Sample paper · GCSE Foundation · grades 1–5
GCSE Foundation sample Paper 2 (calculator)
The real Paper 2 is 1.5 hour 30 minutes and 80 marks, calculator, and all three papers carry equal weight. This sample is 20 original questions in the same content proportions as the Foundation qualification — number 25%, algebra 20%, ratio, proportion and rates of change 25%, geometry and measures 15%, probability 7.5%, statistics 7.5% — with a calculator allowed. AO1 / AO2 / AO3 at this tier: 50% / 25% / 25%.
CalculatorGCSE Foundation
Answer key: GCSE Foundation sample Paper 2 (calculator)
MathsUKwww.geekhero.co.uk
- (b) 7 — Method: trap the number between the two square numbers on either side of it, then decide which of them it is nearer to. Working: 6² = 36 and 7² = 49, so √45 lies between 6 and 7; 49 − 45 = 4 while 45 − 36 = 9, so 45 is nearer to 49. Answer: 7. The distractors: 6 comes from taking the square number below 45 and stopping there, without checking which of 36 and 49 is nearer; 22.5 comes from halving 45 instead of looking for the number that multiplies by itself to give 45; 2,025 comes from squaring 45 instead of taking its square root.
- (c) 32 — The terms are 60, 53, 46, 39, 32 — each found by subtracting 7 from the term before, so the 5th term is 32. Subtracting 7 five times from the first term instead of four times, 60 − 7 × 5 = 25, treats the first term as if it came before the sequence starts. Adding 7 four times instead of subtracting, 60 + 7 × 4 = 88, uses the wrong operation. Stopping one term early gives the 4th term, 39.
- (c) 27.1 cm — The model length is 20.6 ÷ 76 = 0.271052... metres. Converting to centimetres by multiplying by 100 gives 27.1052..., which rounds to 27.1 cm. Forgetting to convert metres to centimetres leaves the answer as 0.271052... metres, which rounds to 0.3 cm if the unit is simply relabelled. Multiplying by 1000 instead of 100 when converting metres to centimetres gives 271.052..., which rounds to 271.1 cm. Multiplying by 76 instead of dividing, 20.6 × 76 = 1565.6, uses the scale factor the wrong way round — that would be the real length if the model were 20.6 units long, not the other way round.
- (d) 50 — The angles in any triangle add up to 180°, so x = 180 − 90 − 40 = 50. "90" comes from subtracting only the 90° angle from 180° and forgetting to also subtract the 40°. "130" comes from adding 90° and 40° together instead of subtracting them from 180°. "45" comes from halving the 90° angle instead of using the angle sum of the triangle at all.
- (c) 100 — There are 3 even numbers on a fair dice (2, 4 and 6), so the probability of landing on an even number is 3/6 = 1/2, and 300 × 1/2 = 150. The probability of landing on a six is 1/6, so 300 × 1/6 = 50. The dice is expected to land on an even number 150 − 50 = 100 more times than on a six. Writing 50 is wrong because that is just the expected number of sixes on its own, without comparing it to the expected number of evens. Writing 150 is wrong because that is just the expected number of evens on its own, without subtracting the sixes. Writing 200 is wrong because it adds the two expected frequencies together (150 + 50 = 200) instead of finding the difference between them. The dice is expected to land on an even number 100 more times than on a six.
- (c) 16 kg — Method: sort the seven weights before finding the middle value. Working: in order, the weights are 10, 12, 14, 16, 18, 20 and 50 kg. There are 7 values, so the median is the 4th one: 16 kg. Reading off the 4th weight in the order the vet recorded them, 10 kg, skips the sorting step and is not the median. Working out the mean, 140 ÷ 7 = 20 kg, finds a different average altogether. Working out the range, 50 − 10 = 40 kg, finds the spread, not the middle value. Always sort your data first — the median lives in the ordered list, not the collection order.
