Sample paper · GCSE Foundation · grades 1–5
GCSE Foundation sample Paper 2 (calculator)
The real Paper 2 is 1.5 hour 30 minutes and 80 marks, calculator, and all three papers carry equal weight. This sample is 20 original questions in the same content proportions as the Foundation qualification — number 25%, algebra 20%, ratio, proportion and rates of change 25%, geometry and measures 15%, probability 7.5%, statistics 7.5% — with a calculator allowed. AO1 / AO2 / AO3 at this tier: 50% / 25% / 25%.
CalculatorGCSE Foundation
Answer key: GCSE Foundation sample Paper 2 (calculator)
MathsUKwww.geekhero.co.uk
- (b) 5.2 × 10⁶ — Method: write the digits as a coefficient that is at least 1 and less than 10, then count the places the decimal point moves to reach that position. Working: the digits give a coefficient of 5.2, and the decimal point travels from the end of 5,200,000 until it sits between the 5 and the 2, a move of 6 places. Answer: 5.2 × 10⁶. The distractors: 52 × 10⁵ is the same amount but not in standard form, because 52 is not less than 10; 5.2 × 10⁵ comes from counting the five zeros in 5,200,000 rather than the six places the decimal point moves; 5.2 × 10⁻⁶ comes from making the index negative because the decimal point was carried to the left.
- (d) 20 km/h — Method: total distance = 9 + 21 = 30 km. Total time = 15 + 45 + 30 = 90 minutes = 1.5 hours. Average speed = total distance ÷ total time = 30 ÷ 1.5 = 20 km/h. Distractor origins: 40 km/h ignores the 45-minute stop, dividing the total distance by the travel time only (30 km ÷ 45 minutes = 40 km/h); 39 km/h averages the two section speeds, 36 km/h and 42 km/h, instead of using total distance over total time; 36 km/h uses only the first section's speed (9 km in 15 minutes), ignoring the second section and the stop.
- (d) b = k ÷ g — Inverse proportion means b × g stays constant (equal to k), so b = k ÷ g. 'b = kg' is the equation for direct proportion, not inverse. 'b = k + g' treats the relationship as additive, which is not proportion at all. 'b = g ÷ k' is direct proportion in disguise: rearranging it gives g = kb, so b still grows as g grows. For inverse proportion the g must be underneath the constant, not above it.
- (d) SSS — All three pairs of corresponding sides are equal (PQ = ST, QR = TU, PR = SU), so the triangles are congruent by the SSS (side-side-side) condition. The distractor SAS would apply if two sides and the included angle were given equal, not three sides. The distractor ASA would apply if two angles and the included side were given equal. The distractor RHS would apply only for right-angled triangles with the hypotenuse and one other side equal.
- (d) 1/15 — The probability that the first bead is red is 3/10. Since the first bead is not put back, there are now only 2 red beads left out of 9 beads in total, so the probability that the second bead is also red is 2/9. Multiplying these, 3/10 × 2/9 = 6/90 = 1/15. A candidate who answers 9/100 has treated the beads as replaced, using 3/10 twice. A candidate who answers 3/50 has correctly reduced the red count to 2 for the second pick but forgotten that the total also falls to 9, using 2/10 instead. A candidate who answers 5/19 has added the numerators and added the denominators, (3+2)/(10+9), instead of multiplying.
- (c) 33 — Method: multiply the mean by the number of tests to get the total marks, then subtract the marks that are already known. Working: four tests with a mean of 29 give a total of 29 × 4 = 116 marks; the first three marks total 31 + 26 + 26 = 83; so the fourth mark is 116 − 83 = 33. Answer: 33, and checking, (31 + 26 + 26 + 33) ÷ 4 = 116 ÷ 4 = 29. The distractors: 116 comes from stopping at the total for all four tests; 29 comes from assuming the missing mark must be the mean itself; 4 comes from multiplying the mean by 3, the number of marks given, leaving 87 − 83 = 4.
