Sample paper · GCSE Foundation · grades 1–5
GCSE Foundation sample Paper 2 (calculator)
The real Paper 2 is 1.5 hour 30 minutes and 80 marks, calculator, and all three papers carry equal weight. This sample is 20 original questions in the same content proportions as the Foundation qualification — number 25%, algebra 20%, ratio, proportion and rates of change 25%, geometry and measures 15%, probability 7.5%, statistics 7.5% — with a calculator allowed. AO1 / AO2 / AO3 at this tier: 50% / 25% / 25%.
CalculatorGCSE Foundation
Answer key: GCSE Foundation sample Paper 2 (calculator)
MathsUKwww.geekhero.co.uk
- (a) 30 cm — The tile's side length must be a common factor of 90 and 120. The factors of 90 include 1, 2, 3, 5, 6, 9, 10, 15, 18, 30, 45, 90; the factors of 120 include 1, 2, 3, 4, 5, 6, 8, 10, 12, 15, 20, 24, 30, 40, 60, 120. The highest number common to both lists is 30, so the largest square tile has a side length of 30 cm. Picking 15 cm, a common factor but not the largest, gives tiles that are smaller than necessary. Picking 10 cm, also a common factor but smaller still, wastes even more of the possible tile size. Working out the lowest common multiple instead of the highest common factor gives 360 cm, a length far bigger than either side of the patio. So the largest square tile Ben can use has a side length of 30 cm.
- (a) 4 — Method: set up the equation 35 + 20h = 115, then subtract the fixed fee and divide by the hourly rate. Working: 20h = 115 − 35 = 80; h = 80 ÷ 20 = 4. Answer: 4 hours. 5.75 comes from dividing the whole £115 by £20 without first subtracting the fixed fee: 115 ÷ 20 = 5.75. 2.71 comes from swapping the fee and the rate round, subtracting £20 and dividing by £35: (115 − 20) ÷ 35 ≈ 2.71. 7.5 comes from adding the fixed fee instead of subtracting it: (115 + 35) ÷ 20 = 7.5.
- (d) 3 : 5 — Simplify the area ratio: 18 : 50 divides by 2 to give 9 : 25. Areas scale with the square of the length ratio, so take the square root of each part: the square root of 9 is 3, and the square root of 25 is 5, giving a side length ratio of 3 : 5. Giving 5 : 3 has the ratio the right way round for larger to smaller, not smaller to larger. Giving 9 : 25 is the simplified area ratio, without square-rooting it. Giving 18 : 50 is the area ratio before it has even been simplified.
- (b) Hexagon — Cutting straight across a prism, at right angles to its length, always gives a cross-section that is the same shape as its end faces. The end faces of a hexagonal prism are hexagons (6-sided), so the cross-section is a hexagon. Choosing Pentagon comes from miscounting the sides of the hexagonal end as five instead of six. Choosing Rectangle comes from cutting along the LENGTH of the prism instead of across it, which gives a rectangular face, not the cross-section asked for. Choosing Triangle comes from confusing a hexagonal prism with a triangular prism.
- (b) 0.225 — The relative frequency of rain is the number of rainy days out of all days recorded: 9 ÷ 40 = 0.225, which is noticeably less than the forecaster's claimed 0.3. Using the number of dry days, 40 − 9 = 31, as the denominator instead of the total of 40 gives 9 ÷ 31 = 0.29 (2 d.p.). Simply reporting the forecaster's claimed value, 0.3, without calculating anything from the data at all, ignores the recorded results completely. Misplacing the decimal point, treating 9 out of 40 as 9%, gives 0.09 instead of 0.225.
- (d) 6 — Method: the mode, or modal value, is the value that occurs most often in the data set, and it is a value from the data rather than a count. Working: size 4 occurs twice, size 5 occurs once, size 6 occurs three times and size 9 occurs once, so the highest frequency is three and the size it belongs to is 6. Answer: 6. The distractors: 3 comes from writing down the frequency of the most common size instead of the size itself; 9 comes from picking the largest size in the list, which confuses the mode with the maximum; 4 comes from stopping at the first size that repeats rather than checking which size repeats most often.
