Sample paper · GCSE Foundation · grades 1–5
GCSE Foundation sample Paper 1 (non-calculator)
The real Paper 1 is 1.5 hour 30 minutes and 80 marks, non-calculator, and all three papers carry equal weight. This sample is 20 original questions in the same content proportions as the Foundation qualification — number 25%, algebra 20%, ratio, proportion and rates of change 25%, geometry and measures 15%, probability 7.5%, statistics 7.5% — with no calculator-only items. AO1 / AO2 / AO3 at this tier: 50% / 25% / 25%.
Non-calculatorGCSE Foundation
Answer key: GCSE Foundation sample Paper 1 (non-calculator)
MathsUKwww.geekhero.co.uk
- (b) 25 g — Method: substitute the number of years into the model, raise the fraction to that power first, then multiply by the starting mass. Working: with n = 3 the model gives M = 200 × (1/2)³. Since (1/2)³ = 1/8, the mass is 200 ÷ 8 = 25. Answer: 25 g. The distractors: 12.5 g comes from halving four times instead of three, counting the first weighing as a year; 300 g comes from multiplying by 1/2 × 3 = 1.5 instead of raising 1/2 to the power 3; 0.125 g comes from working out (1/2)³ = 0.125 and stopping there, without multiplying by the starting mass.
- (d) 28 — The height decreases by 8 cm at each bounce after the first, so the nth bounce reaches 60−(n−1)×8 cm. For the 5th bounce: 60−4×8=60−32=28. A candidate who subtracts 8 one time too many, five times instead of four, would compute 60−5×8=20. A candidate who adds the decrease instead of subtracting it, a sign error, would compute 60+4×8=92. A candidate who works out only the total decrease and forgets to include the starting height of 60 cm would compute just 5×8=40.
- (d) 3 : 2 : 5 — The highest common factor of 45, 30 and 75 is 15. Divide each part by 15: 45 ÷ 15 = 3, 30 ÷ 15 = 2 and 75 ÷ 15 = 5, giving 3 : 2 : 5. Giving 9 : 6 : 15 divides by 5, a common factor but not the highest one. Giving 15 : 10 : 25 divides by 3 only, even further from simplest form. Giving 2 : 3 : 5 has the first two parts swapped.
- (c) 34 cm — Method: a rectangle has two lengths and two widths, so the perimeter is 2 × (length + width). Working: 12 + 5 = 17, then 2 × 17 = 34. Answer: 34 cm. The distractors: 17 cm comes from adding one length and one width and stopping, which is only half of the way round; 24 cm comes from doubling the length alone, 2 × 12, and leaving the two widths out; 60 cm² comes from working out 12 × 5, which is the area of the photograph and carries a squared unit because two lengths have been multiplied.
- (b) 120 — Purple's probability is its angle out of the full circle: 144° ÷ 360° = 2/5. Expected number on purple = 2/5 × 300 = 120. Assuming the three colours are equally likely, ignoring their different angles, gives 300 ÷ 3 = 100. Using orange's angle, 90°, instead of purple's 144° gives a probability of 1/4, so 300 × 1/4 = 75. Treating 144 as a percentage instead of finding its fraction of 360° gives 300 × 0.144 = 43.2, which rounds to 43.
- (b) Tea — Method: the mode is the category with the highest frequency. Working: tea has a frequency of 8, which is higher than coffee's 7, hot chocolate's 4 and juice's 1. Mode = tea. Coffee has the second-highest frequency, 7, not the highest, so it is not the mode. Hot chocolate, with a frequency of 4, and juice, with a frequency of 1, both have lower frequencies still. Always compare every frequency in the table before naming the mode — the highest number wins, however close the next one is.