- (b) −4 — To subtract a negative number, add its positive equivalent: −7 − (−3) becomes −7 + 3. Work out −7 + 3 to get −4. Treating "− (−3)" as simply "−3" without flipping the sign gives the wrong working −7 − 3, which is −10. Ignoring the negative sign on −7 and just subtracting the values, 7 − 3, gives 4, which loses the sign of the starting number. Flipping the sign of both numbers, 7 + 3, gives 10, which changes more than the double negative allows. So −7 − (−3) = −4.
- (d) The roots of x² − 6x + 5 = 0 are x = 1 and x = 5 (since it factorises to (x − 1)(x − 5)), so by symmetry the turning point has x-coordinate 3, not 6. — Factorising, x² − 6x + 5 = (x − 1)(x − 5), so the roots are x = 1 and x = 5. The turning point lies midway between the roots by symmetry: (1 + 5) ÷ 2 = 3. The coefficient of x has no direct role in locating the turning point this way. The option giving −6 makes an arbitrary sign change with no mathematical basis. The option giving 5 wrongly takes just one of the two roots instead of their midpoint.
- (d) 4/7 — Put the tomato plant's height over the sunflower's height: 80/140. Divide both numbers by their highest common factor, 20: 80÷20 = 4, 140÷20 = 7, giving 4/7. (7/4 comes from writing the heights the wrong way round. 3/7 comes from finding the difference in the heights, 140 − 80 = 60 cm, and writing it as a fraction of the sunflower's height, 60/140. 4/11 comes from comparing the tomato plant's height to the total height of both plants, 80/220.)
- (d) The centre — Method: sort the four names by what kind of object each one is, because only one of them names a single point rather than a line or a curve. Working: a chord is a straight line joining two points on the circle; a diameter is the special chord that runs right across the circle through the middle, so it too is a line; an arc is a piece of the circle's own curve. That leaves one name, and it belongs to the point from which every radius is drawn, which is why every point on the circle is the same distance from it. Answer: The centre. The distractors: The chord is picked by a candidate who reads 'the same distance' as a line of fixed length rather than as a point; The diameter is picked by a candidate who names the line that passes through the point instead of the point itself; The arc is picked by a candidate who hunts for a part of the circle's own curve rather than for a point inside it.
- (a) Class A — Class A: 18/24 = 0.75 = 75%. Class B: 21/30 = 0.7 = 70%. Since 75% > 70%, class A had the greater proportion passing, even though fewer pupils passed there in total. Choosing class B compares the raw numbers of pupils who passed (21 > 18) rather than the proportions. The two proportions are not equal — 0.75 and 0.7 are different values, so the two classes did not have the same pass rate. The class sizes being different does not prevent a comparison: converting each to a proportion makes the two classes directly comparable, so the answer can be determined.
- (d) 1 × 10⁷ seconds — Method: the time for a journey is the distance divided by the speed, so round each number to 1 significant figure and then divide; dividing numbers in standard form means dividing the coefficients and subtracting the indices. Working: 3.1 × 10¹⁵ rounds to 3 × 10¹⁵ and 2.998 × 10⁸ rounds to 3 × 10⁸; 3 ÷ 3 = 1 for the coefficients, and 15 − 8 = 7 for the indices. Answer: about 1 × 10⁷ seconds. The distractors: 3 × 10⁷ seconds comes from subtracting the indices correctly but leaving the coefficient as 3 instead of dividing 3 by 3; 1 × 10⁻⁷ seconds comes from dividing the speed by the distance instead of the distance by the speed; 9 × 10²³ seconds comes from multiplying the two quantities instead of dividing them, since 3 × 3 = 9 and 15 + 8 = 23.
- (b) t − 1 — Method: "fewer than" means a subtraction, and the amount taken away is taken away from the quantity being compared with. Working: Grace has t books and Noah has one book fewer, so Noah has t with 1 taken off, written t − 1. Answer: t − 1. The distractors: t + 1 comes from reading "fewer" as "more" and adding instead of subtracting; 1 − t comes from writing the subtraction the wrong way round, taking Grace's books from the 1 rather than the 1 from Grace's books; t comes from giving the number of books Grace has, which is not the person the question asks about.
