, ignoring that a tangent never reaches the centre.
- (d) 0.7 — Method: delayed and not delayed are the only two outcomes, so the two probabilities form an exhaustive set and add to 1; subtract the given probability from 1. Working: 1 − 0.3, written as 1.0 − 0.3 with the decimal points lined up. Answer: 0.7. The distractors: 0.3 comes from giving back the probability that the train is delayed instead of its complement; 0.97 comes from lining the decimal points up wrongly and working out 1.00 − 0.03; 0.5 comes from assuming that delayed and not delayed must be equally likely because there are only two outcomes.
- (a) 0.08 — Method: decimal places are counted from the decimal point, including any zeros straight after it, so rounding to 2 decimal places is decided by the digit in the third decimal place. Working: 0.0759 has 7 in the second decimal place and 5 in the third, and 5 counts as rounding up, so the 7 goes up to 8. Answer: 0.08. The distractors: 0.07 comes from chopping the digits after the second decimal place off instead of rounding them; 0.076 is 0.0759 correct to 2 significant figures rather than 2 decimal places, because the zeros in front of the 7 are not significant figures; 0.1 is 0.0759 rounded to 1 decimal place, a coarser degree of accuracy than the question asks for.
- (c) (2, 5) — Reflecting in the x-axis keeps the x-coordinate the same and changes the sign of the y-coordinate: Q = (2, 5). (−2, −5) comes from reflecting in the y-axis instead, which changes the sign of the x-coordinate. (−2, 5) comes from reflecting in both axes. (2, −5) comes from not applying the reflection at all.
- (a) 20 cm — Method: match the measurement you are given to its own part of the ratio, use it to find the value of one part, then multiply by the parts belonging to the measurement asked for. Working: the length is the second measurement listed, so it matches 4 parts and one part = 16 ÷ 4 = 4 cm; the height is 5 parts, so 5 × 4 = 20. Answer: 20 cm. The distractors: 12 cm is the width, which is the 3-part measurement; 4 cm is the value of one part only; 80 cm comes from multiplying the 16 cm by 5 without first dividing by the 4 parts the length is worth.
- (a) 2 — A cone has one flat face — the circular base — and one curved surface, which is counted as a single face. That gives a total of 2 faces. A candidate who forgets the circular base and counts only the curved surface answers 1. A candidate who mistakenly splits the curved surface into two faces answers 3. A candidate who thinks a cone has no flat faces at all answers 0. The correct number of faces is 2.
- (b) 3/7 — Total parts = 3 + 4 = 7. Boys are 3 of the 7 parts, so the fraction is 3/7. 4/7 comes from finding the fraction of girls instead of boys. 3/4 comes from writing the ratio itself as a fraction, without adding the parts to find the total. 7/3 comes from putting the total number of parts over the number of boys instead of the number of boys over the total.
- (a) It touches the x-axis once, only at x = 4. — (x − 4)² is a square, so it equals zero only when x − 4 = 0, that is at x = 4 — the curve just touches the x-axis there rather than crossing it, since a square cannot be negative on either side to cross through. Saying it crosses at x = 4 and x = −4 wrongly introduces a plus-or-minus, as if taking a square root of x, rather than recognising the bracket is already squared and only zero once. Saying it never touches the x-axis forgets that a squared term CAN equal zero, even though it can never be negative. Saying it crosses at x = 2 and x = −2 confuses (x − 4)² with the different expression x² − 4.
- (d) 3/5 — Put the school journey time over the gym journey time: 12/20. Divide both numbers by their highest common factor, 4: 12÷4 = 3, 20÷4 = 5, giving 3/5. (5/3 comes from writing the times the wrong way round. 2/5 comes from finding the difference in the times, 20 − 12 = 8 minutes, and writing it as a fraction of the gym time, 8/20. 3/8 comes from comparing the school time to the total time for both journeys, 12/32.)
- (a) −22 — Method: both multiplications are carried out before the addition, and a positive multiplied by a negative is negative. Working: (−3) × 4 = −12 and 2 × (−5) = −10, so the calculation becomes −12 + (−10) = −22. Answer: −22. The distractors: 22 comes from ignoring the minus signs and working out 3 × 4 + 2 × 5 = 22; 50 comes from working from left to right with no priority at all, giving −12 + 2 = −10 and then −10 × (−5) = 50; −2 comes from taking 2 × (−5) as +10, so that −12 + 10 = −2.
- (d) 5/4 — Work out the number of free seats: 54 − 24 = 30. Form the fraction 30/24; both numbers share a factor of 6, so 30 ÷ 6 = 5 and 24 ÷ 6 = 4, giving 5/4. 4/5 comes from writing the fraction the wrong way round, as reserved over free (24/30). 5/9 comes from comparing the free seats with the total number of seats (30/54), instead of with the reserved seats. 5/6 comes from miscalculating 54 − 24 as 20 instead of 30, then forming 20/24.
How the 20 questions are shared out
- Number — 5 questions (25% of the qualification)
- Algebra — 4 questions (20% of the qualification)
- Ratio, proportion and rates of change — 5 questions (25% of the qualification)
- Geometry and measures — 3 questions (15% of the qualification)
- Probability — 2 questions (7.5% of the qualification)
- Statistics — 1 question (7.5% of the qualification)
Where an area has fewer printable questions than its share, the shortfall is filled from the other areas. These are original questions, not past papers.