Sample paper · GCSE Foundation · grades 1–5
GCSE Foundation sample Paper 2 (calculator)
The real Paper 2 is 1.5 hour 30 minutes and 80 marks, calculator, and all three papers carry equal weight. This sample is 20 original questions in the same content proportions as the Foundation qualification — number 25%, algebra 20%, ratio, proportion and rates of change 25%, geometry and measures 15%, probability 7.5%, statistics 7.5% — with a calculator allowed. AO1 / AO2 / AO3 at this tier: 50% / 25% / 25%.
CalculatorGCSE Foundation
Answer key: GCSE Foundation sample Paper 2 (calculator)
MathsUKwww.geekhero.co.uk
- (a) 8.15 ≤ y < 8.25 — Rounding to 1 decimal place means the error interval spans half of 0.1, so 0.05, either side of 8.2: 8.2 − 0.05 = 8.15 and 8.2 + 0.05 = 8.25. The lower bound uses ≤ because 8.15 itself rounds to 8.2, but the upper bound uses < because 8.25 would round up to 8.3. So the error interval is 8.15 ≤ y < 8.25. A candidate who used the wrong rounding band gave 8.1 ≤ y < 8.2. A candidate who used a strict inequality at both ends wrote 8.15 < y < 8.25, wrongly excluding 8.15 itself. A candidate who added the full 0.1 instead of half of it wrote 8.2 ≤ y < 8.3.
- (a) x ≈ 6.70 — Since the two roots sum to 7, the other root is 7 − 0.30 = 6.70. The option 7.30 comes from adding the given root to 7 instead of subtracting it. The option 6.30 comes from subtracting 0.70 (one minus the given root) rather than the given root itself. The option 0.70 confuses the required root with the amount by which the given root falls short of 1.
- (a) £1,000 — Method: find the increase, then add it to the original price; the multiplier 1.25 does both steps at once. Working: 25% is one quarter, so 25% of £800 = £800 ÷ 4 = £200, and £800 + £200 = £1,000. Answer: £1,000. The distractors: £200 is the increase on its own, not the new price; £825 comes from adding £25 to £800, treating the 25% as £25; £600 comes from taking the 25% off the price instead of adding it on.
- (a) 8,000,000 cm³ — Method: change the edge length into centimetres first and then cube it, because 1 m = 100 cm and a volume needs that conversion applied to all three dimensions. Working: 2 m = 2 × 100 = 200 cm, so the volume is 200 × 200 × 200. 200 × 200 = 40,000 and 40,000 × 200 = 8,000,000. Answer: 8,000,000 cm³. The distractors: 8,000 cm³ comes from converting 2 m to 20 cm and cubing that; 80,000 cm³ comes from cubing in metres to get 8 m³ and then multiplying by 10,000, the conversion factor for an area rather than the 1,000,000 a volume needs; 8 cm³ comes from cubing the 2 without converting at all and simply writing cm³ because the question asked for that unit.
- (b) 41/160 — In total, 27 + 14 = 41 of the 160 employees cycle to work, so the probability is 41/160 (41 and 160 share no common factor, so this is already in its simplest form). Writing 27/160 is wrong because it only counts the full-time cyclists and leaves out the 14 part-time cyclists. Writing 41/90 is wrong because it uses the full-time total (90) as the denominator instead of the whole survey (160). Writing 1/5 is wrong because it only uses the part-time branch, simplifying 14/70 to 1/5 and ignoring the full-time cyclists completely. The probability is 41/160.
- (b) A line graph — Sales recorded at the end of each of the twelve months are time series data, and a line graph is the chart built to show how a value changes over time, with the points usually joined in order. A pie chart is for showing categorical data as shares of a whole, not a trend over time. A pictogram shows a frequency for separate categories using symbols, not a continuous trend. A scatter graph is for comparing two different variables against each other, not one variable over time.
