Sample paper · GCSE Foundation · grades 1–5
GCSE Foundation sample Paper 1 (non-calculator)
The real Paper 1 is 1.5 hour 30 minutes and 80 marks, non-calculator, and all three papers carry equal weight. This sample is 20 original questions in the same content proportions as the Foundation qualification — number 25%, algebra 20%, ratio, proportion and rates of change 25%, geometry and measures 15%, probability 7.5%, statistics 7.5% — with no calculator-only items. AO1 / AO2 / AO3 at this tier: 50% / 25% / 25%.
Non-calculatorGCSE Foundation
Answer key: GCSE Foundation sample Paper 1 (non-calculator)
MathsUKwww.geekhero.co.uk
- (a) 36 — Method: find the lowest common multiple of 6 and 9, then move up the list of common multiples until one is greater than 20. Working: the common multiples of 6 and 9 are 18, 36, 54 …. 18 is not greater than 20, so the next one, 36, is the smallest value of n that is greater than 20. 18 is the lowest common multiple itself, but it fails the 'greater than 20' condition. 54 is the common multiple after 36, one step too far. 27 is a multiple of 9 but not of 6, since 27 ÷ 6 is not a whole number. Answer: 36.
- (b) 37 — The terms are 7, 13, 19, 25, 31, 37 — each found by adding 6 to the term before, so the 6th term is 37. Adding 6 six times to the first term instead of five times, 7 + 6 × 6 = 43, treats the first term as if it were before the sequence starts. Stopping one term early gives the 5th term, 31. Stopping two terms early gives the 4th term, 25.
- (b) 4/5 — Write the mass of the beans over the mass of the soup: 400/500. Divide the top and bottom by 100 to get 4/5. Choosing 5/4 comes from writing the soup's mass over the beans' mass, the wrong way round. Choosing 1/5 comes from finding the difference in mass (500 − 400 = 100) and writing that over the mass of the soup, instead of using the mass of the beans. Choosing 5/9 comes from writing the mass of the soup over the total mass of both tins (500 out of 900), instead of over the mass of the beans.
- (c) 500 cm² — The area of a triangle is half of base × height. First, base × height = 40 × 25 = 1,000. Half of 1,000 is 500 cm². 1,000 cm² forgets to halve and just gives base × height. 65 cm² adds the base and height together instead of multiplying them. 2,000 cm² doubles base × height instead of halving it.
- (d) 32 — The frequency tree already shows the tea-and-coffee branch directly: of the 50 tea drinkers, 32 also drink coffee, so n(T ∩ C) = 32. Adding both coffee branches together, 32 + 6 = 38, gives n(C), the total number of coffee drinkers, not just those who also drink tea. Using the non-tea branch's figure, 6, describes people who drink coffee but NOT tea. Subtracting to get 50 − 32 = 18 finds the tea drinkers who do NOT drink coffee, the opposite region to the one asked for.
- (b) All 2,000 members of the sports centre. — Method: in a survey, the population is the whole group the survey is trying to find out about, and the sample is the smaller group actually asked. Working: this survey wants to know what the sports centre's members think, so the population is every one of the 2,000 members — whether or not they were personally asked. Saying the population is the 100 members who were asked names the sample, not the population; the sample is drawn FROM the population, so it is smaller than it, not the same as it. Saying the population is everybody who lives in Ipswich widens the group far beyond who the survey is actually about — plenty of Ipswich residents are not members of the sports centre at all, so they are outside this survey altogether. Saying the population is the members who say they are unhappy confuses the population with a result of the survey: whether a member turns out to be happy or unhappy is something the survey finds out, not part of the definition of who is being studied. The population is always the whole group the question is about, before any sampling or any results come in.