- (a) 8.35 ≤ L < 8.45 — Method: a length rounded to 1 decimal place lies within half of 0.1 cm, that is 0.05 cm, of the value written down. The lower limit is included because it rounds up to that value, and the upper limit is excluded because it rounds up to the next value instead. Working: 8.4 − 0.05 = 8.35 and 8.4 + 0.05 = 8.45, so a length of 8.35 cm still rounds to 8.4 cm while a length of 8.45 cm rounds to 8.5 cm. Answer: 8.35 ≤ L < 8.45. The distractors: 8.3 ≤ L < 8.5 goes a whole 0.1 cm either side instead of half of it; 8.35 < L ≤ 8.45 has the two limits the wrong way round, excluding the length that does round to 8.4 cm and including the one that does not; 8.4 ≤ L < 8.5 is the interval for a length truncated to 1 decimal place, not one rounded to it.
- (a) 3x — Method: "three times as old" is a multiplication by 3, applied to the age that is known in terms of the letter. Working: the brother's age is x, and Leo's age is 3 × x, which is written as 3x. Answer: 3x. The distractors: x + 3 comes from reading "three times as old" as "three years older" and adding instead of multiplying; x − 3 comes from reading it as "three years younger" and subtracting; x/3 comes from dividing by 3 instead of multiplying, which describes the brother in terms of Leo rather than Leo in terms of the brother.
- (a) 20 litres per minute — Method: the gradient is the change in the vertical value divided by the change in the horizontal value, and its units are the vertical unit for each one of the horizontal unit. Working: from (2, 50) to (6, 130) the volume changes by 130 − 50 = 80 litres and the time changes by 6 − 2 = 4 minutes, so the gradient is 80 ÷ 4 = 20, measured in litres for each minute. Answer: 20 litres per minute. The distractors: 25 litres per minute comes from using one point on its own, 50 ÷ 2, which assumes the line starts at the origin when the tank already held 50 litres at 2 minutes; 0.05 litres per minute comes from dividing the change in time by the change in volume, 4 ÷ 80, which gives the time for each litre but is then labelled as litres for each minute; 20 minutes for each litre has the right value with the units the wrong way round, and a tank that needed 20 minutes to gain a single litre would be filling far more slowly than this one.
- (c) 27 cm² — Area of a rectangle = length × width = 4.5 × 6 = 27 cm². A pupil who adds the two sides instead of multiplying gets 4.5 + 6 = 10.5 cm². A pupil who works out the perimeter instead of the area gets 2 × (4.5 + 6) = 21 cm². A pupil who rounds 4.5 up to 5 before multiplying gets 5 × 6 = 30 cm². The correct area is 27 cm².
- (c) 100 — There are 3 even numbers on a fair dice (2, 4 and 6), so the probability of landing on an even number is 3/6 = 1/2, and 300 × 1/2 = 150. The probability of landing on a six is 1/6, so 300 × 1/6 = 50. The dice is expected to land on an even number 150 − 50 = 100 more times than on a six. Writing 50 is wrong because that is just the expected number of sixes on its own, without comparing it to the expected number of evens. Writing 150 is wrong because that is just the expected number of evens on its own, without subtracting the sixes. Writing 200 is wrong because it adds the two expected frequencies together (150 + 50 = 200) instead of finding the difference between them. The dice is expected to land on an even number 100 more times than on a six.
- (c) 0.024 — Multiply the digits ignoring the decimal points: 6 × 4 = 24. Count the total number of decimal places in the two numbers being multiplied: 0.6 has 1 decimal place and 0.04 has 2, giving 3 in total. Place the decimal point in 24 so that there are 3 digits after it: 0.024. Counting only 2 decimal places instead of 3 gives 0.24. Counting 4 decimal places instead of 3 gives 0.0024. Counting only 1 decimal place instead of 3 — in effect moving the point in just one of the two numbers, as if the calculation were 6 × 0.4 — gives 2.4. So 0.6 × 0.04 = 0.024.
- (d) −2 — Method: run the machine backwards, undoing the operations in the opposite order and swapping each one for its inverse. Working: the machine added 7 last, so take 7 off the output: 1 − 7 = −6; before that the machine had multiplied by 3, so divide: −6 ÷ 3, and a negative divided by a positive stays negative. Answer: −2, which checks because 3 × (−2) + 7 = −6 + 7 = 1. The distractors: 2 comes from dividing 6 by 3 and losing the minus sign; −6 comes from taking the 7 off and stopping there, never undoing the multiplication; −18 comes from multiplying −6 by 3 instead of dividing by 3.