- (b) 23 kg — Method: the rounded value sits exactly in the middle of the error interval. Working: the interval 22.5 ≤ m < 23.5 stretches 0.5 either side of the rounded value, so the rounded value is 23. Answer: 23 kg. (22 kg comes from rounding the lower bound down instead of finding the middle of the interval. 22.5 kg comes from giving the lower bound itself rather than the rounded value. 23.5 kg comes from giving the upper bound itself rather than the rounded value.)
- (c) x = 2y + 10 — Method: undo the operations done to x in reverse order — add 5, then multiply by 2. Working: y = x/2 − 5, so y + 5 = x/2, so x = 2(y + 5) = 2y + 10. Answer: x = 2y + 10. x = 2y + 5 comes from multiplying only the x/2 term by 2 and forgetting to multiply the 5 as well. x = 2y − 10 comes from a sign error, subtracting 5 instead of adding it before multiplying by 2. x = (y + 5)/2 comes from dividing by 2 instead of multiplying, the wrong operation to undo a division.
- (a) 2 km — Method: multiply the map distance by the scale to get the real distance in centimetres, then convert centimetres to kilometres using 100 cm = 1 m and 1000 m = 1 km. Working: 4 × 50 000 = 200 000 cm; 200 000 ÷ 100 = 2000 m; 2000 ÷ 1000 = 2. Answer: 2 km. The distractors: 200 km comes from dividing the 200 000 cm by 1000 in a single step, as if a kilometre were 1000 cm rather than the 100 000 cm it is; 20 km comes from converting to metres correctly, 200 000 ÷ 100 = 2000 m, and then dividing those metres by 100 instead of by 1000; 0.2 km comes from dividing by 1000 to reach metres, as if a metre were 1000 cm, and then dividing by 1000 again, so 200 000 is divided by 1 000 000 altogether.
- (a) 150° — The arc length is the same fraction of the circumference as the angle is of 360°. The full circumference is 2 × 3.14 × 6 = 37.68 cm, so the angle is 15.7 ÷ 37.68 × 360 = 150°. Treating the 6 cm as a diameter instead of a radius gives a circumference of 18.84 cm and an angle of 300°. Using π = 3 instead of the given 3.14 gives a circumference of 36 cm and an angle of 157°. Treating the fraction 15.7 ÷ 37.68 as being out of 100 rather than 360 gives about 42°.
- (c) 0.49 — The two rounds are independent, so multiply the probability of losing each round: 0.7 × 0.7 = 0.49. Choosing 0.7 comes from giving the probability of losing just one round, forgetting there are two rounds to combine. Choosing 1.4 comes from adding the two probabilities instead of multiplying, 0.7 + 0.7 = 1.4. Choosing 0.09 comes from using the probability of WINNING instead of losing, 0.3 × 0.3 = 0.09.
- (c) 0.94 — Method: a fraction is written as a decimal by making the denominator a power of ten, because the decimal places record tenths, hundredths and thousandths. Working: 50 × 2 = 100, so the numerator must also be multiplied by 2, giving 47 × 2 = 94 and the equivalent fraction 94/100; 94 hundredths is written with two digits after the decimal point. Answer: 0.94. The distractors: 0.47 comes from treating the denominator as though it were already 100 and writing the digits of the numerator straight after the point; 4.7 comes from dividing 47 by 10 instead of by 50; 0.094 comes from multiplying the denominator by 20 to reach 1000 but the numerator by only 2, giving 94/1000.
- (c) 3x + 5 = 17 — An equation contains an equals sign and is true only for particular value(s) of the unknown — solving 3x + 5 = 17 gives the single value x = 4. 3x + 5 is an expression: it has no equals sign, so it cannot be solved, only simplified or evaluated. A = πr² is a formula: it shows the general relationship between different quantities (area and radius), rather than asking for one unknown value. 3(x + 5) ≡ 3x + 15 is an identity: the ≡ sign shows it is true for every value of x, not just one. The equation is 3x + 5 = 17.