- (c) 0.75 — Method: a fraction means the numerator divided by the denominator, and carrying out that division gives the decimal. Working: 3 ÷ 4 is worked out by writing 3 as 3.00; 4 divides into 30 tenths 7 times with 2 tenths left over, and 4 divides into the remaining 20 hundredths exactly 5 times, giving 7 tenths and 5 hundredths. Answer: 0.75. The distractors: 0.34 comes from writing the numerator and the denominator as the two digits after the point instead of dividing; 0.7 comes from adding the numerator and the denominator to get 7 and reading that as seven tenths; 0.25 comes from converting the quarter that is left over rather than the three quarters the question asks about.
- (a) x + 14 — Expand each bracket separately: 3(x + 4) = 3x + 12, and −2(x − 1) = −2x + 2 (multiply −2 by both x and −1). Combine: 3x + 12 − 2x + 2 = x + 14. Writing x + 10 comes from taking −2(x − 1) as −2x − 2, not flipping the sign of the −1 inside the bracket. Writing 5x + 10 comes from treating the second bracket as +2(x − 1) instead of subtracting it, so the x-terms are added rather than subtracted. Writing x + 13 comes from only multiplying the 2 by the x, and carrying the −1 across unmultiplied.
- (c) 25 — Find the constant multiplier from the given pair: 15 ÷ 6 = 2.5, so y is always 2.5 times x. When x = 10, y = 10 × 2.5 = 25. 19 comes from assuming an additive relationship instead of a multiplicative one — adding the difference 15 − 6 = 9 onto 10. 4 comes from using the multiplier the wrong way round (6 ÷ 15 = 0.4) and then multiplying by 10. 15 comes from simply repeating the given value of y, without applying the multiplier to the new value of x at all.
- (d) (11, −2) — First undo the original translation to find the vertex on the original shape: (1 − (−8), 6 − 3) = (9, 3). Then apply the second vector to that original vertex: (9 + 2, 3 + (−5)) = (11, −2). (3, 1) comes from applying the second vector to the image point (1, 6) instead of to the original vertex — (1 + 2, 6 + (−5)) = (3, 1). (7, 8) comes from subtracting the second vector from the original vertex (9, 3) instead of adding it — (9 − 2, 3 − (−5)) = (7, 8). (11, 3) comes from applying only the x-component of the second vector to the original vertex and leaving the y-coordinate unchanged.
- (a) 0.368 — Combining both samples, the spinner landed on red 34 + 58 = 92 times out of a total of 85 + 165 = 250 spins, so the best estimate of the probability is 92/250 = 0.368. Writing 0.400 is wrong because it uses only the first sample, 34/85 = 0.400, ignoring the extra 165 spins recorded afterwards. Writing 0.352 is wrong because it uses only the second sample, 58/165 = 0.352 (to 3 decimal places), ignoring the first 85 spins. Writing 0.376 is wrong because it averages the two separate estimates, (0.400 + 0.352) ÷ 2 = 0.376, instead of combining the actual numbers of reds and spins across both samples. The best estimate of the probability that the spinner lands on red, using all 250 spins, is 0.368.
- (c) 11 — Method: work out the total number of combinations as if there were no restriction, then subtract the one combination that is not allowed. Working: without any restriction there are 4 backdrops × 3 outfits = 12 combinations. The grey backdrop with the formal suit is not allowed, removing 1 combination: 12 − 1 = 11. Answer: 11. 12 comes from forgetting to remove the combination that is not allowed. 8 comes from removing the entire formal suit outfit from the count instead of just the one combination with the grey backdrop. 10 comes from removing two combinations instead of just the one that is not allowed.
- (a) 20 — Method: the paper has run out when S = 0, so substitute S = 0 into the equation and solve for t. Working: 0 = 480 − 24t, so 24t = 480, and t = 480 / 24 = 20. Answer: it takes 20 minutes. The value 480 comes from giving the starting number of sheets, the intercept of the equation, instead of solving for t. The value 456 comes from working out 480 − 24 and stopping after one step instead of solving the equation fully. The value 0.05 comes from inverting the division, working out 24 / 480 instead of 480 / 24.