- (c) 10 — Method: the multiplication is carried out before the subtraction. Working: 4 × 2 = 8, so the calculation becomes 18 − 8 = 10. Answer: 10. The distractors: 28 comes from working from left to right, giving (18 − 4) × 2 = 14 × 2 = 28; −10 comes from subtracting the 18 from the 8 rather than the 8 from the 18, giving 8 − 18 = −10; 12 comes from reading 4 × 2 as 4 + 2 = 6 and then working out 18 − 6 = 12.
- (c) 70 — Method: the numbers of tiles form a sequence in which the same amount is added for each extra row, so the total for a number of rows is that amount multiplied by the number of rows. Working: 20 − 10 = 10 and 30 − 20 = 10, so each row adds 10 tiles; 7 rows therefore need 7 lots of 10, that is 7 × 10. Answer: 70. The distractors: 80 comes from counting one row too many and giving the total for 8 rows; 17 comes from adding the 10 tiles to the 7 rows instead of multiplying; 10 comes from giving the number of tiles in a single row rather than the total for all the rows.
- (d) 19% — Method: write each decrease as a multiplier, multiply the multipliers, then compare the result with 100%. Working: a 10% decrease is a multiplier of 0.9, so the two reductions together give 0.9 × 0.9 = 0.81; the final price is 81% of the original, so the price has fallen by 100% − 81% = 19%. Answer: an overall decrease of 19%. The distractors: 20% comes from adding the two reductions, 10% + 10%, which charges the second 10% against the original price instead of against the already reduced price; 21% comes from using the increase multiplier by mistake, since 1.1 × 1.1 = 1.21, and reading that 21% as a decrease; 81% is the percentage of the original price still being paid, not the percentage taken off.
- (b) 31.4 cm — Circumference = π × diameter, so 3.14 × 10 = 31.4 cm. 15.7 cm comes from using the radius, 5 cm, in place of the diameter: 3.14 × 5 = 15.7, which is only half the circumference. 78.5 cm comes from using the area formula π × radius² instead of the circumference formula: 3.14 × 5² = 3.14 × 25 = 78.5. 62.8 cm comes from keeping the 2 from the radius form of the formula, C = 2 × π × radius, but putting the full diameter into it: 2 × 3.14 × 10 = 62.8.
- (a) 1/12 — The probability that the first dice shows a 6 is 1/6. The probability that the second dice shows an even number, 2, 4 or 6, is 3/6 = 1/2. Since the two dice are independent, multiply the probabilities: 1/6 × 1/2 = 1/12. A candidate who answers 1/6 has considered only the first dice and forgotten the condition on the second dice. A candidate who answers 1/2 has considered only the second dice and forgotten the condition on the first dice. A candidate who answers 1/36 has treated 'an even number' as a single specific value rather than three possible values, using 1/6 × 1/6.
- (c) 9/10 — Method: write the decimal over 10 using its one decimal place. Working: 0.9 = 9/10, which is already in its simplest form since 9 and 10 share no common factor. Answer: 9/10. The student's fraction, 9/100, comes from always writing the denominator as 100, regardless of how many decimal places the number actually has. 9 comes from dropping the decimal point altogether and treating 0.9 as the whole number 9. 1/9 comes from flipping the correct fraction upside down.
- (b) x = 8 — Method: undo the addition first, then undo the division by 4. Working: subtracting 1 from both sides gives x/4 = 2, and multiplying both sides by 4 gives x = 8. Answer: x = 8. The distractors: x = 2 comes from stopping at x/4 = 2 and writing 2 as the value of x; x = 16 comes from adding 1 to both sides instead of subtracting it, giving x/4 = 4; x = 0.5 comes from dividing by 4 instead of multiplying by 4 at the last step.