- (c) 10 — Method: the multiplication is carried out before the subtraction. Working: 4 × 2 = 8, so the calculation becomes 18 − 8 = 10. Answer: 10. The distractors: 28 comes from working from left to right, giving (18 − 4) × 2 = 14 × 2 = 28; −10 comes from subtracting the 18 from the 8 rather than the 8 from the 18, giving 8 − 18 = −10; 12 comes from reading 4 × 2 as 4 + 2 = 6 and then working out 18 − 6 = 12.
- (b) 20 — The rate is the gradient: the change in litres divided by the change in time. From 2 to 7 minutes, the tank gains 150 − 50 = 100 litres over 7 − 2 = 5 minutes, so the rate is 100 ÷ 5 = 20 litres per minute. 100 comes from working out the change in litres but forgetting to divide by the change in time. 25 comes from using only the first reading, 50 ÷ 2, and ignoring the second reading entirely. 0.05 comes from dividing the change in time by the change in litres instead of the other way round, 5 ÷ 100.
- (d) 1 : 2500 — Method: convert the real-world measurement to the same unit as the drawing (centimetres) before writing the ratio. Working: 25 m = 2500 cm, so the scale is 1 : 2500. Wrong options: 1 : 25 comes from not converting metres to centimetres at all; 1 : 250 comes from converting metres to centimetres using ×10 instead of ×100; 1 : 2.5 comes from converting in the wrong direction (treating 25 m as 2.5 cm).
- (c) 8 — Method: the exterior angles of a polygon add up to 360°, so divide 360° by the size of one exterior angle. Working: 360 ÷ 45 = 8. Answer: 8 sides. A candidate who divides into a half turn instead of a full turn, working out 180 ÷ 45, gets 4. A candidate who reads off the given exterior angle as if it were the number of sides gets 45. A candidate who subtracts instead of dividing, working out 360 − 45, gets 315.
- (b) 100 — The sample shows a proportion of 8/60 = 2/15 faulty. Apply that proportion to the new batch of 750: 750 × 2/15 = 100. Flipping the ratio, calculating 8/750 × 60 instead of 8/60 × 750, gives 0.64, which rounds to about 1. Assuming the same number of faulty items applies to the new batch, without scaling for its larger size, just repeats the sample's count of 8. Rounding the proportion 8/60 = 0.1333... down to 0.1 before multiplying gives 750 × 0.1 = 75.
- (a) 36 kg — The mix is 3 + 5 = 8 equal shares, so the cement is 3/8 of the mass. One share is 96 ÷ 8 = 12 kg, and the cement is 3 shares: 3 × 12 = 36 kg. Working out 3/5 of 96 gives 57.6 kg, which uses the sand as the denominator instead of the whole mix; 60 kg is the mass of the sand; 12 kg is one share only.
- (b) y = 84 − 14x — Method: the distance still to go is the whole route minus the distance already covered, and at a steady speed the distance covered after x hours is the speed multiplied by x. Working: after x hours Freya has cycled 14x km, so the distance remaining is the 84 km route take away 14x, giving y = 84 − 14x, a straight line with intercept 84 and gradient −14. Answer: y = 84 − 14x. The distractors: y = 84 + 14x comes from adding the distance cycled to the length of the route rather than taking it away, so the ride would grow longer the further she goes; y = 14x − 84 comes from carrying out the subtraction the wrong way round, which is negative for the whole of the ride; y = 14 − 84x comes from swapping the two numbers over, treating 84 km as the hourly speed and 14 km as the length of the route.