- (a) 36 — Method: add the parts of the ratio, divide the total by the number of parts to find the value of one part, then multiply by the number of parts in the share asked for. Working: 1 + 2 + 3 = 6 parts, 72 ÷ 6 = 12 for one part, and the largest number is 3 parts, so 3 × 12 = 36. Answer: 36. The distractors: 12 is the value of one part, which is the smallest of the three numbers rather than the largest; 24 is 2 parts, the middle number; 216 comes from multiplying 72 by 3 instead of dividing 72 by the 6 parts first.
- (c) 5 — The front elevation shows one square for every cube visible from the front, column by column: the left-hand column is 2 cubes high, so it contributes 2 squares; the middle column is 2 cubes high, so it contributes 2 more; the right-hand column is 1 cube high, so it contributes 1. The total is 2 + 2 + 1 = 5 squares. "6" comes from drawing a full 3 by 2 rectangle, treating every column as if it reached the greatest height. "4" comes from losing a square from one of the two tall columns, counting 2 + 1 + 1. "3" comes from counting one square per column — the width of the solid — and ignoring the heights altogether.
- (a) 14 — Brackets first: 9 − 6 = 3. Then multiply: 3 × 3 = 9. Then add: 5 + 9 = 14. So the answer is 14. A candidate who worked out (5 + 3) × (9 − 6) = 8 × 3 = 24 added before multiplying, ignoring the priority of operations outside the bracket. A candidate who dropped the brackets and worked out 5 + 3 × 9 − 6 = 5 + 27 − 6 = 26 multiplied by the 9 itself instead of by the bracket's value of 3, losing the grouping the brackets give. A candidate who forgot to add the 5 and only worked out 3 × (9 − 6) = 3 × 3 = 9 dropped a term from the calculation.
- (a) 7n + 4 — Method: find the common difference, then find the constant that fits the first term. Working: 18 − 11 = 7, 25 − 18 = 7, 32 − 25 = 7, so the terms increase by 7 each time and the nth term has the form 7n + c. Substituting n = 1: 7(1) + c = 11, so c = 4. Answer: the correct nth term is 7n + 4. The value 7n is Ravi's value, which comes from using only the common difference and leaving out the constant. The value 7n + 11 comes from using the first term as the constant directly, without subtracting the common difference first. The value 11n + 7 comes from swapping the roles of the first term and the common difference — using the first term, 11, as the coefficient of n and the difference, 7, as the constant.
- (d) 3 : 8 — Multiply both parts by 4 to clear the decimal: 0.75 × 4 = 3 and 2 × 4 = 8, giving 3 : 8, which has no common factor other than 1. Giving 75 : 200 multiplies by 100 instead of 4, and has not then been simplified down to 3 : 8. Giving 0.75 : 2 has not been converted into whole numbers at all. Giving 3 : 2 converts the first part correctly but leaves the second part unscaled.
- (b) 45 — Method: list multiples of each number until one is shared by both, or use 9 = 3² and 15 = 3 × 5, taking the highest power of each prime. Working: multiples of 9 are 9, 18, 27, 36, 45 …; multiples of 15 are 15, 30, 45 …. The lowest multiple in both lists is 45. 135 comes from working out 9 × 15 = 135, the product of the two numbers rather than their lowest common multiple. 3 is the highest common factor of 9 and 15, not the lowest common multiple. 24 comes from working out 9 + 15 = 24, which is not a multiple of either number. Answer: 45.
- (c) L = d/5 — The scale 1 : 20 means each cm on the drawing represents 20 cm in real life, so the real length in cm is 20d. Converting to metres by dividing by 100: L = 20d/100 = d/5.
How the 20 questions are shared out
- Number — 5 questions (25% of the qualification)
- Algebra — 4 questions (20% of the qualification)
- Ratio, proportion and rates of change — 5 questions (25% of the qualification)
- Geometry and measures — 3 questions (15% of the qualification)
- Probability — 2 questions (7.5% of the qualification)
- Statistics — 1 question (7.5% of the qualification)
Where an area has fewer printable questions than its share, the shortfall is filled from the other areas. These are original questions, not past papers.