- (d) b = k ÷ g — Inverse proportion means b × g stays constant (equal to k), so b = k ÷ g. 'b = kg' is the equation for direct proportion, not inverse. 'b = k + g' treats the relationship as additive, which is not proportion at all. 'b = g ÷ k' is direct proportion in disguise: rearranging it gives g = kb, so b still grows as g grows. For inverse proportion the g must be underneath the constant, not above it.
- (a) 5 — Looking straight down on a row of 5 cubes standing side by side, each cube contributes exactly one square to the view from above, since the cubes do not overlap and none is hidden behind another — so the plan shows 5 squares in a row. "1" comes from treating the whole row as a single block instead of counting each cube. "10" comes from doubling the count, perhaps by also counting a front elevation's squares alongside the plan's. "25" comes from squaring the number of cubes (5 × 5) instead of counting them.
- (c) 0.024 — Multiply the digits ignoring the decimal points: 6 × 4 = 24. Count the total number of decimal places in the two numbers being multiplied: 0.6 has 1 decimal place and 0.04 has 2, giving 3 in total. Place the decimal point in 24 so that there are 3 digits after it: 0.024. Counting only 2 decimal places instead of 3 gives 0.24. Counting 4 decimal places instead of 3 gives 0.0024. Counting only 1 decimal place instead of 3 — in effect moving the point in just one of the two numbers, as if the calculation were 6 × 0.4 — gives 2.4. So 0.6 × 0.04 = 0.024.
- (d) 50/3 — Method: call the smaller number x, write the larger number in terms of x and use the total. Working: the larger number is 2x, so x + 2x = 50, that is 3x = 50 and x = 50/3. Answer: 50/3, since 50/3 added to 100/3 makes 50 and 100/3 is twice 50/3. The distractors: 100/3 is the larger of the two numbers rather than the smaller one asked for; 25 comes from halving 50 and treating the two numbers as equal; 24 comes from reading 'twice the smaller number' as 'two more than the smaller number' and solving x + (x + 2) = 50.
- (d) 90 cm — Method: scale each dimension by the scale factor, then find the perimeter. Working: model height = 240 ÷ 8 = 30 cm; model width = 120 ÷ 8 = 15 cm. Perimeter = 2 × (30 + 15) = 90 cm. Wrong options: 11.25 cm comes from squaring the scale factor as if finding an area (720 ÷ 64); 510 cm comes from scaling only one dimension and leaving the other at full size; 720 cm comes from finding the real perimeter (2 × (240 + 120)) but forgetting to scale it down at all.
- (a) −22 — Method: both multiplications are carried out before the addition, and a positive multiplied by a negative is negative. Working: (−3) × 4 = −12 and 2 × (−5) = −10, so the calculation becomes −12 + (−10) = −22. Answer: −22. The distractors: 22 comes from ignoring the minus signs and working out 3 × 4 + 2 × 5 = 22; 50 comes from working from left to right with no priority at all, giving −12 + 2 = −10 and then −10 × (−5) = 50; −2 comes from taking 2 × (−5) as +10, so that −12 + 10 = −2.
- (b) 24 — Method: let one part of the ratio be worth x, write both groups in terms of x, and use the fact that the two groups end up equal. Working: the boys are 3x and the girls are 4x; after the 6 boys join, 3x + 6 = 4x, so x = 6; the girls are 4 parts, so 4 × 6 = 24. Answer: 24 girls. The distractors: 18 is the number of boys before the 6 join, which is 3 × 6; 30 comes from adding the 6 new members to the girls as well as to the boys; 42 is the total number of members in the choir before the 6 boys join, the 18 boys and the girls together.
How the 20 questions are shared out
- Number — 5 questions (25% of the qualification)
- Algebra — 4 questions (20% of the qualification)
- Ratio, proportion and rates of change — 5 questions (25% of the qualification)
- Geometry and measures — 3 questions (15% of the qualification)
- Probability — 2 questions (7.5% of the qualification)
- Statistics — 1 question (7.5% of the qualification)
Where an area has fewer printable questions than its share, the shortfall is filled from the other areas. These are original questions, not past papers.