- (d) 4/3 — The amount of yellow paint is 0.75 times the amount of blue paint. As a fraction, 0.75 = 3/4, so yellow = 3/4 of blue. To write blue as a fraction of yellow, use the reciprocal: flip 3/4 to get 4/3. 3/4 comes from keeping the original fraction without inverting it. 1/4 comes from computing 1 − 3/4 = 1/4, which is not how a fraction reverses. 40/3 comes from converting 0.75 to a fraction as 75/1000 = 3/40 (misplacing the decimal point), then inverting that.
- (c) a square — A cube has six identical square faces, and looking at it from directly above, directly from the front, or directly from the side each shows one of these square faces face-on, undistorted — so all three views are squares of the same size. "a triangle" would be the plan or elevation of a solid such as a pyramid or cone, not a cube. "a circle" belongs to a sphere or a cylinder viewed along its axis, not a cube. "a rectangle that is not a square" would appear if the cube's edges were not all equal, which is not true of a cube.
- (d) £6 — First find 30% of £200, which is £60, then find 10% of that: £60 × 0.1 = £6. Adding the two percentages together instead of applying them one after the other, 10% + 30% = 40%, and finding 40% of £200 gives £80. Finding 30% of £200 = £60 correctly but stopping before applying the second percentage leaves £60 as the final answer. Finding only 10% of the original £200, ignoring the 30% entirely, gives £20.
- (d) £2000 — This is an arithmetic sequence with first term £500 and common difference £300. The 6th term is 500 + 5 × 300 = 2000. A candidate who uses 6 lots of the increase instead of 5 gets 500 + 6 × 300 = 2300. A candidate who forgets to add the first year's profit at all gets 5 × 300 = 1500. A candidate who miscounts the number of increases as 4 instead of 5 gets 500 + 4 × 300 = 1700.
- (a) 1000m — Method: kilograms are a smaller unit than tonnes, so change tonnes into kilograms by multiplying by 1000. Working: m tonnes = m × 1000 kg = 1000m kg. So the expression is 1000m. Distractor m/1000 comes from dividing by 1000 instead of multiplying, which would make the number of kilograms smaller than the number of tonnes, the wrong way round. Distractor 1000 + m comes from adding the conversion factor instead of multiplying by it. Distractor m − 1000 comes from subtracting the conversion factor instead of multiplying by it.
- (b) 20 — Method: check a calculator answer by replacing the percentage with a simple fraction — 25% is one quarter, so the calculation becomes a division by 4. Working: 80 ÷ 4 = 20, and the calculator answer of 320 is 80 × 4, which is what happens when the amount is multiplied by 4 instead of divided by it; a quarter of an amount must be smaller than the amount. Answer: 20. The distractors: 25 comes from writing the percentage itself down as the answer; 16 comes from dividing by 5 instead of by 4, which finds 20% rather than 25%; 3.2 comes from working out 80 ÷ 25 instead of a quarter of 80.
- (c) 7800 kg/m³ — Method: build the conversion factor from the two unit changes separately — one for the mass, one for the volume. Working: 1 kg = 1000 g, so the mass figure is divided by 1000; 1 m = 100 cm, so 1 m³ = 100 × 100 × 100 = 1000000 cm³ and the volume figure is multiplied by 1000000. The density figure is therefore multiplied by 1000000 ÷ 1000 = 1000, giving 7.8 × 1000 = 7800. So the density of the metal is 7800 kg/m³. Distractor 780 kg/m³ comes from multiplying by 100 instead of 1000. Distractor 78000 kg/m³ comes from multiplying by 10000, an extra zero. Distractor 7.8 kg/m³ comes from not converting the units at all.
How the 20 questions are shared out
- Number — 5 questions (25% of the qualification)
- Algebra — 4 questions (20% of the qualification)
- Ratio, proportion and rates of change — 5 questions (25% of the qualification)
- Geometry and measures — 3 questions (15% of the qualification)
- Probability — 2 questions (7.5% of the qualification)
- Statistics — 1 question (7.5% of the qualification)
Where an area has fewer printable questions than its share, the shortfall is filled from the other areas. These are original questions, not past papers.