- (a) 150 g — Method: scale the recipe to find the total sugar needed, then subtract the sugar Sam already has. Working: 200 ÷ 8 × 20 = 500, so 500 g is needed in total; 500 − 350 = 150, so 150 g still to buy. Stopping after finding the total, 500, without subtracting what he has gives 500 g. Scaling the wrong way round, 200 × 8 ÷ 20 = 80, wrongly suggests he already has enough, giving 0 g. Adding the amount he has instead of subtracting it, 500 + 350 = 850, gives 850 g.
- (b) 7 — Method: each coordinate of a midpoint is the mean of the matching pair of coordinates, so the y-coordinate of the midpoint depends on the two y-coordinates alone. Working: the y-coordinates are 4 and 10, so the mean is (4 + 10) ÷ 2 = 14 ÷ 2 = 7. Answer: 7. The distractors: 5 comes from working out the x-coordinate of the midpoint, (2 + 8) ÷ 2 = 5, and writing that down in place of the y-coordinate the question asked for; 3 comes from halving the difference of the y-coordinates, (10 − 4) ÷ 2 = 3, which is half the vertical gap rather than a position; 14 comes from adding the two y-coordinates and forgetting to halve the total.
- (b) 2π — Method: treat π as a single unit and subtract the coefficients, just as with algebraic terms. Working: 3π − π = 3π − 1π = 2π. Answer: 2π. 4π comes from adding the coefficients instead of subtracting: 3π + π = 4π. 3 comes from cancelling the π, treating 3π − π as if it were the division 3π ÷ π = 3. 2 comes from finding the correct coefficient, 2, but forgetting to keep π in the final answer.
- (c) x = 4 and x = −1, because the graph crosses the x-axis where x − 4 = 0 or x + 1 = 0. — The graph crosses the x-axis where y = 0, which happens when either bracket equals zero. Solving x − 4 = 0 gives x = 4, and solving x + 1 = 0 gives x = −1. The option x = −4 and x = 1 incorrectly reverses both signs. The option x = 4 and x = 1 misreads the second bracket, ignoring that x + 1 = 0 requires x to be negative. The option x = −4 and x = −1 wrongly assumes both roots must be the negative of the constants shown, which only matches the second bracket, not the first.
- (a) Inverse proportion — A curve that decreases and never touches either axis is the standard shape for inverse proportion, y = k/x. Direct proportion graphs are straight lines through the origin, which this is not, so it must be inverse proportion rather than neither.
- (a) 0.0069 — Leading zeros are not significant, so the significant figures in 0.006852 start at 6: 6, 8, 5, 2. Rounding to 2 significant figures means keeping 6 and 8, and looking at the next digit, 5, to decide whether to round up. Since 5 rounds up, the second significant figure increases from 8 to 9: 0.006852 rounds to 0.0069. A candidate who rounded to 1 significant figure instead of 2 wrote 0.007. A candidate who rounded to 3 significant figures instead of 2 wrote 0.00685. A candidate who did not round up despite the next digit being 5 wrote 0.0068.
- (d) 1.5 — Method: the length scale factor is the square root of the area scale factor, not the area scale factor itself. Working: the area scale factor is 45 ÷ 20 = 2.25, and the square root of 2.25 is 1.5. Answer: 1.5. Nadia's answer, 2.25, is the AREA scale factor — she never took the square root to get back to the length scale factor. 4.5 comes from doubling the area scale factor instead of taking its square root. 0.67 comes from taking the square root in the wrong direction, finding the scale factor from the larger rug to the smaller rug instead of the other way round.
How the 20 questions are shared out
- Number — 5 questions (25% of the qualification)
- Algebra — 4 questions (20% of the qualification)
- Ratio, proportion and rates of change — 5 questions (25% of the qualification)
- Geometry and measures — 3 questions (15% of the qualification)
- Probability — 2 questions (7.5% of the qualification)
- Statistics — 1 question (7.5% of the qualification)
Where an area has fewer printable questions than its share, the shortfall is filled from the other areas. These are original questions, not past papers.