- (d) £82.50 — Find the hourly rate: £52.50 ÷ 7 = £7.50 per hour. For 11 hours: 11 × £7.50 = £82.50. £30 comes from working out the pay for only the extra 4 hours (4 × £7.50), and forgetting to include the original £52.50. £99 comes from misremembering the hourly rate as £9 instead of £7.50, then 11 × £9. £56.50 comes from adding the extra number of hours (4) straight onto the pay in pounds (52.5 + 4), confusing hours with pounds.
- (b) 62 — Method: co-interior (allied) angles between parallel lines add up to 180°. Working: 180 − 118 = 62. Answer: 62°. A candidate who treats co-interior angles as equal, like corresponding angles, gives 118. A candidate who uses 360° instead of 180°, working out 360 − 118, gets 242. A candidate who subtracts as if the angles were complementary, working out 118 − 90, gets 28.
- (a) 0.5, 0.55, 0.56, 0.6, 0.601 — Compare the decimals by giving them all the same number of decimal places first: 0.600, 0.550, 0.601, 0.500, 0.560. Ordering these from smallest to largest gives 0.500, 0.550, 0.560, 0.600, 0.601, which is 0.5, 0.55, 0.56, 0.6, 0.601. Comparing the digits as though they were whole numbers, reading 0.601 as "601" and 0.5 as "5", without padding to the same number of decimal places, gives the wrong order 0.5, 0.6, 0.55, 0.56, 0.601, because it ignores the place value of each digit. Ordering largest to smallest instead of smallest to largest, as the question asks, gives 0.601, 0.6, 0.56, 0.55, 0.5. Misreading the close values 0.55 and 0.56 and swapping them gives 0.5, 0.56, 0.55, 0.6, 0.601. So the correct order, smallest to largest, is 0.5, 0.55, 0.56, 0.6, 0.601.
- (a) x = (y + 9) / 2 — Method: undo the subtraction of 9 first, then undo the multiplication by 2. Working: y = 2x − 9, so adding 9 to both sides gives y + 9 = 2x, then dividing both sides by 2 gives x = (y + 9) / 2. The value x = (y − 9) / 2 comes from a sign error, keeping the −9 instead of moving it to +9. The value x = 2(y + 9) comes from multiplying by 2 instead of dividing. The value x = y / 2 + 9 comes from dividing by 2 before adding 9, the wrong order of operations, instead of dividing the whole bracket.
- (b) 8 — The gradient of a line through the origin is the y-value divided by the x-value at any point on the line. Using (10, 80): gradient = 80 ÷ 10 = 8.
- (c) 2000 mm — Put both lengths into the same unit first. There are 1000 mm in a metre, so the ribbon is 2.4 × 1000 = 2400 mm, and there are 10 mm in a centimetre, so the piece cut off is 40 × 10 = 400 mm. The length left is 2400 − 400 = 2000 mm. 2360 mm subtracts 40 mm instead of 400 mm, 200 mm works in centimetres and then labels the result as millimetres, and 2800 mm adds the piece that was cut off instead of subtracting it.
- (b) 12 — Method: work out what one part of the ratio is worth, then multiply that by the number of parts in the other share. Working: the smaller number matches the 2 parts, so 8 ÷ 2 = 4 for one part, and 3 × 4 = 12. Answer: 12. The distractors: 16 comes from multiplying 8 by 2, the ratio part that belongs to the smaller number; 24 comes from multiplying 8 by 3 without first finding the value of one part; 9 comes from adding the difference between the ratio parts, 3 − 2 = 1, to 8.
How the 20 questions are shared out
- Number — 5 questions (25% of the qualification)
- Algebra — 4 questions (20% of the qualification)
- Ratio, proportion and rates of change — 5 questions (25% of the qualification)
- Geometry and measures — 3 questions (15% of the qualification)
- Probability — 2 questions (7.5% of the qualification)
- Statistics — 1 question (7.5% of the qualification)
Where an area has fewer printable questions than its share, the shortfall is filled from the other areas. These are original questions, not past papers.