- (a) 20% — Method: a percentage concentration compares the sugar with the whole solution, so add the two masses to get the mass of solution and then scale the ratio of sugar to solution to a denominator of 100. Working: the solution has a mass of 200 + 50 = 250 g; sugar:solution = 50:250, and scaling to per 100 gives 50 ÷ 250 × 100 = 20, so the ratio is 20:100. Answer: 20%. The distractors: 25% comes from comparing the sugar with the 200 g of water, 50:200, rather than with the whole solution; 80% is the percentage of the solution that is water, 200:250, which answers for the wrong part of the mixture; 0.2% comes from working out 50 ÷ 250 = 0.2 and writing that decimal down as a percentage without multiplying by 100.
- (d) sector — The region enclosed by two radii and the arc between them is called a sector. A segment is a different region, enclosed by a CHORD and an arc — it does not touch the centre at all. A chord is a straight line, not a region, so it cannot be the answer to a question asking for a region. A semicircle is only correct when the angle between the two radii is exactly 180°, which is not stated here, so it is too specific to be the general answer.
- (a) 6 — Method: list the factors of each number and compare them. Working: the factors of 18 are 1, 2, 3, 6, 9, 18; the factors of 24 are 1, 2, 3, 4, 6, 8, 12, 24. The only option that appears in both lists is 6. 8 is a factor of 24 but not of 18. 9 is a factor of 18 but not of 24. 12 is a factor of 24 but not of 18. Answer: 6.
- (b) 10 — Method: substitute the value of x into the rule and carry out the addition; only the term containing x becomes zero. Working: y = 0 + 10, and adding to zero leaves the 10 unchanged. Answer: y = 10. The distractors: 0 comes from assuming that an input of x = 0 makes the whole rule zero, which is only true when nothing is added on; 11 comes from substituting x = 1 instead of x = 0; −10 comes from reading the rule as y = x − 10.
- (d) 0.6 g/cm³ — Density = mass ÷ volume. 60 ÷ 100 = 0.6 g/cm³. 1.67 g/cm³ comes from dividing the volume by the mass instead of the mass by the volume (100 ÷ 60). 6000 g/cm³ comes from multiplying the mass by the volume instead of dividing (60 × 100). 40 g/cm³ comes from subtracting the mass from the volume (100 − 60) instead of dividing.
- (d) 2 hours — Method: the time for a journey is the distance divided by the speed, so round the distance first and then divide by the speed. Working: 95 km rounds to 100 km, and 100 ÷ 50 = 2; the speed is in kilometres per hour, so the answer is a number of hours. Answer: 2 hours. The distractors: 1 hour comes from rounding the distance down to 50 km to match the speed, so that the journey looks like a single hour of driving; 30 minutes comes from dividing the speed by the distance, 50 ÷ 100, instead of the distance by the speed; 1 hour 54 minutes is the exact time, 95 ÷ 50 = 1.9 hours, worked out in full when the question asks for an estimate.
- (c) Yes — 700 ÷ 7 = 100 ml for the 1 part of concentrate — Method: add the ratio parts to find the total number of parts, divide the total volume by this, then use the ratio to find concentrate's share. Working: 1 + 6 = 7 parts. 700 ÷ 7 = 100 ml per part. Concentrate = 1 part = 100 ml, so Freya is correct. Wrong options: 'divide 700 by 6' uses only one of the ratio numbers instead of the total of 7 parts, giving about 117 ml; '600 ml is concentrate' swaps which ratio number belongs to the concentrate and which belongs to the water; 'half of 700 ml should be concentrate' ignores the ratio altogether and assumes an equal split.
How the 20 questions are shared out
- Number — 5 questions (25% of the qualification)
- Algebra — 4 questions (20% of the qualification)
- Ratio, proportion and rates of change — 5 questions (25% of the qualification)
- Geometry and measures — 3 questions (15% of the qualification)
- Probability — 2 questions (7.5% of the qualification)
- Statistics — 1 question (7.5% of the qualification)
Where an area has fewer printable questions than its share, the shortfall is filled from the other areas. These are original questions, not past papers.